氯化钙种子气溶胶对甲苯二次有机气溶胶与氨形成含氮有机物的影响

苯系物光氧化反应形成的二次有机气溶胶(SOA)是大气细粒子的重要组成部分.SOA羧酸和二元醛组分能与氨反应形成有机酸铵和咪唑类含氮有机物,它们能够吸收205 nm和270 nm的紫外辐射,是棕色碳的主要组分.氯化钙等无机种子气溶胶具有较大的比表面积,可为气相羰基化合物和氨提供凝结与反应载体,从而影响含氮有机物的形成.基于此,本文利用烟雾腔研究氯化钙种子气溶胶存在时甲苯SOA与氨的反应,采用紫外-可见分光光度计测量产物溶液在205 nm和270 nm处的吸光度,并定性研究不同浓度、湿度和酸度的氯化钙种子气溶胶对含氮有机物形成的影响.结果表明:氯化钙种子气溶胶能够促进甲苯SOA含氮有机物的形成;含氮有机物的生成浓度随着氯化钙种子气溶胶浓度和pH值的增加而逐渐增大.但当氯化钙种子气溶胶为碱性时,OH~-会与凝结的有机酸发生酸碱中和反应并抑制二元醛化合物水合形成四醇产物,从而不利于含氮有机物的生成;水分子的增加占据了氯化钙种子气溶胶表面的吸附活性位点,氨被吸附和凝结的量减少,从而导致含氮有机物的生成浓度随着相对湿度的增大而降低.本研究可为人为源SOA棕色碳的形成机制和化学组成研究提供实验依据.     

玉米秸秆生物炭改善污泥脱水性能

本实验以玉米秸秆为原料,制备了生物炭和AlCl₃改性生物炭,研究了2种生物炭分别调理污泥后的脱水效果,并探讨了污泥脱水性能的改善机理.结果表明,经过2种生物炭调理后,污泥比阻（SRF）、泥饼含水率（MC）、污泥沉降体积指数（SV₃₀）、毛细抽吸时间（CST）均下降,污泥净产率（Y_N）升高,说明污泥脱水性能得到了改善,且AlCl₃改性生物炭对污泥脱水性能的改善效果明显优于生物炭.当AlCl₃（溶液浓度3mol/L）改性生物炭的用量为3g/L时,调理后的污泥SRF,MC,SV₃₀,CST分别降低至1.3×10¹²m/kg,81.9%,78.6%,35s,Y_N增加至17.8kg/（m²·h）.分析原因：一方面,经过生物炭调理后,泥饼中会形成一定的骨架结构,使得污泥中的水和EPS能够更容易地释放;另一方面,经过AlCl₃改性后,改性生物炭携带的正电荷（Al³⁺）能够与污泥颗粒所带的负电荷发生电中和作用,使得污泥颗粒更容易聚集,从而提高污泥的脱水效果.     

氯化铁絮凝-直接过滤工艺对地下水中As(Ⅴ)的去除机制研究

为探明氯化铁(Fe Cl3)絮凝-直接过滤工艺对地下水中砷(As)的去除过程及机制,分别进行了批吸附实验、现场絮凝-直接过滤实验、扩展X射线精细结构光谱(EXAFS)及电荷分布多位络合(CD-MUSIC)模拟.采集的地下水样品As主要为五价[As(Ⅴ)],浓度为40μg·L-1.现场柱实验直接过滤工艺中Fe投加量为1.5 mg·L-1,出水As(Ⅴ)浓度均低于10μg·L-1,92 h内可提供64 984 L安全饮用水.固体废物毒性浸出实验表明泥饼浸出液中As浓度为3.4μg·L-1,远低于美国环保署限定值(5 mg·L-1).EXAFS和CD-MUSIC模拟表明Fe Cl3絮凝去除地下水中As(Ⅴ)存在两种机制:在p H 3~9.5范围内,As(Ⅴ)主要以双齿双核吸附在氢氧化铁上;p H9.5时,As(Ⅴ)主要与Ca2+和Mg2+形成沉淀而去除.     

Characteristics of microorganisms isolated from technogenic soils of the Kama region

Microorganisms capable of degrading monocyclic and polycyclic aromatic hydrocarbons and several chlorinated aromatic compounds were isolated from soils polluted with industrial waste from chemical plants. They were identified as representatives of the genera Pseudomonas, Flavobacterium, Alcaligenes, Rhodococcus, Microbacterium, Cellulomonas, Arthrobacter, and Brevibacterium. Among them, bacteria capable of utilizing xenobiotics in a wide range of ambient temperatures and pH and in the presence of high sodium chloride concentrations were revealed.     

Degradation of PVC Containing Mixtures in the Presence of HCl Fixators

Degradation of a model polymer mixture (PVC/PS/PE) and a waste polymer mixture in the presence of HCl fixators (Red Mud, precipitated CaCO₃ and dolamite) was studied using thermal gravimetric analysis (TGA) and a cycled-spheres-reactor. The experiments in cycled-spheres reactor model were performed by stepwise pyrolysis. Liquid products and HCl from each step were collected separately. For the model polymer mixture, the precipitated CaCO₃ showed the best effect on the fixation of evolved HCl and the reduction of chlorine content in the liquid products whereas RM yielded the best result for the waste polymer mixture. In addition, using HCl fixator also affected the degradation of both types of polymer mixture, leading to the formation of more gaseous and less residue.     

Formation of dioxins from combustion of polyvinylidene chloride in a well-controlled incinerator

Polyvinylidene chloride (PVDC; polymer of 1,1-dichloroethylene) was combusted with paper in a well-controlled, small-scale incinerator at an average grate temperature of 700 °C, and then dioxins (PCDDs, PCDFs, and coplanar-PCBs) formed in the exhaust gases were analyzed by gas chromatography/mass spectrometry. PVDC lowered the combustion temperature due to its less flammable character. The amount of total dioxins (PCDDs + PCDFs + coplanar-PCBs) formed in the exhaust gas was 58.0 ng/g of a combustion sample and its toxicity equivalency quantity (TEQ) value was 0.64 ng-TEQ/g. The amount of PCDDs formed in the sample ranged from 2.33 ng/g (Cl₈-isomer) to 0.048 ng/g (Cl₁-isomer). The lower the number of chloride, the less production of PCDDs. On the other hand, there was no relation between the number of chloride and PCDF formation. The amount of PCDFs formed in the sample ranged from 8.02 ng/g (Cl₂-isomer) to 4.46 ng/g (Cl₈-isomer). A polyvinylchloride (PVC) sample produced 207 ng/g of total dioxins and a PVDC sample produced 57.4 ng/g of total dioxins when they were combusted under the same conditions. An approximately equal composition of dioxin isomers was formed from PVDC and PVC samples. Paper was found to contribute to PCDF formation when it was combusted with plastics.     

北京大气PM10中水溶性氯盐的观测研究

氯盐是大气气溶胶中重要水溶性无机盐,对2004年全年北京大气可吸入颗粒中氯盐的变化进行了监测,结果表明北京大气中可溶性氯盐的年均值在(3.1±1.7)μg·m^-3,采暖期平均浓度为(4.6±2.1)μg·m^-3,非采暖期平均浓度为(2.6±1.6)μg·m^-3.最低值出现在5月,为(1.3±0.8)μg·m^-3;最高值出现在12月,为(5.8±5.3)μg·m^-3.日变化在秋冬季多为白天浓度低,晚上浓度高,夏春季多呈现上午高,下午低的特征;季节变化呈现秋冬季高,春夏季低的特点.     

Al13形态在混凝中的作用机制

从铝的水解形态转化角度考察了铝盐在高碱度和高有机物浓度水体中的混凝行为.结果表明,铝盐的混凝效能是与混凝过程中的Al₁₃含量成正比.高投药量时氯化铝(AlCl₃)既可以有效调节水体pH值又能在混凝过程中原位水解产生较多的Al₁₃形态,因而混凝效能要高于聚合氯化铝(PACl).在铝盐混凝中,调节pH值到6～7之间可以控制铝形态分布从而达到提高混凝效能和减少残留铝的目的.在调节pH值强化混凝的方法中使用传统铝盐的效果要好于无机高分子絮凝剂.     

三丁基氯化锡对红鳍笛鲷的急性毒性及不同组织生化指标的影响

为研究有机锡化合物对海洋生物抗氧化防御系统和神经系统的影响,以我国东南沿海常见的中下层增养殖鱼类红鳍笛鲷(Lutjanus erythopterus)幼鱼为实验生物,采用半静态毒性实验方法,分别研究了三丁基氯化锡(tributyltin chloride,TBTCl)的急性毒性和96 h暴露时间内对红鳍笛鲷幼鱼鳃、脑和...     

The influence of ClO− and acidity in the reaction between H2O2 and CuCl2

The potentially explosive reaction of hydrogen peroxide (H₂O₂) and copper chloride (CuCl₂) was investigated. Pressure tests revealed that the reaction was strongly temperature - dependent and can easily undergo runaway reaction. Nevertheless, there was only a slight pressure increase at the low temperatures studied or when using low concentrations of CuCl₂. Under the conditions generating the slight pressure increase, hypochlorite anions (ClO⁻) are generated and the acidity increases. As the reaction reaches completion, ClO⁻ disappears, and the acidity decreases. Interestingly, the addition of phosphate buffer to maintain the weakly acid conditions led to a runaway reaction, and the use of basic ClO⁻ promoted the exothermic reaction. Based on the results, acidity has a strong impact on the reaction behaviour.