基于结构参数响应的内循环流化床流体特性优化数值模拟

流化床是一种结构复杂而能量转化高效的反应器型式,为了实现系统化的内循环流化床优化设计,利用欧拉-欧拉双流体模型构建了不同结构的CFD流化床模型,在分别改变高径比、导流筒与反应器的直径比和底隙高度3个结构因素的情况下,考察流化床内全流场、局部流场、液相运动速度及气含率等气液两相流的响应特性,分析结构因素及操作因素对流体运动的内在影响,阐明工程优化设计的方向.数值模拟结果表明:高径比主要影响气液流动型态,低高径比时容易出现漩涡和返混,工程中应采用导流内构件并重视气体分布装置的合理设计;导流筒与反应器的直径比主要影响液体循环速度,存在一个合理的区间,考虑流动速度与气含率,流化床直径比可取0.6～0.8,最佳取值为0.7;底隙高度影响流化床底泥区的流体运动,应约等于流化床下降区的缝隙长度.CFD模拟可作为污染控制技术工业放大和优化设计的辅助工具.     

NaHCO_3和石灰干式净化焚烧烟气中酸性气体的效果与经济性

在热态试验台上研究了石灰和NaHCO3作为吸附剂时,焚烧烟气中HCl和SO2的净化效果。实验研究表明,HCl的排放达标是更主要的任务,在HCl的初始浓度不高于70mg/m3时,NaHCO3和石灰与焚烧烟气中HCl的化学量比(NSR)在4.0以上,HCl和SO2的排放才能满足欧盟2000标准。经济性方面,虽然NaHCO3比石灰的价格贵,但NaHCO3对保证排放标准更为可靠。     

Sulfide oxidation in fluidized bed bioreactor using nylon support material

A continuous fluidized bed bioreactor (FBBR) with nylon support particles was used to treat synthetic sulfide wastewater at different hydraulic retention time of 25, 50 and 75 min and upflow velocity of 14, 17 and 20 m/hr. The effects of upflow velocity, hydraulic retention time and reactor operation time on sulfide oxidation rate were studied using statistical model. Mixed culture obtained from the activated sludge, taken from tannery effluent treatment plant, was used as a source for microorganisms. The diameter and density of the nylon particles were 2-3 mm and 1140 kg/m³, respectively. Experiments were carried out in the reactor at a temperature of (30 ± 2)℃, at a fixed bed height of 16 cm after the formation of biofilm on the surface of support particles. Biofilm thickness reached (42 ± 3) μupm after 15 days from reactor start-up. The sulfide oxidation, sulfate and sulfur formation is examined at all hydraulic retention times and upflow velocities. The results indicated that almost 90%-92% sulfide oxidation was achieved at all hydraulic retention times. Statistical model could explain 94% of the variability and analysis of variance showed that upflow velocity and hydraulic retention time slightly affected the sulfide oxidation rate. The highest sulfide oxidation of 92% with 70% sulfur was obtained at hydraulic retention time of 75 min and upflow velocity of 14 m/hr.     

Nitrogen removal and simultaneous nitrification and denitrification in a fluidized bed step-feed process

For urban wastewater treatment, we conducted a novel four-stage step-feed wastewater treatment system combined with a fluidized bed laboratory experiment to investigate chemical oxygen demand (COD), NH₄⁺-N, and total nitrogen (TN) removal performance. The removal rates of COD, NH₄⁺-N and TN were 88.2%, 95.7%, and 86.4% with effluent concentrations of COD, NH₄⁺-N and TN less than 50, 8, and 10 mg/L, respectively. Biomass and bacterial activities were also measured, with results showing more nitrobacteria in the activated sludge than in the biofilm; however, bacterial activity of the biofilm biomass and the activated sludge were similar. Nitrogen concentrations during the process were also detected, with simultaneous nitrification and denitrification found to be obvious.     

循环流化床烟气脱硫系统控制技术

阐述了循环流化床烟气脱硫系统电气控制的内容、方法、仪表等技术。根据循环流化床烟气脱硫实验系统温度、压力、流量的测量,实现了该系统闭环开环自动、手动控制的功能,并且根据实验室的具体情况,采取特殊技术方式,完成实验自动化的控制。该控制技术对扩大到实际工程应用具有指导意义。     

流化床微生物燃料电池基质降解动力学研究

研究了在30℃左右条件下,流化床微生物燃料电池(FBMFC)处理有机废水的基质降解动力学。在空气阴极、单室、无膜液固流化床微生物燃料电池中,以污水和椰壳活性炭为液相和固相,通过实验考察不同水力停留时间的污水COD变化。选取Monod模型和简单动力学模型,通过合理的假设推导出流化床微生物燃料电池处理模拟有机废水时的基质降解动力学模型。将实验数据代入到理论推导得到的动力学模型中,进行线性拟合和对比分析,得到Monod模型和一级反应动力学模型表达式。结果表明流化床微生物燃料电池基质降解为一级反应;Monod模型表达式为:t/s0-st=4.769 7/st+15.885,一级动力学模型为:lnCA=-0.025 32t+8.109 15,理论推导模型与实验数据具有较好的吻合性。     

SNCR在垃圾焚烧发电厂的应用与控制

大连垃圾焚烧发电项目采用SNCR控制的技术方案,实现了垃圾焚烧发电系统的脱硝。文章从脱硝系统的选择和控制方案进行了论述,阐述了采用氨水作为还原剂的SNCR系统在垃圾焚烧发电厂的应用效果与经济成本。     

水解－好氧法处理含硫废水的研究

采用水解－好氧法处理炼油过程中产生的含硫废水。试验结果表明：经过此工艺处理后的出水COD、氨氮、硫化物、酚分别为118.5mg/L、29.4mg/L、0.0mg/L和0.50mg/L,相应的去除率分别为90.4％、56.6％、100％和99.3％,出水水质达到国家有关排放标准。同时,设计独特的三相好氧床不仅能有较高的硝化能力,而且无剩余污泥排放。因此,可以省略剩余污泥的处理过程     

三相生物流化床膨胀特性方程的研究

研究建立了描写三相生物流化床床层膨胀特性的经验关联式．当已知床内表观液速、表观气速和载体上生物膜厚度时,能比较准确地预测床层膨胀高度,为设计提供依据．与以往不同的是,本研究通过等效函数的设置和求解,用一个方程将两相床和三相床的膨胀特性描述出来．该方程能反映三相床低气速下的床层收缩行为,在气速为零时可还原为两相床．试验用反应器直径１．４ｍ,高６．５ｍ,载体为０．３—０．５ｍｍ的石英砂,射流曝气体内充氧．４种生物膜厚：５２,８０,１１５,１３７μｍ．试验用生活污水ＢＯＤ５４７．６—７７．２ｍｇ／Ｌ．     

几种含钙工业废料的固定床吸附除磷特性

根据钙化合物为有效除磷吸附剂的基础研究结果,将以钙为主要成分的炼铁高炉炉渣(A)、炼钢转炉炉渣(B)和软磁器加工生产中的废料(C)用于二次处理生活污水的除磷.研究结果表明,材料A在合适的pH与钙离子浓度下具有一定的除磷效果,材料C在钙源得到补充的条件下,表现出良好的除磷性能;而材料B由于其组织结构中游离CaO的水解造成机体膨胀,溶出大量钙离子,这种性质恰好可用于补充材料C对钙的需求,取得较好效果,有希望成为一种高效,廉价的除磷吸附剂.