废弃印刷线路板碘化法浸金研究

针对碘化法从废弃印刷线路板中提取金的工艺设计,分别考察了碘的质量分数、n(I₂)/n(I^-)比值、固液比、双氧水的质量分数、pH值、浸出时间和浸出温度对金浸出率的影响。结合正交设计优化实验方法,提出了从废弃印刷线路板中碘化法浸取金的最佳工艺条件：碘的质量分数为1.1％,n(I₂)∶n(I^-)=1∶10,双氧水的质量分数为1.5％,浸出时间4 h,固液比为1∶10,浸出温度为常温（25℃）,溶液pH值为中性,此时金浸出率可达97.5％。     

砒霜生产化工厂危险废物处置工程设计

通过对砒霜生产化工厂原场址废渣及污染场地调查的基础上,进行了处置方案比选及技术经济比较,确定了就地安全填埋的处置方案。根据区域性危险废物集中安全填埋场的设计经验,本工程采用先进的HDPE双层防渗的安全填埋方式,并设置了雨水分流系统、渗滤液收集系统、封场处理和填埋气体导排系统,整个场区布置合理,对周围环境的影响小,投资少,取得了良好的社会效益和环境效益,并对危险废物处理处置工程设计中应注意的问题提出了建议。     

氮掺杂氧化钛的简易制备及可见光催化活性的研究

为开发对可见光响应的催化剂,以尿素为氮掺杂剂,采用简易溶胶-凝胶法制备氮掺杂氧化钛,并以2,4-DCP的降解检验其光催化活性。XRD、BET、XPS和UV-Vis漫反射光谱分析表明,随着氮/钛原子比（N/Ti)的增大,各催化剂晶粒尺寸减小,比表面积增大,锐钛矿相向金红石相的转变得到抑制,除0#样品出现金红石相外,其他催化剂均只出现锐钛矿相;掺入催化剂的N位于晶格O位点和晶格间隙,替代N和间隙N掺杂使催化剂的光吸收发生明显的红移。荧光光谱分析表明,当N/Ti在0～6范围内增加时,反应体系中·OH自由基的产生速率增加,当N/Ti增大至8时,速率则下降。相似的规律也表现在氮掺杂量对光催化活性的影响。适量氮掺杂能增强氧化钛的可见光催化活性,该改性催化剂可用于有机污染物的太阳光激催化降解。     

稀土在废水处理中的应用进展

综述了国内稀土金属在废水处理中的最新应用进展,总结了稀土复合吸附剂的制备方法及其在含磷、氨氮、砷、氟、铬、镉等废水处理中的效果,讨论了稀土复合混凝剂和稀土催化剂在染料、助剂、化工等高浓度有机废水处理中的应用,为找到高效环保的处理工业废水的方法提供了依据.     

火电厂SCR烟气脱硝催化剂特性及其应用

SCR工艺是火电厂的主流烟气脱硝技术,催化剂是SCR脱硝工艺的核心。通过对不同型式催化剂特性及其应用的对比分析,得出了蜂窝式催化剂综合性能较优的结论,并对不同烟气条件下的催化剂选择提出了建议.     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Occurrence of phenols in leachates from municipal solid waste landfill sites in Japan

The concentrations of 41 phenols in leachates from 38 municipal solid waste (MSW) landfill sites in Japan were measured. The main phenols detected in leachates were phenol, three cresols, 4-tert-butylphenol, 4-tertoctylphenol, 4-nonylphenol, bisphenol A, and some chlorophenols. The concentration levels of phenols were affected by the pH values of the leachates and the different types of landfill waste. The origins of phenol and p-cresol were considered to be incineration residues, and the major origin of 4-tert-butylphenol, bisphenol A, and 2,4,6-trichlorophenol was considered to be solidified fly ash. In contrast, the major origins of 4-tert-octylphenol and 4-nonylphenol were considered to be incombustibles. The discharge of leachates to the environment around MSW landfill sites without water treatment facilities can cause environmental pollution by phenols. In particular, the disposal of incineration residues including solidified fly ash and the codisposal of solidified fly ash and incombustibles might raise the possibility of environmental pollution. Moreover, the discharge of leachates at pH values of 9.8 or more could pollute the water environment with phenol. However, phenol, 4-nonylphenol, and bisphenol A can be removed to below the con centration levels that impact the environment around landfill sites by a series of conventional water treatment processes.     

废旧电池资源化、无害化

对当前国内外在废旧电池的处理处置方面进行了综合性论述,对废旧电池的危害及当前应采取的对策进行分析。     

利用餐饮业废油脂制造生物柴油

世界的石油产量将会逐渐减少,石化柴油燃烧后所排放的废气是造成的城市空气污染的主要原因,生物柴油是石化柴油很好的替代能源,文章介绍了国外废油脂处理利用和甸餐饮业废油脂的概况,提出了利用餐饮业废油脂制造生物柴油的方法和工艺流程,并讨论了利用餐饮业废油脂制造生物柴油的几个问题。     

有机废气中VOC的回收方法

介绍了炭吸附法、冷凝法和膜分离法回胥机废报中ＶＯＤ的原理、工艺流程和工业应用情况，并对这些方法进行了比较，指出了适用范围。