生化黄腐酸对污染水体生物修复的强化作用

研究了生化黄腐酸（BFA）对污染水体生物修复的强化作用。生化黄腐酸能提高水体中微生物活性,加快微生物对目标污染物的降解。在污染水体生物修复强化作用的试验中,投加生化黄腐酸,CODCr、NH3-N、TP和浊度的去除率分别增加了29．47％、20．61％、35％和19．86％,同时有利于水体DO的提升。     

MBR+CSTR联合工艺处理精对苯二甲酸生产废水

通过MBR＋CSTR两段好氧法对精对苯二甲酸生产废水进行处理,取得了令人满意的结果。经过MBR反应器,CODCr由5000mg／L降为500mg／L以下,并且很好地控制了系统pH的上升。在CSTR反应器中CODe。能降至35mg／L,达到国家污水综合排放一级标准（GB8978-1996）。     

非定态SO2制酸工艺在铅精矿烧结烟气治理中的应用

介绍了非定态SO2制酸工艺的特点、流程及其在铅精矿烧结烟气治理中的应用效果.该工艺具有良好的社会效益、环境效益和较好的经济效益,具有较高的推广应用价值.     

微波催化氧化法处理富马酸废水

在活性炭与Fenton试剂存在下,用微波辐射处理多次铁碳微电解处理后的富马酸废水,通过单因素和正交实验对影响因素进行了考察。在100mL水样中,活性炭用量为1．0g、双氧水用量为1．0mL、废水pH为3、微波加热时间为10min、辐射功率为350W的条件下,可以使富马酸废水的COD从300mg／L降至96．6mg／L。     

C9-AA水溶性石油树脂的制备及其阻垢性能

以乙烯生产过程中的副产物C9馏分和丙烯酸为原料,采用自由基溶液聚合,合成具有阻垢性能的C9-AA水溶性石油树脂。考察了引发剂AIBN和溶剂的加入量、C9-AA加入量、Ca^2＋浓度、循环冷却水pH和养护时间对C9-AA水溶性石油树脂阻垢性能的影响,并对其阻垢效果进行了评价。在Ca^2＋质量浓度小于或等于600mg／L、循环冷却水pH小于或等于9．3、C9-AA水溶性石油树脂加入量大于或等于15mg／L的条件下,C9—AA水溶性石油树脂对循环冷却水的阻垢率达到90％以上,其有效作用时间为60h。     

天然水体腐殖质对双酚A光降解影响的研究

以中压汞灯模拟太阳光光源,研究了双酚A(BPA)在水体腐殖质中的光降解过程,探讨了不同来源的腐殖质、腐殖质浓度、BPA初始浓度、溶解氧等因素对BPA光解速率的影响,实验结果表明,BPA在纯水体系中直接光解很慢,但在腐殖质溶液中光解迅速,符合拟一级动力学反应,改变BPA初始浓度对BPA光解速率的影响不明显,增大溶解氧浓度会抑制BPA光解,通过活性氧分子探针鉴定了腐殖质吸收光辐射产生的羟基与单线态氧,利用GC-MS鉴定了双酚A在Nordic湖富里酸(NOFA)中的光敏化降解产物,推测出BPA敏化降解的可能历程为能量转移导致的直接光解、羟基加成和羟基氧化。     

盐酸溶液改性蛭石对气态单质汞的吸附性能

采用盐酸溶液对蛭石进行浸渍处理,考察了盐酸溶液改性蛭石对气态单质汞的吸附能力。研究结果表明：盐酸溶液改性蛭石对气态单质汞的吸附效果好于未改性蛭石,盐酸浓度为4．0mol／L时,盐酸溶液改性蛭石对气态单质汞的吸附效果较佳;进气中气态单质汞的质量浓度越高,盐酸溶液改性蛭石对气态单质汞的去除率越低;适当提高吸附温度对盐酸溶液改性蛭石吸附气态单质汞较有利;降低蛭石粒径,盐酸溶液改性蛭石对气态单质汞的去除率提高。     

Photocatalytic bacterial inactivation by polyoxometalates

The photocatalytic inactivation (PCI) of Escherichia coli (Gram-negative) and Bacillus subtilis (Gram-positive) was performed using polyoxometalate (POM) as a homogeneous photocatalyst and compared with that of heterogeneous TiO₂ photocatalyst. Aqueous suspensions of the microorganisms (10⁷–10⁸ cfu ml⁻¹) and POM (or TiO₂) were irradiated with black light lamps. The POM-PCI was faster than (or comparable to) TiO₂-PCI under the experimental conditions employed in this study. The relative efficiency of POM-PCI was species-dependent. Among three POMs (H₃PW₁₂O₄₀, H₃PMo₁₂O₄₀, and H₄SiW₁₂O₄₀) tested in this study, the inactivation of E. coli was fastest with H₄SiW₁₂O₄₀ while that of B. subtilis was the most efficient with H₃PW₁₂O₄₀. Although the biocidal action of TiO₂ photocatalyst has been commonly ascribed to the role of photogenerated reactive oxygen species such as hydroxyl radicals and superoxides, the cell death mechanism with POM seems to be different from TiO₂-PCI. While TiO₂ caused the cell membrane disruption, POM did not induce the cell lysis. When methanol was added to the POM solution, not only the PCI of E. coli was enhanced (contrary to the case of TiO₂-PCI) but also the dark inactivation was observed. This was ascribed to the in situ production of formaldehyde from the oxidation of methanol. The interesting biocidal property of POM photocatalyst might be utilized as a potential disinfectant technology.     

Pre-concentration and separation of heavy metal ions by chemically modified waste paper gel

Iminodiacetic acid was immobilized on waste paper by chemical modification in order to develop a new type of adsorption gel for heavy metal ions. Adsorption behavior of the gel was investigated for a number of metal ions, specifically Cu(II), Pb(II), Fe(III), Ni(II), Cd(II), and Co(II) at acidic pH. From batch adsorption tests, the order of selectivity was found to be as follows: Cu(II)  Fe(III) > Pb(II) > Ni(II)  Co(II) > Cd(II). Column tests were carried out for pairs of metal ions to understand the separation and pre-concentration behavior of the gel. It was found that mutual separation of Ni(II) from Co(II) and that of Pb(II) from Cd(II) can be achieved at pH 3. Similarly, selective separation of Cu(II) from Cu(II)–Fe(III) and Cu(II)–Pb(II) mixtures at pH 1.5 and 2, respectively, was observed by using this new adsorption gel. In all cases, almost complete recovery of the adsorbed metal was confirmed by elution tests with HCl.     

The Influence of a Coal-Fired Power Plant in Turkey on the Chemical Composition of Rain Water in a Certain Region

In this study, the chemical composition of the rainwater in Yatağan, which is a region surrounding a coal power plant was investigated from February to April 2002. Rainwater samples were obtained from Yatağan, located northwest of Muğla City in Turkey. pH values and concentrations of major ions (Ca²⁺, Na⁺, K⁺, , , ) in the rainwater samples were analyzed. The pH varied from 5.1 to 7.9 with an average of 6.7 which was in alkaline range considering 5.6 as the neutral pH of cloud water in equilibrium with atmospheric CO₂. In the total of 30 rain events, only three events were observed with water in the acidic range (<5.6), which occurred after continuous rains. The equivalent concentration of components followed the order: Ca²⁺ > > Na⁺ > > > K⁺ > H⁺. The anion and cation concentrations in the rainwater samples showed a high sulphate concentration (131 μEq/l), as well as high sodium (40 μEq/l) and calcium (298 μEq/l) concentrations. These values indicate that one probable source of the high sodium concentration is fly ash, after the coal burning process and the power plant can be effective on level concentrations in rainwater. In addition, the dust-rich local and surrounding limestone environment might have caused the high concentration of Ca²⁺ in rainwater of the Yatağan Basin. Due to a large contribution of these cations to the sulphate neutralization action, the rainwater of this region displays only a moderate acidity, which does not cause significant environmental impact.