活性污泥数学模型中异养菌产率系数测定方法的研究

采用间歇活性污泥法和呼吸计量法测定活性污泥数学模型中异养菌产率系数.研究结果表明,间歇活性污泥法测定结果受试验控制条件特别是污泥有机负荷的影响非常大,且试验周期比较长;人工配水条件下,呼吸计量法测定异氧菌产率系数(YH)在0.71以上,比活性污泥数学模型推荐值高,其结果与底物性质有关,该方法准确性高,重现性良好.     

催化铁内电解法处理硝基苯废水的机理与动力学研究

对催化铁内电解法处理硝基苯废水降解动力学特性进行了研究。结果表明，降解过程符合准一级动力学规律。进水浓度、pH值和反应温度强烈影响硝基苯的降解速率。在实验pH值范围内，反应速率常数依次为：强酸性〉弱碱性〉弱酸性〉中性；循环伏安扫描图显示了硝基苯可以在铜电极上直接得电子还原，该反应在强酸和弱碱性条件下效果较好。反应速率常数随进水浓度的增大而减小。提高反应温度可改善处理效果，在30-45℃范围内，提高温度对处理效果的改善并不显著；当温度升高到45℃以上时，升温可以显著改善处理效果。     

COS,CS2 and SO2 in aluminium smelter exhaust

Measurements of carbonyl sulfide (COS) and carbondisulfide (CS₂) were carried out on samples drawn from a smoke stack of an aluminium smelter. Volume mixing ratios of 6 ppm COS and 0.1 ppm CS₂ were measured for gases from the electrolysis unit that had previously passed an Al₂O₃ fluid bed reactor and electrostatic precipitators. Specific emissions of 1.6 kg COS and 0.03 kg CS₂ per ton of primary aluminium were found. Extrapolating from this particular smelter’s conditions to a world mix specific COS emissions of about 4 kg/t(Al) are calculated resulting in emissions of annually 0.08 Tg COS into the atmosphere due to electrolytic aluminium production in 1995. Besides the photochemical conversion of anthropogenic CS₂ aluminium production is established to be the second major industrial source of COS probably exceeding automotive tire wear’s and coal combustion’s contributions.     

电极-生物复合反应器处理城市污水的初步研究

微生物固定在电极表面，电解水产氢与氧所营造的微环境在一定条件下对生物硝化／反硝化及吸／放磷产生了促进作用，使电极-生物复合反应器在脱除有机污染物的同时强化了生物的脱氮及除磷效果。本试验采用了2套结构与尺寸完全相同的单槽内循环反应器，1套通电，1套不通电，在不同电流强度下比较了2套反应器对污染物的去除效果。反应器中以石墨为阳极，活性炭纤维为阴极，电极-生物复合反应器的总氮去除率可比未通电流的反应器高出30％左右，总磷去除率增加11．5％，而氨氮、COD的去除率都维持在100％和95％左右。试验表明，电流的引入在一定条件下能明显强化生物反应器脱氮除磷效果。     

高镍杂铜低温生产电解铜粉试验

用杂铜电解生产铜粉时，电解液的温度一般可控制在２０￣６０℃。本文介绍了在３０℃较低温度和６００￣１２００Ａ／ｍ＾２的较低电流密度下，用杂铜电解生产铜粉的试验过程。试验结果表明：低温和低铜离子浓度对生产细粒铜粉有利，而料低电流密度在保证铜粉粒度的情况下，对节约电能有利。     

常温铁氧体法处理电解锌厂废水试验研究

用常温铁氧体法对山西某电解锌厂废水进行了处理。经试验研究确定了处理该废水的工艺条件:Fe2+/M2+10,添加剂用量1.4g/L,M3+/M2+1.6,Zn2+/Cu2+33.3(废水初始Zn2+/Cu2+),所得磁性产物的饱和磁化率为45.9emu/g,回收率为85.0%。试验中还发现,金属离子的半径对铁氧体的生成有一定的影响。     

Addressing the challenges of implementing safety instrumented systems in multi-product batch processes

Adapting the requirements of IEC 61511 to a batch system can be frustrating, particularly for multi-product units. While a Safety Instrumented System (SIS) for continuous operation is often a straightforward detect-decide-act loop, implementing a SIS for a batch system may involve multiple safety functions, time- or state-dependence, intricate calculations, or complex installations. Relationships between the SIS elements and the basic process control system (BPCS) must be tightly managed, providing both for the safety of the unit and its ability to operate without spurious trips or other hindrances. These issues are further complicated when multiple products requiring different functions or setpoints are produced in the same SIS-protected batch unit.This paper will discuss the challenges particular to the design, operation, and maintenance of a SIS in multi-product batch operations and present practical options for successfully resolving the concerns. A key insight into successful adaptation is treating the batch SIS as a “permission” system for the BPCS to operate. Although many items can be addressed through clever engineering practices, sustainable success relies on proactive, robust management of the safety lifecycle.     

中药废水处理工程应用研究

西安市某制药厂中药废水具有水量水质变化大,可生化性较差的特点.采用电解+水解酸化+ ABR厌氧+接触氧化+絮凝沉淀组合工艺对其进行处理;平均进水p(CODcr)=4 600 mg/L,平均出水p(CODcr)=42 mg/L,CODcr平均去除率为99.1％.实践结果表明,该工艺运行费用低,操作简便,易于维护,处理效果稳定,其出水各项指标均优于《黄河流域(陕西段)污水综合排放标准》(DB 61/224-2011)二级标准.     

超声波强化内电解对对-硝基苯酚的处理

讨论了超声波与内电解处理的可行性。优化超声波、内电解和两者联用的条件,利用常用流程处理10mg/L模拟废水对-硝基苯酚的降解率超过96%,达到国家排放标准和相关行业标准。分析了超声波对内电解强化作用的动力学过程和机理,提出存在的问题和进一步研究的方向。     

铁炭微电解组合工艺处理大蒜切片废水研究

采用铁炭微电解技术为核心工艺的混凝-铁炭微电解-强化电解组合工艺对大蒜切片废水进行处理,主要研究了铁炭微电解的运行参数,包括曝气与否、废水pH值、反应时间、铁炭质量比、铁水质量比对COD去除效果的影响。结果表明:经过组合工艺处理后,废水刺鼻的气味完全消除,浊度去除率达100%,ρ(COD)值由13050mg/L降至878mg/L,去除率达93.3%,BOD5/COD(B/C)值由0.10提高到0.46,废水的可生化性显著提高。