Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Removal of heavy metal ions from aqueous solution using red loess as an adsorbent

The adsorption behaviors of heavy metals onto novel low-cost adsorbent, red loess, were investigated. Red loess was characterized by X-ray diffraction, scanning electron microscopy and Fourier transform infrared spectra. The results indicated that red loess mainly consisted of silicate, ferric and aluminum oxides. Solution pH, adsorbent dosage, initial metal concentration, contact time and temperature significantly influenced the efficiency of heavy metals removal. The adsorption reached equilibrium at 4 hr, and the experimental equilibrium data were fitted to Langmuir monolayer adsorption model. The adsorption of Cu(II) and Zn(II) onto red loess was endothermic, while the adsorption of Pb(II) was exothermic. The maximum adsorption capacities of red loess for Pb(II), Cu(II) and Zn(II) were estimated to be 113.6, 34.2 and 17.5 mg/g, respectively at 25°C and pH 6. The maximum removal efficiencies were 100% for Pb(II) at pH 7, 100% for Cu(II) at pH 8, and 80% for Zn(II) at pH 8. The used adsorbents were readily regenerated using dilute HC1 solution, indicating that red loess has a high reusability. All the above results demonstrated that red loess could be used as a possible alternative low-cost adsorbent for the removal of heavy metals from aqueous solution.     

基于Landsat TM遥感数据的沈阳市生态环境监测与评价

以近年Landsat TM 遥感图像为基础数据源,利用遥感与GIS技术对沈阳市生态环境状况进行了监测.结果表明,2009年间沈阳市生态环境质量处于一般水平,与2008年相比,生态环境质量指数上升,生态环境状况呈现变好的趋势.     

密云水库流域2000-2005年植被覆盖度变化监测

植被是生态系统最重要的组成部分,而植被覆盖度是衡量地表植被状况的一个最重要的指标,是生态系统健康评价的前提和必要的基础。文章利用2000和2005年2个时相的Landsat 7 ETM+遥感影像为数据源,以BP神经网络法为植被覆盖度估算模型,计算了密云水库流域内不同时期的植被覆盖度,生成了该流域2个时相内的植被覆盖度图,以此分析密云水库流域植被覆盖度的时空变化。结果表明,从2000-2005年,密云水库流域内除无植被覆盖类型外(即水域部分),其余土地利用类型的植被覆盖度都呈增加趋势,其中以沙质地和耕地最为明显,分别增长了29.5%和27.3%,并且密云水库流域的平均植被覆盖度不高,尤其西部地区植被覆盖度较差,水土流失和土地沙化情况比较严重。     

正射影像图的制作在土地利用现状中的应用

本实验旨在利用高分辨率遥感卫星影像,通过遥感技术手段,制作出高精度的正射影象并采用ERDAS和ArcGIS软件平台（评测版）,来实现更新土地利用现状图,查清监测区的土地利用现状与环境监测、地质灾害情况。为今后高效、客观、准确地开展年度土地变更调查和环境保护工作奠定坚实的基础和做好技术储备。主要任务利用近期航空遥感数据制作监测区1：2000-1：5000标准分幅DOM;提取监测区土地利用现状图成图及其至今的土地利用变化信息;为环境监测、城市可持续发展、研究城市发展的动态监测等提供依据。构建和更新监测区土地资源管理数据库中的土地利用现状数据库。     

2-丁烯醛生产废水中溶解性有机物的分级解析

采用超滤膜法将2-丁烯醛生产废水中的有机物分为相对分子质量不同的7个级分,并应用溶解性有机碳(dissolved organic carbon,DOC)、紫外吸收光谱(ultraviolet spectrum,UV)、傅里叶变换红外光谱(fourier transform infrared spectrometer,FT-IR)和气相色谱/质谱联用仪(gas chromatography with mass spectrometry,GC-MS)技术对不同相对分子质量区间的有机物所占比例及物质结构进行了研究.结果表明,废水中相对分子质量1×103的有机物所占比例最高,达到88.57%;采用GCMS对废水中相对分子质量1×103的级分进行分析,定性出27种化合物,包含醛、酮、酯、醇、酚、酸、烷烃类及其他苯系物等,其峰面积占有机物峰面积总和的比例分别为6.9%、5.3%、35.4%、13.2%、4.6%、0.4%、1.7%、16.8%,总和为84%.UV和FT-IR分析结果均显示不同相对分子质量区间的光谱吸收特征没有明显差别,级分中存在含有不饱和双键、羟基、羰基化合物及芳香族化合物,与GC-MS检测结果相吻合.研究结果为废水处理工艺的开发与优化提供了重要的指导作用.     

富营养化水体中黑水团的吸收及反射特性分析

对黑水团水体光学特性进行研究,是利用遥感技术监测和评估黑水团事件的前提.针对2015年7月在太湖发生的黑水团现象,采集了太湖黑水团区(区域一)、蓝藻水华区(区域二)、清水区(区域三)共36个水样,对这3个区域的水体遥感反射率以及吸收特性进行对比分析.结果表明:1区域一水体的总颗粒物、色素颗粒物和非色素颗粒物吸收系数比区域二、区域三高出1~2倍,在400~500 nm之间,区域一CDOM吸收系数相比另外两个区域的水体高出2倍左右.导致黑水团区域水体具有很低的遥感反射率,被人眼感知时呈现为黑色;2黑水团区域水体M值低于滇池、巢湖和太湖的M值变化范围,说明黑水团中CDOM的腐殖酸含量较高.此外,叶绿素a浓度与CDOM在350 nm处吸收系数之间具有很好的相关性,表明蓝藻的降解可能是黑水团中CDOM的一个主要来源;3在380 nm之后,黑水团区域的水体总吸收以色素颗粒物占主导,但在短波350~380 nm处,CDOM对总吸收的贡献率高于色素颗粒物和非色素颗粒物.     

Removal of polycyclic aromatic hydrocarbons from aqueous solution by raw and modified plant residue materials as biosorbents

Removal of polycyclic aromatic hydrocarbons （PAHs）, e.g., naphthalene, acenaphthene, phenanthrene and pyrene, from aqueous solution by raw and modified plant residues was investigated to develop low cost biosorbents for organic pollutant abatement. Bamboo wood, pine wood, pine needles and pine bark were selected as plant residues, and acid hydrolysis was used as an easily modification method. The raw and modified biosorbents were characterized by elemental analysis, Fourier transform infrared spectroscopy and scanning electron microscopy. The sorption isotherms of PAHs to raw biosorbents were apparently linear, and were dominated by a partitioning process. In comparison, the isotherms of the hydrolyzed biosorbents displayed nonlinearity, which was controlled by partitioning and the specific interaction mechanism. The sorpfion kinetic curves of PAHs to the raw and modified plant residues fit well with the pseudo second-order kinetics model. The sorption rates were faster for the raw biosorbents than the corresponding hydrolyzed biosorbents, which was attributed to the latter having more condensed domains （i.e., exposed aromatic core）. By the consumption of the amorphous cellulose component under acid hydrolysis, the sorption capability of the hydrolyzed biosorbents was notably enhanced, i.e., 6-18 fold for phenanthrene, 6-8 fold for naphthalene and pyrene and 5-8 fold for acenaphthene. The sorpfion coefficients （Kd） were negatively correlated with the polarity index [（O＋N）/C], and positively correlated with the aromaticity of the biosorbents. For a given biosorbent, a positive linear correlation between logKoc and logKow for different PAHs was observed. Interestingly, the linear plots of logKoc-logKow were parallel for different biosorbents. These observations suggest that the raw and modified plant residues have great potential as biosorbents to remove PAHs from wastewater.     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.