重庆市代表性城区冬季和夏季苯系物来源解析

2009—2010年冬季和夏季在重庆市某代表性城区对大气中苯系物进行观测,并应用苯与甲苯特征比值(B/T)和因子分析法对苯系物来源进行了分析。结果表明,2种源分析方法具有较好的一致性,涂料及溶剂的生产与使用以及机动车尾气和油品使用是该研究区域苯系物的主要来源,贡献率分别为59.3%和16.2%。不同功能区、不同季节,苯系物来源构成有所差异。除受汽车尾气影响外,夏季受涂料、溶剂等生产使用的影响也较大,尤其是投诉集中点位、混合区和工业区;冬季,投诉集中点位主要受涂料、溶剂等生产使用等影响,其他点位可能还受到燃烧源的影响。     

g-C_3N_4/C@Bi_2MoO_6复合光催化剂的制备及其光催化活性

通过水热合成法和液相沉积法制备g-C_3N_4/C@Bi_2MoO_6复合光催化剂,并采用X射线衍射、扫描电子显微镜、氮气吸脱附、紫外-可见漫反射等技术对其进行表征。研究了可见光下g-C_3N_4/C@Bi_2MoO_6催化降解罗丹明B(Rh B)的影响因素,并对其光催化反应机理进行初步探讨。实验结果表明:g-C_3N_4掺杂量为60%(w)时g-C_3N_4/C@Bi_2MoO_6的光催化活性最高;在60%g-C_3N_4/C@Bi_2MoO_6的投加量为1.00 g/L、初始Rh B质量浓度为2.50 mg/L、可见光照射150 min的条件下,Rh B的降解率达到97.90%;在g-C_3N_4/C@Bi_2MoO_6光催化降解体系中,h~+和·O_2~-是主要活性物种。     

四氨基酞菁钯/γ-Al_2O_3可见光催化降解罗丹明B

采用浸渍法制备了四氨基酞菁钯(PdTAPc)/γ-Al_2O_3负载型光催化剂,采用UV-Vis,FTIR,XRD,SEM技术对其进行了表征,并将其用于罗丹明B的可见光催化降解,考察了光催化剂加入量、溶液pH、H_2O_2加入量、反应温度对罗丹明B降解效果的影响,并对光催化剂的稳定性进行了测试。表征结果显示,PdTAPc以圆片状负载于γ-Al_2O_3上,二者的结构均未发生明显变化。实验结果表明:在光催化剂加入量1.6 g/L、溶液pH 7.0、H_2O_2加入量12 mmol/L、反应温度20℃的优化条件下反应120 min,罗丹明B(质量浓度0.05 g/L)的降解率高达95%;光催化剂具有较高的稳定性,使用4次后罗丹明B的降解率仍高于85%。     

粉煤灰基层状金属氧化物对水中活性红X-3B的吸附

以粉煤灰(FA)为原料,采用共沉淀法制备了层状双金属氢氧化物(LDH)和层状金属氧化物(LMO,也称LDO),并采用XRD和BET技术进行了表征。比较了FA、LDH、LMO对活性红X-3B染料(X-3B)的吸附效果;考察了LMO吸附X-3B的影响因素,并探讨了吸附机理。XRD表征结果表明,LMO在吸附X-3B后重新恢复LDH层状结构。BET表征结果表明,LMO的比表面积大于LDH。吸附实验结果表明,3种吸附剂对X-3B吸附效果的优劣顺序为:LMOLDHFA;在初始X-3B质量浓度为50 mg/L、LMO投加量为2.0 g/L、吸附温度为25℃、吸附pH为7、吸附时间为30 min的条件下,X-3B去除率可达98.1%;LMO对X-3B的吸附符合Langmuir等温吸附方程,饱和吸附量为129.53 mg/g,且吸附过程可用准二级动力学方程描述。     

Ce-PbO_2/C电极的制备及其去除水中酸性红B

采用电沉积法制备铈修饰的PbO2/C电极,通过SEM、XRD、XPS及循环伏安对PbO2/C、Ce-PbO2/C电极进行表征,结果表明,Ce-PbO2/C电极比PbO2/C颗粒细小,表面均匀致密,电化学氧化能力较强,修饰电极中Ce以CeO2的形态存在。以Ce-PbO2/C为工作电极,电解浓度为1 000 mg/L的高盐酸性红B模拟活性染料废水,考察了电压、pH、电解质浓度、极间距对脱色率、氨氮去除率及COD去除率的影响。确定适宜工艺条件为：初始酸性红B溶液浓度为1 000 mg/L,pH值为6,电压10 V,电解时间1 h,电极间距1.5 cm,该条件下脱色率、氨氮去除率和COD去除率分别为99.98%、97.23%和90.17%。通过UV-Vis及GC-MS初步分析了降解过程可能存在的中间产物及降解途径。     

纳米TiO2-石墨烯光催化剂的水热合成及其光催化性能

以钛酸四正丁酯和石墨为原料,通过水热法制备了锐钛矿型为主的纳米TiO2复合光催化剂（纳米TiO2-石墨烯）,并采用XRD,FTIR,FESEM,TEM技术对其进行了表征。通过紫外光照射降解溶液中的罗丹明B（RhB）研究了TiO2-石墨烯的光催化活性,分析了初始罗丹明B质量浓度、催化剂加入量、溶液pH和催化剂使用次数等影响降解效果的因素。实验结果表明：在初始RhB质量浓度为20 mg/L、溶液pH为7.10、催化剂加入量为1.000 g/L的条件下,紫外光照射30 min时,纳米TiO2-石墨烯对RhB的降解率高达98.69%,明显高于纳米TiO2的44.69%;纳米TiO2-石墨烯稳定性较强,可多次重复使用。     

颜料红254-TiO_2光催化降解罗丹明B废水

以工业有机颜料C.I.颜料红254(DPP254)为敏化剂,通过溶剂热法对纯TiO2进行改性,得到复合光催化剂DPP254-TiO2。并通过XRD、SEM、UV-Vis DRS和N2吸附-脱附(BET和BJH)等测试手段对DPP254-TiO2进行了表征。以罗丹明B(RhB)为目标降解物,研究了DPP254-TiO2在可见光下对有机污染物的光催化降解性能。同时考察了DPP254含量、反应时间、RhB初始浓度和催化剂浓度等因素对RhB降解速率的影响。结果表明,改性后的催化剂光响应范围由紫外光区拓宽到可见光区。对其光催化反应机理进行了探讨。催化剂重复使用4次,活性没有明显降低,说明催化剂具有很好的稳定性。     

Fate of azadirachtin A and related azadirachtoids on tomatoes after greenhouse treatment

The degradation of the main azadirachtoids on tomatoes was studied after greenhouse treatment. These experiments were carried out at 1 and 5× the concentration recommended by the manufacturer. In all experiments the deposition of azadirachtin A (AZA-A) was below the maximum residue level (MRL). Even if at the highest dose, AZA-A half-life time calculated as pseudo first order kinetic was 1.2 days in agreement with the recommended preharvest interval (PHI) of 3 days. Experiments with a model system showed that sunlight photodegradation is the main factor influencing the rate of disappearance of AZA-A after greenhouse treatment while tomato epicuticular waxes doubled the photodegradation rate of AZA-A in a commercial formulation.     

Levels and risk assessment of chemical contaminants in byproducts for animal feed in Denmark

With aim to provide information on chemical contaminants in byproducts in animal feed, the data from an official control by the Danish Plant Directorate during 1998–2009, were reviewed and several samples of citrus pulp and dried distillers grains with solubles (DDGS) were additionally collected for analysis and risk assessment. The levels of contaminants in the samples from the official control were below maximum limits from EU regulations with only a few exceptions in the following groups; dioxins and dioxin-like polychlorobiphenyls (PCBs) in fish-containing byproducts and dioxins in vegetable and animal fat, hydrogen cyanide in linseed, and cadmium in sunflowers. The levels of pesticides and mycotoxins in the additionally collected samples were below maximum limits. Enniatin B (ENN B) was present in all DDGS samples. The hypothetical cases of carry-over of contamination from these byproducts were designed assuming total absorption and accumulation of the ingested contaminant in meat and milk and high exposure (a byproduct formed 15–20% of the feed ration depending on the species). The risk assessment was refined based on literature data on metabolism in relevant animal species. Risk assessment of contaminants in byproducts is generally based on a worst-case approach, as data on carry-over of a contaminant are sparse. This may lead to erroneous estimation of health hazards. The presence of ENN B in all samples of DDGS indicates that potential impact of this emerging mycotoxin on feed and food safety deserves attention. A challenge for the future is to fill up gaps in toxicological databases and improve models for carry-over of contaminants.     

铁及铁铜氧化物对臭氧氧化酸性红B的催化效能

采用自蔓延溶胶凝胶法分别制备了铁氧化物和铁铜复合氧化物催化剂,以酸性红B为降解对象,对比了单独臭氧氧化、铁氧化物和铁铜复合氧化物催化臭氧氧化对酸性红B的降解效果,考察了磁力搅拌速度(500～1 640 r/min)、溶液pH(3～11)、臭氧投加速率(3.55～28.4 mg/min)对铁铜复合氧化物催化性能的影响。结果表明,与单独臭氧氧化比较,铁氧化物和铁铜复合氧化物均能加速酸性红B的降解,促进色度和COD的去除,结合催化剂的表征结果,推断催化剂表面羟基促进臭氧分解产生.OH是其氧化性能较好的主要原因,另外,催化剂的吸附能力对催化性能也有一定影响。随着磁力搅拌速度、溶液pH、臭氧投加速率的增大,铁铜复合氧化物催化臭氧氧化酸性红B的效果越好。