全自动淋洗-智能蒸馏联合技术检测土壤中阳离子交换量

针对土壤中阳离子交换量检测国标方法的不足,介绍了一种全自动淋洗法结合自动智能一体化蒸馏的联合技术。通过对实际样品和6种土壤标样的比较实验,表明,淋洗时间设置为20 min、乙醇洗涤次数设置为4次、蒸馏液质量设置为130 g较佳,在该条件下,土壤标样及实际样品的相对标准偏差(0.87%~1.07%)远小于行业标准方法的标准偏差(3.87%~5.18%),方法准确度也均在保证值范围内。该方法自动化程度高、可操作性强且检测结果的准确度、精密度及重现性都符合标准规定,可满足大批量土壤样品分析要求。     

Redistribution of zinc, cadmium, and lead among soil fractions in a sandy calcareous soil due to application of poultry litter

This study was conducted to evaluate, using soil columns, the mobilization and redistribution of heavy metals (Zn, Cd, and Pb) among different soil fractions by soluble organic ligands within poultry litter. Uncontaminated soil was amended with Zn, Cd, and Pb to achieve concentration levels of 400, 8, and 200 mg kg⁻¹ soil, respectively. Columns repacked with this amended soil were leached with distilled water, 0.01 M EDTA, 0.01 M CaCl₂, or poultry litter extract (PLE) solutions. After leaching, the soil samples in the columns were sequentially extracted for exchangeable (EXC), carbonate (CARB) organic matter (OM), Mn oxide (MNO), Fe oxide (FEO), and residual (RES) fractions. Considerable mobilization of Zn, Cd, and Pb occurred in soil during EDTA leaching. Leaching with PLE and CaCl₂ solutions significantly decreased Zn and Cd concentrations in the EXC, CARB, and OM fractions. These solutions significantly decreased Pb concentration in the EXC fraction, while PLE solubilized more Pb from EXC fraction than CaCl₂. Thus, the applied poultry litter may change Zn, Cd, and Pb fractions in metal-amended soil and possibly enhance metal mobility.     

电镀污泥标准浸出方法的比对

采用3种固体废物浸出毒性标准浸出方法处理电镀污泥,考察浸提剂、样品粒径、液固比、振荡时间、振荡方式等因素对电镀污泥中重金属浸出效果的影响,用电感耦合等离子体原子发射光谱法同时测定浸出液中铜、锌、镍、铬、铅、镉、钡等元素。试验表明:醋酸缓冲溶液体系浸出液中重金属浓度最高;样品粒径越小,浸出毒性越大;翻转振荡比水平振荡更有利于重金属浸出;液固比增大,重金属浸出量增加;虽然液固比和振荡时间对重金属浸出效果均有影响,但很难确定最佳值。     

Effect of biochar amendment on sorption and leaching of nitrate, ammonium, and phosphate in a sandy soil

When applied to soils, it is unclear whether and how biochar can affect soil nutrients. This has implications both to the availability of nutrients to plants or microbes, as well as to the question of whether biochar soil amendment may enhance or reduce the leaching of nutrients. In this work, a range of laboratory experiments were conducted to determine the effect of biochar amendment on sorption and leaching of nitrate, ammonium, and phosphate in a sandy soil. A total of thirteen biochars were tested in laboratory sorption experiments and most of them showed little/no ability to sorb nitrate or phosphate. However, nine biochars could remove ammonium from aqueous solution. Biochars made from Brazilian pepperwood and peanut hull at 600 °C (PH600 and BP600, respectively) were used in a column leaching experiment to assess their ability to hold nutrients in a sandy soil. The BP600 biochar effectively reduced the total amount of nitrate, ammonium, and phosphate in the leachates by 34.0%, 34.7%, and 20.6%, respectively, relative to the soil alone. The PH600 biochar also reduced the leaching of nitrate and ammonium by 34% and 14%, respectively, but caused additional phosphate release from the soil columns. These results indicate that the effect of biochar on the leaching of agricultural nutrients in soils is not uniform and varies by biochar and nutrient type. Therefore, the nutrient sorption characteristics of a biochar should be studied prior to its use in a particular soil amendment project.     

Changes in mineralogical and leaching properties of converter steel slag resulting from accelerated carbonation at low CO2 pressure

Steel slag can be applied as substitute for natural aggregates in construction applications. The material imposes a high pH (typically 12.5) and low redox potential (Eh), which may lead to environmental problems in specific application scenarios. The aim of this study is to investigate the potential of accelerated steel slag carbonation, at relatively low pCO₂ pressure (0.2 bar), to improve the environmental pH and the leaching properties of steel slag, with specific focus on the leaching of vanadium. Carbonation experiments are performed in laboratory columns with steel slag under water-saturated and -unsaturated conditions and temperatures between 5 and 90 °C. Two types of steel slag are tested; free lime containing (K3) slag and K1 slag with a very low free lime content. The fresh and carbonated slag samples are investigated using a combination of leaching experiments, geochemical modelling of leaching mechanisms and microscopic/mineralogical analysis, in order to identify the major processes that control the slag pH and resulting V leaching. The major changes in the amount of sequestered CO₂ and the resulting pH reduction occurred within 24 h, the free lime containing slag (K3-slag) being more prone to carbonation than the slag with lower free lime content (K1-slag). While carbonation at these conditions was found to occur predominantly at the surface of the slag grains, the formation of cracks was observed in carbonated K3 slag, suggesting that free lime in the interior of slag grains had also reacted. The pH of the K3 slag (originally pH ± 12.5) was reduced by about 1.5 units, while the K1 slag showed a smaller decrease in pH from about 11.7 to 11.1. However, the pH reduction after carbonation of the K3 slag was observed to lead to an increased V-leaching. Vanadium leaching from the K1 slag resulted in levels above the limit values of the Dutch Soil Quality Decree, for both the untreated and carbonated slag. V-leaching from the carbonated K3 slag remained below these limit values at the relatively high pH that remained after carbonation. The V-bearing di-Ca silicate (C2S) phase has been identified as the major source of the V-leaching. It is shown that the dissolution of this mineral is limited in fresh steel slag, but strongly enhanced by carbonation, which causes the observed enhanced release of V from the K3 slag. The obtained insights in the mineral transformation reactions and their effect on pH and V-leaching provide guidance for further improvement of an accelerated carbonation technology.     

Modeling batch leaching behavior of arsenic and selenium from bituminous coal fly ashes

Correctly predicting the leaching potential of arsenic (As) and selenium (Se) is critical for assessing the environmental impact of coal fly ash. This study investigated the impacts of several key environmental factors, including pH, leaching time, and ash washing on the batch leaching behavior of As and Se from bituminous coal fly ashes. The experimental results demonstrated that As and Se leaching from fly ash increased beyond the minimal leaching pH ranges. Increasing leaching time increased As leaching but decreased Se leaching in the alkaline pH condition. A speciation-based adsorption model was used to quantify the batch leaching data, and determine the intrinsic leaching parameters including the total batch leachable mass and the adsorption constant of As or Se. The modeling approach was validated by correctly predicting the independent batch leaching data in a broad pH range and a different L/S condition. Experimental and modeling results also demonstrated that ash washing and ash aging (longer leaching time) did not change the adsorption constants of As and Se on the ash surface. However, ash washing could increase the availability of As and Se for leaching.     

Leaching of Cu and Zn from discarded boat paint particles into tap water and rain water

We studied the leaching of copper and zinc from particles of discarded boat paint added to tap water (pH 7.3) and rain water (pH = 4.7), simulating conditions encountered during the hosing or runoff of antifouling waste. Leaching rates appeared to be diffusion-controlled and were greater in rain water than in tap water and were greater for Zn than for Cu. After a period of 120 h, between about 0.5% and 3% of total Cu and 5-30% of total Zn had been released to the aqueous phase. These observations suggest that Cu and Zn mobilised from fine antifouling particulates during washdown or rainfall events may be important contaminants of runoff and soils in the vicinity of boat repair facilities.     

A GIS-based technique for linking landscape characteristics to non-point source nitrogen export potential: implications for contributing areas management

A Nitrate-N Leaching Index (NLI) is calculated and the results indicate that nitrogen loss in the study area occurs through both leaching and surface runoff. A non-linear regression model of trapping efficiency was combined with a first order decay model to examine the impact of soil characteristics, slope, vegetative cover, land use and distance to streams on the spatial pattern of non-point source nitrogen inputs to streams. The model evaluates the statistical significance of each landscape factor and provides an easy interpretation of the landscape delivery ratio of nitrogen based on a pixel-based characterisation of the watershed. The model was validated by comparing the distributions of the observed and estimated monthly nitrogen concentrations. The exploratory GIS-based method presented here can improve the understanding of the impact of landscape characteristics on nitrate-nitrogen contributing areas and therefore assist watershed management efforts.     

The safety observer effect: the effects of conducting safety observations

INTRODUCTION: Some research suggests that conducting safety observations of another's safety performance may serve as an effective tool in increasing the safety performance of the observer. The primary purpose of the present study was to assess the effects of conducting safety observations on the postural safety performance of observers engaging in an assembly task for short time periods. The secondary objectives of the study were: (a) to measure productivity, and (b) to measure the accuracy of participant safety observations. METHOD: An ABC (A: baseline, B: information, C: observation) multiple-baseline design counterbalanced across postural behaviors (back, shoulder, and feet position) was implemented with six participants. RESULTS AND DISCUSSION: Substantial improvements in postural safety occurred after participants conducted safety observations, and these improvements did not appear to negatively affect productivity. Results also suggest that there is no relation between the accuracy of an observer's safety observation and their subsequent safety performance. IMPACT ON INDUSTRY: This research provides evidence that a safety observation process can function to increase safe postural behavior of observers. Thus, the implementation of such a process may contribute to the prevention of musculoskeletal disorders and related costs in the workplace.     

Utilization of washed MSWI fly ash as partial cement substitute with the addition of dithiocarbamic chelate

The management of the big amount of fly ash as hazardous waste from the municipal solid waste incinerator (MSWI) has encountered many problems in China. In this study, a feasibility research on MSWI fly ash utilization as partial cement substitute in cement mortars was therefore carried out. MSWI fly ash was subjected to washing process to reduce its chlorine content (from 10.16% to 1.28%). Consequently, it was used in cement mortars. Ten percent and 20% replacement of cement by washed ash showed acceptable strength properties. In TCLP and 180-day monolithic tests, the mortars with washed ash presented a little stronger heavy metal leachability, but this fell to the blank level (mortar without washed ash) with the addition of 0.25% chelate. Therefore, this method is proposed as an environment-friendly technology to achieve a satisfactory solution for MSWI fly ash management.