固态胺吸附剂分离密闭空间低浓度CO_2的研究进展

近年来,密闭空间低浓度CO2的吸附分离技术是研究热点,固态胺吸附剂因其再生能耗低、选择性高、易操作等优点受到广泛关注。综述了固态胺吸附剂常见的制备方法、表面改性剂和多孔材料载体,同时综合评价CO2的吸附效率,最终展望了固态胺的发展趋势。     

某机场大气环境现状监测分析

为了研究机场大气环境质量状况,在某机场选取三个监测点,在正常飞行条件下,对不同时间段污染物浓度进行监测与分析。测试结果表明:七天监测期间,机场及机场周围SO2、NO2浓度均未超标,PM10在机场内部有一天超标;各时间段SO2的贡献率在2.9%~12%,各时间段NO2的贡献率在6.9%~77%,机场飞机的尾气对周围空气质量的影响不容忽视。     

改性小麦秸秆的制备及其对水中亚甲基蓝的吸附性能

用碳酸钾(K2CO3)溶液活化法成功地制备改性小麦秸秆。采用傅里叶红外光谱仪(FT-IR)、扫描电子显微镜(SEM)和静态吸附试验对改性前后样品的组成、形貌和吸附性能进行表征和测定,对比了秸秆改性前后的结构和组成变化。结果表明:改性后小麦秸秆半纤维素被部分溶解,出现了多孔疏松的结构。改性小麦秸秆用量、溶液p H和亚甲基蓝的浓度在一定范围内增大有助于改性小麦秸秆对亚甲基蓝吸附速率的提高,吸附类型符合Langmuir吸附等温方程模型且属于拟二级动力学吸附过程。     

壳聚糖对Cu~(2+)的吸附与解吸

研究了溶液pH值、Cu2+初始浓度、吸附剂投加量、吸附时间及温度对壳聚糖吸附Cu2+的影响,并对达到吸附平衡的壳聚糖进行了解吸研究。结果表明,壳聚糖对Cu2+的吸附量随pH值的升高而增大,在pH值为4.7时,基本达到吸附平衡;吸附过程同时符合Langmuir模型和Freundlich模型,最大吸附量为142.9 mg/g;与拟一级动力学模型相比,拟二级动力学模型可以更好地描述吸附过程;吸附剂最佳投加量为1 g/L。用0.03 mol/L H2SO4溶液做脱附液,搅拌10 min,脱附率为73.4%;经过4次脱附-吸附循环,壳聚糖平衡吸附量变化不大,具有良好的重复使用性。     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Efficient dechlorination of chlorinated solvent pollutants under UV irradiation by using the synthesized TiO2 nano-sheets in aqueous phase

Titanium dioxide(TiO2), which is the widely used photo-catalyst, has been synthesized by simple hydrothermal solution containing tetrabutyl titanate and hydrofluoric acid. The synthesized product has been applied to photo-degradation in aqueous phase of chlorinated solvents, namely tetrachloroethene(PCE), trichloroethene(TCE) and 1,1,1-trichloroethane(TCA). The photo-degradation results revealed that the degradation of these harmful chemicals was better in UV/synthesized TiO2 system compared to UV/commercial P25 system and UV only system. The photo-catalytic efficiency of the synthesized TiO2 was 1.4, 1.8 and 3.0 folds higher compared to the commercial P25 for TCA, TCE and PCE degradation, respectively. Moreover, using nitrobenzene(NB) as a probe of hydroxyl radical(.OH), the degradation rate was better over UV/synthesized TiO2, suggesting the high concentration of.OH generated in UV/synthesized TiO2system. In addition,.OH concentration was confirmed by the strong peak displayed in EPR analysis over UV/synthesized TiO2system. The characterization result using XRD and TEM showed that the synthesized TiO2 was in anatase form and consisted of well-defined sheet-shaped structures having a rectangular outline with a thickness of 4 nm, side length of 50 nm and width of 33 nm and a surface 90.3 m2/g. XPS analysis revealed that ≡Ti-F bond was formed on the surface of the synthesized TiO2. The above results on both photocatalytic activity and the surface analysis demonstrated the good applicability of the synthesized TiO2 nano-sheets for the remediation of chlorinated solvent contaminated groundwater.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

Two-step accelerated mineral carbonation and decomposition analysis for the reduction of CO2 emission in the eco-industrial parks

Carbon dioxide（CO2） emissions are a leading contributor to the negative effects of global warming. Globally, research has focused on effective means of reducing and mitigating CO2 emissions. In this study, we examined the efficacy of eco-industrial parks（EIPs） and accelerated mineral carbonation techniques in reducing CO2 emissions in South Korea.First, we used Logarithmic Mean Divisia Index（LMDI） analysis to determine the trends in carbon production and mitigation at the existing EIPs. We found that, although CO2 was generated as byproducts and wastes of production at these EIPs, improved energy intensity effects occurred at all EIPs, and we strongly believe that EIPs are a strong alternative to traditional industrial complexes for reducing net carbon emissions. We also examined the optimal conditions for using accelerated mineral carbonation to dispose of hazardous fly ash produced through the incineration of municipal solid wastes at these EIPs. We determined that this technique most efficiently sequestered CO2 when micro-bubbling, low flow rate inlet gas, and ammonia additives were employed.     

西安市2013年空气质量状况分析

本文收集西安市2013年环境监测站发布的空气质量指数（AQI）及环境空气状况与监测月报资料,对空气质量等级、AQI变化情况、主要污染物浓度变化趋势及采暖期和非采暖期浓度比较进行分析.研究结果表明：西安市2013空气质量二级以上的达标率为37.8％,年均AQI值为151,SO2、NO2、PM10和PM2.5的月监测浓度变化趋势无显著意义,采暖期平均浓度均显著高于非采暖期平均浓度,PM2.5采暖期均值是非采暖期均值的3.09倍.由此可见控制SO2、NO2、PM10和PM2.5的排放是改善西安市空气质量的重点工作.