关于对环卫机械液压系统污染物控制的研究

相比于控制技术,液压传动系统具有更好的优越性,且已在各领域当中得到了广泛的应用。但是在实际的工作运行当中,液压系统的污染故障率相当高,在75％左右。因此,对液压系统污染物的控制十分必要,是液压设备可靠正常运行的保障。下面,本文就环卫机械对液压系统污染物的控制进行研究,以为实际的污染物控制提供参考。     

基于快速聚类方法分析常州市区PM2.5的统计特性

运用统计方法研究常州市区2013~2014年6个国控点六项基本污染物(SO_2、NO_2、CO、O_3、PM_(2.5)和PM_(10))月平均浓度变化,结果表明,除O_3外,其它五项污染物月平均浓度夏季较低冬季较高.颗粒物与风速之间的关系为PM_(2.5)浓度随风速的升高一直降低,PM_(10)随风速的升高浓度先降低后升高.采用快速聚类分析(k-means)并运用SWV和DIV指数对六项基本污染物进行分类,得到4个样本分类.与依据颗粒物化学成分或粒径谱对PM进行源解析方法不同,本研究更多是从PM_(2.5)与其它污染物相关关系以及污染程度等角度按照欧式距离进行分类.不同类中PM_(2.5)来源明显不同,类1中PM_(2.5)与化石燃料燃烧排放密切相关,类2与O_3密切相关,类3与城市不完全燃烧排放、区域灰霾污染密切相关,类4可以归类于城市"背景"类.快速聚类分析结果也表明常州市区PM_(2.5)有着复杂的来源.     

《大气污染防治先进技术汇编》正式发布

正为强化科技支撑大气污染防治工作,贯彻落实国务院《大气污染防治行动计划》,科技部与环境保护部在组织实施《蓝天科技工程"十二五"专项规划》的基础上,对大气污染防治方面的科研成果及应用情况进行了全面梳理和筛选评估,编制形成了《大气污染防治先进技术汇编》(以下简称《技术汇编》),并于3月5日正式发布.《技术汇编》汇集了89项关键技术及130余项相应案例成果,涵盖电站锅炉烟气排放控制、工业锅炉及煤窑锅炉排放控制、典型有毒有害工业废气净化、机动车尾气排放控制、居室及公共场所典型空气污染物净化、无组     

新气候变迁报告:减排若不控制恐将引发大灾难

正联合国气候变迁专家小组于11月2日推出第五个全球气候变迁评估报告.据法国国际广播电台报道,联合国气候变迁问题专家组11月2日在丹麦首都哥本哈根推出对全球气候状况的最新评估报告,报告以超乎寻常的强烈用词警告,人类面对地球生态环境快速恶化的风险,各国政府必须尽快行动,降低温室气体排放,实现在2100年前将温室气体排放量减至零,否则恐将引发生态和社会灾难.同时报告也指出,减排     

《环境工程》投稿指南

<正>一、征稿内容1.工业、厂矿和民用领域产生的废气、废水、固体废弃物等的防治和综合利用新技术。2.污染防治创新性改进的工艺、设备、方法、材料以及运行管理经验。3.各行业节能减排和清洁生产技术。4.受污染场地的修复技术。5.环境质量、污染物监测技术和环境评价领域的创新技术和经验。二、稿件具体要求     

西安市机动车尾气超标原因分析与治理

随着城市机动化的高速发展,西安市整体机动车现状的主要问题在于快速增加的机动车数量和低水平的尾气控制排放技术。通过对西安市机动车尾气超标排放的现象和原因进行研究分析,从排放标准、燃油品质和机动车工况多个方面提出了针对性的改善意见和处理措施,为西安市机动车尾气污染的预防、控制和治理提供了一定的科学依据。     

曝气强度对膜生物反应器处理石化废水工艺运行特征的影响

采用膜生物反应器(Membrane Bioreactor,MBR)处理石化废水,研究曝气强度分别为1.50,3.00 m3/(m2·h)的条件下,MBR对石化废水中主要污染物的去除特征、跨膜压差(Trans Membrane Pressure,TMP)和混合液性质的变化特征。结果表明:在两种曝气强度条件下MBR对COD、NH+4-N及挥发酚等污染物的平均去除率分别为80.74%、80.23%、96.79%和97.55%、99.34%、98.84%,即在不同曝气条件下,曝气强度的变化对MBR的污染物去除性能无显著影响。但随着曝气强度由1.50 m3/(m2·h)增加到3.00 m3/(m2·h),MBR达到设定的最大跨膜压差(TMPMax=25k Pa)的运行时间由11.8 d增加到31.4 d,TMP上升速率降低。通过活性污泥颗粒粒径分析发现:增加曝气强度后,对膜污染影响显著的活性污泥颗粒粒径范围(0~2μm)所占体积比由2.10%减小到1.78%;并且混合液中溶解性微生物产物(soluble microbial product,SMP)和胞外聚合物(extracellular polymeric substance,EPS)质量浓度分别由24.07 mg/L和15.66 mg/g减小到15.14 mg/L和9.81 mg/g,从而降低了膜污染速率。     

Evaluation of accuracy of linear regression models in predicting urban stormwater discharge characteristics

Stormwater runoff has been identified as a source of pollution for the environment, especially for receiving waters. In order to quantify and manage the impacts of stormwater runoff on the environment, predictive models and mathematical models have been developed. Predictive tools such as regression models have been widely used to predict stormwater discharge characteristics. Storm event characteristics, such as antecedent dry days （ADD）, have been related to response variables, such as pollutant loads and concentrations. However it has been a controversial issue among many studies to consider ADD as an important variable in predicting stormwater discharge characteristics. In this study, we examined the accuracy of general linear regression models in predicting discharge characteristics of roadway runoff. A total of 17 storm events were monitored in two highway segments, located in Gwangju, Korea. Data from the monitoring were used to calibrate United States Environmental Protection Agency＇s Storm Water Management Model （SWMM）. The calibrated SWMM was simulated for 55 storm events, and the results of total suspended solid （TSS） discharge loads and event mean concentrations （EMC） were extracted. From these data, linear regression models were developed. R2 and p-values of the regression of ADD for both TSS loads and EMCs were investigated. Results showed that pollutant loads were better predicted than pollutant EMC in the multiple regression models. Regression may not provide the true effect of site-specific characteristics, due to uncertainty in the data.     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

Efficient dechlorination of chlorinated solvent pollutants under UV irradiation by using the synthesized TiO2 nano-sheets in aqueous phase

Titanium dioxide(TiO2), which is the widely used photo-catalyst, has been synthesized by simple hydrothermal solution containing tetrabutyl titanate and hydrofluoric acid. The synthesized product has been applied to photo-degradation in aqueous phase of chlorinated solvents, namely tetrachloroethene(PCE), trichloroethene(TCE) and 1,1,1-trichloroethane(TCA). The photo-degradation results revealed that the degradation of these harmful chemicals was better in UV/synthesized TiO2 system compared to UV/commercial P25 system and UV only system. The photo-catalytic efficiency of the synthesized TiO2 was 1.4, 1.8 and 3.0 folds higher compared to the commercial P25 for TCA, TCE and PCE degradation, respectively. Moreover, using nitrobenzene(NB) as a probe of hydroxyl radical(.OH), the degradation rate was better over UV/synthesized TiO2, suggesting the high concentration of.OH generated in UV/synthesized TiO2system. In addition,.OH concentration was confirmed by the strong peak displayed in EPR analysis over UV/synthesized TiO2system. The characterization result using XRD and TEM showed that the synthesized TiO2 was in anatase form and consisted of well-defined sheet-shaped structures having a rectangular outline with a thickness of 4 nm, side length of 50 nm and width of 33 nm and a surface 90.3 m2/g. XPS analysis revealed that ≡Ti-F bond was formed on the surface of the synthesized TiO2. The above results on both photocatalytic activity and the surface analysis demonstrated the good applicability of the synthesized TiO2 nano-sheets for the remediation of chlorinated solvent contaminated groundwater.