西安市工业燃煤汞排放清单

依据燃煤汞含量、燃煤汞排放因子和西安市工业行业燃煤消费量建立西安市燃煤大气汞排放清单。2003年西安市工业燃煤汞大气排放量为0.33t,热电厂、化学品制造和造纸业是燃煤汞大气排放的最主要行业,其中热电厂占42.0%。排放清单的建立为西安市制定燃煤大气汞污染调控措施和评价燃煤汞污染的环境风险提供了科学的基础依据。     

Pyrolysis characteristics of the mixture of printed circuit board scraps and coal powder

Thermogravimetric (TG) analysis and infrared spectroscopy were used to analyze the pyrolysis characteristics of printed circuit board scraps (PCBs), coal powder and their mixtures under nitrogen atmosphere. The experimental results show that there is a large difference between waste PCBs and coal powder in pyrolysis processing. The pyrolysis properties of the mixing samples are the result of interaction of the PCBs and coal powder, which is influenced by the content of mixture. The degree of pyrolysis and pyrolysis properties of the mixture are much better than that of the single component. The TG and the differential thermogravimetric (DTG) curves of the PCBs mixed with coal powder move towards the high-temperature zone with increasing amount of coal powder and subsequently the DTG peak also becomes wider. The Coats–Redfern integral method was used to determine the kinetic parameters of pyrolysis reaction mechanism with the different proportion of mixture. The gas of pyrolysis mainly composes of CO₂, CO, H₂O and some hydrocarbon. The bromide characteristic absorption peak has been detected obviously in the pyrolysis gas of PCBs. On the contrary, the absorption peak of the bromide is not obvious in pyrolysis gas of the PCBs samples adding 40% coal powder.     

Risk management and workers’ safety behavior control in coal mine

According to the risk management characteristics and the actual needs of safety production in coal mine, we thoroughly analyze the system of risk management method in coal mine and implement it in Geting Coal Mine. The system manages and controls the potential accident risks, hazard sources and human behavior risks. On this basis, the system of workers’ safety behavior control technology in coal mine is further studied, the “three disobeying” is classified and managed, the “three disobeying” database and safety countermeasures database are established, and the application software - the system of risk management and safety countermeasures optimization in coal mine based on B/S mode is developed and applied, which uses intranet to analyze and supervise the “three disobeying”, publish early-warning information, optimize management and control countermeasures; at the same time, the important prompting messages can be automatically sent to the mobile phones of relevant managers and the person in charge through public communication system in order to improve the real time capability and effectiveness of unsafe behavior control. The technological system and application software implemented in Geting Coal Mine has achieved good results.     

A CART technique to adjust production from longwall coal operations under ventilation constraints

Methane emissions in longwall coal mines can arise from a variety of geologic and production factors, where ventilation and degasification are primary control measures to prevent excessive methane levels. However, poor ventilation practices or inadequate ventilation may result in accumulation of dangerous methane-air mixtures. The need exists for a set of rules and a model to be used as guidelines to adjust coal production according to expected methane emissions and current ventilation conditions.In this paper, hierarchical classification and regression tree (CART) analyses are performed as nonparametric modeling efforts to predict methane emissions that can arise during extraction of a longwall panel. These emissions are predicted for a range of coal productivities while considering specific operational, panel design and geologic parameters such as gas content, proximate composition of coal, seam height, panel width, cut height, cut depth, and panel size. Analyses are conducted for longwall mines with and without degasification of the longwall panel. These models define a range of coal productivities that can be achieved without exceeding specified emissions rates under given operating and geological conditions.Finally, the technique was applied to longwall mines that operate with and without degasification system to demonstrate its use and predictive capability. The predicted results proved to be close to the actual measurements to estimate ventilation requirements. Thus, the CART-based model that is given in this paper can be used to predict methane emission rates and to adjust operation parameters under ventilation constrains in longwall mining.     

Study of coal oxidation behaviour in re-opened sealed heating

Possible changes in the oxidation behaviour of coal in the spontaneous combustion site of re-opened sealed heating were studied. Two samples of bituminous coal and three types of coal pre-treatment procedures were applied to simulate in situ conditions at the “spon-com” site: i) pre-oxidation of coal, ii) pre-heating of coal under inert gas, and iii) immersion of pre-heated coal in liquid water. Pre-treated samples were then examined for the production rate of the indication gases evolved during oxidation and for oxidation heat effects. Two main conclusions were drawn with respect to oxidation of the coal in re-opened sealed heating: i) carbon monoxide and unsaturated hydrocarbons maintain their relevance as spontaneous combustion indication gases, however, increased production of both carbon oxides can be expected; ii) coal in the extinguished spontaneous combustion site gains increased susceptibility to the self-heating process.     

Life cycle assessment of sewage sludge co-incineration in a coal-based power station

A life cycle assessment was conducted to evaluate the environmental and economic effects of sewage sludge co-incineration in a coal-fired power plant. The general approach employed by a coal-fired power plant was also assessed as control. Sewage sludge co-incineration technology causes greater environmental burden than does coal-based energy production technology because of the additional electricity consumption and wastewater treatment required for the pretreatment of sewage sludge, direct emissions from sludge incineration, and incinerated ash disposal processes. However, sewage sludge co-incineration presents higher economic benefits because of electricity subsidies and the income generating potential of sludge. Environmental assessment results indicate that sewage sludge co-incineration is unsuitable for mitigating the increasing pressure brought on by sewage sludge pollution. Reducing the overall environmental effect of sludge co-incineration power stations necessitates increasing net coal consumption efficiency, incinerated ash reuse rate, dedust system efficiency, and sludge water content rate.     

基于半荒漠脆弱生态环境下煤矿开采环境综合治理研究

煤矿开发对周围环境产生的破坏及衍生、次生灾害不断增加。人类对此的认识和对相关领域的研究不断全面和深入。结合煤矿开采对环境的直接及间接影响,本文从根本上对半荒漠环境下的煤矿开采环境保护提出了一些针对性的措施,对于内蒙、新疆等类似地区的煤矿开采提供参考。     

煤矿开采对地下水资源的影响及对策

煤矿开采通常会对地下水环境产生重要影响,本文根据崔木井田地下水的赋存特征,通过分析煤矿开采过程对地下水资源的影响程度,提出了保护具有区域供水意义的洛河组含水层的控制对策。     

一种封闭式选煤车间的设计

近年来,随着国家对煤炭行业控制环境污染的条件越来越严格,为了更有效的治理煤场环境污染,改善煤场周边地区环境质量,根据国内已建成的大型封闭厂房的设计经验,提出一种封闭式煤炭风选车间,车间采用轻型门式钢架结构设计,常规经济柱距6m,抗风柱柱距7．5m,室内净高10m。工程长度90m,跨度35m,屋盖系统采用钢桁架结构体系,单层压型彩色钢板封闭。封闭车间同时配套通风除尘系统,有效降低煤尘量。     

煤焦油加工废气治理方法简述

煤焦油加工项目属于重污染行业,产生的废气大部分有致癌作用,必须做好配套的环保设施和安全设施,本文介绍了煤焦油加工过程中废气产生及防治对策,减少环境污染。