Economics of harvesting age-structured fish populations

A generic age-structured model is developed to derive analytical results on optimal harvesting. Given two age classes, knife-edge selectivity, and no stock-dependent harvesting cost, the steady state is a unique saddle point. Adding harvesting cost does not alter the uniqueness, given that the utility is linear. Under specific conditions such as nonselective gear, optimal harvesting is proved to be a stationary cycle that represents pulse fishing. Optimal steady states are different if age-structured information is ignored and optimization is based on traditional biomass variables. This implies that the existence of optimal sustainable harvesting depends on age-structured information. Given a specific set of conditions such as low interest rate and knife-edge selectivity, optimal harvesting converges toward a unique saddle point independently of the number of age classes.     

Conversion of leather wastes to useful products

The main objective of the present study is to investigate the production of useful materials from different kinds of leather waste. Three different types of tannery wastes (chromium- and vegetable-tanned shavings, and buffing dust) were pyrolyzed in a fixed bed reactor at temperatures of 450 and 600 °C under N₂ atmosphere. Gas, oil, ammonium carbonate and carboneous residue were obtained by pyrolysis. The effect of temperature and type of leather waste on product distribution of pyrolysis was investigated. Buffing dust gave the highest yield of oil (ca. 23%), while other wastes recorded yields of ca. 9%. Results of elemental analysis and column chromatography showed that pyrolysis oils could be used as fuel or chemical feedstock after re-treatment. The yields of carboneous residue (chars) were between 37.5% and 48.5% and their calorific value was between 4300 and 6000 kcal kg⁻¹, suitable for use as solid fuel. In addition, these chars were activated by CO₂ to obtain the activated carbon. The activated carbon having highest surface area (799.5 m² g⁻¹) was obtained from chromium-tanned shavings. Activated carbons prepared from chromium-tanned leather were presented as an adsorbant for the adsorption of dyes from aqueous solution.     

Biomass combustion and indoor air pollution: the bright and dark sides of small is beautiful

About half the world's households cook and/or heat daily with biomass fuels. At small scale, biomass combustion releases significant amounts of particulates, carbon monoxide, and hydrocarbons, the latter with significant concentrations of polycyclic aromatic hydrocarbons. Preliminary measurements in kitchens of developing-country villages have established airborne concentrations of these healthdamaging pollutants that are orders of magnitude above urban levels or relevant standards. Particle size measurements and dose calculations lead to significant concerns about potential health hazards. The few epidemiological studies are consistent with such effects although more work is clearly needed. These findings may have significant implications for the planning of rural energy development in a number of countries. In particular, they may relate directly to the question of the optimum balance between centralized and decentralized systems.     

Mitigation of greenhouse gases by adoption of improved biomass cookstoves

Greenhouse gases especially CO₂ can be reduced with the help of improved biomass cookstoves. This paper deals with the design and development of biomass stoves (single pot and double pot) with better efficiency for meeting household cooking energy requirement. Thermal performance, flue gas emission of carbon monoxide (CO) and carbon dioxide (CO₂) have been investigated. It was seen from the result that the flue gas emission is within permissible limit as recommended by World Health Organization. The design of improved biomass stove sent to Palampur (32^o10’N,76^o30’E) center situated in Himalaya in hilly terrain of India, where the acceptability of double pot stoves (85%) is quite high compared to single pot stoves (30%). Thermal efficiencies of both single and double pot stove were recorded about 21% and 25% respectively. An improved biomass cookstove can save about 161 kg of CO₂ annually. Improved cookstoves was found eco-friendly in nature and suitable for the cooking requirement of hilly areas.     

Reduction behaviors of permanganate by microbial cells and concomitant accumulation of divalent cations of Mg2+, Zn2+, and Co2+

Permanganate treatment is widely used for disinfection of bacteria in surface-contaminated water. In this paper, the fate of the dissolved permanganate in aqueous solution after contact with cells of Pseudomonas fluorescens was studied. Concomitant accumulation of divalent cations of Mg~(2+), Zn~(2+), and Co~(2+) during precipitation of Mn oxides was also studied. The time course of the Mn concentration in solution showed an abrupt decrease after contact of Mn(VII) with microbial cells, followed by an increase after ～ 24 hr.XRD analysis of the precipitated Mn oxides, called biomass Mn oxides, showed the formation of low-crystalline birnessite. Visible spectroscopy and X-ray absorption near edge structure(XANES) analyses indicated that dissolved Mn(VII) was reduced to form biomass Mn oxides involving Mn(IV) and Mn(III), followed by reduction to soluble Mn(II).The numbers of electron transferred from microbial cells to permanganate and to biomass Mn oxides for 24 hr after the contact indicated that the numbers of electron transfer from microbial cell was approximately 50 times higher to dissolved permanganate than to the biomass Mn oxides in present experimental conditions. The 24 hr accumulation of divalent cations during formation of biomass Mn oxides was in the order of Co~(2+) Zn~(2+) Mg~(2+).XANES analysis of Co showed that oxidation of Co~(2+) to Co~(3+) resulted in higher accumulation of Co than Zn and Mg. Thus, treatment of surface water by KMnO_4 solution is effective not only for disinfection of microorganisms, but also for the elimination of metal cations from surface water.     

Soil physi-chemical properties,biomass and nutrient contents of forest litter in mixed plantations of Eucalyptus grandis and three tree species北大核心CSCD

In the present study, we compared the soil physical and chemical properties, biomass of forest litter and nutrient contents in three-and-half-year plantations of E. grandis mixed with Toona ciliate, Alnus formosana, Sassafras tzumu. The results indicated that mixing T. ciliate and A. formosana with E. grandis mitigated soil acidification. In E. grandis × S. tzumu plantations, the soil bulk density decreased, but the moisture capacity and porosity increased. The mixed plantations of E. grandis × S. tzumu significantly increased the soil total C, N, P and K content, by 64.7%, 41.9%, 28.6% and 7.7%, respectively. The mixed plantations of E. grandis × A. formosana also significantly increased the soil total C, N and P content, by 15.2%, 27.9% and 47.6%, respectively. Compared with the pure plantations, the mixed plantations had significantly lower soil hydrolysis N and higher available P content. Only the E. grandis × A. formosana plantations had higher soil available K content. Compared with that in pure plantations, the biomass of branch litter and leaf litter was significantly higher in E. grandis × A. formosana plantations but significantly lower in E. grandis × A. formosana and E. grandis × A. formosana plantations; the biomass of leaf litter and total biomass of litter of E. grandis × S. tzumu were 9.8% and 9.3% respectively lower. The litter C content in three kinds of mixed forest was significantly lower and the litter N content was significantly higher than that in the pure plantations. Only the mixed plantations of E. grandis × A. formosana plantations would increase the content of litter P. The mixed plantations of E. grandis × S. tzumu would increase the content of litter K. In general, S. tzumu is the optimal tree species to mix with E. grandis, followed by A. formosana, but T. ciliate is unsuitble for mixed plantation with E. grandis.     

Individual particle analysis of aerosols collected at Lhasa City in the Tibetan Plateau

To understand the composition and major sources of aerosol particles in Lhasa City on the Tibetan Plateau (TP), individual particles were collected from 2 February to 8 March, 2013 in Tibet University. The mean concentrations of both PM_2.5 and PM₁₀ during the sampling were 25.7 ± 21.7 and 57.2 ± 46.7 μg/m³, respectively, much lower than those of other cities in East and South Asia, but higher than those in the remote region in TP like Nam Co, indicating minor urban pollution. Combining the observations with the meteorological parameters and back trajectory analysis, it was concluded that local sources controlled the pollution during the sampling. Transmission electron microscopy (TEM) combined with energy-dispersive X-ray spectra (EDS) was used to study 408 particles sampled on four days. Based on the EDS analysis, a total of 8 different particle categories were classified for all 408 particles, including Si-rich, Ca-rich, soot, K-rich, Fe-rich, Pb-rich, Al-rich and other particles. The dominant elements were Si, Al and Ca, which were mainly attributed to mineral dust in the earth's crust such as feldspar and clay. Fe-, Pb-, K-, Al-rich particles and soot mainly originated from anthropogenic sources like firework combustion and biomass burning during the sampling. During the sampling, the pollution mainly came from mineral dust, while the celebration ceremony and religious ritual produced a large quantity of anthropogenic metal-bearing particles on 9 and 25 February 2013. Cement particles also had a minor influence. The data obtained in this study can be useful for developing pollution control strategies.     

On-line CO, CO2 emissions evaluation and (benzene, toluene, xylene) determination from experimental burn of tropical biomass

Atmospheric pollution and global warming issues are increasingly becoming major environmental concerns. Fire is one of the significant sources of pollutant gases released into the atmosphere; and tropical biomass fires, which are of particular interest in this study, contribute greatly to the global budget of CO and CO₂. This pioneer research simulates the natural biomass burning strategy in Malaysia using an experimental burning facility. The investigation was conducted on the emissions (CO₂, CO, and Benzene, Toluene, Ethylbenzene, Xylenes (BTEX)) from ten tropical biomass species. The selected species represent the major tropical forests that are frequently subjected to dry forest fire incidents. An experimental burning facility equipped with an on-line gas analyzer was employed to determine the burning emissions. The major emission factors were found to vary among the species, and the specific results were as follows. The moisture content of a particular biomass greatly influenced its emission pattern. The smoke analysis results revealed the existence of BTEX, which were sampled from a combustion chamber by enrichment traps aided with a universal gas sampler. The BTEX were determined by organic solvent extraction followed by GC/MS quantification, the results of which suggested that the biomass burning emission factor contributed significant amounts of benzene, toluene, and m,p-xylene. The modified combustion efficiency (MCE) changed in response to changes in the sample moisture content. Therefore, this study concluded that the emission of some pollutants mainly depends on the burning phase and sample moisture content of the biomass.     

Comparison of three culture methods for Cladophora oligoclona北大核心CSCD

The growth of Cladophora spp. is vigorous in the field, but not good under indoor culture conditions. In order to promote the study on ecology, water environment treatment characteristics, and the development and utilization of Cladophora, the effects of three different culture methods (standing, ventilating, water flowing + ventilating) on biomass, morphology, and photosynthetic activity of C. oligoclona were compared in order to find a suitable method for its indoor culture. The results showed that the culture method of water flowing + ventilating could effectively promote C. oligoclona biomass accumulation; the morphologies in the three culture methods were different. C. oligoclona with increased single cell length and reduced cell diameter was found in the culture method involving water flowing + ventilating; in this method, the length of the main branch and branch of the cell, plant height, and branch length of C. oligoclona were significantly higher than that in the standing and ventilating culture methods (P < 0.05). C. oligoclona cultured in the water flowing + ventilating method also showed a higher photosynthetic activity. In conclusion, among the three culture methods, the water flowing + ventilating culture method is the most suitable for the indoor culturing of C. oligoclona; this method can also provide a technical reference for the further indoor mass culture of C. oligoclona. © 2018 Science Press. All rights reserved.