垃圾焚烧过程中影响重金属分布因素的研究

在转式垃圾焚烧炉和固定床加热炉中,研究了有机垃圾焚烧过程中温度、水分、无机氯及有机氯对几种重金属分布的影响。研究结果表明,焚烧垃圾过程中焚烧温度对重金属分布特性的影响特性不一,重金属锌和铅容易转移到气相中去,而重金属镍和铬大部分是以固态形式残留在底渣中;水能与重金属及其化合物发生反应,引起物质转变,影响重金属的分布;氯的存在也影响重金属的分布特性,氯的参与使重金属更易向飞灰或烟气中迁移。     

上流式缺氧污泥床和好氧生物膜组合脱氮工艺的研究

将上流式颗粒污泥床(USB)用于反硝化和生物膜法用于自养硝化处理蔗糖配水和小区生活污水,反硝化污泥床去除有机物和硝态氮具有节省需好氧去除有机物的能耗的优势,同时好氧生物膜法硝化效率高。试验结果表明,当工艺进水的有机负荷小于2kgCOD/m3·d时,出水COD均小于60mg/L,好氧单元进水有机负荷和氨氮负荷分别小于13kgCOD/m3·d和09kgNH3N/m3·d时,出水氨氮小于5mg/L;COD/NO-3N是影响反硝化的关键因素,处理蔗糖配水时,COD/NO-3N大于5时反硝化脱氮完全,而COD/NO-3N为10时,生活污水作为电子供体仍然脱氮不完全;有机物含量过高导致好氧单元硝化效果降低,HRT是影响好氧单元硝化效率的主要因素,HRT缩短为15h时,氨氮去除率降低了85%左右;同时处理蔗糖配水和生活污水的反硝化菌活性相当。     

厌氧工艺对含铬(Ⅵ)废水处理效果初探

以砂石和活性炭作为填料,自制厌氧生物滤床系统,并对系统进行驯化,发现完成驯化后的稳定系统具有良好的去铬(Ⅵ)能力.废水在系统中经过2 h运行,加入碳源的试验组与不加碳源的对照组的铬(Ⅵ)去除率分别为87.33%和66.31%.恒流泵最佳流量为47 mL/min,外加碳源后,铬(Ⅵ)的浓度由60 mg/L左右降到0.5 mg/L以下,需要4 h,而对照组需要14 h,铬(Ⅵ)浓度由64.66 mg/L提高到 75.53 mg/L时,对本系统负面影响甚微,提高到95.47 mg/L时,系统出水达标所需时间延长到7.5 h.本系统具有耐受一定程度的浓度冲击以及进一步驯化、提高处理负荷的潜力.     

某电厂生活污水再生处理回用系统设计与调试

随着水危机问题日益严峻,再生水回用已经成为解决水资源担缺的重要途径之一。河北某电厂采用“顸处理-悬挂链曝气生物移动床-深度过滤-臭氧消毒”工艺对原生活污水处理系统进行改造,处理后再生水用作循环冷却水补给水。经过填料挂膜及联机试运行,再生水水质指标为：CODcr=11.8mg／L,BOD5=3、8mg／L,SS=6mg／L,pH=7．67,大肠杆菌群≤3个／L,水质符合循环冷却水补给水的国家标准。该工艺可以广泛应用于生活污水的再生处理回用。     

云南省城市生活垃圾处理温室气体排放特征

根据《IPCC国家温室气体清单指南》和《省级温室气体清单编制指南》方法,建立2018年云南省16个州(市)城市生活垃圾处理温室气体排放清单,包括生活垃圾填埋和焚烧处理过程,并分析了温室气体排放的时间分布、空间分布和影响因素等。结果表明;(1)2018年云南省生活垃圾处理温室气体总排放量为536万t CO_2当量,各州(市)间排放量差异明显,滇中经济发达地区和滇东北人口密度较高地区排放量明显高于滇西北地区。(2)2005—2018年,云南省生活垃圾处理排放的温室气体量增长了191.3%,温室气体排放组成发生明显变化,CH4比重不断下降,CO_2比重不断增加。(3)城镇人口数量、生活垃圾处理量、经济发展水平与温室气体排放量显著相关,其中人口数量更为明显。     

煤层瓦斯含量测定定点取样方法研究进展

基于文献调研及前期研究,分析了目前煤矿井下煤层瓦斯含量直接测定时所采用定点取样方法及其弊端,阐述了学者们提出的改进型定点取样方法,并对煤层瓦斯含量测定定点取样方法的研究进行了展望,指出:①取样过程瓦斯损失量小、取样时升温低、机械复杂度低是基于煤芯管法定点取样方法的发展方向;②开展煤储层条件下的瓦斯运移规律研究,建立并完善各种基于煤芯管法的定点取样方法的瓦斯损失量模型;③适用于松软煤层的定点取样方法的研发亟待开展;④基于负压气力输送理论的定点取样方法是定点取样方法研究的趋势,动态颗粒煤变负压瓦斯解吸规律是建立对应瓦斯损失量模型的基础研究。     

Characteristics of the stabilized/solidified municipal solid wastes incineration fly ash and the leaching behavior of Cr and Pb

Fly ash is a hazardous byproduct of municipal solid wastes incineration (MSWI). An alkali activated blast furnace slag-based cementitious material was used to stabilize/solidify the fly ash at experimental level. The characteristics of the stabilized/solidified fly ash, including metal leachability, mineralogical characteristics and the distributions of metals in matrices, were tested by toxic characteristic leaching procedure (TCLP), X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive spectrometer (SEM-EDS) respectively. Continuous acid extraction was utilized to extract metal ions and characterize their leaching behavior. The stabilization/solidification procedure for MSWI fly ash demonstrates a strong fixing capacity for the metals by the formation of C-S-H phase, hydrated calcium aluminosilicate and ettringite. The stabilized/solidified fly ash shows a dense and homogeneous microstructure. Cr is mainly solidified in hydrated calcium aluminosilicate, C-S-H and ettringite phase through physical encapsulation, precipitation, adsorption or substitution mechanisms, and Pb is mainly solidified in C-S-H phase and absorbed in the Si-O structure.     

臭氧-曝气生物滤池深度处理垃圾焚烧渗滤液可行性研究

研究了臭氧-曝气生物滤池(BAF)代替纳滤和反渗透深度处理垃圾焚烧渗滤液达标排放的技术可行性.半间歇臭氧氧化试验表明,实验用水的可生化性随着氧化时间的增加而增加,色度及UV254, 15min内去除率分别达91%和64%;氧化时间为45min时COD去除率59%, 45min后COD去除较慢, 120min时去除率77%.确定臭氧氧化时间为1h,在同样臭氧浓度与流量下进行了臭氧-BAF处理垃圾焚烧渗滤液的连续实验.结果发现,此工艺对COD、色度和UV254的去除率分别可达75%,95%和90%,其中2/3运行时间里COD低于排放标准100 mg/L.其中出水色度可稳定保持在40度以下达标排放.经过进一步优化,臭氧-BAF有望用于垃圾焚烧渗滤液的达标处理.GC-MS检测表明烷烃,芳香族化合物及含氮杂环化合物是试验用水的主要污染物,臭氧-BAF能够有效去除后两类化合物,但难以去除烷烃.     

Comparative study on the efficiency and environmental impact of two methods of utilizing polyvinyl chloride waste based on life cycle assessments

Two processes of utilizing polyvinyl chloride （PVC） waste, an incineration process and a vacuum pyrolysis process, for energy conversion were compared to determine their efficiency and environmental perfor- mance. We carried out a life cycle assessment with each of the two processes to evaluate their environmental impact and defined the goals and limits of our remit. As well, we established an inventory of PVC waste from incineration and vacuum pyrolysis based on process analysis, data collection and calculations. The results show that electrical power output per unit mass of PVC waste in the incineration process was twice as high as that of the vacuum pyrolysis process. Incineration had a larger total environmental impact potential than vacuum pyrolysis. The total environmental impact potential of PVC waste from incineration was three times higher than that from vacuum pyrolysis. Incineration of PVC disposed 300 ng. 100 kgI of dioxins and vacuum pyrolysis 98.19 ng- 100 kgI of dioxins. As well, we analyzed the data for their uncertainty with results quantified in terms of three uncertainties： basic uncertainty, additional uncertainty, and computational uncertainty. The coefficients of variation of the data were less than 25% and the quality of the inventory data was acceptable with low uncertainty. Both PVC waste disposal processes were of similar quality and their results comparable. The results of our life cycle impact assessment （LCIA） showed considerable reliability of our methodology. Overall, the vacuum pyrolysis process has a number advantages and greater potential for development of PVC disposal than the incineration process.     

沸石滤池深度处理石化废水二级出水研究

采用小试规模沸石滤池,深度处理石化废水二级出水,通过考察滤池对CODCrNH4^-N和挥发酚的去除情况,分析了沸石去除污染物的规律和机理。结果表明：沸石滤池对CODCr,NH4^＋-N和挥发酚的平均去除率分别达到27．32％、94．67％和34．47％。在滤池运行初期,离子交换起主要作用。随着反应器的运行,离子交换因沸石饱和而减弱,而生物氧化逐渐起作用。由于沸石资源丰富、价格低廉和性能优越,所以沸石滤池作为三级深度处理技术具有广阔应用前景。