Rapid prenatal diagnosis of aneuploidy from uncultured amniotic fluid cells using five-colour fluorescence in situ hybridization

In this paper we describe the use of five-colour fluorescence in situ hybridization for prenatal diagnosis of aneuploidy using uncultured amniotic fluid cells. The analysis is based on ratio mixing of dual-labelled probes and digital imaging for the detection and visualization of five different probes specific for the five target chromosomes, 13, 18, 21, X, and Y. A retrospective blind analysis of 30 coded uncultured amniotic fluid samples correctly detected fetal sex and five trisomy 21 cases. Multicolour fluorescence in situ hybridization used in this way allows rapid and simultaneous detection of the most frequent aneuploidies.     

大气飘尘对大鼠肺细胞的毒性比较

采用大白鼠气管内注入飘尘后分析肺灌洗液的方法，比较了上海不同地区飘尘对大鼠肺细胞的毒性；再运用毒性指数及效应指数，综合评价了上海市不同地区大气飘尘污染的状况。研究表明：从肺灌洗液的生化成份分析及细胞分类显示，以彭浦新村、隆昌路平凉路、康定路胶州路３个点的飘尘毒性较大。综合评价结果，彭浦新村的效应指数最大，以后依次为康定路胶州路、鲁班路斜土路、青云路、隆昌路平凉路等。     

水泥负载TiO2光催化降解染料水溶液的研究

研究了以ＴｉＯ２为催化剂，且将ＴｉＯ２涂布在模拟工业水处理浅池的水泥质池底表面，以直管高压汞灯为光源，对有机染料酸性玫瑰红Ｂ和晒化绿Ｂ进行光催化降解的可行性。结果表明，在实验条件下，本系统对以上染料有显著的光降解作用，浓度为２５ｍｇ／Ｌ的上述二种染料溶液，经３０ｍｉｎ光照，其降解率分别达８８．２％，此外，还探讨了染料浓度，染料体积、染料溶液ＰＨ值等因素对光降解的影响。     

染料废水的治理现状及展望

介绍了染料废水的处理现状,目前国内外主要的处理方法有物化法(常用的有吸附法、混凝法、膜技术等)、化学法(如氧化法、电解法等)和生化法(投菌法微生物降解,好氧/厌氧工艺),介绍了各种工艺方法处理染料废水的实例并指出了各方法的优缺点和技术的关键,最后对今后染料废水处理技术的发展进行了展望。     

Recycling of high purity selenium from CIGS solar cell waste materials

Copper indium gallium diselenide (CIGS) is a promising material in thin film solar cell production. To make CIGS solar cells more competitive, both economically and environmentally, in comparison to other energy sources, methods for recycling are needed. In addition to the generally high price of the material, significant amounts of the metals are lost in the manufacturing process. The feasibility of recycling selenium from CIGS through oxidation at elevated temperatures was therefore examined. During oxidation gaseous selenium dioxide was formed and could be separated from the other elements, which remained in solid state. Upon cooling, the selenium dioxide sublimes and can be collected as crystals. After oxidation for 1 h at 800 °C all of the selenium was separated from the CIGS material. Two different reduction methods for reduction of the selenium dioxide to selenium were tested. In the first reduction method an organic molecule was used as the reducing agent in a Riley reaction. In the second reduction method sulphur dioxide gas was used. Both methods resulted in high purity selenium. This proves that the studied selenium separation method could be the first step in a recycling process aimed at the complete separation and recovery of high purity elements from CIGS.     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

β-In2S3的制备及其太阳光下降解土霉素

利用水热反应法制备β-In2S3纳米颗粒光催化剂,并利用SEM、TEM和XRD等对其进行分析表征;采用土霉素溶液模拟四环素类抗生素废水,探讨In2S3对土霉素的降解效果.结果表明,β-In2S3为立方相纳米颗粒结构,该纳米颗粒由纳米片组成,直径约15~30 nm.以太阳光为辐射光源,In2S3对土霉素具有良好的光催化降解效果,在4 h内对初始浓度为30 mg·L-1的土霉素降解率可达98%以上.降解土霉素后的催化剂在无水乙醇中清洗并烘干,经4次循环利用后,β-In2S3的降解能力仍能达到85%以上,表明β-In2S3光催化剂具有良好的稳定性以及光催化活性.     

In-situ synthesis of TiO2 rutile/anatase heterostructure by DC magnetron sputtering at room temperature and thickness effect of outermost rutile layer on photocatalysis

TiO_2 rutile/anatase heterostructure thin films with varying rutile thickness have been in-situ synthesized via DC magnetron sputtering with Ar gas at room temperature. The crystal texture, surface morphology, energy gap and optical properties of the films have been investigated by X-ray diffraction meter, grazing incidence X-ray diffraction meter, Raman spectroscopy, scanning electron microscopy, and UV–visible spectrophotometer, which indicates that the rutile/anatase heterostructure films are successfully fabricated. The further degradation experiments display that the photocatalytic activity can be dramatically affected by the thickness of the outmost rutile layer and the 100 nm thickness exhibits the best performance in all of the TiO_2 thin films. With the increase of the outmost rutile layer, the optical band gap of TiO_2 film displays a systematic decrease slightly. However,the change in photocatalytic activity does not coincide with that in the band gap. The photoresponse and electrochemical properties of the thin films have been characterized to understand the mechanism of the varied photocatalytic activity.     

太阳风暴对短波电子装备性能的影响及应对措施

目的掌握太阳风暴对短波电子装备性能的影响及应对措施,为系统设计提供参考。方法分析太阳风暴的表现形式,并从作用距离、目标检测、定位精度等方面给出太阳风暴对短波超视距雷达、短波通信等装备的影响。结果电离层SID、电离层暴可造成短波通信中断,短波通信可用频段变窄。电离层强吸收可降低天波超视距雷达作用距离和目标定位精度,电子浓度、电离层虚高快速变化影响超视距雷达检测性能和定位精度,负相电离层暴使天波超视距雷达可用频段严重变窄。地球磁暴期间,电磁场突变产生的强电压和电流有可能烧毁用于天、地波超视距雷达的电子设备。电离层非规则现象对超视距雷达有严重影响。结论太阳风暴对电子装备性能有利有弊,要分别对待。系统设计时应充分考虑太阳风暴的影响,在出现太阳风暴时,采取针对性措施降低其影响。     

铝合金-丁腈橡胶航空带垫卡箍典型环境损伤研究

目的研究典型环境对丁腈橡胶-铝合金带垫卡箍的损伤效应。方法通过模拟铝合金-丁腈橡胶航空带垫卡箍使用时的装配结构和应力状态,应用GJB 150A—2009中的湿热和太阳辐射两种典型老化环境,采用宏观形貌观察、卡箍保持力测试和橡胶衬垫拉伸性能测试方法,结合扫描电子显微镜和傅里叶红外光谱技术,分析带垫卡箍的性能劣化过程。结果带垫卡箍在湿热和太阳辐射环境中老化50 d后,卡箍橡胶衬垫表面出现大量微孔缺陷,拉伸性能大幅降低,导致卡箍保持力分别下降了35%和51%。结论带垫卡箍在模拟装配状态下进行湿热和太阳辐射环境暴露实验,卡箍橡胶衬垫内部结构由致密逐渐变得疏松,部分碳碳双键发生氧化交联反应,并在一定程度上提高了聚合物的交联密度,材料硬度提高,回弹性能减弱,橡胶衬垫对芯轴的包裹能力降低,导致卡箍保持力性能降低。