Photolysis Behavior of Herbicide Propisochlor in Water Media and Preliminary Analysis of Photoproducts Under Different Light Sources

Photolysis behavior of a new herbicide propisochlor in water media as well as the effects of light sources, initial concentration of propisochlor, pH value, dissolved oxygen (DO) level, and salinity on the photolysis process was investigated. It was found that the relationship between initial concentration of propisochlor and its photodegradation rate was negatively correlated. The changes in acidity and alkalinity of the reaction medium influenced the photoreaction rate evidently. In the alkaline solution the degradation was accelerated. In the reaction media with different pH values, the photolysis followed the first-order kinetics. The presence of dissolved oxygen may promote the photolysis and there existed an optimum of dissolved oxygen concentrations. Increasing the DO level can weaken the promotion and even have an adverse effect. It was demonstrated that with dissolved oxygen the photodegradation of propisochlor followed the first-order kinetics equation. The addition of salt ions Ca²⁺ and Mg²⁺ changed the ionic strength and solvent polarity, resulting in the effect on propisochlor photolysis. The photoproducts were detected by both HPLC and GC-MS methods. It was found that photolysis products varied under different light sources. Conclusions may be reached that in the photodegradation of propisochlor, the benzene ring remained intact under irradiation of both solar light and high-pressure mercury lamp, and the amido link was relatively stable, while dechlorination was liable to take place; moreover, α-hydrogen at the substituent of benzene ring was active.     

Kinetics and mechanism of the hydrolysis of thiamethoxam

The degradation of thiamethoxam [(EZ)-3-(2-chloro-1,3-thiazol-5-yl-methyl)-5-methyl-1,3,5-oxadiazinan-4-ylidene (nitro) amine] insecticide in buffers at different pH and temperature levels was investigated in laboratory studies. Acidic hydrolysis under conventional heating conditions and alkaline hydrolysis under both conventional heating and microwave conditions were carried out. Different hydrolysis products were found to form under alkaline and acidic conditions. Hydrolysis of thiamethoxam in acidic, neutral and alkaline buffers followed first-order reaction rate kinetics at pH 4, 7 and 9.2, respectively. Thiamethoxam readily hydrolyzed in alkaline buffer but was comparatively stable in neutral buffer solution. The main products formed under different conditions were characterized on the basis of infrared (IR), ¹H-NMR and Mass spectroscopy. The possible mechanisms for the formation of these hydrolysis products have also been proposed.     

pH值对污泥发酵产酸的影响

利用剩余污泥厌氧发酵产生挥发性脂肪酸,可作为污水脱氮除磷的有机碳源,而pH值是发酵产酸过程中重要的控制参数.研究了不同pH值条件下剩余污泥厌氧发酵产酸过程中各参数变化规律,探索pH值对其过程的影响及其分析.结果表明,碱性条件有利于污泥发酵产酸过程,实验最佳条件是控制反应初始pH值为10.0,仅8d发酵挥发性脂肪酸浓度就达到8.90 mmol/L.此外,污泥在发酵过程中,酸性条件下NH4+-N和PO43--P的释放量均大于碱性条件.     

酸碱调控及底物浓度对木糖发酵产酸特性的影响

以木糖为碳源采用间歇培养方式,对木糖厌氧发酵产酸进行研究。考察木糖浓度和初始pH值对木糖厌氧产酸的影响。结果表明,随着木糖浓度的增加,总产酸量得到提高,但木糖利用率却呈现下降的趋势。当木糖浓度为5 g/L时,其利用率为100%,15 g/L时利用率为73.9%,此时挥发性脂肪酸(VFAs)为9.22 g/L。木糖的分批投加可有效促进产酸,尤其是促进乙酸浓度的提高。pH为5.0和6.0左右时,VFAs主要成分为乙酸和丁酸;而pH为7.0～9.0时,乙酸含量明显增高,在pH值为8.0的条件下乙酸含量占总VFAs的80.1%。在pH=8.0时经过8 d左右的发酵,VFAs浓度可达9.34 g/L。     

SBR处理高浓度养猪废水工艺条件

以养猪场废水作为研究对象,采用序列间歇式活性污泥法SBR,通过实验研究了供气量、pH、排泥量、原水稀释倍数、水力停留时间（HRT）对SBR出水水质的影响。结果表明,供气量为375 L/（min·m³）、pH为8.0,并添加排泥100 mL的操作,可使SBR处理效果明显提高,COD、磷和凯氏氮去除率最高分别可达96.37%、94.14%、99.38%。逐步降低进水稀释倍数有利于培养出处理高浓度有机养猪废水的活性污泥,可将平均COD、磷和凯氏氮含量高达9 161.24、33.41和1 502.77 mg/L的养猪废水处理至出水的490.11、5.35和17.84 mg/L。降低HRT对SBR去除率影响不大。     

基于指标规范值的室内空气客观评价的概率神经网络模型

为了建立简单、普适、通用的概率神经网络的室内空气评价模型,在适当设定室内空气各项指标的参照值及指标值的规范变换式基础上,使室内空气同级标准不同指标的规范值差异尽可能小,从而用规范值表示的各指标都可用同一个规范指标"等效"替代。因此,概率神经网络隐层各类模式的基函数中心矢量的各指标分量值与同级标准所有15项指标规范值的均值等同。将基于指标规范值的概率神经网络模型用于室内空气的评价实例进行检验,验证了该模型的普适性、通用性和简便性。     

市政污泥深度脱水药剂优化研究简

污泥含水率高影响污泥后续处置。利用化学药剂对污泥进行深度脱水处理可使污泥减量化、稳定化。为提高深度脱水效果,对添加剂进行了种类和添加量的优化研究（石灰、工业石灰、粉煤灰、硅藻土、十二烷基磺酸钠和飞灰;5%、10%、15%、20%、25%和30%）,另外,还进行了复合投加实验。研究结果表明,石灰、工业石灰、粉煤灰的深度脱水效果最好;复合添加中,25%石灰+5%粉煤灰,20%石灰+10%粉煤灰,10%石灰+20%粉煤灰的深度脱水效果最好。5%的石灰或者工业石灰的添加剂量使干化污泥pH值达到12.25,粉煤灰、硅藻土、十二烷基磺酸钠和飞灰的添加对干化污泥pH值影响相对要小。     

不同浸提剂对污染河道底泥中重金属的浸出影响

以某有色金属冶炼企业排放口下游河道底泥为研究对象,分别采用无机酸(盐酸、硫酸、硝酸)和有机酸(醋酸、柠檬酸、苹果酸和丁二酸)研究在不同酸性条件(pH为2~6)下Pb、Cd、Zn、Cu的浸出效果。结果表明,有机酸的浸提能力明显高于无机酸,且4种重金属的浸出浓度均随着pH的升高而迅速降低。对无机酸而言,当pH3时,重金属的浸出浓度趋于稳定;对有机酸而言,在pH为2~5的较大范围内,醋酸表现出较高的浸提能力,而柠檬酸对Pb和Cu没有明显的浸出效果。结合泥质特点,从重金属的络合、沉淀、水解、吸附等反应过程对其浸出特征进行了分析,同时提出醋酸良好的缓冲能力是其浸提效果优于其他有机酸的重要原因。     

基于DO控制实现SBR短程硝化过程

采用序批式反应器(SBR)处理模拟氨氮废水,研究了固定供氧模式下氨氮降解过程和溶解氧变化规律,并对DO控制实现短程硝化机理进行了探讨.实验结果表明,当DO＜1 mg/L时,体系产生亚硝酸盐积累,当亚硝化反应结束后,DO出现跃升现象,并且pH值对短程硝化有一定影响,充足的碱度和较高的pH值有利于建立以DO为控制参数实现短程硝化过程控制.短程硝化启动后,亚硝酸盐积累率达90％以上,并且经过度曝气5d后,系统仍保持稳定运行.     

RuO2-IrO2-SnO2/Ti阳极电催化氧化苯酚的研究

以RuO2-IrO2-SnO2/Ti钛网电极为阳极,RuO2-IrO2/Ti钛网电极为阴极,构建了电催化氧化体系,同时以苯酚为底物、硫酸钠为电解质,考察了不同pH、极板间距、电流密度和苯酚初始浓度对苯酚去除率的影响。结果表明,在pH为6.5、极板间距为1.0cm、电流密度为50mA/cm2、苯酚初始质量浓度为1 000mg/L的最佳实验条件下,取硫酸钠质量浓度为20g/L的苯酚模拟废水250mL,120min时苯酚去除率可以达到98.4%。