废塑料再生过程废水中微塑料去除模拟试验

微塑料是一种存在于不同环境介质中的新兴污染物,主要来源于废弃塑料制品,其存在污染范围广、潜在环境污染大的问题.废塑料再生企业生产废水中微塑料浓度远高于其他类型废水,对其生产废水中的微塑料进行处理具有重要的环境意义.模拟废塑料再生过程的生产废水并进行微塑料去除的絮凝沉淀试验,研究絮凝剂投加量、pH、水力快速搅拌条件的单因素和正交试验对废水中微塑料去除率及其各因素作用的影响.结果表明:①当PAC (聚合氯化铝)投加量为10 mL,PAM (聚丙烯酰胺)投加量为7 mL,pH为9,水力快速搅拌条件为100 r/min下维持40 s再200 r/min下维持40 s时,微塑料的总去除率最高,达91%.②PAC投加量是影响微塑料去除效果的主要因素,其次是pH.③微塑料的去除率与其本身的密度有关,密度大的ABS (acrylonitrile butadiene styrene,丙烯腈-丁二烯-苯乙烯)去除率最高,密度小的PE (polyethylene,聚乙烯)去除率最低.④不同粒径区间的微塑料去除率区别较大,粒径小(0.1~0.25 mm)的微塑料去除效果最好.研究显示,通过控制PAC和PAM的投加量、pH和水力搅拌速率等条件,能够有效将废水中的微塑料通过絮凝沉淀的方法去除,从而达到净化含微塑料生产废水的目的.      

温度和含水率对村镇垃圾焚烧烟气中有机物排放的影响

使用管式炉模拟村镇生活垃圾焚烧过程,研究不同焚烧温度和不同垃圾含水率条件下,村镇垃圾焚烧烟气中多环芳烃（PAHs）、氯苯及苯系物的生成和分布特性.结果表明,焚烧温度为550℃时,烟气中多环芳烃和氯苯的释放量最大,当温度小于550℃时,多环芳烃和氯苯的释放量随温度升高而增加,温度大于550℃时,多环芳烃和氯苯的释放量随温度升高而降低.高温焚烧不仅可以抑制烟气中多环芳烃的浓度及减少大分子量PAHs的排放,还能降低氯苯的释放量和氯代数,从而减小村镇垃圾焚烧烟气中的毒性;苯系物随着温度升高,由热解转变为高温合成,释放量也随着增加.水分对多环芳烃和氯苯有较大影响,对苯系物的影响较小.在400℃条件焚烧时,水分含量对多环芳烃总体上是促进的,而在850℃焚烧条件下则表现出抑制作用;而水分对氯苯则均表现出抑制作用,并且可以降低氯苯化合物的氯代数.     

有机垃圾厌氧消化泡沫产生机理及控制方法

为了分析厌氧消化泡沫的产生机理和控制方法有助于解决有机垃圾厌氧消化起泡问题,本文调研了近年来报道的厌氧消化系统起泡现象,并从底物特性、反应器构造及运行条件和消化过程相关特性3方面分析了不同底物、工艺和环境条件下厌氧消化反应器的起泡机理;讨论了丝状菌指数、表面张力、粘度、有机负荷、起泡趋势和泡沫稳定性等参数作为起泡风险评价指标的合理性;介绍和比较了4类消泡方法（物理法、机械法、生物法和化学法）的消泡原理及优缺点.目前,除污泥厌氧消化系统外,其他有机垃圾厌氧消化系统起泡的主要因素尚不明确,而这也限制了泡沫控制方法的开发.后期探索关键起泡微生物或研究生物表面活性物质与起泡的相关性,将有助于从新的角度揭示起泡机理,并开发出针对性更强的泡沫控制方法.     

不同基质生物炭对厌氧处理餐厨垃圾效能及微生态的影响

探究了剩余污泥（SS）、餐厨垃圾（FW）、玉米芯（CC）、甘蔗渣（BG）4种不同基质生物炭对厌氧生物处理餐厨垃圾效能的影响,对厌氧污泥的关键酶活性、微生物群落分布以及代谢途径等微生态进行了分析.结果表明,厌氧反应器分别加入4种生物炭后,COD平均去除率分别提高了29.49%、23.16%、29.42%、40.32%;傅里叶红外分析表明,投加SS生物炭组出水中羟基、酰胺基以及C-O-C伸缩振动峰减弱.4个厌氧反应器中厌氧污泥的乙酸激酶活性分别为0.40,0.42,0.96,0.98 μmol/g,表明投加CC与BG生物炭促进了餐厨垃圾的厌氧水解酸化过程;厌氧污泥胞外聚合物的蛋白质/多糖之比分别为0.415、0.56、1.89、2.8,投加CC、BG生物炭提高了污泥的稳定性.4个厌氧反应器中拟杆菌门、变形菌门、厚壁菌门为主要菌群,投加BG生物炭促进了变形菌门与厚壁菌门的生长;对于古细菌而言,甲烷杆菌属与甲烷丝菌属为优势种群,SS组的甲烷杆菌属丰度最高（53.48%）,而BG组中甲烷丝菌属丰度最高（42.72%）.KEGG功能分析表明古菌及细菌均以碳水化合物代谢、氨基酸代谢为主;而投加BG与SS生物炭后,微生物膜运输水平得到了提高.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Cumulative impact assessment in environmental planning: A coastal wetland watershed example

Several theoretical, analytical, and institutional difficulties have impeded the development and application of the assessment of cumulative environmental impacts. Watershed development on coastal wetlands offers an ideal context for evaluating the land disturbance target approach to cumulative impact assessment. A model land use planning system involving a time series approach was developed for Elkhorn Slough in California. The approach included four major components: evaluation of erosion susceptibility, measurement of land disturbance, establishment of a land disturbance target, and a comparison of existing and target land disturbance values. Further research is needed to test the transferability of the approach in a wide range of coastal watersheds and to verify the applicability of the methods to other cumulative impact problems.     

From proposal to decision: Suggestions for tightening up the “NEPA process”

Although the process of documenting compliance with NEPA (the National Environmental Policy Act) requires no drastic revisions, it can be managed more rigorously. Suggestions for revision can be grouped under five major steps: 1) getting a complete proposal from the applicant; 2) getting the decision-making process onto the right decision-making path; 3) modifying the applicant's proposal 4) going down a shorter path through the EA/FONSI (environmental assessment and finding of no significant impact) or through categorical exclusion review; and 5) going down the longer path through the EIS. Step 2 is perhaps the most critical, because there a decision must be made whether to write an EA/FONSI or an EIS, on the basis of whether the proposal would “significantly affect … the … environment.” In the past, this decision has not always been made promptly or rigorously. Accordingly, we suggest that the agency responsible for NEPA compliance should develop a system (a “black box”), consisting of a core group of specialists working with an interdisciplinary team, using sophisticated techniques for modeling impacts and directing both their research and their writing according to the concept of significance. By determining more efficiently and reliably whether the impacts of a proposal would be significant, such an approach would improve management of the total process.     

Induction of cytochrome P4501A and endocrine disrupting effects of school incinerator residues

The emission of the dioxin-like compounds from on-site waste incinerators of seven schools in Kyonggi Province of Korea was evaluated by determination of the cytochrome P4501A(CYP1A) catalytic activity and antiestrogenic activity using cell culturemicrobioassay. The residue samples were extracted in a Soxhlet apparatus using toluene for 20 hr. The concentrated crude extractswere fractionated with a basic alumina column. Dioxin-like compounds were then extracted. Induction of CYP1A activity in a rat(H4IIE) hepatoma cell line was used as indicator of biologicaleffect of incinerator residues and measured as 7-ethoxyresorufin-O-deethylase(EROD) activities. The EROD activities of fraction II extracts (one of the two extracts) in the H4IIE cells were from 0.044±0.002 to 4.424±0.351 ng-TEQ g^-1 (TCDD Toxicity equivalent), showing relatively high inducing capacity. Antisetrogenicity of the extracts was measured as decrease in E₂-induced cell proliferation. Most of the extracts showed antiestrogenic activity in MCF7-BUS cell.The TEQ levels of the incinerator residues and the antiestrogenicactivities were in good correlation, strongly suggesting that thepotent toxic emissions were indeed produced from the on-site school waste semi-incinerators and could cause the antiestrogenicity.     

C OD在线分析仪比对中应注意的问题

分析了COD在线分析仪和实验室比对结果人为差异的原因是样品不均匀,在线分析仪取样装置滤过,取样层面和采样方式以及沉淀消除的方法不同造成的.提出应在相同的地点、层面和同一容器取样,用相同沉淀消除方法去除样品中氯离子干扰,保证两方法比对中使用水样的一致均匀,使测试结果正确可信.