UV／TiO2薄膜体系光降解酞酸酯研究

采用自制玻璃负载TiO2薄膜，研究了UV-Vis／TiO2以及UV／TiO2／H2O2体系对2种酞酸酯DBP和DEHP的光催化降解情况。研究结果表明，TiO2在暗处对酞酸酯没有降解作用；UV／TiO2体系能有效光降解DBP和DEHP，TiO2具有明显的光催化作用，增强因子分别为，fDBP=2．06，fDEHP=1．53；在一定浓度范围内DBP在UV／TiO2体系中的降解速率与其初始浓度成负一级动力学关系；UV／TiO2／H2O2体系对DBP的光降解能力远大于UV／TiO2和UV／H2O2体系，H2O2能显著提高TiO2的光催化活性。     

The role of interfacial films in the mass transfer of naphthalene from creosotes to water

Viscous, semi-rigid interfacial films that are formed at the interface of certain multi-component non-aqueous phase liquid (NAPLs) and water can significantly reduce the rates of mass transfer of solutes. Creosote-water systems were investigated for their ability to form interfacial films. The effects of these films on the creosote-water partition and on mass transfer of a representative solute, naphthalene, were investigated in a series of experiments. The area-independent mass transfer coefficient of naphthalene contained in creosote decreased by 30% over a 1-week period in systems containing creosote and water. Further aging for up to 21 days did not result in significant additional decreases in the mass transfer coefficient. The creosote-water partition coefficient, however, did not change with extended contact. The presence of viscous interfacial films in creosote-water systems was demonstrated in pendant drop tests. These interfacial films most likely caused the reduction in solute mass transfer coefficients by providing significant resistance to the diffusion of solutes through the interfacial film. Results from mass transfer experiments conducted under different system conditions suggested that hindered diffusion of naphthalene through the bulk creosote phase, changes in composition of creosote as a result of extended dissolution, or changes in creosote-water interfacial area did not contribute to the decrease in naphthalene mass transfer coefficient.     

多孔陶瓷球负载纳米晶粒二氧化钛光催化剂的制备及光催化活性

以多孔陶瓷球为载体,采用溶胶-凝胶法在其表面进行纳米TiO2薄膜负载,制备了多孔陶瓷球负载纳米晶粒二氧化钛光催化剂,经X射线衍射法(XRD)等手段对其表征结果表明,复合载体经500℃焙烧后,TiO2以锐钛矿晶型存在。对催化剂降解活性艳蓝溶液的催化活性进行研究表明,催化剂在5 h内可完全降解活性艳蓝染料。     

城市污泥薄层干燥特性及动力学研究

通过污泥干燥实验,研究了污泥干燥过程中的形貌变化,考察了泥层厚度、温度、风速对污泥干燥特性的影响,并引入薄层干燥模型,采用MATLAB对污泥干燥的动力学过程进行模拟。结果表明:污泥中网络状的絮体结构不利于水分的蒸发;在泥层厚度为0.4 mm,将污泥含水百分比20%作为干燥终点时,干燥过程为恒速干燥,能够有效地降低干燥时间;提高温度和风速,可以提高污泥水分的表面蒸发速率,减少干燥时间;Page模型比其他模型更适合本次污泥干燥分析。应用Fick扩散模型,得到在温度50~70℃、泥层厚度0.4~2.0 mm条件下有效扩散系数的变化范围为1.13×10-9~8.90×10-9m2/s,并得到了有效扩散系数随厚度、温度变化的关系式。     

Aging properties of extruded high-amylose starch

The structural and mechanical properties of extruded high-amylose and normal cornstarch were studied as a function of time and humidity to determine the suitability of high-amylose cornstarch for use in biodegradable plastic materials. After extrusion at 170°C and 20–30% moisture, high-amylose starch was mostly amorphous, with small amounts of V- and A-type crystal structures. Tensile strengths for the extruded high-amylose starch ribbons were rather stable with time (65, 50, and 35 MPa at 20, 50, and 80% RH) and were higher than those for normal cornstarch (25, 40, and 15 MPa after 84 days at 20, 50, and 80% RH). Elongations at break declined gradually with time for high-amylose starch (6, 11, and 11% after 84 days at 20, 50, and 80% RH), while rapid declines were seen for normal cornstarch at higher humidities (3, 9, and 3% after 84 days at 20, 50, and 80% RH). Differential scanning calorimetry revealed that normal cornstarch aged at a high humidity had much larger sub-T _g endotherms than high-amylose cornstarch. These endotherms reflect decreases in enthalpy and free volume which occur in amorphous polymers due to structural relaxation. It appears, therefore, that plastic materials prepared from gelatinized or melted high-amylose cornstarch should have greater strength and flexibility and slower physical aging than those prepared from gelatinized normal cornstarch.Paper presented at the Bio/Environmentally Degradable Polymer Society—Second National Meeting, August 19–21, 1993, Chicago, Illinois.Product names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable.     

可见光光电-Fenton体系中TiO2薄膜电极的制备及应用

采用可见光光电-Fenton体系对罗丹明B模拟废水进行处理。探讨了自制电解液、阳极氧化时间、煅烧温度、煅烧时间因素对阳极材料-TiO2薄膜电极的制备的影响,以及以此为阳极材料的可见光光电-Fenton体系对污染物的降解效果和光电协同作用,并通过响应面优化实验对制备条件优化。在单因素实验得到了参数取值的粗略范围的基础上,通过响应面优化实验得到了最优的制备条件:电解液0.5%NH4F丙三醇溶液、阳极氧化时间93.26 min、煅烧温度602.89℃、煅烧时间127.49 min,模拟出在该条件下的光电-Fenton去除率为70.78%;对此条件下的TiO2薄膜电极进行光催化和电-Fenton实验,得到光电协同因子为1.92;各因素对光电-Fenton去除率影响大小关系为:阳极氧化时间>煅烧时间>煅烧温度。响应面模型3次验证实验的误差均在5%以内,模型可用。     

Mechanical Performance and Design Criteria of Biodegradable Low-tunnel Films

The overall mechanical behaviour of a series of experimental Mater-Bi made thin low-tunnel films is analysed with respect to the effect of two major factors: the film processing optimisation during manufacturing and the design of the low-tunnels structural system. The analysis of the mechanical behaviour of the biodegradable low-tunnel films, based on the results of extensive full-scale and small-scale experiments, combined with laboratory testing of the mechanical properties of the film, proves that a rather good mechanical behaviour is possible for these films, comparable to the behaviour of conventional agricultural films in terms of strength, provided that two criteria are met: (a) the low tunnel structural design is based on the initial stress at yield value of the film, which represents the asymptotic value of the tensile strength of the film, following its evolution with the time of exposure to real field conditions; (b) the processing of the film is optimised for the particular biodegradable material and film thickness under consideration. It is also confirmed that the stabilisation schemes used with conventional polyethylene films are not suitable for the biodegradable films.

Review of advances in the thin layer chromatography of pesticides: 2012–2014

Publications reporting techniques and applications of thin layer chromatography (planar chromatography) for the separation, detection, qualitative, and quantitative determination, and preparative isolation of pesticides and their metabolites are reviewed for the period from November 1, 2012 to November 1, 2014. Analyses are described for a variety of sample types and pesticide classes. In addition to references on residue analysis, studies such as pesticide structure – retention relationships, identification and characterization of natural and synthesized pesticides, metabolism, bioactivity, degradation, soil mobility, and lipophilicity are covered.     

Evaluation of the mobility of c14‐labelled pesticides in soils by thin layer chromatography using a linear analyser

Abstract

The mobility of seven pesticides in a chromic cambisol soil was studied by soil thin layer chromatography. Pesticide mobilities were determined by means of conventional autoradiographs of the chromatograms, as well as from sequential series of curves and images of the pesticide spots provided by a linear analyser. The R _f values obtained from the autoradiographs and those provided by the linear analyser were quite consistent. Based on such values, pesticide mobility decreased in the following order: acephate > fluometuron > atrazine > ethofumesate > metolachlor > diazinon > glyphosate. According to the mobility scale proposed by Helling and Turner (1968), acephate is highly mobile; atrazine, fluometuron, ethofumesate and metolachlor are moderately mobile; diazinon is slightly mobile; and glyphosate is immobile. The images provided by the linear analyser allow to determine the R _f values for the zones of maximum activity in the pesticide spots (R _f ^max), as well as the activities of different spot zones and those corresponding to R _f and R _f ^max. The results obtained show the image analyser to provide more expeditious R _f measurements from the chromatograms and open up new prospects for using soil TLC to investigate pesticide mobility.     

Review of advances in the thin layer chromatography of pesticides: 2006–2008

Applications of thin layer chromatography and high performance thin layer chromatography for the separation, detection, qualitative and quantitative determination, and preparatire isolation of pesticides and their metabolites are reviewed for the period from July 1, 2006 to November 1, 2008. Analyses are described for a variety of sample types and pesticide classes. In addition to references on residue and formulation analysis, studies such as pesticide-structure relationships, identification and characterization of plant pesticides, metabolism, degradation, mobility, and lipophilicity are covered. Future prospects for pesticide thin layer chromatography are also considered.