Surface applied water treatment residuals affect bioavailable phosphorus losses in Florida sands

Water treatment residuals (WTR) can reduce runoff P loss and surface co-application of P-sources and WTR is a practical way of land applying the residuals. In a rainfall simulation study, we evaluated the effects of surface co-applied P-sources and an Al-WTR on runoff and leacheate bioavailable P (BAP) losses from a Florida sand. Four P-sources, namely poultry manure, Boca Raton biosolids (high water-soluble P), Pompano biosolids (moderate water-soluble P), and triple super phosphate (TSP) were surface applied at 56 and 224kgPha(-1) (by weight) to represent low and high soil P loads typical of P- and N-based amendments rates. The treatments further received surface applied WTR at 0 or 10gWTRkg(-1) soil. BAP loss masses were greater in leachate (16.4-536mg) than in runoff (0.91-46mg), but were reduced in runoff and leachate by surface applied WTR. Masses of total BAP lost in the presence of surface applied WTR were less than approximately 75% of BAP losses in the absence of WTR. Total BAP losses from each of the organic sources applied at N-based rates were not greater than P loss from TSP applied at a P-based rate. The BAP loss at the N-based rate of moderate water-soluble P-source (Pompano biosolids) was not greater than BAP losses at the P-based rates of other organic sources tested. The hazards of excess P from applying organic P-sources at N-based rates are not greater than observed at P-based rates of mineral fertilizer. Results suggest that management of the environmental P hazards associated with N-based rates of organic materials in Florida sands is possible by either applying P-sources with WTR or using a moderate water-soluble P-source.     

Review of biosolids management options and co-incineration of a biosolid-derived fuel

This paper reviews current biosolids management options, and identifies incineration as a promising technology. Incineration is attractive both for volume reduction and energy recovery. Reported emissions from the incineration of biosolids were compared to various regulations to identify the challenges and future direction of biosolids incineration research. Most of the gaseous and metal emissions were lower than existing regulations, or could be met by existing technologies. This paper also presents the results of an experimental study to investigate the potential use of biosolids for co-incineration with wood pellets in a conventional wood pellet stove. Pilot scale combustion tests revealed that co-incineration of 10% biosolids with 90% premium grade wood pellets resulted in successful combustion without any significant degradation of efficiency and emissions.     

Field dissipation of 4-nonylphenol, 4-t-octylphenol, triclosan and bisphenol A following land application of biosolids

The persistence of contaminants entering the environment through land application of biosolids needs to be understood to assess the potential risks associated. This study used two biosolids treatments to examine the dissipation of four organic compounds: 4-nonylphenol, 4-t-octylphenol, bisphenol A and triclosan, under field conditions in South Australia. The pattern of dissipation was assessed to determine if a first-order or a biphasic model better described the data. The field dissipation data was compared to previously obtained laboratory degradation data. The concentrations of 4-nonylphenol, 4-t-octylphenol and bisphenol A decreased during the field study, whereas the concentration of triclosan showed no marked decrease. The time taken for 50% of the initial concentration of the compounds in the two biosolids to dissipate (DT50), based on a first-order model, was 257 and 248 d for 4-nonylphenol, 231 and 75 d for 4-t-octylphenol and 289 and 43 d for bisphenol A. These field DT50 values were 10- to 20-times longer for 4-nonylphenol and 4-t-octylphenol and 2.5-times longer for bisphenol A than DT50 values determined in the laboratory. A DT50 value could not be determined for triclosan as this compound showed no marked decrease in concentration. The biphasic model provided a significantly improved fit to the 4-t-octylphenol data in both biosolids treatments, however, for 4-nonylphenol and bisphenol A it only improved the fit for one treatment. This study shows that the use of laboratory experiments to predict field persistence of compounds in biosolids amended soils may greatly overestimate degradation rates and inaccurately predict patterns of dissipation.     

Fast extraction of polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran in sewage sludge and soil samples

The current environmental legislations recommend monitoring chemical contaminants such as polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans before the use of sewage sludge on the agricultural land. In this study, a solid–liquid extraction with low-temperature purification (SLE-LTP) was optimized and validated to determine 2,3,7,8-tetrachlorodibenzo-p-dioxin and 2,3,7,8-tetrachlorodibenzofuran in sewage sludge and soil samples. The analyses were performed by gas chromatography-mass spectrometry operating in the selective ion mode (GC-MS-SIM). Acetonitrile:ethyl acetate 6.5:1.5 (v/v) was the best extraction phase, and the recoveries percentages were close to 100%. The linearity was demonstrated in the range of 1.25–25 µg L^?1 of 1.25–20 µg L^?1 for sewage sludge and soil, respectively. Matrix effect was proved for the two compounds and in the two matrices studied. Extraction percentages were between 78 and 109% and relative standard deviations ≤ 19%. The proposed method is faster than methods described in the literature because showed a few steps. The quantification limits (LOQ) in sewage sludge were 6.4 and 32 ng TEQ kg^?1 for 2,3,7,8-TCDF and 2,3,7,8-TCDD, respectively. In soil, LOQs were 0.8 and 8.0 ng TEQ kg^?1 for 2,3,7,8-TCDF and 2,3,7,8-TCDD, respectively. These values are lower than the maximum residue limits established by European Legislation. The method was applied to 22 agricultural soil samples from different Brazilian cities and 2,3,7,8-TCDF was detected in one of these samples.     

Napropamide Residues in Runoff and Infiltration Water from Pepper Production

Abstract

A field study was conducted on a Lowell silty loam soil of 2.7% organic matter at the Kentucky State University Research Farm, Franklin County, Kentucky. Eighteen universal soil loss equation (USLE) standard plots (22 × 3.7 m each) were established on a 10% slope. Three soil management practices were used: (i) class-A biosolids (sewage sludge), (ii) yard waste compost, each mixed with native soil at a rate of 50 ton acre^?1 on a dry-weight basis, and (iii) a no-mulch (NM) treatment (rototilled bare soil), used for comparison purposes. Devrinol 50-DF “napropamide” [N,N-diethyl-2-(1-naphthyloxy) propionamide]was applied as a preemergent herbicide, incorporated into the soil surface, and the plots were planted with 60-day-old sweet bell pepper seedlings. Napropamide residues one hour following spraying averaged 0.8, 0.4, and 0.3 μ g g^{? 1} dry soil in sewage sludge, yard waste compost, and no-mulch treatments, respectively. Surface runoff water, runoff sediment, and napropamide residues in runoff were significantly reduced by the compost and biosolid treatments. Yard waste compost treatments increased water infiltration and napropamide residues in the vadose zone compared to sewage sludge and NM treatments. Total pepper yields from yard waste compost amended soils (9187 lbs acre^?1) was significantly higher (P < 0.05) than yield from either the soil amended with class-A biosolids (6984 lbs acre^?1) or the no-mulch soil (7162 lbs acre ^?1).     

Leaching of nitrogen, phosphorus, TOC and COD from the biosolids of the municipal wastewater treatment plant of Thessaloniki

Biosolids from the WWTP of Thessaloniki were examined for the leaching of phosphorus (as ), nitrogen (as and ), and organic matter (as TOC and COD), using two tests: (1) a pH static leaching test and (2) a characterization test, relating contaminant release to the liquid to solid (L/S) ratio. Moreover, a Microtox toxicity test was conducted, to examine the pH dependency of the toxicity of the sludge leachate on the Vibrio fischeri bacterium. Maximum phosphorus release was observed at pH < 3 and at pH > 10. Ammonium nitrogen exhibited maximum leachability at near neutral pH conditions, while nitrate nitrogen exhibited a mild increase in the leachate, as the leachant pH increased from 2 to 12. Both TOC and COD exhibited an increase in the leachate concentration, as the leachant pH was increased from 2 to 12. Ecotoxicological analysis showed that maximum toxicity occurred at very low and very high pH-conditions. As liquid-to-solid ratio increased, the leachate concentration (in mg/l) of all parameters studied decreased. The results of the study were used to conduct a release assessment estimate for the case of Thessaloniki.     

Indicators for managing biosolids in Ireland

Sustainable development indicators (SDIs) have emerged as a tool to measure progress towards sustainable development for a number of fields. However, no indicator initiative to date has been aimed at biosolids management at local authority, regional or national levels. This paper presents a study where stakeholders involved in the management of biosolids in Ireland participated in the development of SDIs for managing biosolids at the local/regional level. A significant 81% of participating stakeholders find SDIs either 'useful' or 'very useful' as a tool for managing biosolids. A suite of 22 indicators has been developed and arranged according to the driving force-pressure-state-impact-response (DPSIR) indicator framework. The indicators address all the domains of biosolids management namely, production, quality, cost, legislation/regulation, training/research and recycling/disposal. The stakeholder approach is recognition that no effective indicator set can be developed without the input of stakeholders.     

Determination of three cresol isomers in sewage sludge by solid-liquid extraction with low temperature purification and gas chromatography-mass spectrometry

Abstract

Cresols are chemical contaminants derivative from phenol which can be found in sewage sludge. However, little attention has been given to monitoring these compounds in environmental matrices in the literature. Thus, the objective of this study was to develop a simple method based on solid-liquid extraction with low temperature purification for determining three cresol isomers in sludge. The quantification of these compounds was performed by gas chromatography coupled to mass spectrometry with a previous derivatization step. After a detailed study, the cresol recovery was higher than 91%, with relative standard deviation lower than 12% and a limit of quantification of 20?μg kg^?1. Linearity was achieved between 10 and 90?μg L^?1 (R² > 0.98) with the standard solutions prepared in matrix extracts due to the trouble caused by the matrix effect. The proposed method was applied with success for monitoring cresols in sewage sludge samples coming from six different wastewater treatment plants. All samples showed contamination by cresols, mainly p-cresol with values between 32.3 and 516.9?μg kg^?1. The majority of the analyzed samples showed a total sum of the isomers higher than the maximum residue limit established by Brazilian legislation (160?μg kg^?1).     

A bioeconomic model of afforestation in Southern Ontario: Integration of fiber,carbon and municipal biosolids values

This study explores the economic attractiveness of afforestation as a strategy for the joint production of fibre, carbon storage and biosolids (treated municipal sewage sludge) disposal for municipalities in Southern and Central Ontario, Canada. We use a spatial, stochastic model, the Canadian Forest Service Afforestation Feasibility Model (CFS-AFM), to simulate a range of spatial biosolids application scenarios in hybrid poplar afforestation projects. Results suggest that such joint afforestation strategies could be financially attractive. Significant cost savings can be expected through decreases in transportation distances and avoided waste disposal fees. Sensitivity analysis is used to examine the effects of variations in critical model parameters on net present values. Our findings indicate that waste disposal savings from application of biosolids on hybrid poplar plantations combined with incentives for landowners to sequester carbon can easily compete with agricultural land rental values in some regions of Ontario. Social acceptance of this kind of activity, however, may be an impediment to adoption.