二氧化碳的回收和利用

炼油厂的制氢尾气中含有大量二氧化碳，将其分离回收并加以利用具有一定的社会效益和经济效益。     

截流法研究CS2和O3的反应

应用截流法研究了气相CS_2和O_3的反应。研究表明,CS_2和O_3的反应为表观二级反应,在干燥氮气和干燥空气条件下得到反应速率常数k_Ⅱ分别为5.47、5.28 L/(mol·s)。水汽明显加快反应速率。Co_3Ccs_2时,反应最终产物为CO_2、COS和SO_2。并讨论了反应机理。     

沈阳区域环境空气中一氧化氮与二氧化氮时空分布规律

以沈阳区域环境空气监测分析结果为依据 ,分析了 1 994～ 1 998年内空气中一氧化氮与二氧化氮时空分布状况及其变化趋势     

Assessing microbial degradation of o-xylene at field-scale from the reduction in mass flow rate combined with compound-specific isotope analyses

In recent years, natural attenuation (NA) has evolved into a possible remediation alternative, especially in the case of BTEX spills. In order to be approved by the regulators, biodegradation needs to be demonstrated which requires efficient site investigation and monitoring tools. Three methods--the Integral Groundwater Investigation method, the compound-specific isotope analysis (CSIA) and a newly developed combination of both--were used in this work to quantify at field scale the biodegradation of o-xylene at a former gasworks site which is heavily contaminated with BTEX and PAHs. First, the Integral Groundwater Investigation method [Schwarz, R., Ptak, T., Holder, T., Teutsch, G., 1998. Groundwater risk assessment at contaminated sites: a new investigation approach. In: Herbert, M. and Kovar, K. (Editors), GQ'98 Groundwater Quality: Remediation and Protection. IAHS Publication 250, pp. 68-71; COH 4 (2000) 170] was applied, which allows the determination of mass flow rates of o-xylene by integral pumping tests. Concentration time series obtained during pumping at two wells were used to calculate inversely contaminant mass flow rates at the two control planes that are defined by the diameter of the maximum isochrone. A reactive transport model was used within a Monte Carlo approach to identify biodegradation as the dominant process for reduction in the contaminant mass flow rate between the two consecutive control planes. Secondly, compound-specific carbon isotope analyses of o-xylene were performed on the basis of point-scale samples from the same two wells. The Rayleigh equation was used to quantify the degree of biodegradation that occurred between the wells. Thirdly, a combination of the Integral Groundwater Investigation method and the compound-specific isotope analysis was developed and applied. It comprises isotope measurements during the integral pumping tests and the evaluation of delta13C time series by an inversion algorithm to obtain spatially integrated mean isotope values at the control planes. It was shown that the Rayleigh equation is applicable to spatially integrated mean isotope values in order to obtain the mean biodegradation between the consecutive control planes. All three approaches yielded consistently a 98-99% degradation of o-xylene.     

δC variations in tree rings as an indication of severe changes in the urban air quality

Annual growth rings sampled from three free-standing trees (Platanus hybrida sp.), grew in the metropolitan area of Palermo (Italy) and covering a 118 years time span (1880–1998), have been studied for their ¹³C/¹²C carbon isotope ratios. It has been found that the ¹³C/¹²C tree ring record, during the study time interval, decreased of −3.6‰, from −26.4‰ in 1880 to −30‰ in 1998. Such a progressive depletion has been attributed to the addition of anthropogenic ¹³C depleted carbon dioxide to the local atmosphere. The observed ¹³C/¹²C decrease has been used to infer some possible pathways of atmospheric CO₂ change in the study urban area.     

Cyclohexane oxidation and carbon deposition over metal oxide catalysts

Catalytic activity of V, Mn, Ni, Cu, Zn, Mo, Zr and Ce oxides over an -alumina support was evaluated for cyclohexane oxidation under oxygen deficient conditions in order to understand the relation between carbon deposition and catalytic activity/selectivity. Carbon formation over the catalysts during the oxidation reaction was measured by means of Fourier transformed infrared spectroscopy (FTIR). Catalysts Mn/Al₂O₃ and Ce/Al₂O₃, which are selective for deep oxidation of cyclohexane, possessed relatively carbon free surfaces. The catalysts with relatively high carbon deposition (V, Ni, Cu, Zn, Mo and Zr) produced CO in addition to CO₂. Traces of formaldehyde were produced over the catalysts Mo and V.     

火化过程中二噁英类污染物减排技术研究

为减少火化过程中二噁英类污染物的排放,研究了"热交换器 布袋除尘器 活性炭纤维毡"三级组合对火化遗体烟气中二噁英类污染物的去除效果.利用急冷技术将二次燃烧室排出的火化烟气温度降到90～130℃.实验表明,布袋除尘器去除火化烟气中二噁英类污染物的效率为57.4%;布袋除尘器分别与厚度为5、15 mm的活性炭纤维毡组合去除火化烟气中二噁英类污染物的效率分别为64.0%和89.2%.     

Heterogeneity of chlorinated hydrocarbon sorption properties in a sandy aquifer

Hydraulic conductivity and sorption coefficients for chlorinated hydrocarbons (chloroform, carbon tetrachloride and tetrachloroethylene) were evaluated for 216 sediment samples collected across a 15 m transect and a 21 m depth interval in a contaminated aquifer near Schoolcraft, Michigan. Relationships between hydraulic conductivity, linear sorption partition coefficients, grain size classes, and spatial location were investigated using linear regression analysis and geostatistical techniques. Clear evidence of layering was found in sorption properties, hydraulic conductivity and grain sizes. Conductivity correlated well with grain size, as expected, but sorption varied inversely with grain size, contrary to some previous reports. No significant correlation was found between sorption properties and hydraulic conductivity. This is likely due to the unexpected presence of small amounts of highly sorptive coal-like solids, which dominate the sorption behavior but have little effect on conductivity. The results demonstrate that recent findings regarding the high sorption capacity of coal materials found in soils can exert a controlling influence on contaminant transport. Designers of in situ remediation systems should be cautioned that 1) it is not reasonable to assume that sorption capacity and hydraulic conductivity are related, 2) sorption capacity and hydraulic conductivity are critical measurements for contaminant site characterization and subsequent transport modeling, 3) estimating sorption capacity from organic carbon measurement may lead to greater errors than performing sorption isotherms, and 4) it is more important to characterize vertical heterogeneity rather than horizontal heterogeneity because both sorption and hydraulic conductivity are correlated across longer distances in the horizontal plane.     

COS,CS2 and SO2 in aluminium smelter exhaust

Measurements of carbonyl sulfide (COS) and carbondisulfide (CS₂) were carried out on samples drawn from a smoke stack of an aluminium smelter. Volume mixing ratios of 6 ppm COS and 0.1 ppm CS₂ were measured for gases from the electrolysis unit that had previously passed an Al₂O₃ fluid bed reactor and electrostatic precipitators. Specific emissions of 1.6 kg COS and 0.03 kg CS₂ per ton of primary aluminium were found. Extrapolating from this particular smelter’s conditions to a world mix specific COS emissions of about 4 kg/t(Al) are calculated resulting in emissions of annually 0.08 Tg COS into the atmosphere due to electrolytic aluminium production in 1995. Besides the photochemical conversion of anthropogenic CS₂ aluminium production is established to be the second major industrial source of COS probably exceeding automotive tire wear’s and coal combustion’s contributions.     

Monitoring trichloroethene remediation at an iron permeable reactive barrier using stable carbon isotopic analysis

Stable carbon isotopic analysis, in combination with compositional analysis, was used to evaluate the performance of an iron permeable reactive barrier (PRB) for the remediation of ground water contaminated with trichloroethene (TCE) at Spill Site 7 (SS7), F.E. Warren Air Force Base, Wyoming. Compositional data indicated that although the PRB appeared to be reducing TCE to concentrations below treatment goals within and immediately downgradient of the PRB, concentrations remained higher than expected at wells further downgradient (i.e. >9 m) of the PRB. At two wells downgradient of the PRB, TCE concentrations were comparable to upgradient values, and delta13C values of TCE at these wells were not significantly different than upgradient values. Since the process of sorption/desorption does not significantly fractionate carbon isotope values, this suggests that the TCE observed at these wells is desorbing from local aquifer materials and was present before the PRB was installed. In contrast, three other downgradient wells show significantly more enriched delta13C values compared to the upgradient mean. In addition, delta13C values for the degradation products of TCE, cis-dichloroethene and vinyl chloride, show fractionation patterns expected for the products of the reductive dechlorination of TCE. Since concentrations of both TCE and degradation products drop to below detection limit in wells within the PRB and directly below it, these downgradient chlorinated hydrocarbon concentrations are attributed to desorption from local aquifer material. The carbon isotope values indicate that this dissolved contaminant is subject to local degradation, likely due to in situ microbial activity.