Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

海水中阴极极化对X80钢应力腐蚀及氢脆敏感性的影响

目的研究不同p H值海水中阴极极化对X80管线钢应力腐蚀及氢脆的抑制作用。方法采用慢应变速率拉伸试验、电化学测试、微观组织观察等分析方法。结果 X80钢在天然海水中的析氢电位约为-940m V(vs.SCE,下同),海水p H为3.5时析氢电位发生正移。其应力腐蚀敏感性与极化电位有很大关系,随着极化电位负移,X80钢的氢脆敏感性增加。天然海水中当极化电位负于-950 m V时,断口出现准解理断裂特征形貌。在-1050 m V极化电位下,钢材进入氢脆断裂区发生脆性断裂。海水p H为3.5时,-900 m V钢材有发生氢脆的危险。结论与天然海水相比,X80钢在p H为3.5的酸性海水中具有较高的应力腐蚀敏感性,两种海水介质中X80钢的应力腐蚀敏感性均随极化电位负移而增加。     

可靠性强化试验技术在某型伺服作动器研制中的适用性探索

目的探索可靠性强化试验技术在典型机电液一体化产品伺服作动器研制过程中的适用性。方法以某型伺服作动器为研究对象,从故障激发的角度对可靠性强化试验技术的应用进行可行性分析,在响应调查和应力分析的基础上,结合产品的工作特点设计适用于该类伺服作动器的可靠性强化试验方案,包含低温步进应力试验、高温步进应力试验、快速温度循环试验10个循环、振动步进应力试验(包含气锤式三轴向六自由度超高斯随机振动方式及电磁振动台随机振动方式)及综合环境应力试验5个循环,并依此进行试验。结果在快速温度循环试验及综合环境应力试验过程中,均有效地激发出了产品的漏油故障,与相似产品外场暴露的漏油故障模式相吻合。结论可靠性强化试验技术可有效地应用于典型机电液一体化产品伺服作动器的研制过程,设计的可靠性强化试验方案可有效地激发外场出现频率较高的故障,可作为该类产品研制的试验手段之一。     

“天舟一号”货运飞船在轨污染探测数据分析

目的分析"天舟一号"(TZ-1)货运飞船的空间污染探测器的在轨探测数据。方法 TZ-1货运飞船上的污染探测器采用石英晶体微量天平(QCM),利用污染物沉积在QCM探测器传感晶片表面引起的振荡频率变化情况来分析航天器在轨空间污染环境。根据其探测原理,通过分析下传的原始数据,得到航天器在轨的污染累积量结果。结果航天器在轨飞行过程中,污染累积已达到会导致污染敏感器件光学性能明显退化的程度,并且污染源温度是影响航天器污染累积量的一个重要因素,可以将其作为航天器在轨污染控制的重要措施。结论该研究结果可以为航天器污染设计、控制提供参考,为提高航天器可靠性设计提供数据支持。     

A Variance Estimator for Constrained Estimates of Change in Relative Categorical Frequencies

Consistent estimators of change and state becomes an issue when sample data come from a mix of permanent and temporary observation units. A joint maximum likelihood estimator of state and change creates estimates of state that depend on antecedent viz. posterior survey results and may differ from estimates of state derived from a single-date analysis of the sample data. A constrained estimator of change in relative categorical frequencies that eliminates this potential inconsistency is proposed and a model based estimator of their sampling variance is developed. The performance of the constrained estimator is quantified against six criteria and a joint maximum likelihood estimator in simulated sampling from 15 populations with three combinations of permanent and temporary samples, four to six categorical class attributes, and constant size between sampling dates. Bias of the constrained estimators was negligible but larger than for joint maximum likelihood estimators. Mean absolute deviations and variances of constrained estimators were generally at par with the joint estimators. Constrained estimators of root mean square errors and achieved coverage of nominal confidence intervals of constrained estimators were occasionally better. A generalized variance function for the constrained estimates of change is provided as a computational shortcut.     

碱片—离子色谱法测定大气中硫酸盐化速率方法探讨

实验证实碱片－离子色谱测定大气中硫酸盐化速率方法操作简便快速，准确可靠，最低检出浓度可达０．１ｍｇ／Ｌ，可替代碱片－重量法测定。     

固相微萃取-毛细管气相色谱法快速同步分析水中有机氯及有机磷农药

固相微萃取是一种快速、简便,集萃取浓缩进样于一体的样品前处理技术,具有分析时间短、灵敏度高、无需有机溶剂的优点.用固相微萃取富集水中8种有机氯及7种有机磷农药,毛细管气相色谱ECD检测器分离分析,整个分析过程只需26min,检出限可达0.002～1μg/L,已用于地表水中有机氯及有机磷农药含量的测定.     

不同区域城市空气O3和PM2.5累积速率时序模型

利用2017—2018年全国7个区域10个典型城市环境空气O₃和PM_2.5浓度数据，统计污染物累积速率，进而采用回归方法拟合污染物浓度及其累积速率的时间序列模型，分析不同区域污染物时序变化特征差异。结果表明：不同区域O₃浓度时序曲线拟合程度总体高于PM_2.5，石家庄O₃拟合程度最高，西安PM_2.5拟合程度最高。以07：00、14：00分别作为O₃、PM_2.5模拟起点是24 h中的最优模型。不同城市夏季O₃小时浓度时序变化曲线均为单峰形态，O₃浓度及累积速率峰值出现时间可能由城市所处经度决定，太原O₃累积最快，西安O₃消解最快。各城市间冬季PM_2.5小时浓度及其累积速率时序变化曲线形态差异较大，沈阳PM_2.5累积和消解均最快。与浓度相比，城市环境空气O₃和PM_2.5累积速率与光照、扩散条件等有更好的时间相关性。     

雨天硫酸盐化速率样品扩散分析

选择采样期不同降雨天数的碱片，测定余边的硫酸盐化速率含量，其结果为：采样期全月无雨时，余边上的硫酸盐均未检出；半月以上至全月有雨时检出率为１００％，检出量占样品量的２．７０～１５．９５％。经扩散试验，查清了余边上的硫酸盐主要是有效面积上采集的样品的扩散，并提出了相应的修正方法。     

Desert Water Harvesting to Benefit Wildlife: A Simple, Cheap, And Durable Sub-Surface Water Harvester for Remote Locations

A sub-surface desert water harvester was constructed in the sagebrush steppe habitat of south-central Idaho, U.S.A. The desert water harvester utilizes a buried micro-catchment and three buried storage tanks to augment water for wildlife during the dry season. In this region, mean annual precipitation (MAP) ranges between about 150–250 mm (6″–10″), 70% of which falls during the cold season, November to May. Mid-summer through early autumn, June through October, is the dry portion of the year. During this period, the sub-surface water harvester provides supplemental water for wildlife for 30–90 days, depending upon the precipitation that year. The desert water harvester is constructed with commonly available, “over the counter” materials. The micro-catchment is made of a square-shaped, 20 mL. “PERMALON” polyethylene pond liner (approximately 22.9 m × 22.9 m = 523 m²) buried at a depth of about 60 cm. A PVC pipe connects the harvester with two storage tanks and a drinking trough. The total capacity of the water harvester is about 4777 L (1262 U.S. gallons) which includes three underground storage tanks, a trough and pipes. The drinking trough is refined with an access ramp for birds and small animals. The technology is simple, cheap, and durable and can be adapted to other uses, e.g. drip irrigation, short-term water for small livestock, poultry farming etc. The desert water harvester can be used to concentrate and collect water from precipitation and run-off in semi-arid and arid regions. Water harvested in such a relatively small area will not impact the ground water table but it should help to grow small areas of crops or vegetables to aid villagers in self-sufficiency.