一种新材料在城市生活垃圾卫生填埋场中的应用

针对我国目前垃圾填埋场存在的问题 ,提出推广应用一种新型的复合土工合成材料 (GCL)。简要介绍了GCL的结构及水力特性 ,图解说明了GCL在垃圾填埋场中的各种应用 ,并与CCL、GM相比较 ,说明了GCL在垃圾填埋场中的应用优势     

Variation of crack intensity factor in three compacted clay liners exposed to annual cycle of atmospheric conditions with and without geotextile cover

Performance of compacted clay liners commonly used as landfill barrier systems can be subject to decline in terms of hydraulic conductivity if left exposed to atmospheric conditions for an extended period of time prior to placement of overlaying layers. The resulting desiccation cracking can lead to increased hydraulic conductivity. Desiccation crack intensity was studied for three clayey soils commonly used for construction of landfill barrier system in a relatively large scale test setup exposed to real time atmospheric conditions over a complete annual cycle. A white separator geotextile cover was presumed to be capable of reducing the intensity of desiccation cracking through absorbing and maintaining higher amounts of moisture and reducing the temperature of the soil surface in comparison to a directly exposed soil surface. Desiccation cracking was monitored using a digital imaging technique for three compacted clay liners in two sets, one open to air and the second covered with the white geotextile. Crack intensity factor approached a relatively stable phase after certain cycles corresponding to atmospheric dry wet cycles. The results indicated that the white separator geotextile was capable of reducing the crack intensity factor by 37.4–45.9% throughout the experiment including the cyclic phase of desiccation cracking. During the stable phase, the maximum reduction in crack intensity factor of 90.4% as a result of applying geotextile cover was observed for the soil with the lowest plastic index and clay content and therefore the lowest magnitude of crack intensity factor. The other two soils with similar clay content but different plastic index showed 23.6% and 52.2% reductions in crack intensity factor after cyclic phase when covered with geotextile.     

城市污泥对不同质地土壤保水效果研究

利用城市污泥滞水性强的特性可开发污泥作为保水剂的新功能。通过土培实验,在砂土、壤土和粘土中加入不同质量的污泥,研究污泥对不同质地土壤的保水效果。结果表明:在充分供水条件下,添加污泥能显著提高3种质地土壤的持水能力,土壤中添加20%的污泥后,砂土、粘土和壤土初始含水率分别增加11.2%、8.7%和8.8%;在3种质地土壤中添加污泥均可增大土壤的保水性,使水分蒸发减慢,且污泥添加量越多,土壤含水率越大;土壤累积失水量主要受到土壤中含水量的影响,也和不同质地土壤自身的蒸发量有关;在150 g土壤中添加10 g污泥,对砂土保水性提高不大,对壤土保水性提高最大,随着添加污泥量的增多,污泥对砂土的保水效果提高最明显。研究表明:开发污泥做为保水剂是可行的,这为污泥的资源化利用提供了新的途径,也为复合保水剂的研制提供了新的廉价材料,对于污泥治理及农业节水都有重要意义。     

Coupled modeling of cement/claystone interactions and radionuclide migration

The interactions between cement and a clayey host-rock of an underground repository for intermediate-level radioactive waste are studied with the reactive transport code HYTEC for supporting performance assessment. Care is taken in using relevant time scales (100,000 years) and dimensions. Based on a literature review, three hypotheses are considered with respect to the mineralogical composition of the claystone and the neo-formed phases. In the long term, the pH is buffered for all hypotheses and important mineral transformations occur both in cement and the host-rock. The destruction of the primary minerals is localized close to the cement/claystone interface and is characterized by the precipitation of secondary phases with retention properties (illite, zeolite). However, beyond the zone of intense mineral transformations, the pore water chemistry is also disturbed over a dozen meters due to an attenuated but continuous flux of hydroxyl, potassium and calcium ions. Four interdependent mechanisms control the profile in the whole system: diffusion of the alkaline plume, mineralogical buffering, ion exchange and clogging of the pore space at the cement/claystone interface. The migration of a selected group of radionuclides (Cs, Ra, Tc and U) is explicitly integrated in the simulations of the strongly coupled system. Theoretical profiles of distribution coefficient (Kd) and solubility limit values are derived from the simulations, and their sensitivity with respect to the system evolution is estimated.     

Modeling of non-reactive solute transport in fractured clayey till during variable flow rate and time

Fractures and biopores can act as preferential flow paths in clay aquitards and may rapidly transmit contaminants into underlying aquifers. Reliable numerical models for assessment of groundwater contamination from such aquitards are needed for planning, regulatory and remediation purposes. In this investigation, high resolution preferential water-saturated flow and bromide transport data were used to evaluate the suitability of equivalent porous medium (EPM), dual porosity (DP) and discrete fracture/matrix diffusion (DFMD) numerical modeling approaches for assessment of flow and non-reactive solute transport in clayey till. The experimental data were obtained from four large undisturbed soil columns (taken from 1.5 to 3.5 m depth) in which biopores and channels along fractures controlled 96-99% of water-saturated flow. Simulating the transport data with the EPM effective porosity model (FRACTRAN in EPM mode) was not successful because calibrated effective porosity for the same column had to be varied up to 1 order of magnitude in order to simulate solute breakthrough for the applied flow rates between 11 and 49 mm/day. Attempts to simulate the same data with the DP models CXTFIT and MODFLOW/MT3D were also unsuccessful because fitted values for dispersion, mobile zone porosity, and mass transfer coefficient between mobile and immobile zones varied several orders of magnitude for the different flow rates, and because dispersion values were furthermore not physically realistic. Only the DFMD modeling approach (FRACTRAN in DFMD mode) was capable to simulate the observed changes in solute transport behavior during alternating flow rate without changing values of calibrated fracture spacing and fracture aperture to represent the macropores.     

浓度变化时复合衬层中有机污染物的一维扩散分析

在考虑填埋场有机污染物浓度随时间变化的基础上,对有机污染物在复合衬层中的一维扩散问题进行了解析求解.计算模型考虑了2种常见的下边界条件,即零浓度下边界及零通量下边界.计算模型亦考虑了污染物在各介质中的背景浓度.利用该解析解得到的结果和已有的试验结果较为接近.对于美国规范规定的标准复合衬层,当污染物在膜中的扩散系数达到1.0×10-13m2·s-1且膜的分配系数达到50时,基本上可以忽略土工膜作为有机污染物扩散屏障的作用;对于同样的复合衬层,若膜的扩散系数达到1.0×10-12m2·s-1,则膜分配系数只需达到5即可忽略土工膜作为有机污染物扩散屏障的作用.对于标准复合衬层及GM GCL复合衬层,膜分配系数的变化对有机污染物通量击穿曲线的影响较大,而膜扩散系数对其的影响则相对较小.     

利用生活垃圾填埋场上建设飞灰固化物填埋场适宜性探讨

针对利用原有生活垃圾填埋场改扩建飞灰固化物填埋场,从勘查设计和建设角度,通过与常规生活垃圾填埋的安全和环保各相关因素对比,分析扩建前后填埋场稳定性、防渗及导排系统等勘察设计要点,研讨扩建工程新老填埋堆体基础层、防渗及导排系统等安全环保关键技术及扩建的适宜性,为扩建的可行性研究提出较为系统的技术论证思路.     

Analysis of a gas-phase partitioning tracer test conducted in an unsaturated fractured-clay formation

The gas-phase partitioning tracer method was used to estimate non-aqueous phase liquid (NAPL), water, and air saturations in the vadose zone at a chlorinated-solvent contaminated field site in Tucson, AZ. The tracer test was conducted in a fractured-clay system that is the confining layer for the underlying regional aquifer. Three suites of three tracers were injected into wells located 14, 24, and 24 m from a single, central extraction well. The tracers comprised noble gases (traditionally thought to be nonsorbing), alkanes (primarily water partitioning), perfluorides (primarily NAPL partitioning), and halons (both NAPL and water partitioning). Observations of vacuum response were consistent with flow in a fractured system. The halon tracers exhibited the greatest amount of retardation, and helium and the perfluoride tracers the least. The alkane tracers were unexpectedly more retarded than the perfluoride tracers, indicating low NAPL saturations and high water saturations. An NAPL saturation of 0.01, water saturation of 0.215, and gas saturation of 0.775 was estimated based on analysis of the suite of tracers comprising helium, perfluoromethylcyclohexane and dibromodifluoromethane, which was considered to be the most robust set. The estimated saturations compare reasonably well to independently determined values.     

Effect of clay minerals on extractability of heavy metals and sewage sludge mineralization in soil

An incubation experiment lasting 111 d was carried out to study the effect of the addition of three clay minerals (Na-bentonite, Ca-bentonite, and zeolite) to soil derived from sewage sludge on water-extractable and exchangeable forms of four heavy metals (Zn, Cd, Cu, and Ni), as well as on soil organic matter mineralization, microbial biomass C and the release of inorganic N. The addition of clay minerals led to a significant decrease in water-extractable and exchangeable forms of heavy metals. The extent of decrease ranged from 14 to 75% for the water-extractable heavy metals and from 12 to 42% for the exchangeable form over the incubation time, as compared with untreated soil. The reduction in extractability of heavy metals was greater due to the addition of Na-bentonite and Ca-bentonite than that due to the addition of zeolite. Addition of clay minerals did not affect any of the following microbiological parameters in the soil: microbial biomass C, organic C (C_org) mineralization, and metabolic quotient (qCO₂), and release of inorganic N during the first 3 weeks of incubation. However, as the incubation period increased, these parameters were significantly increased by the addition of clay minerals, especially by the addition of Na-bentonite and Ca-bentonite. This result is explained by a strong reduction in extractability of heavy metals after the addition of Na-bentonite and Ca-bentonite.     

Utilization of sepiolite materials as a bottom liner material in solid waste landfills

Landfill bottom liners are generally constructed with natural clay soils due to their high strength and low hydraulic conductivity characteristics. However, in recent years it is increasingly difficult to find locally available clay soils that satisfy the required engineering properties. Fine grained soils such as sepiolite and zeolite may be used as alternative materials in the constructions of landfill bottom liners. A study was conducted to investigate the feasibility of using natural clay rich in kaolinite, sepiolite, zeolite, and their mixtures as a bottom liner material. Unconfined compression tests, swell tests, hydraulic conductivity tests, batch and column adsorption tests were performed on each type of soil and sepiolite–zeolite mixtures. The results of the current study indicate that sepiolite is the dominant material that affects both the geomechanical and geoenvironmental properties of these alternative liners. An increase in sepiolite content in the sepiolite–zeolite mixtures increased the strength, swelling potential and metal adsorption capacities of the soil mixtures. Moreover, hydraulic conductivity of the mixtures decreased significantly with the addition of sepiolite. The utilization of sepiolite–zeolite materials as a bottom liner material allowed for thinner liners with some reduction in construction costs compared to use of a kaolinite-rich clay.