初始温度和压力对排污空间甲烷-空气混合物爆燃特性影响的模拟研究

市政排污空间作为城市公共基础设施的重要组成部分，易积聚可燃气体形成爆炸性环境。结合排污空间的特殊环境条件，采用Fluidyn-MP多物理场数值模拟软件，建立了20 L球形爆炸罐分析模型，通过改变初始温度和初始压力，对排污空间甲烷-空气混合物爆燃特性及其变化规律进行模拟研究。结果表明:初始温度升高导致甲烷-空气混合物最大爆炸压力降低，缩短了到达最大爆炸压力的时间；初始压力增加导致最大爆炸压力急剧升高，并延长了到达最大爆炸压力的时间；最大爆炸压力对初始压力的敏感程度远大于初始温度的影响。此外，随着初始温度和初始压力的升高，爆炸火焰平均传播速度增加，而火焰传播速度对初始温度较敏感。     

湖北省2008年初低温雨雪冰冻过程气候特征分析

2008年初，湖北省出现了严重的低温雨雪冰冻灾害，直接经济损失高达110亿元以上，有必要对灾害期间的气候特征进行系统、科学的分析和总结。对湖北省76个气象站2008年1月12日～2月3日气温、降水（雪）、日照以及低温持续日数等要素进行时空间差异分析及历史与同期比较，并选取10个代表站历史上所有低温雨雪天气过程，对其过程持续低温日数、最长连续雨雪日数、过程极端低温进行比较分析。结果表明：（1）此次过程的平均气温异常偏低，该省大部为-1～-2℃，比常年同期偏低4～6℃，为各站历史同期最低，其中主要是最高气温异常偏低所致，但极端低温并不低；（2）降雪过程频繁，雨雪量异常偏多；（3）低温冰冻持续时间长，该省大部在16～22 d，位于历史第一；（4）日照异常偏少。持续而稳定的大气环流异常形势是湖北省大范围低温雨雪天气的直接原因。     

Air Temperature Changes in a Steppe Marmot Burrow in the Summer–Autumn Period

Observations of air temperature changes in a steppe marmot burrow were performed from late July to mid-October. Until early September, temperature in the burrow remained relatively constant, but then it began to decrease rapidly. This occurred after air temperature above the ground became equal to the temperature in the burrow. Supposedly, it is in this particular period that marmots begin to plug the entrance to the burrow with earth, thus reducing heat exchange between the increasingly cold aboveground air and the air in the burrow.     

Prenatal prediction of childhood-onset spinal muscular atrophy (SMA) in Turkish families

Childhood-onset spinal muscular atrophy (SMA) is one of the most common neurodegenerative genetic disorders. SMN1 is the SMA-determining gene deleted or mutated in the majority of SMA cases. There is no effective cure or treatment for this disease yet. Thus, the availability of prenatal testing is important. Here we report prenatal prediction for 68 fetuses in 63 Turkish SMA families using direct deletion analysis of the SMN1 gene by restriction digestion. The genotype of the index case was known in 40 families (Group A) but unknown in the remaining 23 families (Group B). A total of ten fetuses were predicted to be affected. Eight of these fetuses were derived from Group A and two of these fetuses were from Group B families. Two fetuses from the same family in Group A had the SMNhyb1 gene in addition to homozygous deletion of the NAIP gene. One fetus from Group A was homozygously deleted for only exon 8 of the SMN2 gene, and further analysis showed the presence of both the SMN1 and SMNhyb1 genes but not the SMN2 gene. In addition, one carrier with a homozygous deletion of only exon 8 of the SMN1 gene was detected to have a SMNhyb2 gene, which was also found in the fetus. To our knowledge, these are the first prenatal cases with SMNhyb genes. Follow-up studies demonstrated that the prenatal predictions and the phenotype of the fetuses correlated well in 33 type I pregnancies demonstrating that a careful molecular analysis of the SMN genes is very useful in predicting the phenotype of the fetus in families at risk for SMA. Copyright © 2002 John Wiley & Sons, Ltd.     

金属改性对SAPO-34低温还原NO性能的影响

采用浸渍法制备金属改性SAPO-34分子筛催化剂,分析比较了不同单金属（Cu或Co）及不同比例双金属（Cu：Co=1：1、3：1、5：1,质量比）改性催化剂对NO的催化还原性能,评价了不同催化剂的N₂选择性,并采用扫描电子显微镜（SEM）、比表面积测试、X射线衍射分析（XRD）、NH₃-程序升温脱附（NH₃-TPD）等表征手段对催化剂的物化性能进行了分析.结果表明,单金属Cu改性催化剂具有较宽的温度区间,在250~450℃范围内NO的转化率始终保持在100%;双金属改性使NO转化率保持为100%的最低温度下降了25~50℃,显著拓宽了低温段窗口,其中,Cu₃Co₁/SAPO-34催化剂的低温催化还原性能最好,200℃即可实现100%的NO转化率,175℃下的转化率也高达80%以上.Cu-Co双金属改性SAPO-34分子筛催化剂具有优异的低温催化还原NO性能,具有在机动车尾气、工业废气的低温脱硝治理领域应用的潜力.     

Effects of SO2 and H2O on low-temperature NO conversion over F-V2O5-WO3/TiO2 catalysts

F-V_2 O_5-WO3/Ti02 catalysts were prepared by the impregnation method.As the content of F ions increased from 0.00 to 0.35 wt.%,the NO conversion of F-V_2 O_5-WO_3/TiO_2 catalysts initially increased and then decreased.The 0.2 F-V_2 O_5-WO_3/TiO_2 catalyst(0.2 wt.% F ion)exhibited the best denitration(De-NOx) performance,with more than 95% NO conversion in the temperature range 160-360℃,and 99.0% N2 selectivity between 110 and 280℃.The addition of an appropriate amount of F ions eroded the surface morphology of the catalyst and reduced its grain size,thus enhancing the NO conversion at low temperature as well as the sulfur and water resistance of the V_2 O_5-WO3/Ti02 catalyst.After selective catalytic reduction(SCR) reaction in a gas flow containing SO_2 and H_2 O,the number of NH3 adsorption sites,active component content,specific surface area and pore volume decreased to different degrees.Ammonium sulfate species deposited on the catalyst surface,which blocked part of the active sites and reduced the NO conversion performance of the catalyst.On-line thermal regeneration could not completely recover the catalyst activity,although it prolonged the cumulative life of the catalyst.In addition,a mechanism for the effects of S02 and H_2 O on catalyst NO conversion was proposed.     

Effects of calcination temperature on physicochemical property and activity of CuSO4/TiO2 ammonia-selective catalytic reduction catalysts

CuSO_4/TiO_2 catalysts with high catalytic activity and excellent resistant to SO_2 and H_2 O,were thought to be promising catalysts used in Selective catalytic reduction of nitrogen oxides by NH_3.The performance of catalysts is largely affected by calcination temperature.Here,effects of calcination temperature on physicochemical property and catalytic activity of CuSO_4/TiO_2 catalysts were investigated in depth.Catalyst samples calcined at different temperatures were prepared first and then physicochemical properties of the catalyst were characterized by N2 adsorption-desorption,X-ray diffraction,thermogravimetric analysis,Raman spectra,Fourier-transform infrared spectroscopy,X-ray photoelectron spectroscopy,temperature-pro grammed desorption of NH_3,temperature-programmed reduction of H_2 and in situ diffuse reflectance infrared Fourier transform spectroscopy.Results revealed that high calcination temperature had three main effects on the catalyst.First,sintering and anatase transform into rutile with increase of calcination temperature,causing a decrement of specific surface area.Second,decomposition of CuSO_4 under higher calcination temperature,resulting in disappears of Br(?)nsted acid sites(S-OH),which had an adverse effect on surface acidity.Third,CuO from the decomposition of CuSO_4 changed surface reducibility of the catalyst and favored the process of NH_3 oxidation to nitrogen oxides(NO_x).Thus,catalytic activity of the catalyst calcined under high temperatures(≥600℃) decreased largely.     

基于模糊PI控制的瞬态高温控制策略研究

目的通过地面环境试验研究气动热引起的瞬态高温环境对飞行器结构的影响。方法设计基于石英灯和离心机的瞬态高温-加速度复合试验系统,研究温度和加速度同步控制系统的结构和原理,分析无制冷装置环境下瞬态高温控制的难点,提出基于模糊PI控制器的温度控制策略。结果通过MATLAB仿真验证,设计的模糊PI控制器相比传统的PI控制器能够有效提高温度控制的动态性能与精确性。结论将基于模糊PI控制的瞬态加热控制策略应用于瞬态高温控制是可行、有效的,能为地面气动热模拟环境试验提供技术保障。     

随机振动响应峰值因子的预计理论研究

简要介绍了超越概率理论、超越频次理论、损伤等效理论和功率谱密度(PSD)的时域拟合理论等4种常见的峰值因子预计理论,并基于三角级数提出了一种新的预计理论。结合试飞加速度数据样本,对比分析超越频次理论、PSD时域拟合理论和三角级数理论的预估精度。研究表明,上述4种常见的预计理论本质上属于统计学理论;PSD时域拟合理论预计的峰值因子波动较大,峰值因子与归一化次数满足高斯分布;三角级数理论的预估精度较高,但缺乏离散峰个数的合理判据。     

内饰材料发射率对密封舱室热防护效率的影响

目的探究密封舱室热防护效率与其内饰材料表面发射率的关系,分析内饰材料发射率对其表面温度、舱室内温度的影响规律。方法采用自行设计的小型密封舱室和加热测量装置,对内饰材料表面及舱室内温度进行测量。结果当内饰材料发射率为0.09时,内饰表面温度为141.2℃,舱室内平均温度仅为90.8℃;内饰材料发射率为0.91时,内饰表面温度为124.4℃,舱室内平均温度为109.1℃。结论试样表面温度随材料发射率的提高而降低,舱室内部空气平均温度随材料发射率的提高而升高;试样表面温度与舱室空气平均温度的温度差随材料发射率的提高而减小;同时,相同试样表面温度与舱室平均温度的温度差随加热温度的提高而增加。