Dry and heat stress affects H2S production of Salmonella on selective plating media

The pH of Salmonella pre-enrichment media can become acidic (pH 4.0–5.0) when feeds/ingredients are incubated for 24?h. Salmonella in feed that have been stressed by heat and desiccation exhibit different pH tolerances than non-stressed cultures. Acidic conditions can result in cell injury/death and affect biochemical pathways. In this study, eight serotypes of Salmonella were grown in sterile meat and bone meal that was subjected to desiccation and heat stress. Cultures of non-stressed and stressed isolates were subsequently exposed to acidic pH from 4.0 to 7.0 in 0.5?pH increments (3 replicates/pH increment) in citrate buffer. At 6 and 24?h, serial dilutions were plated in duplicate on XLT-4 (xylose lysine tergitol-4) agar. Four serotypes showed an impaired ability to decarboxylate lysine on XLT-4. This inability to decarboxylate lysine was dependent on isolate, stress status, and incubation time. When the isolates’ ability to decarboxylate lysine was examined using biochemical tests, cultures were found to be able to decarboxylate lysine with the exception of S. Infantis. This suggests that XLT-4 contains a biochemical stressor(s) which affects the rate of decarboxylation by these Salmonella. These results suggest that acidic conditions may influence the detection and confirmation of Salmonella in feed.     

Effects of T-2 toxin on histopathology,fatty acid and water distribution of shrimp (Litopenaeus vannamei) muscle

T-2 toxin (T-2), one of the naturally occurring mycotoxins, often accumulates in aquatic animals from contaminated feed. Shrimp (n?=?30 per group) were fed with different concentrations (0, 0.5, 1.5, 4.5 and 13.5?mg kg^?1) of T-2 for 20?days. Changes in histopathology, fatty acid and water distribution of shrimp muscle were analyzed. Histopathology of shrimp muscle showed dose-dependent marked degenerative and necrotic changes on exposure to dietary T-2. The T-2 significantly (P?<?0.05) affected the muscle fatty acid composition. ∑SFA, ∑MUFA and ∑PUFA initially decreased and then increased slowly in the high-dosed groups. C16:0, C18:1n-9 and C18:2n-6 were the main saturated fatty acid (SFA), monounsaturated fatty acid (MUFA) and polyunsaturated fatty acid (PUFA), respectively. Also, T-2 significantly affected water distribution in shrimp muscle. High doses of T-2 reduced free water content, resulting in a reduction in the water holding capacity and hence changes to the shrimp muscle quality. Collectively, these results illustrated that T-2 significantly affects the fatty acid and water distribution, and also muscle histopathology, all of which would result in a reduction in the quality and nutritional value of shrimp.     

半干法脱除球团烟气中的SO2及Hg0

采用钙基吸收剂及复合氧化剂半干法脱除模拟球团烟气中的SO_2及Hg~0,考察了多因素条件对吸收效果的影响。实验结果表明,在以NaClO和NaClO_2为复合氧化剂、 NaClO与NaClO_2体积比1∶0.5、复合氧化剂质量分数3%、反应温度110℃、钙基吸收剂质量3.0 g、模拟烟气进气流量1.2 L/min的条件下,SO_2和Hg~0的脱除率分别为98%和93%,证明钙基吸收剂与复合氧化剂对污染物球团烟气中的SO_2和Hg~0有良好的脱除作用。     

Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

CeO2/TiO2纳米管催化剂脱硝性能研究

利用废气中本身含有的CO催化还原烟气中的NO_x,可以实现以废治废。采用TiO₂纳米管负载CeO₂,制备CeO₂/TiO₂纳米管催化剂,并对其进行了SEM表征及影响因素实验。实验结果表明：在n（Ce）∶n（Ti）=3∶7、焙烧温度500 ℃、焙烧时间3 h时制备的CeO₂/TiO₂纳米管催化剂形貌较好,表面颗粒分布相对均匀;反应温度400~600 ℃时NO脱除率达98%;该催化剂具有一定的抗氧性能;当n（SO₂）∶n（NO）=（1∶2）~（2∶1）时,NO脱除率仍然在95%以上。     

锐钛矿-金红石混合晶型TiO2降解气相苯

用溶胶-凝胶法并通过控制煅烧温度合成不同晶相比的混合晶型纳米TiO_2,在紫外光光照下降解气相苯。考察了苯初始质量浓度、紫外灯光照强度和催化剂加入量对苯去除率的影响;探究了光催化降解气相苯的动力学特征。结果表明:450℃煅烧制备的催化剂降解苯效率最高,此催化剂金红石相质量分数为6.30%;在苯初始质量浓度为74.39 mg/m~3、催化剂加入量为7 g、光照强度为2.18 klux的最佳条件下反应84 min,苯去除率达99.73%;光催化降解率与光照强度之间符合0.5级动力学特征;当催化剂加入量为3 g时,单位时间单位质量催化剂降解苯的质量最多;苯的光催化降解反应均符合一级动力学方程。     

CePO4-TiO2固溶体的NH3-SCR活性

采用共沉淀法合成了不同Ce与Ti摩尔比的CePO₄-TiO₂复合材料,利用XRD、TEM、NH₃-TPD和H₂-TPR技术对其物理化学性质进行了表征,并对其NH₃-SCR活性进行了评价。实验结果表明：随着CePO₄含量的增加,催化剂的活性提高;当Ce与Ti的摩尔比为8:2时催化剂的活性最高,230 ℃的NO转化率达到100%,且具有更广的温度窗口,优于纯CePO₄。表征结果显示,CePO₄与TiO₂形成固溶体后,颗粒尺寸较为均匀,强酸位的数量增多,氧化还原性能提升,从而提高了催化剂的SCR反应活性,同时改善了其抗水抗硫性能。     

含碳纳米TiO2光催化降解甲醇

采用管式光催化反应器,在石英玻璃管壁上涂镀含碳纳米TiO2薄膜,研究含碳纳米TiO2对甲醇气体的光催化降解性能。实验结果表明：随气体流量增加,甲醇降解率呈线性降低;在气体流量为200mL／min、相对湿度为40％、甲醇初始质量浓度为90～170mg／m^3的较佳条件下,甲醇降解率维持在80％以上,最高达85％;在甲醇初始质量浓度为150mg／m^3、气体流餐为200mL／min、相对湿度为40％的条件下,德国Degusa—P25光催化剂对甲醇的平均降解率为89％,含碳纳米TiO2对甲醇的平均降解率为82％,最人降解率为85％。     

芦苇化感物质EMA对铜绿微囊藻生长及藻毒素产生和释放的影响

研究了芦苇化感物质2-甲基乙酰乙酸乙酯（ethyl-2-methylacetoacetate,EMA）对铜绿微囊藻PCC7806的生长抑制特性以及对微囊藻毒素MC-LR产生和释放的影响.结果表明,EMA在培养1周内对铜绿微囊藻PCC7806具有较强的抑制作用,EC_50,7d值为2.0 mg·L^-1,但EMA的抑制效果随时间的延长而减弱.整个培养期间,EMA对MC-LR的胞外释放无显著影响.培养7　d后,单位藻细胞内MC-LR的含量随EMA浓度的增加而升高,EMA投加浓度为1.5　mg·L^-1时,单位藻细胞MC-LR的含量为25 ng·(10⁶个)^-1,比对照组增加了39%.但单位体积培养液中MC-LR总量（胞内和胞外的总和）随EMA浓度增加先略微升高后显著降低,EMA投加浓度为3 mg·L^-1时,培养液中MC-LR胞内胞外总量为28 μg·L^-1,约为对照组的一半;16　d后,EMA对单个细胞内MC-LR的含量以及MC-LR总量均无显著影响.     

微等离子弧放电催化水处理技术的研究

采用钛为阳极的微等离子弧放电技术,研究了在模拟废水处理中放电催化效应及其机理,发现该技术对甲基橙有好的放电催化处理效果.甲基橙的脱色程度与峰值电压、脉冲频率、占空比、阳极电极面积等有关.在0.3mol·L-1的H3PO4电解液中,在峰值电压为550V、脉冲频率200Hz,占空比1∶180、阳极电极面积50mm×50mm条件下,20min内600mL、20mg·L-1的甲基橙溶液脱色率达90%.实验结果表明,该放电催化体系具有协同效果好、能效高、反应器设计要求简单等特点,是一种有发展前景的水处理新技术.