河北省气溶胶标高时空变化及其成因

以2012年河北省20个监测站的MODIS AOD(气溶胶光学厚度)和近地面水平能见度数据为基础,应用Peterson 模型和高斯模型,计算气溶胶标高月均值年内变化模型系数;应用全微分近似计算原理,构建了气溶胶标高时空变化的成因模型.结果表明:①全省平均气溶胶标高以夏季最高,为3.298 km;春、秋季次之,分别为2.864和2.284 km;冬季最低,为1.597 km. 全省气溶胶标高空间分布以夏季地域差异最显著,最大值为3.193 km;冬季地域差异最小,最大值为1.487 km. ②在全省尺度上,大气颗粒物排放强度和大气边界层高度每变化1%时,将会引致气溶胶标高分别变化0.577%和0.143%,二者对气溶胶标高变化的贡献率分别为80.1%和19.9%;在省内6个次级区域尺度上,大气颗粒物排放强度越大的区域,大气边界层高度对气溶胶标高的贡献率越大,如冀中南平原、沧州沿海平原和冀东平原的贡献率分别达到63.7%、57.8%、54.2%;反之则贡献率较低,如冀中平原、冀西北山区和冀东北山区的贡献率则分别仅为45.4%、32.6%、8.6%.      

不同通风条件下柴油池火的实验研究

为了分析不同通风条件对柴油池火燃烧特性及引燃特性的影响,进行205 mm带水垫层柴油池火的引燃实验,通过对池火燃料的质量损失速率、火焰高度、温度及热辐射等的监测,分析通风环境中柴油池火的热传递规律。结果表明:当风速为0.5 m/s时,火灾进入旺盛阶段的时间提前,火焰平均温度最高;当风速为1 m/s时,风速的增加导致油池火的质量损失速率增加,位于主火源下风向的待引燃火源获得的热辐射通量增大,火灾旺盛阶段火焰的平均温度降低,火焰高度降低,下风向相邻油盘引燃的时间提前;1 m/s情况下,205 mm带水垫层柴油池火的安全间距需增加到1D以上;通风环境对池火发展及蔓延的影响是显著的,应适当加大下风向可燃物的安全间距,合理选择通风排烟风速,优化火灾应急救援策略。     

中国西南地区时雨量分布特征与时月变化

利用2005-2017年夏半年国家大监站的逐小时降水量资料,14个要素被设计来进行多角度分析。多数要素与地形高度有良好的负相关关系。时段雨量最大值主要集中地是四川盆地西部,其次是贵州南部,云南南部边缘地带有少许站点,云贵高原主体及其与青藏高原交接带内没有最大值出现。多个要素在9到12时出现日变化最高峰。月际变化一般在7月出现最大值。随月份推进,强降水区会在贵州西南部、云南南部边缘出现后,跳跃到川渝地区出现。时段累积雨量最大值随时间增加而增加,多个要素的时间增加一倍时雨量增大10%到20%。以小时而言,西南地区降水几率平均为1/10,最多的可以达到1/4,最少的不到1/14。6月份降水时数最多,10月的雨时数仅次于6月,4月最少。连续时段与标准日界时段雨量的显著差异出现在川渝地区;白天12 h降水与夜间12 h降水的显著差异也出现在川渝地区。总体而言,连续时段的累积雨量大于标准日界的相同时间长度的累积雨量,白天降水量大于夜间降水量。     

Air Pollution Potential: Regional Study in Argentina

/ Air pollution potential is a measure of the atmospheric conditions that are unable to transport and dilute pollutants into the air, independently of the existence of sources. This potential can be determined from two atmospheric parameters: mixing height and transport wind. In this paper a statistical analysis of the mixing height and transport wind, in order to determine the areas with high or poor atmospheric ventilation in Argentina, is presented. In order to achieve this, meteorological data registered during 1979-1982 at eight meteorological stations were used. Daily values of the maximum mixing height were calculated from observations of daily temperatures at different heights and maximum surface temperature. At the same time as the maximum mixing height, the values of the transport wind were determined from the surface windspeed and the characteristics of the ground in the surroundings of each meteorological station. The mean seasonal values for both parameters were obtained. Isopleths of the mean seasonal of the maximum mixing heights were drawn. The percentage of seasonal frequencies of poor ventilation conditions were calculated and the frequency isopleths were also drawn to determine areas with minor and major relative frequencies. It was found that the northeastern and central-eastern regions of Argentina had a high air pollution potential during the whole year. Unfavorable atmospheric ventilation conditions were also found in the central-western side of the country during the cold seasons (37.5% in autumn and 56.9% in winter). The region with the greatest atmospheric ventilation is located south of 40 degrees S, where the frequency of poor ventilation varies between 8.0% in summer and 10.8% in winter.     

通风对堆肥供氧的影响及堆高优化研究

通风是影响好氧堆肥过程中堆体氧气浓度的重要因素.通过设置0.01 m3/(min ·m3)(Al)、0.1 m3/(min·m3)(A2)和0.2 m3/(min·m3)(A3)三种不同通风速率进行好氧堆肥试验,考查堆体中氧气的变化情况,并利用氧气一维扩散方程进行堆体高度的优化.结果表明,鼓风停止时,处理A2、A3的氧...     

湿热环境中汽车板表面腐蚀萌生与表面轮廓特征的关系

目的探究储运过程中深冲用汽车板表面轮廓对其耐蚀性能的影响。方法在模拟的高温高湿腐蚀环境中研究两类无间隙原子钢在其腐蚀初期表面锈点的萌生规律,并采用白光干涉轮廓仪对钢板的表面形貌特征进行表征,探究影响储运过程中汽车板耐蚀性能的表面状态因素。结果仅通过平均粗糙度Sa的差异无法区分具有不同表面轮廓特征的汽车板,因此也无法使用平均粗糙度参数Sa预估汽车板的耐蚀性能。在锈点萌生初期,汽车板表面轮廓的最大高度Sz和最大峰高Sp值的大小直接影响表面电化学活性。在锈点扩展阶段,汽车板表面波峰聚集程度的作用对锈点扩展的影响更为显著。结论 Sz和Sp越大,锈点萌生的速度越快;波峰聚集程度越高,锈点扩展速度越快。该研究结果为提高钢板表面耐蚀性能提供了一条新的思路。     

综放条件下垮落直接顶“两带”分布高度研究

通过相似模拟实验和理论分析,对直接顶不规则垮落和规则垮落两带分布形成的原因及其分布高度进行了深入的分析研究。研究认为,在综放条件下,散体状态的直接顶在渐进流动过程中的某一时刻形成的＂散体拱＂结构构成了不规则垮落带和规则垮落带的分界线,是垮落直接顶呈＂两带＂分布的原因。不规则垮落带分布的研究是＂两带＂分布研究的关键,其分布的高度取决于拱的高度和煤层厚度,其中拱的高度又是重要影响因素。文章对垮落直接顶＂两带＂分布高度的研究,对于深化综放采场煤岩流动规律的研究具有重要意义。     

Meteorological conditions at the release site during the two tracer experiments

The state of the boundary layer at the release site during the two tracer experiments is described, based on measurements of atmospheric turbulence carried out by a sonic anemometer, profiles of horizontal and vertical wind by a SODAR as well as frequent radiosonde releases. The boundary layer height is derived from radiosoundings, modelled and discussed. The study is meant as background for discussions of the tracer behaviour near the release site, and possible influence of the local meteorology at the release site on the long-range dispersion. The difference in the initial meso-meteorological conditions between the two experiments is discussed and some of its consequences for the dispersion of the released tracer are clarified. It is concluded that the first experiment is well suited for validation of long-range transport and dispersion models, whereas the second experiment calls for further model development. It is concluded that the micrometeorological measurements are very important as background information for the understanding of plume behaviour on small as well as long scales.     

The role of wind field, mixing height and horizontal diffusivity investigated through two lagrangian particle models

Two Lagrangian particle models, APOLLO and MILORD, were used to simulate the first ETEX experiment. The role played by wind field, mixing height h and horizontal diffusivity K_H appeared to be the most important aspects to be studied. The sensitivity to the accuracy of the input advection field was studied through the application of APOLLO using different ECMWF data sets differing in space and time resolution and in being forecasted or analysed, corresponding to the real-time, emergency-like condition, and to the a posteriori benchmark simulation. The role of h and K_H was investigated by running both APOLLO and MILORD with different parameterisations, and comparing the model results between them and with the available observations.The model evaluation was carried out through a set of statistical indexes computed on three hourly average concentrations paired in space and time and time-integrated concentrations. It was found that the quality of the input wind field plays a major role in predicting with sufficient accuracy the plume position and extension after the first 24 h from the beginning of the release. The best-model results are obtained with large values of K_H (in the range of 2.5×10⁴–4.5×10⁴ m² s^-1), which confirms the need to enhance the horizontal diffusion, in order to include the advection fluctuations unresolved by large-scale meteorological fields. A fixed value of h in the range 1000–1500 m seems to be more efficient than space and time variable h computed with standard algorithms. A reasonable explanation for this result is given, based on the consideration that in the long range, particles diffuse also in the residual layer above the stable nocturnal boundary layer.     

装置进气口宽度对不同尺寸油盘火旋风燃烧特性影响的研究

为探究进气口宽度对火旋风燃烧特性的影响,利用自然驱动的四面边墙夹缝式装置对不同进气口宽度使用１５０,２００,２５０ mm 3种直径进行实验研究。由燃料质量随时间变化曲线得出准稳态阶段火旋风的质量燃烧速率;利用摄像机记录火焰的连续图像并获得火焰高度。结果表明:针对实验室小型火旋风（150~250 mm）,在进气口宽度为35 mm左右时,火旋风的燃烧速率最大,即火旋风的燃烧强度存在1个最佳的进气口宽度;当火焰高度达到最高时,环量也存在1个临界值。