光活性二氧化钛膜的制备方法

近二十年来发展起来的光催化技术可利用太阳光能对水体中的多种有机污染物进行降解．这符合可持续发展的长远需要,具有诱人的发展前景。光催化技术利用可再生的清洁资源,氧化能力强．适用于广谱有机物,能使难被一般氧化剂氧化、又难生物降解的污染物降解．是当前太阳能利用及水污染控制方面开辟的前沿领域．在治理环境污染方面具有明显的发展优势。本文以溶胶-凝胶法、金属有机化学气相淀积、煅烧沉淀法等多种方法制备光活性二氧化钛膜。     

无机阴离子对TiO2/SiO2光催化降解酸性红B活性的影响

以酸性红B为模型化合物，分别考察了6种常见的无机阴离子对TiO2/SiO2复合光催化剂活性的影响，并考察了导致催化剂失活的无机阴离子的最低浓度。结果表明，除了HCO3^-能引起催化剂部分不可逆中毒外，其余5种离子并没有在催化剂形成占位。失活的催化剂通过简的HCl冲洗即可再生。另外，对催化剂的失活机制作了初步探讨。     

无机阳离子对TiO2光催化降解染料的影响

考察了6种无机阳离子对P-25 TiO2光催化降解染料的影响，结果发现，Cu^2 ，Mn^2 和Ni^2 对光催化反应有强烈的抑制作用，Ca^2 ，Mg^2 和Al^3 对光催化反应速率无明显的负影响．经X光电能谱(XPS)的分析，确定锰离子以氧化物的形式沉积在氧化钛表面，使催化剂不可逆的中毒．Cu^2 和Ni^2 通过俘获光致电子导致催化活性降低。     

纳米TiO2光催化氧化异丙醇和丙酮反应的研究

分别研究了纳米TiO2 在主波长为 364nm的汞灯光照下催化氧化i C3H7OH和CH3COCH3水溶液的反应速率 .通过XRD ,TEM ,BET和FT IR PAS对催化剂进行表征 ,粉末的晶型主要为锐钛矿型 .平均粒径在 1 5nm左右 ,比表面积为 1 0 1 0± 0 2m2 ·g- 1 ,FT IR PAS的检测结果表明 ,CH3COCH3是i C3H7OH光催化氧化的中间产物 ,其光催化氧化反应为 :i C3H7OH [O]CH3COCH3[O]CH3COOH[O]…[O]CO2 H2 O     

Zr/TiO2纳米颗粒的制备及其光催化活性

以钛酸丁酯,乙醇为原料,用固相合成法制备了Zr/TiO2纳米颗粒,用XRD、TEM对其组成、颗粒大小、形貌进行了表征.通过对罗丹明B的降解反应,考察了Zr/TiO2的光催化活性.结果表明,Zr/TiO2为纳米颗粒,平均粒径为12.7 nm左右,且颗粒均匀;掺杂金属离子Zr提高了TiO2光催化效率,掺杂2.0%Zr的催化剂活性最高.Zr/TiO2的光催化反应,首先是反应物在Zr/TiO2表面发生吸附作用,然后进一步发生光催化降解.     

多相光催化在水污染治理中的应用

多相光催化过程是近年来日益引起重视的污染治理新技术，具有适用范围广、可使污染物彻底破坏、适用于低浓污染物治理等优点，本文对国外近年有关多相光催化在水污染治理中应用的研究结果进行了总结，包括各种有机污染物的氧化及各种无机离子的治理，并讨论了多相光催化过程的优点及实用性。     

微波无极灯：一种具有前景的高效光催化光源

微波无极灯具有制造容易、价格低廉、能耗小和光强大等优点.作为光催化氧化的光源时,由于微波的协同作用可有效提高光催化活性,并能简化反应器.从发光机理、微波协同作用、优缺点和影响因素等方面,对微波无极灯在光催化领域的研究进行详细阐述.     

H2O2 formation from photocatalytic processes at the ZnO/water interface

The paper focuses on the production of H2O2 by photocatalysis over ZnO in an aerated aqueous phase. The presence of different reductants that increase the H2O2 production in the aqueous phase is analysed; particular attention is paid to nitrite, which has been shown to be the reductant that produces the most significant increments in the H2O2 production. The photocatalytic anodic decomposition of ZnO in the presence of the different reductants is also investigated. From the results obtained, the relevance of the ZnO photocatalysis in the formation of environmental hydrogen peroxide is estimated.     

Model reactor for photocatalytic degradation of persistent chemicals in ponds and waste water

A laboratory scale flow-through model reactor for the degradation of persistent chemicals using titanium dioxide (TiO₂) as photocatalyst immobilized on glass beads is presented. In the test system with a volume of 18 L contaminated water is pumped to the upper part of the floating reactor and flows over the coated beads which are exposed to UV-radiation. The degradation of two dyes of different persistance was investigated. Primary degradation of methylene blue did not fit a first order kinetic due to coincident adsorption onto the photocatalyst and direct photolysis, resulting in a half-life of 6 h. A filtrate of a green algae suspension accelerated the colour removal. In contrast, reactive red 2 was degraded only by photocatalysis; neither adsorption nor direct photolysis led to a colour removal. The course of primary degradation followed a first order kinetic with a half-life of 18 h and a rate constant of 0.04 h⁻¹. Analysis of the degradation products indicated mineralization by detection of NO₂⁻ and NO₃⁻, accompanied by a decrease of pH and an increase of conductivity. A successful adaptation of the model reactor (scale 1:10) to dimensions required for surface waters and waste water treatment plants would be a costefficient and environmentally sustainable application of photocatalysis for the treatment of industrially polluted water and could be of relevance for third world contries, particularly those favoured by high solar radiation.