超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

紫外辐照-催化湿式过氧化氢氧化技术处理酸性大红GR染料废水

采用自制的负载型CuO-ZnO-CeO2/γ-Al2O3催化剂,常温常压下通过紫外辐照-催化湿式氧化技术处理酸性大红GR模拟染料废水。考察了催化剂加入量、H2O2加入量、废水pH、反应时间、初始酸性大红GR质量浓度等对废水脱色率的影响。实验得到最佳工艺条件为初始酸性大红GR质量浓度200mg/L,催化剂加入量10.0g/L,H2O2加入量2.0mL/L,废水pH4,反应时间2h。最佳工艺条件下废水脱色率达99.33%。     

某退役后辐照装置的辐射水平监测与评价

依据国家相关标准对某退役后辐照装置周围的辐射水平进行监测与评价,通过数据评价得出该单位辐照装置退役场所未受到放射性污染,其退役后对环境的辐射影响可以忽略。     

紫外光谱结合正交试验设计同时测定水中苯系物

利用正交试验设计,以光谱预处理、特征筛选及多元校正方法为考察因素,每个因素的4种不同方法为水平,确定了水中3种苯系物（苯酚、苯胺及苯甲酸）紫外光谱数据的最佳分析方法,从而建立了其定量校正模型。对于苯酚、苯胺及苯甲酸,其光谱预处理、特征筛选及多元校正分别采用一阶导数+无信息变量消除法（UVE）+偏最小二乘回归（PLSR）,Savitzky-Golay平滑+变量结合种群分析法（VCPA）+PLSR,Savitzky-Golay平滑+移动窗口偏最小二乘法（MWPLS）+PLSR。在独立测试集上3组分的预测误差均方根（RMSEP）分别为0.809 4、0.796 3和0.945 4。水样加标回收实验的回收率为97.79%~103.84%,相对标准偏差（RSD）小于3%。该方法可作为一种同时测定水中苯系物的简便有效方法。     

A new photoproduct of the drug furosemide in aqueous media

The solar phototransformation of furosemide has been investigated in aqueous media. Irradiation of the drug in distilled water, in water and humic acids or nitrate ions, and in sewage sludge water affords a new dehalogenated dimer. The formation of the dimer has been explained by the formation of a cation radical intermediate. The low-measured environmental concentration of furosemide with respect to predicted environmental concentration in the Po and Lambro Rivers could be justified by its phototransformation.     

山东潍坊紫外线辐射特征及影响因素

近10多年来,随着人类居住环境的恶化,紫外线给人类造成了巨大的伤害。利用潍坊市气象台2004~2006年逐日紫外线观测资料,分析了太阳紫外线辐射到达地面的强度指数和等级,同时分析了这些量的年、月、日变化特征,研究了影响紫外线辐射的主要的几种因子。影响紫外线辐射强度的主要因素是臭氧、地表反射率、大气气溶胶和云,这些影响因素的变化对太阳紫外线到达地面的辐射起着举足轻重的作用。     

PRODUCTION PROCESSES UNDER THE ICE IN LAKE ST. CLAIR: 1. IRRADIATION AND TEMPERATURE1

ABSTRACT: Data from three ice-covered stations in Lake St. Clair were collected to evaluate the effect of ice and related variables on phytoplankton production. Primary production, phytoplankton standing crop, irradiation and temperature were measured from January to April, 1973. Mean production values ranged from 0.74 mgC/m³/h at station 1 near Mitchell Bay to 3.4 mgC/m³/h in waters at stations 2 and 3 below the Thames River mouth. A similar pattern was observed in chlorophyll a concentration, the mean values ranged from 0.63 μg/1 at station 1 to 2.1 and 1.3 μg/1 at stations 2 and 3. Temperature stratification occurred at the three stations. However, the temperatures at station 1 were consistently more than a degree warmer than at the other two stations. Irradiation was low, having a mean value at the sampling depth of .075 ly/min. The data is interpreted to indicate that the ice-bound phytoplankton were adapted to the low irradiation. It is suggested that the variation observed between stations is related to the formation of a plume by the Thames River and differences in nutrient loads carried by the St. Clair and Thames Rivers.     

Synthesis, crystal structure, photodegradation kinetics and photocatalytic activity of novel photocatalyst ZnBiYO4

ZnBiYO₄ was synthesized by a solid-state reaction method for the first time. The structural and photocatalytic properties of ZnBiYO₄ were characterized by X-ray diffraction, scanning electron microscopy, X-ray photoelectron spectroscopy and UV-Vis diffuse reflectance. ZnBiYO₄ crystallized with a tetragonal spinel structure with space group I41/A. The lattice parameters for ZnBiYO₄ were a = b = 11.176479 Å and c= 10.014323 Å. The band gap of ZnBiYO₄ was estimated to be 1.58 eV. The photocatalytic activity of ZnBiYO₄ was assessed by photodegradation of methyl orange under visible light irradiation. The results showed that ZnBiYO₄ had higher catalytic activity compared with N-doped TiO₂ under the same experimental conditions using visible light irradiation. The photocatalytic degradation of methyl orange with ZnBiYO₄ or N-doped TiO₂ as catalyst followed first-order reaction kinetics, and the first-order rate constant was 0.01575 and 0.00416 min^-1 for ZnBiYO₄ and N-doped TiO₂, respectively. After visible light irradiation for 220 min with ZnBiYO₄ as catalyst, complete removal and mineralization of methyl orange were observed. The reduction of total organic carbon, formation of inorganic products, SO₄^2- and NO₃^-, and evolution of CO₂ revealed the continuous mineralization of methyl orange during the photocatalytic process. The intermediate products were identified using liquid chromatography- mass spectrometry. The ZnBiYO₄/(visible light) photocatalysis system was found to be suitable for textile industry wastewater treatment and could be used to solve other environmental chemical pollution problems.     

Analysis of trace dicyandiamide in stream water using solid phase extraction and liquid chromatography UV spectrometry

An improved method for trace level quantification of dicyandiamide in stream water has been developed. This method includes sample pretreatment using solid phase extraction. The extraction procedure (including loading, washing, and eluting) used a flow rate of 1.0 mL/min, and dicyandiamide was eluted with 20 mL of a methanol/acetonitrile mixture (V/V = 2:3), followed by pre-concentration using nitrogen evaporation and analysis with high performance liquid chromatography–ultraviolet spectroscopy (HPLC–UV). Sample extraction was carried out using a Waters Sep-Pak AC-2 Cartridge (with activated carbon). Separation was achieved on a ZIC^®-Hydrophilic Interaction Liquid Chromatography (ZIC-HILIC) (50 mm × 2.1 mm, 3.5 μm) chromatography column and quantification was accomplished based on UV absorbance. A reliable linear relationship was obtained for the calibration curve using standard solutions (R² > 0.999). Recoveries for dicyandiamide ranged from 84.6% to 96.8%, and the relative standard deviations (RSDs, n = 3) were below 6.1% with a detection limit of 5.0 ng/mL for stream water samples.     

高能重离子辐照下国产RPV钢A508-3的硬化行为

目的 研究在563 K的温度条件下,高能重离子辐照导致国产RPV钢A508-3的硬化行为。方法 使用回旋加速器提供的352.8 MeV Fe²¹⁺对A508-3钢试样进行辐照,使其依次达到0.15、0.30、1.50 dpa的损伤水平。借助辐照终端的梯度减能装置,在样品表面至25 μm的深度范围内产生一个准均匀分布的原子离位损伤坪区,并使用纳米压痕仪和维氏显微硬度计测量了试样的硬度。结果 考虑到压痕尺寸效应的影响,采用Nix-Gao模型对硬度数据进行拟合,由于高能Fe离子产生了较厚的损伤区,辐照试样中的软基效应明显减弱。辐照后的试样出现明显的硬化现象,且随着辐照剂量的增大,硬化增量有饱和趋势。通过辐照前和辐照至0.15 dpa试样的微硬度数据,得出其与纳米硬度之间的线性关系(Hv0=0.85 H0)。结论 借助A508-3辐照前后的硬度数据,计算发现试样的屈服强度增量与辐照剂量之间存在一种幂函数关系,这为A508-3钢中子-离子辐照硬化的映射关系研究提供了基础数据。