Use of wastes derived from earthquakes for the production of concrete masonry partition wall blocks

Utilization of construction and demolition (C&D) wastes as recycled aggregates in the production of concrete and concrete products have attracted much attention in recent years. However, the presence of large quantities of crushed clay brick in some the C&D waste streams (e.g. waste derived collapsed masonry buildings after an earthquake) renders the recycled aggregates unsuitable for high grade use. One possibility is to make use of the low grade recycled aggregates for concrete block production. In this paper, we report the results of a comprehensive study to assess the feasibility of using crushed clay brick as coarse and fine aggregates in concrete masonry block production. The effects of the content of crushed coarse and fine clay brick aggregates (CBA) on the mechanical properties of non-structural concrete block were quantified. From the experimental test results, it was observed that incorporating the crushed clay brick aggregates had a significant influence on the properties of blocks. The hardened density and drying shrinkage of the block specimens decreased with an increase in CBA content. The use of CBA increased the water absorption of block specimens. The results suggested that the amount of crushed clay brick to be used in concrete masonry blocks should be controlled at less than 25% (coarse aggregate) and within 50-75% for fine aggregates.     

色谱自动进样瓶可溶出砷对样品砷形态测定的影响

选用几种常用玻璃色谱自动进样瓶(简称色谱瓶),包括硼硅玻璃、一级水解级玻璃和高白料玻璃色谱瓶,以及聚丙烯材质的色谱瓶,1%HNO3对色谱瓶浸提后用ICP-MS和HPLC-ICP-MS测定浸提液中砷的总量和形态,并研究了10%HNO3对色谱瓶的清洗效果;此外还探讨了温度及时间对玻璃色谱瓶中砷释放的影响.结果表明,玻璃色谱瓶中砷普遍存在,其中硼硅玻璃色谱瓶浸提液中砷浓度低于1μg·L-1,用10%HNO3酸泡24 h能够全部清除;而一级水解级玻璃和高白料玻璃色谱瓶浸提液中砷的浓度则高达45.67μg·L-1和70.25μg·L-1,酸泡24 h后也有较高的残留量,浓度分别为1.63μg·L-1和0.94μg·L-1.高温能促进玻璃色谱瓶中砷的释放;玻璃色谱瓶中砷的释放量随时间的延长而增加,但短时间内即达到平衡.形态分析结果表明,玻璃色谱瓶浸提液中砷形态为As(Ⅴ),没有检测到As(Ⅲ)、二甲基砷酸(DMA)和甲基砷酸(MMA).同时,聚丙烯色谱瓶浸提液中砷总量低于检测限,因而在进行砷形态测定时,建议使用聚丙烯色谱瓶或者经10%HNO3清洗后的硼硅玻璃色谱瓶,以避免玻璃色谱瓶中As(Ⅴ)的污染.     

可吸入颗粒物中非晶质含量的原样XRD分析

为了获取尽可能完整的样品信息,直接利用采集的大气PM10原样进行非晶质X射线衍射(XRD)的定量分析.按照实际PM10的构成用玻璃纤维滤膜采集人为模拟大气结晶颗粒物样品,结合实验拟合得到的滤膜衍射图,推导出根据空白滤膜衍射强度计算不同样品载量时滤膜的衍射强度公式,从而消除了滤膜的基底效应的影响,并计算出实际大气样品中非晶质的衍射强度.采用无定形碳模拟大气中的非晶质,通过测定纯碳的衍射强度,得到纯碳比空白玻璃纤维滤膜的参比强度K为0.59,类比绝热法求出非晶质的质量百分比.应用该方法对北京市2010年冬季采集到的一组大气可吸入颗粒物样品进行了原样XRD分析,得出其非晶质含量分别为10.44%、13.83%、15.12%、15.88%和11.96%.     

CRT含铅玻璃及其冶炼废渣的铅浸出毒性研究

通过评估阴极射线管(CRT)含铅玻璃及其冶炼后废渣的环境影响,有助于CRT玻璃回收和处置.本文采用醋酸缓冲液法(HJ/300-2007)研究了CRT的三种含铅玻璃及其铅冶炼后废渣的铅浸出特性,结果表明锥玻璃、颈玻璃和熔接玻璃铅浸出浓度均超出危险废物浸出标准,其中熔接玻璃中的铅极易溶出,在CRT玻璃中毒性最大;而铅冶炼废渣中的铅也极易溶出,废渣中的含铅量应低于1.5%才可视为一般固体废弃物.除了铅在化合物中的含量,铅的赋存结构使铅化合物浸出毒性差异很大.     

600t/d浮法玻璃熔窑脱硫工艺改进及相关参数分析

通过对600 t/d浮法玻璃熔窑脱硫工艺的现场实验,取得了预期效果。实验过程的工艺参数控制如下:1)输送风机2台,一台直通,一台开度为30%～35%;引风机2台,一用一备,开度70%～85%;通过输送风机和引风机的联动调节,控制窑压在4±1Pa范围内。2)通过热电偶的温度检测,自动进行补减水量和微动调节闸阀控制烟气进塔温度在180～200℃。3)合理调整双翼闸板开度在75%～85%,既满足窑压要求,又能控制烟气进塔流速在8～10 m/s。     

Comparison of batch leaching tests and influence of pH on the release of metals from construction and demolition wastes

Construction and demolition wastes are suitable for use in road construction. However, leaching characterization of recycled materials is required to determine their pollutant potential and the consequence of their application in different scenarios. The motivation of this paper is derived from the increasing use of different leaching test methods. In Europe, the confusion resulting from the wide variety of tests used to evaluate environmental properties of construction materials implies that an evaluation of the current practices and the attempt to consolidate the approaches are required.Two equilibrium-based leaching tests (the Dutch test and the European standard) were conducted to assess the environmental impact of four recycled aggregates. Three natural limestone aggregates were used as controls. Both tests measure the potential release of hazardous elements under extreme conditions using different leaching parameters (L/S ratio, pH value and contact time). The results proved that pH is the most relevant factor on the assessment of the differences between leaching methods due to its strong control on the pollutant release.To classify the materials according to their environmental effects, the concentration limit values of the metals imposed by Council Decision 2003/33/EC were used as a reference. The comparison allowed the classification of the recycled aggregates as inert wastes, with the exception of the MR-2 aggregate, which was classified as non-hazardous material.     

工业贮池防腐材料及其施工性能

总结了常用的工业贮池防腐蚀处理方法、防腐蚀材料的性能及施工过程和要点,比较了玻璃钢衬里、玻璃鳞片与乙烯基酯树脂混合衬里和耐酸块材砌筑等防腐蚀处理工艺的工艺条件,并介绍了玻璃钢衬里工艺中所用树脂的类型及性能.     

耐酸胶泥用于脱硫烟囱防腐的可行性初探

结合一失败案例,探讨了耐酸胶泥内衬用于脱硫烟囱排烟筒防腐的技术可行性。从设计、施工、材料特性等方面进行了分析,得出了耐酸胶泥内衬在脱硫后湿烟囱排烟筒中应慎用的结论。     

真空碳热还原法无害化处理废弃阴极射线管锥玻璃的研究

危险电子废物阴极射线管(cathode ray tube,CRT)是当前我国电子垃圾处理处置中首要必须解决的难题,其关键在于含铅锥玻璃的处珲处置.本研究探讨了真空碳热还原法从CRT锥玻璃中分离并回收有害重会属铅的同时同收钾和钠的规律.结果表明,铅、钾和钠的回收率随温度的升高、压力的降低、碳加入量的增加及保持时间的延长而增大;当温度为1 000℃、系统压力为10 Pa时,加入10%的碳粉并保持4 h,铅回收率接近100%,钠和钾的回收率分别为65.04%和50.55%.该方法为废弃阴极射线管玻璃的无害化和资源化提供了理论依据和实验数据.     

高效负载型光催化剂制备及其加铂修饰技术

通过光催化氧化五氯苯酚钠实验,结合对催化剂晶型结构、比表面积的表征分析,优化钛酸四丁酯水解制备TiO₂负载型催化剂并加铂修饰的制备条件:R值、烧结温度、粘合剂添加量、空心玻璃珠粒径大小及催化剂中铂含量,从而制备出高效、实用的负载加铂修饰型半导体光催化剂.实验结果表明,当R=10,温度为650℃烧结1h,TiO₂∶硅酸钠∶空心玻璃珠=10∶2.5∶20(W),铂在催化剂中的重量百分比为1.4%～1.6%,空心玻璃珠的粒径为0.5mm时,所制备的加铂修饰负载型催化剂催化活性、使用寿命和牢固度均比较理想.用该催化剂做光催化实验,当反应液初始五氯苯酚钠浓度为100mg/L、pH值为6.5,催化剂投加量为2g/L,通氧气量为1.6mL/s,光照强度为30kW/m²时,五氯苯酚钠2 h光催化氧化率达92.0%.