污水厂污泥一体化竖式强化渗滤浓缩自然干化与消化研究

针对目前国内污泥处理处置存在的问题,为实现污泥浓缩消化一体化,开发了污泥一体化强化渗滤浓缩自然干化与消化新工艺反应器,并进行了城市水厂污泥处理试验.结果表明,在有机负荷为0.8 kg VSS/(m3·d)、平均水力停留时间为8.3 d、污泥停留时间为120 d的条件下,污泥有机物去除率可达到44.4%,排泥含水率达到79.1%,污泥消化与浓缩过程起到了相互促进的作用.渗滤液须抽回至污水处理厂处理.     

Trends in airborne particulates in Stuttgart, Germany: 1972-2005

Since 1972, at the University of Hohenheim in Stuttgart, Germany, airborne particulate matter (PM12 and then PM10) was continuously collected on filters and analyzed for environmentally relevant elements by X-ray fluorescence analysis. The resulting long-term time series are suitable for the investigation of trends and of seasonal variation. For the period 1972-2005, monthly and annual concentration mean values of 13 elements (Br, Ca, Cr, Cu, Fe, K, Mn, Ni, Pb, S, Ti, V, and Zn) in the air are presented. Trend curves were fitted and the mean yearly variation of the concentration for these elements was calculated and represented graphically. All trend curves show a diminution of the air pollution during this period, but to different extents. Mean trends in percent per year were calculated for each element both for the entire investigation period and for three data subsets of 10-11 years. Possible explanations are discussed in detail.     

Particle fluxes above forests: observations, methodological considerations and method comparisons

This paper reports a study designed to test, evaluate and compare micro-meteorological methods for determining the particle number flux above forest canopies. Half-hour average particle number fluxes above a representative broad-leaved forest in Denmark derived using eddy covariance range from -7x10(7) m(-2) s(-1) (1st percentile) to 5x10(7) m(-2) s(-1) (99th percentile), and have a median value of -1.6x10(6) m(-2) s(-1). The statistical uncertainties associated with the particle number flux estimates are larger than those for momentum fluxes and imply that in this data set approximately half of the particle number fluxes are not statistically different to zero. Particle number fluxes from relaxed eddy accumulation (REA) and eddy covariance are highly correlated and of almost identical magnitude. Flux estimates from the co-spectral and dissipation methods are also correlated with those from eddy covariance but exhibit higher absolute magnitude of fluxes.     

Seasonal variation in dissolved gaseous mercury and total mercury concentrations in Juam Reservoir, Korea

Dissolved gaseous mercury (DGM) and total mercury (TM) concentrations were measured in Juam Reservoir, Korea. DGM concentrations were higher in spring (64+/-13pgL(-1)) and summer (109+/-15pgL(-1)), and lower in fall (20+/-2pgL(-1)) and winter (23+/-6pgL(-1)). In contrast, TM concentrations were higher in fall (3.2+/-0.1ngL(-1)) and winter (3.3+/-0.1ngL(-1)) than in spring (2.3+/-0.1ngL(-1)) and summer (2.2+/-0.4ngL(-1)). DGM concentrations were correlated with water temperature (p<0.0001), ORP (p<0.0001), UV intensity (UV-A: p=0.008; UV-B: p=0.003), and DOC concentration (p=0.0107). DGM concentrations varied diurnally with UV intensity. The average summer DGM (109+/-15pgL(-1)) and TM (2.2+/-0.4ngL(-1)) concentrations in Juam Reservoir were higher than the averages for North American lakes (DGM=38+/-16pgL(-1); TM=1.0+/-1.2ngL(-1)), but lower than levels reported for Baihua Reservoir in China.     

Physicochemical substance properties as indicators for unreliable exposure in microplate-based bioassays

In the last years many efforts were made to transform standardized algal test protocols into low-cost microplate assays. While advantages were pointed out frequently, limitations are not systematically addressed, thus hindering a widespread utilisation. In this study a group of organic substances with a wide distribution of volatility (log K_AW from −6.53 to −2.13) and lipophilicity (log K_OW from 1.26 to 4.92) was investigated with respect to the influence of these physicochemical properties on their algal toxicity in different assays. Therefore the EC₅₀ values were determined with a microplate assay based on ISO 8692 protocol and the results were compared with those of an established algal growth inhibition test conducted in air tight glass vessels. Using the ratio of the EC₅₀ values, a clear connection between biological response and volatility as well as lipophilicity of test substances could be detected. Chemicals with a log K_OW higher than 3 or a Henry coefficient log K_AW higher than −4 were identified as less effective in the microplate assay than in the comparative assay. The loss in nominal concentration due to physicochemical properties could be shown to contribute to this using HPLC analysis. Consequently, when using microplate assay’s one should be aware that lipophilic and volatile chemicals might be underestimated in their toxicity, which could be indicated from evaluating related physicochemical properties modelled from structural information prior to an experimental investigation.     

焊点热疲劳失效原因分析

某PCBA样品在使用约半年后出现功能失效,该PCBA在封装后进行整体灌胶,将失效样品剥离,发现部分器件直接脱落,通过表面观察、切片分析、EBSD分析、应力分析、热膨胀系数测试等手段对样品进行分析,结果表明:各封装材料存在热失配,且焊点缺陷较多且存在应力集中区,加速焊点的疲劳失效进程,导致PCBA功能失效。     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

A method to estimate the impact of clear-cutting on nutrient concentrations in boreal headwater streams

Large-scale forestry operations, like clear-cutting, may impair surface water quality if not done with environmental considerations in mind. Catchment and country level estimates of nutrient loads from forestry are generally based on specific export values, i.e., changes in annual exports due to the implemented forestry operations expressed in kg ha⁻¹. We introduce here a specific concentration approach as a method to estimate the impact of clear-cutting on nutrient concentrations and export in headwater streams. This new method is potentially a more dynamic and flexible tool to estimate nutrient loads caused by forestry, because variation in annual runoff can be taken into account in load assessments. We combined water quality data from eight boreal headwater catchment pairs located in Finland and Sweden, where the effect of clear-cutting on stream water quality has been studied experimentally. Statistically significant specific concentration values could be produced for total nitrogen, nitrate, ammonium, and phosphate. The significant increases in the concentrations of these nutrients occurred between 2 and 6 years after clear-cutting. Significant specific concentration values could not be produced for total phosphorus and total organic carbon with the whole dataset, although in some single studies significant increases in their concentrations after clear-cutting were observed. The presented method enables taking into account variation in runoff, temporal dynamics of effects, and the proportional size of the treated area in load calculations. The number of existing studies considering large site-specific variation in responses to clear-cutting is small, and therefore further empirical studies are needed to improve predictive capabilities of the specific concentration values.     

燃煤机组烟囱在线烟尘仪监测烟尘浓度偏高原因分析及对策

除尘电价补贴政策的出台以及新环保标准的实施,一方面提高了电厂降低烟尘排放浓度的积极性,另一方面对烟尘在线监测系统提出了更高的要求。针对一些采用湿法脱硫和无GGH的燃煤机组,会出现烟囱在线烟尘仪监测的烟尘浓度高于电除尘器出口烟尘的浓度,对产生这一现象的原因进行了分析并提出相应的解决对策。     

生物膜法污水处理工艺中微生物量的对比研究

采用生物膜法污水处理工艺,对深圳布吉秀峰工业城污水进行现场中试研究.出水中有机物BOD₅,COD_Cr及悬浮物去除率一般在80%以上,曝气生物滤池工艺中的污泥质量浓度2倍于生物接触氧化工艺,曝气生物滤池中的原生动物及后生动物密度比生物接触氧化工艺高出1～2个数量级.试验中曝气生物滤池的去除效果比生物接触氧化工艺稍好,从反应器中污泥质量浓度(ρ(MLSS))及原生动物、后生动物数量的比较进一步证实这一结论.