Combustion performance and emission characteristics on HCCI engine of waste plastic pyrolysis oil biodiesel blends with external PFI and vaporiser

ABSTRACT

Analysis of plastic oil obtained from waste plastic through pyrolysis process, as an alternative to biodiesel is presented in this paper. The HCCI engine is considered for experimental validation of combustion performance and emission characteristics. To accumulate pyrolysis oil as fuel, the design modifications were made in external mixture formation on the existing computerised 4-stroke, single cylinder, water cooled, direct injection kirloskar diesel engine connected with eddy current dynamometer to satisfy HCCI conditions. HCCI engine can be worked on wide assortment of fuels beginning from diesel to different blends (WPPO 5%,10%,15% and 20% by volume) of biodiesel .The designed additional device connected to the engine is utilised for fuel vaporisation and mixture arrangement. In the experimental study, the combustion results were initiate to be of 39.69 % higher Rate of Heat Release (RoHR) for biodiesel HCCI as compared with diesel HCCI. Higher brake thermal efficiency (BTE) was found 37 % without exhaust gas recirculation (EGR) at WPPO 20 % biodiesel blend. And also found 50 % and 65 % reduction in NOx emission and 18 % and 28 % reduction in smoke opacity are obtained for biodiesel vapour induction without EGR and biodiesel vapour induction with 15 % EGR as compared with diesel fuel. The CO (0.34 %), and UHC (2.15 %) emissions are increases with 15 % EGR, but the emissions are within the standard limits specified by the emissions standards.     

从胶片生产废料中回收银

介绍了从涂布废水,废胶片、废乳剂中回收银的工艺流程,叙述了工业试验出现的问题和采取的措施。工业试验结果表明,对从上述３种废料中得到的湿银泥,采用培烧－置换－铸锭工艺回收银,回收率大于９９％,产品银锭的纯度大于９９．９％。     

Biodegradation of Whey Protein-Based Edible Films

The biodegradability of the edible films made of whey proteins by disulfide cross-linking was investigated. Whey protein concentrate (WPC) and whey protein isolate (WPI) films were subjected to microbial degradation using Pseudomonas aeruginosa and composting burial degradation. Results from the microbial degradation showed that whey protein films could support the growth of P. aeruginosa. The bacterial growth characteristics were well described using the Gompertz model. WPC films degraded faster than WPI films, suggesting that the biodegradability of protein films is associated with the film composition and the extent of covalent cross-linking. WPI films buried in a compost pile began to degrade in two days and became darker over time. More than 80% of total solids were lost in 7 days.     

Comparison of the weight-loss degradability of various biodegradable plastics under laboratory composting conditions

Eight kinds of biodegradable plastics were compared for their degradability in controlled laboratory composting conditions. A thin film of each plastic was mixed into the composting material, and weight-loss degradability was calculated from the weight changes of the film during composting. It was found that weight-loss degradability strongly depended on the specific kind of biodegradable plastic; two were very high, four moderate, and the remaining two very slight. The most easily degradable plastic degraded by as much as 81.4% over 8 days of composting. By comparing the weight-loss degradability with ultimate degradability, which is defined as a molar ratio of carbon loss as CO₂ to the carbon contained in the biodegradable plastic, the order of the ease of degradation of the biodegradable plastics differed. Received: February 7, 2000 / Accepted April 14, 2000     

厌氧水解—高负荷生物滤池处理城镇污水的试验研究

厌氧水解－高负荷生物滤池是一种利用附着在塑料模块填料上的微生物系统对城镇污水中的污染物质进行降解处理的绿色环保技术。厌氧水解池和高负荷生物滤池采用的塑料模块填料具有高空隙率、高附着面积、高布水性能和抗堵塞的优异性能,并无须回流。当厌氧水解池水力停留时间为4小时,生物滤池水力负荷为30米^3/米^2。日,该系统处理城镇污水的CODCr去除率达80－86％,BOD5去除率达85％－95％。SS去除率达85－95％,处理后出水上述各项指标均可满足国家二级生物处理排放标准的要求。与广泛运用的活性法处理系统相比,该技术可节约基建投资20％以上,节约能耗50％以上,同时还具有流程简单、管理方便、耐冲击负荷、剩余污泥少等特点。     

TiO2薄膜光催化降解双酚A的研究

采用sol-gel法制备TiO2薄膜.以该薄膜为催化剂,研究了在H2O2存在的条件下,对内分泌干扰物质双酚A的光催化降解反应.分别讨论了pH值、H2O2的加入量、双酚A的初始浓度以及光照时间对降解反应的影响.结果表明,在pH=4,30 mg/L的H2O2中对初始浓度为50 mg/L的双酚A溶液光照180 min有较好的降解效果.     

太湖塑料添加剂时空分布和生态风险评价

为揭示新冠疫情背景下太湖塑料添加剂的时空分布和风险水平,研究了典型的双酚类、邻苯二甲酸酯类和苯并三唑类等塑料添加剂在太湖表层水体的赋存情况.对全太湖19个监测点位进行4个季度的监测,并评估其潜在的生态风险.结果表明,自2020年秋季至2021年夏季,双酚A（BPA）、邻苯二甲酸二乙酯（DEP）、邻苯二甲酸二（2-甲氧基）乙酯（DMEP）、邻苯二甲基丁基苄基酯（BBP）和苯并三唑（UV-328）在太湖表层水体中均有检出.DEP、 DMEP、 BBP、 BPA和UV-328的检出率分别为100%、 97%、 58%、 98%和7%.对比近年来的塑料添加剂污染水平可以发现,太湖的各类塑料添加剂污染水平并未随疫情背景下塑料制品用量的剧增而加重,反而因人类活动减缓而呈现下降趋势.太湖塑料添加剂检出浓度有明显的季度差异,春、夏季平均值高于秋、冬季,分别是104.7、 100.3、 30.7和29.9ng·L^-1.其在空间分布上也具有一定的差异性,主要表现为高浓度点位聚集在太湖西南沿岸.生态风险评估结果表明,太湖塑料添加剂的赋存对藻类存在低风险,比例达30%,秋、冬季风险性高于...     

共混塑料在海水中的光降解及海洋环境风险

共混塑料因其用途广泛且价格低廉,生产和使用量逐渐增加,然而共混塑料在海水中光降解及其海洋环境风险尚不明确.选取聚丙烯/热塑性淀粉共混塑料（PP/TPS）和聚乳酸/对苯二甲酸-己二酸丁二醇酯/热塑性淀粉共混塑料（PLA/PBAT/TPS）为研究对象,单一聚合物塑料聚丙烯（PP）和聚乳酸（PLA）作为对照,探究共混塑料在海水中光降解后微塑料（MPs）的形成和物理化学性质的变化.MPs的粒径分布显示,与PP和PLA相比,PP/TPS和PLA/PBAT/TPS光降解后容易产生尺寸更小的颗粒,主要原因是共混塑料机械性能和抗紫外线能力较差.共混塑料光降解后表面出现更多裂纹和褶皱,表面形貌发生明显变化,而PP和PLA变化不明显.ATR-FTIR光谱显示PP/TPS和PLA/PBAT/TPS光降解后热塑性淀粉（TPS）的特征峰减小,表明共混塑料的淀粉组分降解.C 1s光谱表明,老化共混塑料含有更少的—OH,进一步证实了TPS的光降解.以上结果表明PP/TPS和PLA/PBAT/TPS比PP和PLA光降解程度更高,从而产生更多小粒径MPs.综上所述,共混塑料可能比单一聚合物塑料对海洋环境风险更高,对共混塑料的生产和使用应谨慎.     

塑胶跑道中有机磷酸酯的含量及健康风险

采用超声萃取-层析净化-气相色谱/质谱联用仪定量分析塑胶跑道中7种有机磷酸酯(OPEs),方法回收率为71.41%~110.58%,标准曲线相关系数r0.99,质控良好.采集并分析了成都市12个学校内的塑胶跑道样品中OPEs的含量及分布.结果表明2/3学校内的塑胶跑道样品中检出了OPEs,其中磷酸三正丁酯[tri-n-butyl phosphate,TnBP]、磷酸三异辛酯[tris(2-ethylhexyl)phosphate,TEHP]的检出率较高,而磷酸三(2-氯乙基)酯[tri(2-chloroethyl)phosphate,TCEP]、磷酸三(1,3-二氯异丙基)酯[tridichloropropyl phosphate,TDCPP]、磷酸三苯酯[triphenyl Phosphate,TPh P]在所有样品中均未检测到.Σ7OPEs含量范围为ND~534.89 ng·g~(-1),其中单体含量最高的是TnBP(ND~462.18 ng·g~(-1)).一个样品中检出了毒性较大的氯代磷酸酯-TCPP[trichloropropyl phosphate],含量为205.94 ng·g~(-1).成人和儿童通过皮肤接触摄入的Σ7OPEs日均暴露剂量(以bw计)最高,分别为0.14 ng·(kg·d)~(-1)和0.64 ng·(kg·d)~(-1),儿童的日均暴露剂量明显高于成人.成人及儿童的风险熵值(RQ)为10~(-7)~10~(-5).建议政府对塑胶跑道中OPEs使用量及添加种类进行管控,以更好地保护人群健康.     

存余垃圾中废旧塑料性能演变及资源转化探讨

通过对全国范围内不同地域填埋场中存余垃圾组分含量以及存余垃圾中废旧塑料性能变化进行分析,发现存余垃圾中塑料占比较高,且填埋时间小于7a时,其力学及热学性能与未经填埋处理的原生废旧塑料性能基本无差异,具有较高的资源属性,但污染程度较高,难以直接进行高值化利用.文章进一步分析了国内现有清洁提质和处理处置技术,并针对存余垃圾中废旧塑料特性,提出一条由多效组合洁净技术与直接挤压成型工艺相结合的新型适用性清洁与高值化技术路线.