C/N和污泥浓度对以pH值调控的亚硝化系统影响

pH是亚硝化系统实现并稳定的重要调控手段,为研究不同C/N(0、1、2、3、4)及污泥浓度(污泥量∶配水量为1∶6、1∶3、1∶1)下亚硝化系统的pH变化规律及在不同pH变化下对污染物去除转化过程的影响,以乙酸钠为碳源,采用锥形瓶接种成熟的亚硝化污泥进行了批次试验.结果表明,相同污泥浓度下,C/N越大,pH增量越大,反硝化效率越高;相同C/N下,污泥浓度越大,pH增量越小,反硝化效率越高.反应系统对碳氮的去除转化与pH变化存在较大的相关性,且反硝化与亚硝化反应具有先后顺序.整个系统运行期间,pH上升过程的比COD去除速率是pH下降时的7～16倍,pH下降过程的比氨氧化速率(SAOR)是上升过程的1～20倍,当pH 6. 1,系统失去氨氧化能力.本试验过程中,C/N为4时该系统碳氮去除效率较其他工况最佳,3个污泥浓度下分别耗时480、350、300 min完成氨的转化及80%的COD去除.不同工况下,亚硝化反应在系统内的占比维持在50%以上,且NO-3-N浓度一直低于5 mg·L-1,表明该系统以亚硝化作用为主导.     

ZnTiO3-TiO2复合光催化剂的制备及光催化降解有机污染物机制分析

TiO_2光催化剂因无毒无害而在光催化降解污染物领域有巨大潜力.但由于TiO_2的光生电子空穴复合较快,量子效率较低,限制了它的广泛使用.在本研究中,通过溶胶-凝胶(Sol-Gel)法制备了ZnTiO_3-TiO_2异质结复合光催化剂,分析了配比和煅烧温度对材料光催化性能的影响,以甲基橙(MO)溶液为模拟污染物进行光催化降解,探讨了其催化效果及效率提升的机制.结果表明,在紫外光照射下,ZnTiO_3与TiO_2比值为0. 3时,在600℃下煅烧3 h后,其催化效果最佳且表现出良好的化学稳定性.通过光电流测试和电子自旋共振波谱仪的检测结果,证明复合光催化剂的光生电子和空穴复合率降低,从而提高了光催化活性.     

有源滤波器在港口起重设备上的应用

由于技术的进步和生产要求的提高．变频技术被越来越多的使用在包括港口起重机械在内的起重设备中。在提高整机性能的同时,大量谐波的出现也给起重设备的运行带来较大危害。本文针对某港口出现的谐波问题,采用了有源滤波器对谐波进行处理,取得了良好的效果,具有广阔的应用前景。     

工业换热设备的能效评价意义及方法

本文从节能角度,阐述了换热器能效评价的意义;根据换热器的用途,将其分为工艺换热器和辅助换热器,以此为基础,介绍影响换热器能效的主要因素;从我国目前对换热器能效评价的现状出发,提出热力学参数法一用传递有效度方法适合目前的技术水平现状,并简要介绍了该方法的原理和应用。本文的研究,希望对我国换热器能效评级工作有所帮助。     

The potential contribution of sustainable waste management to energy use and greenhouse gas emission reduction in the Netherlands

Future limitations on the availability of selected resources stress the need for increased material efficiency. In addition, in a climate-constrained world the impact of resource use on greenhouse gas emissions should be minimized. Waste management is key to achieve sustainable resource management. Ways to use resources more efficiently include prevention of waste, reuse of products and materials, and recycling of materials, while incineration and anaerobic digestion may recover part of the embodied energy of materials. This study used iWaste, a simulation model, to investigate the extent to which savings in energy consumption and CO₂ emissions can be achieved in the Netherlands through recycling of waste streams versus waste incineration, and to assess the extent to which this potential is reflected in the LAP2 (currently initiated policy). Three waste streams (i.e. household waste, bulky household waste, and construction and demolition waste) and three scenarios compare current policy to scenarios that focus on high-quality recycling (Recycling+) or incineration with increased efficiency (Incineration+). The results show that aiming for more and high-quality recycling can result in emission reductions of 2.3 MtCO₂ annually in the Netherlands compared to the reference situation in 2008. The main contributors to this reduction potential are found in optimizing the recycling of plastics (PET, PE and PP), textiles, paper, and organic waste. A scenario assuming a higher energy conversion efficiency of the incinerator treating the residual waste stream, achieves an emission reduction equivalent to only one third (0.7 MtCO₂/year) of the reduction achieved in the Recycling+ scenario. Furthermore, the results of the study show that currently initiated policy only partially realizes the full potential identified. A focus on highest quality use of recovered materials is essential to realize the full potential energy and CO₂ emission reduction identified for the Netherlands. Detailed economic and technical analyses of high quality recycling are recommended to further evaluate viable integrated waste management policies.     

基于PLC的电器能效测试系统设计

文章通过介绍一种基于PLC并符合GB 21519-2008要求的储水式热水器能效测试系统设计方案,研究PLC在电器能效测试的应用。该系统采用PLC作为下位机,控制电磁阀通断给所检测的样品供水和排水,通过读取能耗检测元件信号计算出能耗值,通过重量传感器输出量的变化换算得出储水式热水器的容积,利用温度模块测得样机各点的温度值;上位机采用PC机,利用组态软件,对现场实施监控与数据实时处理,通过友好的界面快速、实时、准确分析、计算、储存能效值。该系统的设计能有效地提高能效测试的可靠性和工作效率。     

Home energy efficiency grants and advice: findings from the English Midlands

Research was conducted in Nottinghamshire, England to investigate public attitudes regarding home energy efficiency issues. Quantitative data were collected in the form of a postal survey, achieving over three hundred responses. Additionally, predominantly qualitative data were collected in semi-structured interviews in 15 homes. The issues investigated included the grant-funded energy efficiency measures installed by the public, the organisations providing grants, the means by which the recipients were referred to the organisations, and the public's preferences regarding energy efficiency advice. Findings were made about the local authority's success in encouraging the take-up of energy efficiency grants, about the public's preferences for the means by which advice should be provided, about trust relating to energy efficiency grants provided by gas and electricity suppliers, and about people's knowledge of the most effective energy efficiency measures. Additional findings were drawn about specific energy efficiency issues, including old heating systems and compact fluorescent light bulbs.     

Policy,Institutional and Market Barriers to the Implementation of Clean Development Mechanisms (CDM) in China

China is the second largest emitter of greenhouse gases (GHG) in the world, with potentially about two thirds of total Certified Emission Reductions (CERs) for Asia on the world carbon market (). Since 68% of its primary energy is from coal, China's average energy intensity is 7.5 times higher than the EU and 4.3 times higher than the US (EU, 2003 The European Union on-line. (2003). (http://europa.eu.int/index_ns_en.htm accessed Oct 2003  [Google Scholar]). Therefore, introducing advanced clean technologies and management to China represents opportunities for Annex I countries to obtain low-cost CERs through CDM projects, and access to one of the largest potential energy conservation markets in the world.

CDM can provide a win-win solution for both China and Annex I countries, and the Chinese government considers that the introduction of CDM projects can bring advanced energy technologies and foreign investment to China, thereby helping China's sustainable economy and generating CERs. As energy efficiency is generally low and carbon intensity is high in both China's energy supply and demand sectors, numerous options exist for cost-effective energy conservation and GHG mitigation with CDM.

This paper reviews current Chinese policies and administrative and institutional settings for CDM cooperation, and discusses existing policy, institutional and other barriers in the energy market by drawing on observations and experience from previous initiatives such as Cleaner Production and energy efficiency. Some options to remove these barriers are addressed. In order to make CDM projects feasible, China's government needs to promote awareness, streamline administrative systems, and be more active in building a competitive edge in the world carbon market.     

Second Law Analysis for Solar Cookers

Abstract

This article presents the importance and usefulness of Second Law (exergy) analysis for evaluating and comparing solar cookers in meaningful ways. The thermodynamic considerations required for the development of rational and meaningful methodologies for the evaluation and comparison of the efficiency of the solar cookers were defined. Energy and exergy equations were also developed to obtain energy and exergy efficiencies of the solar cookers. The evaluation of the solar cookers requires a measure of efficiency, which is rational, meaningful, and practical. Exergy analysis provides an alternative means of evaluating and comparing the solar cookers. Since exergy is a measure of the quality or usefulness of energy, exergy efficiency measures are more significant than energy efficiency measures, exergy analysis should be considered in the evaluation of the solar cookers.     

Market efficiency,filter rules and buffer stock profitability

This paper uses a model of the optimum buffer stock as a ‘filter rule’ together with a financial model that can be used to assess the efficiency of international commodity markets. The approach is simpler to apply than many other methods which have hitherto been used and yields an economy in theoretical and computational effort. The arguments are applied as a case study to the international copper market. The main conclusion is that private storage is not under-provided for and that a public buffer stock agency would be unlikely to be self-financing.