Spectrum characteristics analysis of microseismic signals transmitting between coal bedding

This study was performed to investigate the propagation law of microseismic signals transmitting along the direction parallel and vertical to the bedding in the process of coal rock rupture under uniaxial compression. Microseismic signals during the whole process of coal-rock deformation fracture until burst failure was tested by using the coal rock rupture microseismic experimental system. The empirical mode decomposition graphic, Hilbert spectrum and time-frequency spectrum were obtained by using Hilbert-Huang Transform or HHT. Also the microseismic signals transmitting along the direction parallel and vertical to the bedding in the process of coal rock rupture were spectrum comparative analyzed with EMD analysis method. Results show that amplitude and velocity of microseismic signals changed very small along the parallel direction to bedding in the process of propagation, but microseismic signals delayed and amplitude weakened obviously along the vertical direction to bedding. Signal delay and signal attenuation were confirmed that bedding impact on microseismic wave transmitting.     

Mechanism research on coal and gas outburst during vibration blasting

The coal and gas outburst results from plenty of factors, while vibration is the most important factor among them. Therefore, the influences of vibration acting on gas desorption and coal structure had been conducted. And the mechanism of coal and gas outburst induced by vibration was illustrated through examples. The results showed that the gas desorption accelerates under the action of vibration, and then the gas gradient increases. Meanwhile, vibration would increase and expand fractures in the internal coal body, which aggravates the risk of coal and gas outburst greatly. In conclusion, vibration is a more important factor attributable to coal and gas outburst compared with other coal mining method, mining technology and construction method.     

Experimental study on oxygen consumption rate of residual coal in goaf

In order to research the actual oxygen consumption rate of residual coal in goaf, the heating and oxidizing experiment was conducted respectively on five types of single particle size of coal samples and one hybrid particle size of coal samples by using self-developed CSC-B2 test system. This study measured inlet and outlet oxygen concentration of the oxidation tank, and calculated the oxygen consumption rate of each coal sample at different temperatures. For the residual coal in the same goaf, which is regarded as a hybrid particle size of coal consisting of a variety of single granularity of coal, its oxygen consumption rate is the mass weighted average of the rate of each particle size of coal. Accordingly, this paper established the equation of oxygen consumption rate of hybrid particle size of coal samples, taking into account temperature, granularity and oxygen concentration. Then comparison between the calculated value and the actually measured value of oxygen consumption rate of hybrid particle size of coal samples at different temperatures was conducted. And the results reveal that the calculated value basically coincide with the actually measured one. Moreover, the results prove that the established calculation formula for oxygen consumption rate can be used to accurately calculate the actual oxygen consumption rate of residual coal samples. The achievement of this research is of theoretical and practical significance for learning about the characteristics of coal spontaneous combustion and forecasting the self-ignition of residual coal in goaf.     

Simulation analysis on structure safety of coal mine mobile refuge chamber under explosion load

In order to check structural strength of coal mine mobiles refuge chamber, and do security evaluation of the mobile refuge chamber, a refuge chamber model was established, then a finite element method was instituted for it to ensure the refuge chamber would not be severely damaged when gas or coal dust explosion suddenly happened. A triangle shock wave with 1.2 MPa over-pressure, 300 ms lasting time was settled. Explicit nonlinear dynamic analysis program was used to simulate response of the refuge chamber. The maximum stress was 244 MPa, located in central part of sides and tail end of the last capsule. The maximum displacement was 29.32 mm, located in central part of sides and tail end of the last capsule. The calculation indicated that the refuge chamber was not obviously damaged. It could reliable work to meet safety requirements. Compared with the reported experimental results, the simulation method was verified. Based on analysis, suggestions were put forward for further improving.     

韩桥煤矿-330m水平泵房水泵水垢产生成因研究

2003年4月,徐州矿务集团韩桥煤矿-330m水平泵房出现严重的结垢.首先用X-衍射分析仪对水垢成分进行测试,然后对矿井水的水化学和微生物特征分3个不同时段(2003年4月、2003年10月、2004年4月)采样、测试,并利用水质模拟软件PHREEQC计算方解石、文石、白云石的饱和指数.通过综合对比分析,对水泵结垢原因进行了追踪研究.结果表明,水垢主要成分以碳酸盐水垢为主,微生物主要为球菌和杆菌,水泵结垢与微生物无直接关系;矿井停采前,-330m水平水质类型为SO4-Ca-Mg,SO24-质量浓度高达1613·90mg/L,pH=6.71,矿井停采后,2003年4-10月,-330m东巷水质类型变化为SO4-HCO3-Ca-Mg,其中HCO-3、(K Na )质量浓度明显上升,pH值明显上升,尤其在2003年4月达到最高,为8·36.2003年10月-2004年4月,水质类型又变化为SO4-Ca-Mg,pH值下降为6.35～7.02.综合分析认为,矿井地面某造纸厂碱性污水渗漏引起pH值升高是结垢的主要原因.     

Arsenic content and distribution pattern in Chinese coals

About 500 samples of coal, pyritic coal balls, pyritic gangue and coal seam gangue were collected from different coal basins and geologic periods of coal formation to determine the arsenic (As) content and distribution pattern in China. The Permian-Carboniferous and Jurassic coals in the North China Plate and Northwest China account for nearly 85% of total Chinese coal reserves and data showed that As content ranged from 0.1 to 94?mg?kg^?1, with the majority between 1 and 14.9?mg?kg^?1. The As content of some Late Permian coals in Southwest Guizhou Province and stone coal in the South Qinling Mountain area were exceedingly high (30–534?mg?kg^?1), but the majority of coal in the Southwest Guizhou Province contained low to medium amounts. Only the coals, which are situated in or near igneous rocks and are not considered a part of Chinese coal reserves, possessed unusually high As content (>30?mg?kg^?1). Arsenic was also concentrated in pyritic coal balls and the pyritic gangue of the coal seam with values ranging from 21.5 to 142.46?mg?kg^?1 and an average of 69?mg?kg^?1 in Shaanxi and 78?mg?kg^?1 in Shandong. Arsenic contents in coal gangue in the Northwest and North China Plate is about 0.2–15?mg?kg^?1, a little lower than coals in the same seam. Washing gangue (waste from coal washing) generally contained more As than coal, because the washed gangue has more pyrite than the natural gangue (black shale). Washing coal reduced the content of the pyritic sulfur, heavy metals and As. Based on amounts of coal used with different As content in Chinese coal reserves, the average As content of Chinese coals is about 4.5?mg?kg^?1.     

Treatment of dyeing wastewater using coal fly ash as co-coagulant

This article deals with the co-coagulation of dyeing wastewater by coal fly ash using FeSO₄ as coagulant, Benzo Scarlet 4BS and Brilliant Acid Scarlet 3R as the testing dyes. The optimal concentration of FeSO₄ for co-coagulation process is 0.6–0.8?g/L wastewater, and the concentration of fly ash 4–5?g/L. The experimental results show that the co-coagulation process by fly ash helps to improve the color reduction, greatly accelerate the formation and settling of the floc, and reduce the content of the floc. The mechanism for co-coagulation process is discussed and similar effect is obtained when the co-coagulation method is applied for the treatment of the real dyeing wastewater samples.     

西部开发中的煤矿区生态环境保护与重建问题

分析了西部尤其是西北地区煤矿区生态环境坡坏的现状，确定了矿区重庆重建工程的目标，提出了矿区生态环境保护与重建的具体措施。     

Flame propagation in hybrid mixture of coal dust and methane

To investigate the flame propagation through hybrid mixture of coal dust and methane in a combustion chamber, a high-speed video camera with a microscopic lens and a Schlieren optical system were used to record the flame propagation process and to obtain the direct light emission photographs. Flame temperature was detected by a fine thermocouple. The suspended coal dust in the mixture of methane and air was ignited by an electric spark. The flame propagation speeds and maximum flame temperatures of the mixture were analyzed. The results show that the co-presence of coal dust and methane improves the flame propagation speed and maximum flame temperature notably, which become much higher than that of the single-coal dust flame. The flame front temperature varies with the coal dust concentration.     

塑性石膏浆防治煤炭自燃性能研究

综述了国内外喷注型浆体防煤自燃技术的现状和发展趋势,通过实验,得出塑性石膏浆的配制方案和堵漏风效果。结果表明：在井下高湿环境中,塑性石膏浆不仅具有良好的附着性、充填性和保塑性,而且用料单一、成本较低、无毒无害,满足防治煤炭自燃对喷注型材料的基本要求,有利于提高煤矿生产的安全保障程度。