钢结构防腐涂层面漆可剥离现象的原因分析及处理措施

目的分析钢结构防腐涂层面漆出现可剥离现象的原因。方法利用质谱仪、环境扫描电镜、ICS 1100型离子色谱仪对涂料和漆膜进行测试分析。结果聚氨酯涂料和漆膜样品含有高沸点溶剂三甲苯和四甲苯,通过微观形貌分析发现漆膜固化不充分,在漆膜样品的萃取溶液中检测出了铵基盐类物质。结论聚氨酯涂料中的高沸点溶剂、低温环境下的小分子胺析出和湿热海洋环境是导致涂层面漆出现大面积可剥离现象的主要原因。     

Synergistic inhibition of aluminum dust explosion by gas–solid inhibitors

The inhibition mechanism of gas-solid inhibitors on Al dust explosion was investigated experimentally in a closed cuboid chamber. The variation of parameters concerning flame propagation characteristic and explosion severity used to reflect the synergistic inhibition effect of gas-solid inhibitors on Al dust explosion were elucidated. The results showed that flame propagation velocity and explosion overpressure were inhibited with the increase of gas-solid inhibitors. The inhibition curves of gas-solid inhibitors within the experimental range were further obtained. The reason concerning the SEEP phenomenon was revealed through the GC-MS analysis. The combustion of ammonia enhanced the explosion overpressure when solid inhibitors performed at low concentration. The gas-phase product could be regarded as the inert gas as long as enough amount of inhibitors were added. To comprehend the inhibition mechanism of gas-solid inhibitors, X-ray diffraction was applied to figure out the crystal structure of explosion residue. The results indicated that both physical and chemical inhibition effects were imposed on Al dust explosion by gas-solid inhibitors, including endothermic decomposition, dilution of oxidizer, coverage of Al dust, and scavenger of free radicals. The results of this study will provide a scientific basis for the design of inhibition technology for the dust explosion.     

城市高架桥降雨径流多环芳烃（PAHs）污染特征及其生态风险评价

以上海市高架桥降雨径流作为研究对象,分析了4场高架路面降雨径流溶解相、颗粒相16种PAHs的质量浓度和场次降雨径流平均浓度（Event Mean Concentration）。探讨了城市高架降雨径流中PAHs质量浓度特征、动态变化过程和污染状况。通过对无量纲累积径流量和无量纲累积污染物负荷曲线M（V）进行幂函数拟合,对4场降雨径流不同环数和总PAHs冲刷强度进行了定量表征。以水样中8种PAHs的监测质量浓度及其对3至40种水生生物的LC50为基础数据,采用推广风险系数法对径流水体PAHs进行了生态风险评价。结果表明：地表径流中溶解态PAHs的质量浓度为27.9~979.4 ng·L-1,主要以3环和4环组分为主;颗粒态PAHs中的质量浓度为1120.1~4892.6 ng·L-1,主要以4-6环的组分为主。径流样品中PAHs更容易吸附在颗粒物上,PAHs主要以颗粒相为主,且4-6环颗粒相PAHs所占比例更高,也显示了化石燃料不完全燃烧的特征。4场降雨径流以2013-05-26次降雨EMC值最大,PAHs污染水平最高。其中通过对BaP的EMC值计算,发现4场降雨径流中BaP的EMC值皆超过了国家的排放标准,应引起相关监测管理部门重视。4场降雨径流均表现不同程度的初始冲刷效应,雨强和径流量是影响初始冲刷的2个重要因素。初始冲刷散点拟合状况良好,定量表征发现2013-06-27次降雨初始冲刷强度最大。风险商表征说明,径流水体PAHs造成的生态风险较小,但部分单体PAH对水生生物的生态影响不容忽视。     

沿海城市PM10和PM2.5自动监测过程中质量浓度“倒挂”现象分析与成因探讨

2020年2—3月,位于福建沿海地区中部的莆田市在环境空气质量自动监测过程中出现了严重的PM_(10)和PM_(2.5)质量浓度"倒挂"现象,小时值"倒挂"率为19.86%,日均值"倒挂"率为16.67%。在高相对湿度和低风速气象条件下,颗粒物会出现严重的"倒挂"现象,"倒挂"过程中常伴随着颗粒物和气态污染物(SO_2、NO_2和CO)质量浓度的增加。因此,于2020年2月16日—3月26日开展了颗粒物自动监测和手工监测比对,并结合气象参数、气态污染物质量浓度,以及PM_(10)和PM_(2.5)中水溶性离子和液态水的含量特征,进一步探讨了莆田市颗粒物质量浓度"倒挂"的主要成因。研究表明,PM_(10)和PM_(2.5)自动监测仪器检测原理的差异是导致颗粒物质量浓度"倒挂"的重要原因之一,而气象条件(相对湿度、气温和风速等)、颗粒物质量浓度、颗粒物中主要吸湿组分(NO_3~-、SO_4~(2-)和NH_4~+)和液态水的含量也是颗粒物质量浓度"倒挂"的主要影响因素。莆田市2020年2—3月出现高频率"倒挂"现象是多重因素共同作用的结果,解决该问题需要同时考虑监测仪器检测原理、气象参数、颗粒物质量浓度和吸湿组分等的影响。