Trophoblast-like cells sorted from peripheral maternal blood using flow cytometry: A multiparametric study involving transmission electron microscopy and fetal dna amplification

Three monoclonal antibodies (MAbs) against trophoblast (GB17, GB21, and GB25) and flow cytometry were used to sort trophoblast-like cells (TLCs) from peripheral blood of pregnant women. Sorted TLCs were processed for electron microscopy and fetal DNA amplification of the Y-specific sequences from mothers carrying male fetuses. At the ultra-structural level, most of the nucleated cells had the morphology of leucocytes, suggesting maternal contaminants, and we did not find the characteristic features of the free inter-villous trophoblast cells. Nevertheless, polymerase chain reaction (PCR) analysis showed an amplification of Y-specific sequences in two out of three samples of sorted TLCs. These results suggest that besides the maternal leucocytes, sufficient trophoblast nucleated fetal cells can be obtained using cell enrichment by sorting. This sensitive method holds promise for non-invasive prenatal diagnosis of fetal sex and if sufficient Y(positive) nuclei are found, for the diagnosis of selected numerical chromosome abnormalities.     

北京市发展CNG汽车的条件与前景分析

北京市汽车排放污染物贡献率已达到：HC73.5％，CO63．4％，NOx46％。用CNG代替汽油作汽车燃料，可使CO减少97％、HC减少72％、NOx减少39％、CO2减少24％、SO2减少90％。建立CNG加气站和CNG汽车改装这两个CNG应用关键问题在技术上、经济上都是可行的。北京市CNG燃料来源有保障。北京市车辆都比较适合使用CNG气体燃料。北京有很强的CNG汽车产业科技力量。对北京市当前发展CNG汽车产业提出了一些建议。     

乙醇汽油与普通汽油非常规污染物排放特性对比研究

在一台满足国Ⅴ排放标准的双喷射(气口喷射+缸内直喷)汽油机上开展了燃用E10乙醇汽油(乙醇体积比为10%)对发动机非常规排放特性影响的试验研究.使用傅里叶变换红外分析仪(FTIR)测量了饱和烃、不饱和烃、芳香烃及醇、醛等非常规污染物排放量,对比分析了双喷射模式时各工况下E0和E10两种燃料的非常规排放水平.结果表明,双喷射模式下,加入乙醇有效降低了乙烯、1,3-丁二烯、苯和甲苯的排放量,但会导致乙醛排放升高.双喷射模式下,随着负荷增加,两种燃料下的1,3-丁二烯和甲苯排放呈现先升高后降低的趋势,乙烯、甲醛和苯排放则先降低后升高.乙醇能抑制1,3-丁二烯、乙烯生成,抑制效果为PFI模式优于双喷射模式,GDI模式抑制量最低.PFI和GDI模式下E10的甲醛排放均显著升高,但双喷射模式有效抑制了甲醛排放的增加.     

基于遥感尾气监测的柴油车气态污染物排放因子计算方法研究

采用遥感尾气测试系统实测了柴油车在实际道路工况下的CO、HC和NO排放特征,修正了排放因子的计算方法,并与车载排放测试系统（PEMS）实测结果进行了验证,获得了实测车辆的CO、HC和NO排放因子.测试结果显示,在各种遥感监测的工况下柴油车尾气中均含有较高浓度的氧气,未考虑氧气影响的燃烧方程反演获得的各污染物体积浓度计算值与PEMS实测值的偏差较大,且氧气浓度越大,偏差越大.经过氧气修正的燃烧方程反演计算的尾气浓度与PEMS实测值吻合度大幅提升,适用于实际工况下遥感检测车辆尾气的反演计算.修正算法得到CO、HC和NO的排放因子离散性较小,精确度较高,可以为量化柴油车尾气排放贡献提供科学依据.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

乌鲁木齐市餐饮业油烟污染的调查及防治初探

通过对乌鲁木齐市20家餐饮业油烟污染的调查分析，结果表明，乌鲁木齐市餐饮业油烟污染严重，并提出了防治措施。     

苏州市机动车尾气中主要污染物特征分析

为了解苏州市机动车尾气中主要污染物浓度特征,运用SPSS19.0时间序列建模器,预测了未来5年(2017—2021年)苏州市机动车保有量,分析和对比了苏州市路边站点和国控站点的主要污染物数据。结果表明,未来5年,苏州市机动车保有量呈现上升趋势,2020年机动车保有量将达到373.1万辆,相比2014年增加约37.5%;路边站点NO2值略高于国控站点,但差异不显著;路边站点CO值明显高于国控站点;路边站点PM10和PM2.5值总体略高于国控站点;路边站点苯系物值高于国控站点。     

Multipoint source method in air pollution modelling of cold start emission

The paper presents a new method of air pollution modelling on a micro scale. For estimation of concentration of car exhaust pollutants, each car is treated as an instantaneous moving emission source. This approach enables us to model time and spatial changes of emission, especially during cold and cool start of an engine. These stages of engine work are a source of significant pollution concentration in urban areas. In this work, two models are proposed: one for the estimation of emission after cold start of the engine and another for the prediction of pollutant concentration. The first model (defined for individual exhaust gas pollutants) enables us to calculate the emission as a function of time after the cold or cool start, ambient temperature and average speed of motion. This model uses the HBEFA database. The second mathematical model is developed in order to calculate the pollutant dispersion and concentrations. The finite volume method is applied to discretise the set of partial differential equations describing wind flow and pollutant dispersion in the domain considered. Models presented in this paper can be called short-term models on a small spatial scale. The results of numerical simulation of pollutant emission and dispersion are also presented.     

城市高架道路建设对机动车尾气污染的影响分析

通过现场观测和对比，分析了城市一般道路上和城市高架道路下机动车排放污染物浓度差异的原因，分析结果表明，扩散条件对城市机动车尾气污染有着重要影响，例举日本对城市高架道路建设的有关规定，提出应重视城市高架道路建设的环境预评估等。     

电化学法烟气脱硫制取浓硫酸

利用电化学脱硫生产硫酸是一种自然资源再利用的新型大气环保技术 ,它通过电解I- /I2 体系生成I2 来吸收氧化烟气中的SO2 ,其脱硫率可达 95%～ 99% ,并生成 85%以上的高浓度硫酸和纯氢。以期获得废渣废液的零排放。