碳源变化对降解2,4-D的好氧颗粒污泥性能及形态的影响

在长期运行的序批式生物反应器(SBR)中,考察了以葡萄糖和2,4-二氯苯氧乙酸(2,4-D)为混合碳源培养的好氧颗粒污泥在转换为2,4-D唯一碳源废水后,其形态、结构及对目标污染物去除功能的变化.结果表明,基质转换为2,4-D单一碳源后,好氧颗粒污泥仍保持了对目标污染物高效的去除能力.当进水2,4-D浓度为361～564mg/L,其去除率为99.2%～100%,COD平均去除率达到85.6%.混合碳源向2,4-D单一碳源转换对原好氧颗粒结构产生一定破坏作用,使其发生部分解体,粒径由513μm下降到302μm.但好氧颗粒污泥良好的耐负荷冲击使其保持了颗粒主体,通过一段时间适应调整后能够重新聚集生长,最终获得能够利用2,4-D为唯一碳源生长并具有良好沉降性(SVI20～40mL/g)的好氧颗粒污泥,粒径为489μm.扫描电子显微镜(SEM)观察结果表明,混合碳源转向单一碳源使好氧颗粒生物相丰富度降低.     

Effects of Cu（Ⅱ） and humic acid on atrazine photodegradation

This work was designed to explore the characteristics of photodegradation of herbicides in the copper-polluted water body. The results showed that Cu(II) alone could induce a photo Fenton-like reaction to enhance the degradation of atrazine, in which hydroxyl radical ( OH) was a main active species. Humic acids restrained atrazine degradation, nevertheless, when introducing Cu(II), the photodegradation was accelerated, in which singlet oxygen (1O2) replaced OH acting as the prevailing species. A feasible mechanism for the photochemical process was also proposed, which is helpful for better understanding the environmental photochemistry of atrazine in the copper-polluted water.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Antimicrobial activity of thin metallic silver flakes, waste products of a manufacturing process

The aim of the research was to develop new products and processes from a manufacturing waste from an Italian metallurgic company. The company produced thin silver metallic films and the production scraps were silver flakes. The possibility to use the silver flakes in water disinfection processes was studied. The antimicrobial activity of the flakes was investigated in batch using Escherichia coli as Gram-negative microorganism model. The flakes did not show any antimicrobial activity, so they were activated with two different processes: thermal activation in reducing atmosphere and chemical activation, obtaining, respectively, reduced flakes (RF) and chemical flakes (CF). The flakes, activated with either treatment, showed antimicrobial activity against E. coli. The kill rate was dependent on the type of activated flakes. The chemical flakes were more efficient than reduced flakes. The kill rate determined for 1 g of CF, 1.0 ± 0.2 min⁻¹, was greater than the kill rate determined for 1 g of RF, 0.069 ± 0.004 min⁻¹. This was confirmed also by the minimum inhibitory concentration values. It was demonstrated that the antimicrobial capability was dependent on flakes amount and on the type of aqueous medium. Furthermore, the flakes maintained their properties also when used a second time. Finally, the antimicrobial activities of flakes were tested in an effluent of a wastewater treatment plant where a variety of heterotrophic bacteria were present.     

Silver impregnated carbon for adsorption and desorption of elemental mercury vapors

The Hg0 vapor adsorption experimental results on a novel sorbent obtained by impregnating a commercially available activated carbon (Darco G60 from BDH) with silver nitrate were reported. The study was performed by using a fundamental approach, in an apparatus at laboratory scale in which a synthetic flue gas, formed by Hg0 vapors in a nitrogen gas stream, at a given temperature and mercury concentration, was flowed through a fixed bed of adsorbent material. Breakthrough curves and adsorption isotherms were obtained for bed temperatures of 90, 120 and 150°C and for Hg0 concentrations in the gas varying in the range of 0.8–5.0 mg/m3. The experimental gas-solid equilibrium data were used to evaluate the Langmuir parameters and the heat of adsorption. The experimental results showed that silver impregnated carbon was very effective to capture elemental mercury and the amount of mercury adsorbed by the carbon decreased as the bed temperature increased. In addition, to evaluate the possibility of adsorbent recovery, desorption was also studied. Desorption runs showed that both the adsorbing material and the mercury could be easily recovered, since at the end of desorption the residue on solid was almost negligible. The material balance on mercury and the constitutive equations of the adsorption phenomenon were integrated, leading to the evaluation of only one kinetic parameter which fits well both the experimentally determined breakthrough and desorption curves.     

Efficacy of natural biocide on control of microbial induced corrosion in oil pipelines mediated by Desulfovibrio vulgaris and Desulfovibrio gigas

We compared the efficacy of a natural biocide with four chemical tetrakishydroxymethyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, and formaldehyde, glutaraldehyde, to control microbial induced corrosion in oil pipelines. The efficacy of biocides were monitored against Desulfovibrio vulgaris and Desulfovibrio gigas in experimental pipes by measuring cell counts, H2S production, Fe(II) production, production of extracellular polymeric substances and structure of biofilm. The treatment with cow urine had minimum planktonic cell counts of 3 102 CFU/mL as well as biofilm cell counts of 9 101 CFU/mL as compared with tetrakishydroxyl methyl phosphonium sulfonate, benzyl trimethyl ammonium chloride, formaldehyde and glutaraldehyde. Sulfide production was the lowest with cow urine (0.08 mmol/L), followed by tetrakishydroxymethyl phosphonium sulfonate 0.72 mmol/L. On day 90 of treatment, Fe(II) production was also found to be the lowest with cow urine. The scanning electron microscopic studies indicated that the biofilm bacteria were killed by cow urine. These results demonstrate the cow urine mediated control of microbially induced corrosion, and this is indicative of its potential as a viable substitute of toxic biocides. To the best of our knowledge, this seems to be the first report which screens possible biocidal activity by cow urine as compared to the most common biocides which oil industry is currently using.     

响应面法优化复合微生物吸附剂对低浓度Cr3+的吸附

根据已有4种微生物吸附剂的吸附基团存在的差异特征,将其复配成复合吸附剂,借助统计学方法研究其对低ρ(Cr3+)废水的吸附性能.在单因素试验基础上,利用P-B(Plackett-Burman)法筛选出吸附过程4个主要影响因素分别为pH,初始ρ(Cr3+)及微生物吸附剂XB和TQ的投加量,应用最陡爬坡试验接近主要因素最优水平,采用Box-Behnken试验设计和响应面分析得到对低浓度Cr3+吸附过程的二阶模型.结果表明,最优吸附条件为pH 4.0,初始ρ(Cr3+)为4.86mg/L,XB和TQ的投加量分别为0.20和0.13 g/L,实际吸附率达到87.54%,与理论预测值(87.68%)接近,且高出单一吸附剂吸附率7.79%～17.35%.FT-IR扫描显示,复合微生物吸附剂性能提高与表面基团增多有关.通过响应面分析法优化复合微生物吸附,吸附性能明显提高.     

基于服务式GIS的流域水质目标管理技术平台架构设计

针对流域水质目标管理与GIS集成技术,对比分析传统模式与服务式GIS模式的优劣,提出了基于服务式GIS的流域水质目标管理技术平台的层次结构、总体架构及建设步骤;基于具体建设需求分析,构建了辽河流域水质目标管理技术平台的详细架构。     

重金属离子快速检测技术研究与应用进展

在突发环境污染事件和区域生态风险筛查中迫切需要环境样品中重金属离子的快速检测技术手段。环境样品中重金属离子的快速检测技术有电化学方法和生物学方法。电化学检测方法主要是阳极溶出伏安法(AnodicStripping Voltammetry,ASV),可以同时检测多种重金属离子,有标准化认证的产品,但是检测成本相对较高。随着纳米粒子技术(Nanoparticles,NPs)和石英微天平分析技术(Quartz Crystal Microbalance,QCM)的引入,ASV法的检测成本将不断降低;生物检测方法包括免疫检测(Immunoassay,IA)和功能DNA(Functional DNA)检测技术。重金属离子的免疫检测技术样品通量大,检测成本低,已经广泛用于食品行业,其中汞离子的免疫检测方法已经成为环境样品标准检测方法之一。免疫检测传感器技术将拓展重金属离子的快速检测的应用空间。功能DNA传感器检测的研究为重金属离子的快速检测提供了新的技术手段,但是这些仅限于实验室研究,还没有达到实际应用的水平。