pH对海绵铁过滤柱预处理染色废水的影响

通过滤柱考察了进水pH变化对海绵铁预处理染色废水的影响。研究结果表明,在pH为6、7、8、10时,过滤周期内脱色率都高于94%,出水pH大于7。与pH=6、7、8对比可知,在pH=10时,水头损失小,周期产水量高,出水含铁量低。海绵铁过滤柱活化后脱色率、周期产水量与活化前基本相同,出水pH比活化前低,出水铁含量相对较高。同时,通过扫描电镜图发现过滤柱内海绵铁腐蚀程度从上至下逐渐变小。     

氢气还原海绵铁去除水体中硝酸盐的研究

利用小球烧结和氢气还原工艺制备了粒径1mm～5mm的多孔性球形海绵铁,对球形海绵铁去除水体中硝酸盐的效率及去除动力学进行了研究。结果表明:溶液初始pH值对硝酸盐去除效率的影响显著,初始pH值小于3时,硝酸盐的去除率随溶液初始pH的增加而逐渐降低;初始pH值大于3时,硝酸盐的去除率又随之升高。硝酸盐浓度低于10mgN/L时,硝酸盐去除率随着硝酸盐初始浓度的增加而增加,硝酸盐的残余量保持在0.4mgN/L左右;硝酸盐浓度高于20mgN/L时,硝酸盐的去除率随初始硝酸盐浓度的增加而略有降低。球形海绵铁去除硝酸盐为一级动力学反应,反应级数为0.970～1.378,表观反应速率常数为0.314h-1～0.536h-1。海绵铁还原硝酸盐的主要产物为氨氮,随着还原反应的进行,溶液pH值快速增加,氨氮以分子态氨的形式从水中逸出。进行归纳总结和对比,并以多环芳烃的提取为例列举了各方法的应用步骤,从而为其他环境样品其他有机物分析预处理提供参考。     

大型沼气工程中生物脱硫技术

随着我国对可再生能源的开发和利用的不断深入发展,利用畜禽粪便厌氧发酵产沼气是一种非常有前景的能源利用途径,但所产生的沼气中都含有H2S气体,由于它是一种腐蚀性很强的化合物,所以沼气脱硫是沼气利用的关键环节。本文以某工程调试与运行实例分析了大型沼气工程中的生物脱硫技术,以为同类型工程提供参考。     

活性炭对水中Cr（Ⅵ）吸附行为的研究

采用批量吸附实验,研究了活性炭对水中Cr（Ⅵ）的吸附行为,探讨了溶液pH值、活性炭用量、吸附时间、吸附过程中加入酸对Cr（Ⅵ）吸附的影响和吸附前后pH值的变化以及活性炭的再生。结果表明,利用活性炭处理Cr（Ⅵ）,具有处理效果好、再生容易等特点。在pH为4．00的缓冲系统中,等温吸附线符合Langmuir型,并可以用Freundlich等温吸附方程对其吸附进行描述;在pH为3．52的非缓冲系统中,等温吸附线类型属于BDDT吸附等温线分类中的类型Ⅱ。     

水温和pH对饮用水中铝形态分布的影响

铝对输配水系统及人体健康的影响主要与其存在形态有关.本研究采用硫酸铝模拟配水考察了水温和pH对溶液中铝形态分布的影响情况.考察的主要铝形态包括单核铝、溶解铝、悬浮铝和多核铝;采用的形态分析方法为荧光分光光度法.结果表明:当pH=6.5时,悬浮铝为饮用水中铝的主要存在形态,在总铝中的质量分数为62.2%;而当pH>7.0时,单核铝为主要形态,且随反应时间的增加变化不大.各水质条件下的多核铝浓度均较低,且随反应时间的变化也不大.水温对铝形态的影响与pH是一致的,由pOH可将二者统一起来.通过调节pOH可以实现饮用水中铝形态的控制,这将对输配水系统的运行管理及铝毒性控制提供理论依据.     

MAP沉淀法目标产物最优形成条件及分析方法

为了确定鸟粪石(MAP：MgNH₄PO₄·6H₂O)形成的最优条件,引入化学剖析法,利用酸溶液将鸟粪石沉淀法中所得沉淀物溶解后进行相应的元素分析;提出一种根据沉淀物中的NH⁺₄-N含量间接计算确定鸟粪石含量(即纯度)的分析方法.根据这种计算分析方法,分别得出了不同pH条件下以自来水(主要为地下水)和超纯水作为溶剂所合成的鸟粪石纯度,并对pH和Ca²⁺在鸟粪石形成过程中的影响进行了评估.结果表明,该计算分析方法能够有效实现对MAP沉淀法目标产物的定量分析,弥补了国内外目前普遍依靠XRD技术定性判断所得沉淀物中鸟粪石是否存在的缺陷.以超纯水作为溶剂时,使鸟粪石纯度>90%的最佳pH范围在7.5～9.0,而以自来水为溶剂时,获得相同鸟粪石纯度最佳pH范围则是7.0～7.5.实际污水中常常含有相当数量的Ca²⁺,实施碱性条件(pH>8.0)的MAP沉淀势必大幅降低鸟粪石的纯度.因此,对实际污水回收磷而言,MAP沉淀法的最优pH条件应控制在中性范围(<8.0)以内.     

基于ASBR反应器的厌氧氨氧化启动及特性研究

采用ASBR反应器,接种消化污泥和厌氧颗粒污泥的混合污泥,在温度(35±1)℃、HRT为24h、pH为7.3～8.5的条件下经过160d的培养,获得了砖红色的厌氧氨氧化菌菌胶团.试验结果表明:进水NH+4-N和NO-2-N浓度约为180mg·L-1,平均总氮容积负荷为0.38kg·m-3·d-1时.NH4+4-N和NO-2N的去除率平均为93.2%和95.7%,TN平均去除率为86.9%.厌氧氨氧化反应过程出水pH值高于进水,稳定在7.74左右.     

废弃钻井液固化处理pH值控制措施

提出了在原有固化处理技术的基础上,根据钻井泥浆原样pH值的高低,在固化材中适量加入酸性盐类混凝剂有效控制pH值的方法。采用此方法后,废弃钻井液的固化处理效果好,能够满足环保标准要求。     

浸渍液pH值对V-Mo/Ti脱硝催化剂性能的影响研究

为提升V-Mo/Ti催化剂的脱硝性能,在催化剂制备过程中调节浸渍工艺参数,制备了一系列不同浸渍液pH值的催化剂,采用XRD、N2-吸附脱附、拉曼光谱、UV-Vis、H2-TPR、NH3-TPD等手段对催化剂进行表征,考察了pH值的变化对催化剂物理化学性能的影响,采用固定床微型反应器对催化剂的脱硝性能进行评价。结果表明,降低浸渍液pH值,可以抑制催化剂上VOx物种的聚合,提升催化剂的还原性能,有利于提升催化剂的脱硝效率,降低脱硝反应过程中N2O生成量。同时,浸渍液pH值的变化,也会影响催化剂的酸性性能。当浸渍液pH值低于3.64时,催化剂酸性性能显著降低,造成催化剂脱硝性能降低;当浸渍液pH值控制在3.64时,催化剂的还原性能和酸性性能匹配较好,从而显示了较高的脱硝性能。     

An experimental study on the influence of zeolite on changes of pH and alkalinity in anaerobic treatment of compost leachate

With the increase of urbanization, municipal solid waste has also increased. Therefore, the need for solid waste management is also increasing compared with earlier decades. Composting is a good option for the recycling of solid waste; however, it produces leachate, which requires proper treatment systems to prevent environmental degradation. Due to high chemical oxygen demand (COD) concentrations in compost leachate, anaerobic treatment is the best option for handling the effluent, and an anaerobic baffled reactor (ABR) is one such anaerobic reactor that can be used for its treatment. Because of high ammonia and heavy metal concentrations, as well as the possibility of sludge washout in ABRs, it is important to use proper media, such as zeolite, which can reduce inhibition effects and sludge washout from the reactor. Anaerobic treatment, especially during the methanogenesis phase, is sensitive, and pH and alkalinity are parameters that influence the treatment. Therefore, adjusting these parameters within a normal range is very important to the proper functioning of anaerobic systems. In this study, a pilot‐scale ABR was used, and the last 4 of the 8 ABR compartments were filled with zeolite. The bioreactor was operated at hydraulic retention times (HRT) of 3, 4, and 5 days, with zeolite filling ratios of 10%, 20%, and 30%, and influent COD concentrations of 10,000, 20,000, and 30,000 milligrams per liter (mg/L). In this study, pH value was 6.43 ± 0.1, 6.96 ± 0.3, and 6.96 ± 0.25 at filling ratios of 10%, 20%, and 30%, respectively. According to the results, in all filling ratios, no significant changes were observed in the pH value when the organic loading rate increased and its amount was within a constant range. Influent alkalinity was equal to 2015 ± 510, 2884 ± 505, and 4154 ± 233 milligrams of calcium carbonate per liter (mg CaCO₃/L) at influent COD concentrations of 10,000, 20,000, and 30,000 mg/L, respectively, and in effluent, they were 2536 ± 336, 3379 ± 639, and 4377 ± 325 mg CaCO₃/L, respectively. The amount of alkalinity in the effluent increased compared with the alkalinity in the influent. The results show that the amount of alkalinity in the influent and effluent was similar, and the alkalinity enhancement was lower when the filling ratio was increased from 10% to 20%, and 20% to 30%. Comparisons of the results from zeolite with and without biofilm showed that, in cases of zeolite with biofilm, the amounts of silica and oxygen decreased and the amount of carbon increased, and it showed the formation of biofilm on the surface of zeolite. In addition, the absence of sodium in the zeolite with the biofilm indicated that sodium was exchanged with ammonium ions. According to the results, zeolite can be used in anaerobic reactors as a medium, and it also reduces fluctuations in pH and alkalinity at different organic loading rates, providing a normal range for anaerobic treatment.