固定化反硝化聚磷菌同步除磷脱氮实验研究

实验采用海藻酸钠和PVA添加膨润土包埋固定经富集驯化的以反硝化聚磷菌(DNPAOs)为主的活性污泥,利用体视显微镜和扫描电子显微镜考察了固定化小球的形态和表面结构,并对厌氧/好氧条件下,包埋小球除磷脱氮性能进行探讨,结果表明:固定化小球具有良好的强化生物除磷和较好的反硝化脱氮性能,体系的COD去除率平均达74.9%,平均除磷效率为95.3%,氨氮平均去除率达到95.2%左右。小球若长时间缺氧,在其内部会出现厌氧区,并产生厌氧放磷现象。     

腐殖酸钠对钙、镁离子吸附效果的研究

实验研究了腐殖酸钠混合液对钙、镁离子的吸附性能。高温条件下由草炭和NaOH制取的腐殖酸钠混合液,吸附水中的钙镁离子,结果发现：随着混合液用量的增加,其对钙镁离子的去除效率增加。当混合液用量为8ml时,二者的吸附效率均在88％以上,其中对镁离子的去除率可达100％,而且由于钙镁离子具有相同的核外电子层结构及类似的化学性质,因此混合液对钙镁离子的去除效果类似,表明腐殖酸钠混合液对钙镁离子具有极好的去除效果,可广泛应用于处理含钙镁离子的污水。     

化学还原法处理电镀含铬废水的工程应用

用亚硫酸氢钠作还原剂处理含铬电镀废水时,不调节废水pH值会出现暂时定性检测不含六价铬的假象,过一段时间废水中又会出现六价铬,导致排水不达标.针对这一现象进行实验和工程实践,结果表明,不调节pH值增加亚硫酸氢钠的投加量和不增加亚硫酸氢钠投加量而pH值调节到3～4都能使处理后水质稳定,达到排放标准(GB21900-2008...     

乙酸钠作为碳源不同污泥源短程反硝化过程亚硝酸盐积累特性

为探究乙酸钠作为碳源时,不同污泥源外源短程反硝化过程中亚硝酸盐积累特性,采用1号和2号SBR分别接种某污水处理厂二沉池和同步硝化反硝化除磷系统剩余污泥,通过合理控制初始硝酸盐浓度和缺氧时间,实现了短程反硝化的启动,并考察了其在不同初始COD和NO_3~--N浓度条件下的碳、氮去除特性.试验结果表明:以乙酸钠为碳源,1号和2号SBR可分别在21 d和20 d实现短程反硝化的成功启动,且其NO_2~--N积累量和亚硝酸盐积累率(NAR)均维持在较高水平,分别为12. 61 mg·L-1、79. 76%和13. 85 mg·L-1、87. 60%.当2号SBR初始NO_3~--N浓度为20 mg·L-1,且初始COD浓度由60mg·L-1升高至140 mg·L-1时,系统实现最高NO_2~--N积累时间可由160 min逐渐缩短至6 min,同时NO_3~--N比反硝化速率(以VSS计)由3. 84 mg·(g·h)-1增加至7. 35 mg·(g·h)-1,初始COD浓度的提高有利于实现短程反硝化过程NO_2~--N积累. 2号SBR初始COD浓度为100 mg·L-1,当初始NO_3~--N浓度由20 mg·L-1增加至30 mg·L-1时,系统NAR均维持在90%以上,最高可达100%(NO_3~--N初始浓度为25 mg·L-1);当初始NO_3~--N浓度≥35 mg·L-1时,系统COD不足导致NO_3~--N不能被完全还原为NO_2~--N.此外,在不同初始COD浓度(80、100、120 mg·L-1)和NO_3~--N浓度(20、25、30、40 mg·L-1)条件下,2号SBR的脱氮除碳和短程反硝化性能均优于1号SBR.     

过硫酸钠缓释胶囊反应带修复苯胺污染地下水

针对有机污染地下水原位化学氧化修复中普遍存在的氧化剂过量使用、污染物反弹和二次污染问题,以苯胺（AN）为特征污染物,以活化过硫酸盐为氧化剂,采用硬脂酸为胶结剂,制备过硫酸钠（PS）和硫酸亚铁（FeSO₄）缓释胶囊,构建基于PS和FeSO₄缓释胶囊的可渗透反应屏障（PS-FeSO₄-PRB）,考查了缓释胶囊组分、地下水流速对PRB中活性物质释放和AN去除的影响.结果表明,当缓释胶囊中活性物质/硬脂酸为1/2,地下水流速为0.1mL/min时,48h后PRB中PS和Fe²⁺累计释放率分别为43.18%和14.98%.当PRB中FeSO₄/PS为1/9时,AN累计去除率达到95.37%,TOC累计去除率为57.07%.采用砂柱模拟AN污染地下水,比较了直接注射PS和FeSO₄与PS-FeSO₄-PRB两种处理方式的修复性能,4d内两者的AN累计去除率分别为35.22%和69.74%,TOC累计去除率分别为15.83%与14.88%.PS-FeSO₄-PRB修复效果明显高于直接注射处理.GC/MS分析表明,处理后产生了对苯醌、偶氮苯以及长链烷烃等产物,导致AN矿化率不高.pH值和Eh连续记录结果表明,PS-FeSO₄-PRB处理能够保持反应体系氧化还原电位和酸碱性的相对稳定.相比直接注射氧化剂,基于PS和FeSO₄-缓释胶囊的PRB处理中地下水的急性毒性更低,二次污染风险更小.     

Aging of PVDF and PES ultrafiltration membranes by sodium hypochlorite: Effect of solution pH

Sodium hypochlorite (NaClO) is a commonly applied cleaning agent for ultrafiltration membranes in water and wastewater treatment. Long-term exposure to NaClO might change the properties and performance of polymeric membranes, and ultimately shorten membrane lifespan. Active species in NaClO solution vary with solution pH, and the aging effects can change depending on the membrane material. In this study, the aging of polyvinylidene fluoride (PVDF) and polyethersulfone (PES) membranes by NaClO at pH 3–11 was investigated by examining variations in chemical composition, surface charge, surface morphology, mechanical strength, permeability, and retention ability. Polyvinyl pyrrolidone (PVP), which was blended in both membranes, was oxidized and dislodged due to NaClO aging at all investigated pH values, but the oxidation products and dislodgement ratio of PVP varied with solution pH. For the PVDF membrane, NaClO aging at pH 3–11 caused a moderate increase in permeability and decreased retention due to the oxidation and release of PVP. The tensile strength decreased only at pH 11 because of the defluorination of PVDF molecules. For the PES membrane, NaClO aging at all investigated pH resulted in chain scission of PES molecules, which was favored at pH 7 and 9, potentially due to the formation of free radicals. Therefore, a decrease in tensile strength and retention ability, as well as an increase in permeability, occurred in the PES membrane for NaClO aging at pH 3–11. Overall, the results can provide a basis for selecting chemical cleaning conditions for PVDF and PES membranes.     

Thermal defluorination behaviors of PFOS,PFOA and PFBS during regeneration of activated carbon by molten salt

• New method of mineralizing PFCs was proposed. • Activated carbon was regenerated while mineralizing PFCs. • Molten NaOH has good mineralization effect on PFOS and PFBS. Current study proposes a green regeneration method of activated carbon (AC) laden with Perfluorochemicals (PFCs) from the perspective of environmental safety and resource regeneration. The defluorination efficiencies of AC adsorbed perfluorooctanesulfonate (PFOS), perfluorooctanoic acid (PFOA) and perfluorobutanesulfonate (PFBS) using three molten sodium salts and one molten alkali were compared. Results showed that defluorination efficiencies of molten NaOH for the three PFCs were higher than the other three molten sodium salts at lower temperature. At 700°C, the defluorination efficiencies of PFOS and PFBS using molten NaOH reached to 84.2% and 79.2%, respectively, while the defluorination efficiency of PFOA was 35.3%. In addition, the temperature of molten salt, the holding time and the ratio of salt to carbon were directly proportional to the defluorination efficiency. The low defluorination efficiency of PFOA was due to the low thermal stability of PFOA, which made it difficult to be captured by molten salt.The weight loss range of PFOA was 75°C–125°C, which was much lower than PFOS and PFBS (400°C–500°C). From the perspective of gas production, fluorine-containing gases produced from molten NaOH-treated AC were significantly reduced, which means that environmental risks were significantly reduced. After molten NaOH treatment, the regenerated AC had higher adsorption capacity than that of pre-treated AC.     

氯酸钠氧化盐酸酸洗废液制备聚氯化铁

钢材在深加工过程中通常使用盐酸对其表面进行酸洗除锈,从而产生大量废液。为了实现盐酸酸洗废液的资源化处理,以氯酸钠作为氧化剂制备聚氯化铁,考察了氧化剂加入量、浓盐酸加入量、反应时间、反应温度等因素对Fe²⁺转化率的影响。实验得到的最佳工艺条件为：每处理100 mL废液需加入7.0 g氯酸钠、12 mL浓盐酸（12 mol/L）、0.3 g磷酸二氢钾,反应温度30 ℃,反应时间30 min,搅拌转速5 r/s。该条件下,Fe²⁺转化率可达98.51%,得到的聚氯化铁产品符合《水处理剂 聚氯化铁》（HG/T 4672—2014）标准。     

水中LAS的光催化氧化处理研究

本文研究了三聚磷酸钠（STPP）浓度变化和温度变化条件下,对水中直链十二烷基苯磺酸钠（LAS）光催化氧化降解的影响,并根据动力学研究的结果,充分说明了造成上述影响的原因。     

沉淀--吸附处理双氯灭痛高浓度有机废水的工艺研究

介绍了用沉淀－吸附法处理双氯灭痛高浓度有机废水的工艺。先用废盐酸将废水的ｐＨ调节到４,沉淀、过滤,然后将滤液依次经过炉渣、生炭串级吸附,处理后的废水ＣＯＤＣｒ、ｐＨ、ＳＳ均达到ＧＢ８９７８－８８污水综合排放制药行业二级标准。