烧碱装置降膜蒸发器的腐蚀检查

铢覆层下腐蚀(碱腐蚀和碱应力腐蚀开裂)严重影响烧碱装置降膜蒸发器的安全运行。分析一起降膜蒸发器泄漏案例,发现分离器与管板角焊缝碱应力腐蚀破裂的主要原因是镍覆层焊缝存在贯穿性气孔,认为高浓度碱溶液环境中镍覆层致密性的检查和评价对镍-钢复合板设备安全运行具有重要意义。总结降膜蒸发器管束、管程壳体、焊接接头等部位镍覆层致密性失效导致的腐蚀损伤,提出了重点部位腐蚀检查的技术要求。     

油田化学添加剂对污水处理系统腐蚀行为的影响

目的明确净水剂、絮凝剂、助凝剂、缓蚀剂对污水处理系统腐蚀行为的作用效果。方法通过工艺流程分析、腐蚀形貌观察、腐蚀产物成分分析、腐蚀失重测试等手段,分析污水处理系统腐蚀原因,考察油田化学添加剂对SSF污水处理系统腐蚀行为的影响。结果输送介质中溶解的二氧化碳、高浓度氯离子、氧是导致SSF净化装置内腐蚀的主要原因。分别添加质量浓度为150、0.3、60 mg/L的净水剂、絮凝剂、助凝剂后,动态腐蚀速率可从1.8544 mm/a降到0.6674、0.8627、0.3530 mm/a,静态腐蚀速率可从1.2515 mm/a降到0.9565、0.9474、0.6256 mm/a。添加160 mg/L缓蚀剂,动态腐蚀速率从1.8544 mm/a降低到0.0822 mm/a,静态腐蚀速率从1.2515 mm/a降低到0.0238 mm/a。同时添加净水剂、絮凝剂、助凝剂三种药剂,动态腐蚀速率为0.7672 mm/a,静态腐蚀速率为0.8742 mm/a;同时添加净水剂、絮凝剂、助凝剂、缓蚀剂四种药剂,动态腐蚀速率为0.3069 mm/a,静态腐蚀速率为0.0263 mm/a。结论添加缓蚀剂能有效控制SSF污水处理系统内腐蚀。污水处理用净水剂、絮凝剂、助凝剂对腐蚀有一定抑制作用。在动态条件下,净水剂、絮凝剂、助凝剂降低了缓蚀剂的缓蚀效果,在静态条件下,三种添加剂对缓蚀剂的缓蚀效果影响较小。     

Evaluation of the spontaneous combustion tendency of corrosion products in oil tanks based on TOPSIS methodologies

Spontaneous ignition of the corrosion products of an oil tank may lead to an explosion. To evaluate the spontaneous combustion tendency of corrosion products in oil tanks, the thermodynamic characteristic parameters of the corrosion products of oil tanks were obtained by thermogravimetry as evaluation indexes. Then, the objective weights of these indexes were calculated via the CRITIC method, and TOPSIS theory was used to comprehensively evaluate the spontaneous combustion tendency of corrosion product samples from oil tanks. The results show that the weight of the mass loss rate at the ignition point is the highest, and the apparent activation energy of the corrosion products is not the decisive factor affecting their spontaneous combustion tendency. As such, the spontaneous combustion tendency of the corrosion products of oil tanks cannot be based on only the apparent activation energy. The spontaneous combustion tendency of the corrosion products of a gasoline tank is lower than that of a diesel tank. The higher the heating rate is, the stronger the tendency of spontaneous combustion will be.     

Safety and reliability assessment of external corrosion defects assessment of buried pipelines—soil interface: A mechanisms and FE study

Due to local liquid accumulation (AL) in the low-lying section of the buried natural gas pipeline, external corrosion will occur at the interface between the pipeline and the soil. External corrosion will produce pit defects, which will reduce the bearing capacity of the pipeline and affect the normal operation of the pipeline. In addition, corrosion group defects can interact with each other. Thus, the service life of the pipeline is seriously affected. In this work, a case of local corrosion failure of the pipeline caused by liquid accumulation on-site is presented. The importance of this work is verified by experiment and field excavation. Besides, based on the Mises-Stress yield criterion, nonlinear analysis was carried out with the finite element method (FEM). The effects of internal pressure, corrosion pit defect size, internal and external wall corrosion, corrosion pit group, and different types of volumetric corrosion pit defects on the failure of L360QS steel pipe were analyzed with consideration of the effects of axial and circumferential zones of corrosion pits. These correlations have not been seen in previous studies. The FE results make up for the disadvantage that the corrosion is simplified to equal depth corrosion in the code, which will underestimate the residual strength of the actual corroded pipeline and lead to unnecessary repair or replacement. The results provide a reference for failure analysis and strength evaluation of buried L360QS steel pipe with corrosion defect.     

The human serum paraoxonase—Polymorphism and specificity

Human serum contains EDTA‐sensitive (Ca⁺⁺‐dependent) and EDTA‐stable (albumin) paraoxonases which hydrolyse paraoxon, 0,0‐diethyl,0–4‐nitrophenyl phosphate.

In Caucasians the EDTA‐sensitive enzyme shows a genetically determined polymorphism which is governed by two alleles. In typical Mongoloid or Negro populations this polymorphism is expressed to a lesser degree, and in a few samples (e.g. Aborigines) it cannot be observed at all. The distribution of the activity of the EDTA‐stable (albumin) paraoxonase is unimodal.

Many authors supposed that paraoxonase is an arylesterase (EC 3.1.1.2) which means that it is also able to hydrolyse phenylacetate or β‐naphthylacetate. New investigations have shown that the human serum fractions splitting paraoxon can be separated from those hydrolysing phenylacetate and related substrates.

The polymorphism of the EDTA‐sensitive human serum paraoxonase can be applied to investigations concerning specificity. From this it becomes evident that this enzyme is rather specific. Already slight changes of the paraoxon molecule lead to a decrease of activity. On the other hand the enzyme seems to hydrolyse also phosphonic acid esters and 4‐nitrophenylacetate in the same way like paraoxon (polymorphism).

There is a linkage relationship of paraoxonase with cystic fibrosis and DNA markers. According to these results the (EDTA‐sensitive) paraoxonase locus is on the human chromosome 7.

A high serum paraoxonase level actually protects serum cholinesterase (EC 3.1.1.8) and has to be considered in biological monitoring of workers exposed to parathion.     

可燃物爆炸抑制的研究现状及发展

从实验研究、数值模拟和微观反应机理三个方面概括总结了近年来可燃物爆炸抑制的研究现状,总结了现阶段的研究成果,指出了研究中存在的不足。实验研究主要涉及卤代烃、水、干粉这三种抑制剂,研究了这三种抑制剂的制效果及优缺点;理论计算主要阐述爆炸及其抑制的反应特性、反应机理,现阶段的理论研究以宏观反应机理为主,缺乏对爆炸及其抑制的微观机理的研究,对爆炸及其抑制的本质认识不够。基于以上原因,对今后的研究方向进行了展望。     

300MW机组锅炉屏式过热器爆管原因分析

某电厂300MW机组锅炉在投产运行仅仅13260小时便发生了屏式过热器爆管事故,经初步分析该不锈钢管弯管是由于固溶化处理不当,在残余应力、热应力及氟离子等共同作用下,在奥氏体晶界薄弱处产生晶间腐蚀微裂纹,继而不断发展并最终造成爆管事故的发生。建议加强原材料验收检验及规范锅炉运行操作规程,以最大限度减少此类事故的发生。     

天然海水中碳钢缓蚀剂吸附和阳极脱附行为的研究

以锌盐、葡萄糖酸盐为主要缓蚀成分复配的适用于天然海水中碳钢的高效缓蚀剂,采用极化曲线、循环伏安曲线和交流阻抗谱图分析了该缓蚀剂的阳极脱附行为.结果表明,碳钢在海水中的零电荷电位约为-0.6 V;缓蚀剂的吸附电位区间为-0.5～-0.8 V,缓蚀剂在该区间内存在特性吸附.当阳极极化电位超过-0.45 V时,极化电流迅速增大,缓蚀剂因发生大量脱附而失去对阳极过程的控制.     

硬膜缓蚀剂对钛合金紧固件电偶腐蚀的防护作用研究

目的 研究YTF-3硬膜缓蚀剂对由TC4螺栓、不锈钢螺母、7050铝合金及TC4钛合金夹层板组成的组件电偶腐蚀的影响作用。方法 利用硬膜缓蚀剂对钛合金紧固件和夹层板进行整体腐蚀防护处理,并通过盐雾加速腐蚀试验。将齿轮槽螺栓与无耳托板自锁螺母安装连接后,进行自然环境加速腐蚀试验,腐蚀后对螺栓螺母以及夹层板的腐蚀情况进行拍照检查,采用图像处理方式对腐蚀情况进行评价,并通过室温拉伸试验对钛合金螺栓腐蚀前后的力学性能情况进行对比分析。结果 经过腐蚀试验后,TC4螺栓和铝合金组件刷涂缓蚀剂区域比未刷涂缓蚀剂区域的平均腐蚀面积要小。不锈钢螺母与TC4钛合金组件刷涂缓蚀剂区域出现明显褶皱和破损现象。对比了试验前后钛合金螺栓的最大拉断载荷,发现降幅仅为0.5%。结论 铝合金夹层板会遭受电偶腐蚀,而YTF-3缓蚀剂可以有效隔绝腐蚀介质渗入固定间隙,大幅缓解电偶腐蚀,而钛合金螺栓在加速腐蚀试验中并未发生明显的腐蚀,并且力学性能无明显改变。     

浅谈气相防锈技术

简单地介绍了目前在金属防锈领域广泛应用的气相防锈技术的防锈机理和该技术的优点,重点介绍了当前所使用的气相防锈剂种类和气相防锈材料的现状,并对气相防锈塑料薄膜的优点和制作方法以及其发展趋势进行了分析,指出了国内气相防锈技术的差距和其良好的发展前景.