分点进水A/O工艺处理低碳源生活污水的脱氮性能研究

针对低C/N比污水脱氮的难点问题,在缺氧段不同点设置进水口,采用分点进水A/O工艺处理校园生活污水.考察了在污泥回流比为100%,硝化液回流比为200%,分流比为1∶1,缺氧池水力停留时间(HRT)分别为2、2.4和3 h情况下,分点进水A/O工艺的反硝化性能,并与传统的A/O工艺进行比较.结果表明,当缺氧池的水力停留...     

一体化A/O生物膜反应器脱氮特性研究

采用新型的一体化A/O生物膜反应器,对生活污水进行脱氮处理实验.研究了溶解氧(DO)质量浓度对硝化和反硝化作用的影响,并对反应器的脱氮特性和降解机理进行了探讨.结果表明:DO对一体化A/O反应器脱氮影响较大,随着好氧区DO的增加,NH3-N和TN的去除率相应增加.当DO为2～4 mg/L时,发生同步硝化反硝化作用,NH...     

Short-term effect of temperature variation on the competition between PAOs and GAOs during acclimation period of an EBPR system

Sequencing batch reactor (SBR) for enhanced biological phosphorus removal (EBPR) processes was used to investigate the impact of the temperature shock on the competition between phosphorus-accumulating organisms (PAOs) and glycogen accumulating organisms (GAOs) in start-up stage. During the 34 days operation, SBR was set with temperature variation(0–5 d, 22±1°C; 6–13 d, 29±1°C; 14–34 d, 14±1°C). PAOs and GAOs were analyzed by fluorescent in situ hybridization (FISH), and intracellular polyphosphate granules were stained by Neisser-stain. The results showed that the influence of temperature shock on PAOs’ abundance was more serious than that on GAOs in the enriching process. Under sudden and substantially temperature variation, from 22±1°C to 29±1°C and then to 14±1°C, the domination of PAOs was deteriorated. After temperature shock, PAOs’ competitive advantages at low temperature that concluded in other study did not appear in our study. As mesophilic, GAOs (indicated by Alphaproteobacteria and Gammaproteobacteria) were more temperature adaptive and better grew and took the domination at 14±1°C in the end. In the competition process, organisms of tetrad forming organisms (TFOs)-like shape which were considered as typical GAOs, were observed. With the evidence of poly-P granules containing by Neisser-straining and result of FISH, these organisms of TFOs-like shape were better to be assumed as adaption state or a special self-protecting shape of PAOs.     

Zn-TiO2纳米管的光催化活性

采用水热合成-浸渍法制备锌掺杂TiO2纳米管(Zn-TiO2纳米管),透射电镜照片显示Zn-TiO2纳米管为两端开口形貌均一的中空管状结构,管径约6～8 nm,壁厚约1 nm,长度约50～200 nm。研究了Zn-TiO2纳米管对甲基橙的光催化性能,结果表明:掺杂适量锌提高了TiO2纳米管对甲基橙的光催化降解性能,0.4%Zn-TiO2纳米管的光催化性能最佳。同时还探讨了Zn-TiO2纳米管用量和初始pH值等因素对光催化降解甲基橙的影响,结果显示Zn-TiO2纳米管能有效地降解甲基橙。随着光催化反应进行,CODCr去除率和脱色率变化规律不完全相同,可能是由于芳基和烷基降解速率不同所致。     

Temperature and feed strategy effects on sulfate and organic matter removal in an AnSBB

The objective of this work was to analyze the interaction effects between temperature, feed strategy and COD/[SO(4)(2-)] levels, maintaining the same ratio, on sulfate and organic matter removal efficiency from a synthetic wastewater. This work is thus a continuation of Archilha et al. (2010) who studied the effect of feed strategy at 30 °C using different COD/[SO(4)(2-)] ratios and levels. A 3.7-L anaerobic sequencing batch reactor with recirculation of the liquid phase and which contained immobilized biomass on polyurethane foam (AnSBBR) was used to treat 2.0 L synthetic wastewater in 8 h cycles. The temperatures of 15, 22.5 and 30 °C with two feed strategies were assessed: (a) batch and (b) batch followed by fed-batch. In strategy (a) the reactor was fed in 10 min with 2 L wastewater containing sulfate and carbon sources. In strategy (b) 1.2 L wastewater (containing only the sulfate source) was fed during the first 10 min of the cycle and the remaining 0.8 L (containing only the carbon source) in 240 min. Based on COD/[SO(4)(2-)] = 1 and on the organic matter (0.5 and 1.5 gCOD/L) and sulfate (0.5 and 1.5 gSO(4)(2-)/L) concentrations, the sulfate and organic matter loading rates applied were 1.5 and 4.5 g/L.d, i.e., same COD/[SO(4)(2-)] ratio (=1) but different levels (1.5/1.5 and 4.5/4.5 gCOD/gSO(4)(2-)). When reactor feed was 1.5 gCOD/L.d and 1.5 gSO(4)(2-)/L.d, gradual feeding (strategy b) showed to favor sulfate and organic matter removal in the investigated temperature range, indicating improved utilization of the electron donor for sulfate reduction. Sulfate removal efficiencies were 87.9; 86.3 and 84.4%, and organic matter removal efficiencies 95.2; 86.5 and 80.8% at operation temperatures of 30; 22.5 and 15 °C, respectively. On the other hand, when feeding was 4.5 gCOD/L.d and 4.5 gSO(4)(2-)/L.d, gradual feeding did not favor sulfate removal, indicating that gradual feeding of the electron donor did not improve sulfate reduction.     

Low-cost and efficient adsorbent derived from pyrolysis of Jatropha curcas seeds for the removal of Cu2+ from aqueous solutions

Biochar, is a low-cost material that can be used as an alternative adsorbent for the removal of heavy metals. In this study, a low-cost and efficient adsorbent synthesised from Jatropha curcas seeds was used for the uptake of Cu²⁺ from aqueous solutions. The as-prepared adsorbent was characterised by scanning electron microscopy and Brunauer–Emmett–Teller analysis post calcination at 500 °C, its BET surface area and total pore volume were 39.62?m²?g^?1 and 0.049?m³?g^?1, respectively. Subsequently, the effects of initial pH of the solution, contact time, and adsorbent material dosage on the adsorption of Cu²⁺ by the prepared adsorbent were investigated. The as-prepared adsorbent exhibited a high performance, with a maximum adsorption amount of 32.895?mg?g^?1 for Cu²⁺ at pH 5.0 and 25 °C, owing to the presence of ?OH, C=O, C–O, Si-O-Si, and O-Si-O on its surface. The predominant Cu²⁺ adsorption mechanism was assumed to be ion exchange. Notably, the Cu²⁺ adsorption could attain equilibrium within 90?min. In addition, the fact that the Langmuir model was a better fit than the Freundlich model for the isotherm data of Cu²⁺ adsorption by the as-prepared adsorbent suggested that the adsorption of Cu²⁺ was a monolayer adsorption process.     

Hydrologic and water quality performance of a laboratory scale bioretention unit

A bioretention unit (BRU) or cell is a green infrastructure practice that is widely used as a low impact development (LID) technique for urban stormwater management. Bioretention is considered a good fit for use in China’s sponge city construction projects. However, studies on bioretention design, which incorporates site-specific environmental and social-economic conditions in China are still very much needed. In this study, an experimental BRU, consisted of two cells planted with Turf grass and Buxus sinica,was tested with eighteen synthesized storm events. Three levels (high, median, low) of flows and concentrations of pollutants (TN, TP and COD) were fed to the BRU and the performance of which was examined. The results showed that the BRU not only delayed and lowered the peak flows but also removed TN, TP and COD in various ways and to different extents. Under the high, medium and low inflow rate conditions, the outflow peaks were delayed for at least 13 minutes and lowered at least 52%. The two cells stored a maximum of 231 mm and 265 mm for turf grass and Buxus sinica, respectively. For both cells the total depth available for storage was 1,220 mm, including a maximum 110 mm deep ponding area. The largest infiltrate rate was 206 mm/h for both cells with different plants. For the eighteen events, TP and COD were removed at least 60% and 42% by mean concentration, and 65% and 49% by total load, respectively. In the reservoir layer, the efficiency ratio of removal of TN, TP and COD were 52%, 8% and 38%, respectively, within 5 days after runoff events stopped. Furthermore, the engineering implication of the hydrological and water quality performances in sponge city construction projects is discussed.

Open image in new window

     

Metallic wastewater treatment by sulfate reduction using anaerobic rotating biological contactor reactor under high metal loading conditions

An-RBC reactor is highly suited to treat metallic wastewater. Metal removal is due to sulfide precipitation via sulfate reduction by SRB. Cu(II) removal was the best among the different heavy metals. Maximum metal removal is achieved at low metal loading condition. Metal removal matched well with the solubility product values of respective metal sulfide salts. This study was aimed at investigating the performance of anaerobic rotating biological contactor reactor treating synthetic wastewater containing a mixture of heavy metals under sulfate reducing condition. Statistically valid factorial design of experiments was carried out to understand the dynamics of metal removal using this bioreactor system. Copper removal was maximum (>98%), followed by other heavy metals at their respective low inlet concentrations. Metal loading rates less than 3.7 mg/L?h in case of Cu(II); less than 1.69 mg/L?h for Ni(II), Pb(II), Zn(II), Fe(III) and Cd(II) are favorable to the performance of the An-RBC reactor. Removal efficiency of the heavy metals from mixture depended on the metal species and their inlet loading concentrations. Analysis of metal precipitates formed in the sulfidogenic bioreactor by field emission scanning electron microscopy along with energy dispersive X-ray spectroscopy (FESEM-EDX) confirmed metal sulfide precipitation by SRB. All these results clearly revealed that the attached growth biofilm bioreactor is well suited for heavy metal removal from complex mixture.     

Investigation of phosphate adsorption from an aqueous solution using spent fluid catalytic cracking catalyst containing lanthanum

A spent fluid catalytic cracking (FCC) catalyst containing lanthanum (La) was used as a novel adsorbent for phosphorus (P) in simulated wastewater. The experiments were conducted in a batch system to optimize the operation variables, including pH, calcination temperature, shaking time, solid-liquid ratio, and reaction temperature under three initial P-concentrations (C₀ = 0.5, 1.0, and 5.0 mg/L). Orthogonal analysis was used to determine that the initial P-concentration was the most important parameter for P removal. The P-removal rate exceeded 99% and the spent FCC catalyst was more suitable for use in low P-concentration wastewater (C₀ <5.0 mg/L). Isotherms, thermodynamics and dynamics of adsorption are used to analyze the mechanism of phosphorus removal. The results show that the adsorption is an endothermic reaction with high affinity and poor reversibility, which indicates a low risk of second releasing of phosphate. Moreover, chemical and physical adsorption coexist in this adsorption process with LaPO₄ and KH₂PO₄ formed on the spent FCC catalyst as the adsorption product. These results demonstrate that the spent FCC catalyst containing La is a potential adsorbent for P-removal from wastewater, which allows recycling of the spent FCC catalyst to improve the quality of water body.

Open image in new window

     

Duckweed Landoltia punctata purifies micro-polluted surface water and produces starch北大核心CSCD

Aquatic plant duckweed has remarkable potential in nutritional water purification and starch accumulation; at present, it has received increasing attention. This study aimed to investigate the ability of duckweed in nutrient recovery from micro-polluted surface water; further, the starch accumulation capacity of duckweed was evaluated. The results showed that duckweed can achieve better depth treatment of the micro-polluted surface water, within 1-day treatment, by duckweed. Ammonia nitrogen and total phosphorus status of Class V and worse than class V water was improved to a superior level; moreover, the nitrogen and phosphorus removal rates were 98.5% and 82.9%, respectively. In addition, duckweed can rapidly accumulate starch during water treatment. The starch content of duckweed was 28.38% and 21.57% (dry weight) in Class V and worse than class V wastewater after 3 days of treatment, respectively, and reached 52.15% and 49.58% on day 15. Moreover, additional carbon dioxide (CO2) supplementation promoted the starch production. The starch content increased by 55.7% compared with that of control, and the average starch accumulation rate increased by 2.72 times in 3 days. Therefore, duckweed can not only rapidly purify micro-polluted water, but also accumulate a large amount of starch. This study forms the basis for wastewater treatment and post-treatment utilization of duckweed biomass. © 2018 Science Press. All rights reserved.