Mitochondrial electron transport chain is involved in microcystin-RR induced tobacco BY-2 cells apoptosis

Microcystin-RR （MC-RR） has been suggested to induce apoptosis in tobacco BY-2 cells through mitochondrial dysfunction including the loss of mitochondrial membrane potential . TO further elucidate the mechanisms involved in MC-RR induced apoptosis in tobacco BY-2 cells, we have investigated the role of mitochondrial electron transport chain （ETC） as a potential source for reactive oxygen species （ROS）. Tobacco BY-2 cells after exposure to MC-RR （60 mg/L） displayed apoptotic changes in association with an increased production of ROS and loss of Am. All of these adverse effects were significantly attenuated by ETC inhibitors including Rotenone （2 μmol/L, complex I inhibitor） and antimycin A （0.01 μmol/L, complex III inhibitor）, but not by thenoyltrifluoroacetone （S μmol/L, complex Ⅱinhibitor）. These results suggest that rnitochondrial ETC plays a key role in mediating MC-RR induced apoptosis in tobacco BY-2 cells through an increased mitochondrial production of ROS.     

石油污染物对海底微生物燃料电池性能的影响及加速降解效应

海底石油污染物在缺氧环境下导致其生物降解过程缓慢,对海洋环境造成长期危害.本文利用海底微生物燃料电池(BMFCs)原理,尝试通过电催化作用提高海底石油污染物的降解速率.对比测试了含油电池装置(BMFCs-A)与无油电池装置(BMFCs-B)的电化学性能,研究了石油污染物对电池性能的影响;比较了含油通路(BMFCs-A)和断路状态下(BMFCs-C)的石油降解率和细菌聚集量,分析了BMFCs对石油污染物降解的加速作用.结果表明,BMFCs-A和BMFCs-B阳极的交换电流密度分别为1.37×10-2A·m-2和1.50×10-3A·m-2,最大输出功率密度分别是105.79 m W·m-2和83.60 m W·m-2,BMFCs-A装置的抗极化能力增强,交换电流密度提高近9倍,最大输出功率密度提高1.27倍.BMFCs-A和BMFCs-C阳极表面的异养菌数量分别是(66±3.61)×107CFU·g-1和(7.3±2.08)×107CFU·g-1,细菌数量增加了8倍,高的异养菌数量导致石油降解加速进行,BMFCs的石油降解率是自然条件下的18.7倍.BMFCs在电化学性能提高的同时,加速石油污染物的降解.本文同时提出了一种海底微生物燃料电池对石油污染物加速降解的新模式.     

SNOW AND ICE ALBEDO MEASURED WITH TWO TYPES OF PYRANOMETERS1

ABSTRACT: In order to obtain total short-wave albedos of snow and ice, both incident and reflected solar radiation were measured over a frozen lake surface using two different types of radiation measurement devices: a Kipp and Zonen thermopile pyranometer with a spectral sensitivity of 300 to 2800 nm and a LI-COR photovoltaic pyranometer with a spectral sensitivity of 400 to 1100 am. The spectral response of the LI-COR pyranometers limits its use as a short-wave radiation measurement device. Therefore, two equations were developed to adjust both the daily incident radiation data and the daily reflected radiation data measured by the LI-COR instrument to total short-wave radiation values, i.e., to the waveband of 300 to 2800 nm (visible to near-infrared spectrum). The LI-COR data were then adjusted, and a total short-wave adjusted albedo was calculated with a modeling efficiency of 0.97.     

Water-saving Technologies,Solar Green House and Ecological Rehabilitation in Minqin Oasis of Gansu Province,China

Land degradation and desertification have become severe environmental problems in arid areas due to excessive use of water resources. It is urgent to reduce agricultural water use for ecological rehabilitation, which may result in a decrease in agricultural production and farmer＇s welfare. This paper focused on the impacts of some main measures including extensions of watersaving irrigation, expanding solar green house and increasing off-farm employment, which are generally recognized to be important to alleviate water shortage and poverty. A bioconomic model is applied taking Minqin Oasis in Gansu Province as a case study site. Simulation results showed that the effect of expanding solar greenhouse was more positive than other ones so it drew more attention. On the view of the different effects between each irrigation zone, mixed policy patterns suitable for them are suggested. In Baqu, expanding solar greenhouse should be the most important, auxiliary with encouraging pipe irrigation. Inversely, with regard to Quanshan, the major attention should be paid to subsidy for pipe irrigation and it would be better to supply the off-farm employment opportunities to the households in Huqu, where the expanding of solar greenhouse should also be summoned. Finally, it should be noted that farmer＇s income would only resume to 90% of the current level in the short run by putting more effort into local policies. Thus, the ecological compensation is needed to ensure farmer＇s welfare.     

Clean fuels from municipal solid waste for fuel cell buses in metropolitan areas

Increasing volumes of municipal solid waste (MSW) pose disposal problems for many cities. Costs are rising as landfilling becomes more difficult. The production of clean transportation fuels (methanol or hydrogen) from MSW is one economically and environmentally promising option for dealing with these problems. An attractive feature is that elimination of essentially all air pollutant emissions is inherent in the process. Current and future air emissions standards should be easily met. Methanol or hydrogen used in fuel cell vehicles (FCV) can help address problems of deteriorating urban air quality due to vehicle pollution and heavy dependence of the transport sector on imported petroleum. Buses are initial targets for commercial application of fuel cells. Coupled with FCVs, MSW could become a major transportation energy resource. For example, less than 25% of New York City's MSW supply would be sufficient to produce the methanol or hydrogen needed to fuel the entire city's bus fleet, if the buses were fuel cell powered. Estimated breakeven tipping fees required for hydrogen or methanol from MSW to compete with the cost of these fuels made from natural gas today are $52 to $89/raw tonne MSW for hydrogen and $64 to $104/raw tonne MSW for methanol (in 1991$), depending on the gasification technology considered. For comparison, the average tipping fee today in New York City is $74/tonne (1991$). Because of the high fuel economies expected for fuel cell buses, total lifecycle costs per bus-km could be lower than for conventional diesel-engine buses.     

Impact of utilizing reflector,single-axis and two-axis sun trackers on the performance of an evacuated tube solar collector

ABSTRACT

In this paper, a novel evacuated tube solar collector (ETSC) is first designed and built. Then, the impact of adding reflector, reflector plus single-axis sun tracker and reflector plus two-axis sun tracker to the built ETSC on the thermal efficiency of the ETSC is evaluated both theoretically and experimentally. In this regard, four identical versions of the proposed ETSC have been built and utilized in four collectors built and presented in this research work. The first collector is the same proposed built ETSC, the second collector is a parabolic trough solar collector comprising one built ETSC and a reflector (ETSC+R), the third collector is composed of one built ETSC, a reflector and a single-axis sun tracker all built in this study (ETSC+R+ ST), and the fourth collector consists of one built ETSC, a reflector and a two-axis sun tracker all built in this study (ETSC+R+ DT). Theoretical basis and concepts of the four collectors are formulated and analyzed in separate subsections. Theoretical results are outlined and highlighted at the end of each subsection. Experimental measurements and data obtained from the operation of the four collectors in the four seasons are presented that point by point verify theoretical results obtained in this study. To provide a comprehensive view, a techno-economic numerical comparison is performed between the four collectors. The following points, which are also the novelty and contributions of this work, are deduced from theoretical concepts, experimental data, and comparison provided in this study:

?There is no technical and economic justification for adding a reflector to an ETSC that results in forming a parabolic trough solar collector (ETSC+R) without any sun tracker.

?There is no economic justification for adding a single-axis sun tracker to a parabolic trough solar collector (ETSC+R).

?There is no economic justification for adding a two-axis sun tracker to a parabolic trough solar collector (ETSC+R).

?Comparing between a two-axis sun tracker and a single-axis sun tracker, adding the single-axis type to a parabolic trough solar collector (ETSC+R) is more advantageous.     

AN INSULATED EVAPORIMETER1

Evaporation was measured from a circular evaporation pan, 18 inches in diameter and 8 inches deep. The pan was insulated on the sides and bottom using 2 inches of freon-blown polyurethane foam. A U.S. Weather Bureau Class A evaporation pan was used to obtain reference evaporation measurements. Water evaporation from the Class A pan and the insulated pan were highly correlated. Using a water-methanol mixture, the insulated pan may be operated at temperatures below 32 F; the equivalent liquid water evaporation may be determined using a regression equation.