臭氧在"臭氧-生物活性炭"饮用水处理工艺中的作用研究

本文通过分析饮用水深度处理中试工艺各处理单元出水水质指标的变化研究臭氧在臭氧生物活性炭工艺中的作用。试验结果表明：在中试工艺中，臭氧具有很好的氧化、杀藻和消毒的作用；并且两级臭氧氧化分别对常规处理单元和颗粒活性炭去除污染物具有一定的促进作用。     

从废感光胶片中回收银

研究了以Fe3 -乙二胺四乙酸二钠-N a2S2O3体系为浸取剂从废感光胶片中回收银的方法,考察了浸出银的最佳工艺条件。实验表明,当浸取剂中FeC l3.6H2O质量浓度为35g/L、N a2S2O3.5H2O质量浓度为150g/L、pH为7、固液质量比为3∶10时,浸取剂可重复使用6次,胶片上银的浸出率可达99%以上;浸取液中的银采用硼氢化钠还原回收,粗银粉配以熔剂高温熔炼可得到纯度达99.78%的银,银回收率达96.88%,回收银后的浸取液可循环使用。     

Mechanical Properties with the Functional Group of Additives for Starch/PVA Blend Film

This paper deals with the mechanical properties and degree of swelling (DS) of starch/PVA blend film with the functional groups i.e., hydroxyl and carboxyl group, of additives. Starch/PVA blend films were prepared by using the mixing process. Glycerol (GL) with 3 hydroxyl group, sorbitol (SO) with 6 hydroxyl group, succinic acid (SA) with 2 carboxyl group, malic acid (MA) with 1 hydroxyl and 2 carboxyl group, tartaric acid (TA) with 2 hydroxyl and 2 carboxyl group and citric acid (CA) with 1 hydroxyl and 3 carboxyl group were used as additives. The results of measured tensile strength (TS) and elongation (%E) verified that both hydroxyl and carboxyl group as a functional groups increased the flexibility and strength of the film. Values of DS for GL-added and SA-added films were low. However, DS values of the films added MA, TA or CA with both hydroxyl and carboxyl group were comparatively high. When the film was dried at low temperature, the properties of the films were evidently improved. The reason is probably because the hydrogen bonding was activated at low temperature.     

臭氧-生物活性炭深度处理黄浦江水源水中试研究

以黄浦江水源水厂的滤后水为试验对象，进行饮用水O3-BAC深度处理工艺影响因素的中试研完。针对进水水质的试验结果表明，最优臭氧投加量为3mg／L左右，空床停留时间为15min左右。试验结果可为工程设计提供有益的参考。     

炼油污水深度处理回用工艺实验研究

试验工艺流程的方案选定,充分吸收了各炼油厂进行的污水深度处理的成功试验经验,以原臭氧生物活性炭工艺单元为基础,提出了以混凝气浮与臭氧生物活性炭串联工艺为核心的总体工艺流程,以降低工程投资及处理成本,提高污水回用的经济效益;同时,指出试验过程中所存在的问题及其对策。因此,开展炼油污水深度处理回用工艺试验研究,必将为炼油污水深度处理提供强有力的技术支撑,可作为相关污水回用处理工艺选择的参考。     

Mechanical and Barrier Properties of Biodegradable Films Made from Chitosan and Poly (Lactic Acid) Blends

Biodegradable film blends of chitosan with poly(lactic acid) (PLA) were prepared by solution mixing and film casting. The main goal of these blends is to improve the water vapor barrier of chitosan by blending it with a hydrophobic biodegradable polymer from renewable resources. Mechanical properties of obtained films were assessed by tensile test. Thermal properties, water barrier properties, and water sensitivity were studied by differential scanning calorimeter analysis, water vapor permeability measurements, and surface-angle contact tests, respectively. The incorporation of PLA to chitosan improved the water barrier properties and decreased the water sensitivity of chitosan film. However, the tensile strength and elastic modulus of chitosan decreased with the addition of PLA. Mechanical and thermal properties revealed that chitosan and PLA blends are incompatible, consistent with the results of Fourier transform infrared (FTIR) analysis that showed the absence of specific interaction between chitosan and PLA.     

炭法烟气脱硫技术研究进展

炭法烟气脱硫技术经半个多世纪的发展，在脱硫剂、脱硫工艺、脱硫原理及联合脱除氮氧化物和有毒物质等方面取得了许多进展。在概述炭法烟气脱硫技术研究进展的同时，分析了制约炭法烟气脱硫技术发展的原因并对炭法烟气脱硫技术的发展方向提出了几点建议。     

炼油污水的深度处理

对炼油污水深度处理常用技术——过滤、膜分离、化学氧化技术进行了详细的论述，并结合中试试验，对动态砂滤系统、PAN膜处理系统和高级氧化系统处理炼油厂二级排放水的适用性进行了论证。     

ZnCl2-微波法制甘蔗渣活性炭工艺条件研究

以工业副产物甘蔗渣为原料,ZnCl2-微波法制备活性炭,用正交实验研究了活化剂ZnCl2浸泡浓度、浸泡时间、微波功率和作用时间等实验因素对活性炭性能的影响.     

电化学反应器吸附去除氟离子的研究

采用改性活性炭粉末对用纯净水加氟化钠配制而成的含氟水溶液进行动态电吸附去除实验.研究不同电压、电吸附时间,以及Cl-和SO2-4对氟离子去除的影响,并探讨吸附动力学和吸附方程.实验结果表明:活性炭对氟离子的吸附等温方程符合Freundlich方程,吸附动力学符合一级动力学方程;活性炭对氟离子去除与所施加的电位、吸附时间等因素有关,施加的电位越大,去除效果越好;随着吸附去除时间的延长,氟离子浓度下降趋缓;Cl-对氟离子去除影响很小,而SO2-4对氟离子去除有显著的不利影响.