武夷新区土地利用变化及景观格局研究

以2010年的LandsatTM遥感影像图和武夷新区总体规划中新区2030年土地利用规划图为基础数据,在RS和GIS技术支持下,结合马尔科夫模型和景观生态学方法分析了未来武夷新区的土地利用与案观格局变化。结果表明：在规划实施后,建设用地通过占用耕地和林地而大面积增加,使得林地和耕地相应减少,人类活动对景观的干扰强度增大,区域景观斑块形状趋于规则简单化,斑块总数有所减少,平均斑块面积增大,景观连接度增强,破碎化程度降低,景观多样性增加。     

排污权交易指标关联要素探讨

目前,排污权有偿使用和交易作为各地环保工作体制、机制创新的热点,是利用经济手段促进环境保护的有益尝试。本文从指标来源、指标使用期限、与污染减排的关系、技术支撑以及指标交易后续监管五个方面分析了排污权交易指标关联要素,得出交易指标与国家政策、污染减排以及环境监管密切相关的结论,从完善国家政策、强化与污染减排衔接和突出指标后续监管三个方面提出了相应的对策建议。     

土地利用方式改变对红树林沉积物中营养元素含量的影响

以广西、广东、海南等地代表性红树林湿地为对象,研究红树林湿地利用方式的改变对沉积物有机碳、总硫、总氮和总磷等营养元素的含量变化和影响,结果表明：1）广东和海南红树林区总氮和总磷变化相似,均为：沉积物〉农田〉鱼塘〉光滩,广西大冠沙稍有不同,光滩的氮磷含量最低;有机碳和总硫含量各地稍有差异,但是红树林沉积物中的有机碳,总硫...     

Prompting safety-belt use in the context of a belt-use law: the flash-for life revisited

PROBLEM: Safety-belt use reduces motor vehicle crash-related morbidity and mortality, yet an estimated 18% of drivers do not consistently buckle up (NHTSA, 2005). In 1985, Geller and colleagues developed an interpersonal Flash-for-Life prompt that increased belt use among 22% of 1,087 unbuckled drivers (Geller, Bruff, & Nimmer, 1985). METHOD: The Flash-for-Life intervention was re-introduced at a large university with high safety-belt use (i.e., 80%). College students stood at parking-lot entrance/exits and "flashed" signs with the message, "Please Buckle Up, I Care" to unbuckled drivers. RESULTS: Of 427 unbuckled drivers observed, 30% of these complied with the prompt. Male drivers were significantly more likely to comply with prompts delivered by females. DISCUSSION: Compliance was higher than in the 1985 study, indicating a high baseline rate of safety-belt use does not negate potential beneficial influence of a prompting intervention. This intervention is particularly effective with college-aged males, a sub-group of the driving population least likely to buckle-up. IMPACT ON INDUSTRY: A simple behavioral prompt could be used at most industrial complexes to increase safety-belt use among vehicle occupants who are not buckled-up.     

Observed LATCH use and misuse characteristics of child restraint systems in seven states

INTRODUCTION: Although the LATCH System (Lower Anchors and Tethers for Children) holds the promise of simplifying the installation of a child restraint system (CRS) to the vehicle's seat, many drivers transporting young children have difficulties using this technology. This paper reports on an observation study of LATCH use and misuse. METHOD: Observations of approximately 1,000 children less than 5 years of age in CRSs, in the back seats of vehicles that were equipped with tether and lower anchors, in seven states. RESULTS: Tethers were used for 51% of the children when the forward-facing CRS had tether straps and the vehicle had tether anchors. Lower anchors were used for 58% of the children when the CRS had lower attachments and the vehicle had lower anchors. The most common tether and lower attachment misuses were loose tether straps (18% of cases) and loose lower attachment installation (30% of the cases), respectively. Vehicle safety belts were used in combination with lower attachments in 20% of all lower anchor installations. CONCLUSION: As more caregivers of young children drive vehicles equipped with LATCH, it will be important to promote the proper installation of CRSs using this technology. LATCH education messages must also emphasize that the lower anchors may not always be the safest choice for CRS attachment -- the safest attachment is the one that results in a tight fit and will be used correctly consistently.     

A direct observation study of nighttime safety belt use in Indiana

INTRODUCTION: Nearly all direct observation studies of safety belt use are conducted exclusively during daylight hours. Recent work has suggested that safety belt use at night may differ from daytime belt use. METHODS: An observational study of nighttime safety belt use, utilizing specialized night vision equipment, was conducted in Indiana surrounding the Click It or Ticket 2006 safety belt mobilization activities. A pre- and a post-mobilization statewide direct observation survey was conducted at night coinciding with daytime safety belt use data collection conducted by the state of Indiana. Daytime and nighttime belt use rates were compared. RESULTS: The comparisons across the mobilization period revealed a significant increase during the day, but a significant decrease at night. Comparisons between daytime and nighttime belt use revealed no overall difference during the pre wave, but a significant difference during the post wave. Finally, many common daytime trends in belt use were also found at night, with the exception of the typical age and seating position effects. DISCUSSION: The mobilization activities had a positive effect on daytime belt use, but no effect on nighttime belt use, likely resulting in the differences between daytime and nighttime belt use observed during the post wave. IMPACT ON INDUSTRY: The findings of this study suggest that safety belt mobilizations implemented only during the day do not influence nighttime safety belt use. Changes to how these programs are implemented or additional programs specifically targeting belt use at night should be considered, along with continued monitoring of nighttime belt use.     

Tropical deforestation in a future international climate policy regime—lessons from the Brazilian Amazon

The possibility of adopting national targets for carbon dioxide (CO₂) emissions from tropical deforestation in a future international climate treaty has received increasing attention recently. This attention has been prompted by proposals to this end and more intensified talks on possible commitments for developing countries beyond the United Nations Framework Convention on Climate Change Kyoto Protocol. We analyze four main scientific and political challenges associated with national targets for emissions from tropical deforestation: (1) reducing the uncertainties in emission inventories, (2) preserving the environmental integrity of the treaty, (3) promoting political acceptance and participation in the regime, and (4) providing economic incentives for reduced deforestation. We draw the following conclusions. (1) Although there are large uncertainties in carbon flux from deforestation, these are in the same range as for other emissions included in the current Kyoto protocol (i.e., non-CO₂ GHGs), and they can be reduced. However, for forest degradation processes the uncertainties are larger. A large challenge lies in building competence and institutions for monitoring the full spectrum of land use changes in developing countries. (2 and 3) Setting targets for deforestation is difficult, and uncertainties in future emissions imply a risk of creating ‘tropical hot air’. However, there are proposals that may sufficiently deal with this, and these proposals may also have the advantage of making the targets more attractive, politically speaking. Moreover, we conclude that while a full carbon accounting system will likely be politically unacceptable for tropical countries, the current carbon accounting system should be broadened to include forest degradation in order to safeguard environmental integrity. (4) Doubts can be cast over the possible effect a climate regime alone will have on deforestation rates, though little thorough analysis of this issue has been made.

浅析电子废弃物回收利用及危害解决办法

随着高科技的发展和人们需求的增长,电子产品不断推陈出新,电子废弃物成为世界上数量增长最快的垃圾."电子垃圾",主要包括各种使用后废弃的电脑、通信设备、电视机、电冰箱、洗衣机等电子电器产品.电子废弃物不规范回收处理易造成污染.电子废弃物中含有很多可回收再利用的有色金属、黑色金属、玻璃等物质.严格意义上讲,这些电子废弃物,不应称其为电子垃圾,而应称作电子旧货.伴随着电子工业的高速发展,电子废弃物污染不可避免地摆在了我们面前.电子废弃物具有危害性和可利用性.     

Sustainability issues in sheet metal forming processes: an overview

Environmental sustainability in manufacturing is nowadays an urgent and remarkable issue and the main concerns are related to more efficient use of materials and energy.In sheet metal forming processes there is still a lack of knowledge in this field mainly due to the need of a proper modelling of sustainability issues and factors to be taken into account. The aim of this paper is mainly to underline the state of the art from a forming point of view about the sustainability contributions offered in any phase of a product life cycle. Actually, a lack in terms of comprehensive contributions is present in the technical literature, thus, the authors try to give a sort of holistic vision aimed to provide basic guidelines in order to help in identifying the possible solutions with regard to all the phases of a forming product life cycle. The main attention was paid to sheet metal forming technologies. The paper gives an overview of the main topics concerning sheet metal forming problems related to energy and resource efficiency with the aim to stress the principal contributions which may derive from such processes to environmental performances of manufacturing.     

基于ARDL方法分析福建省资源利用与经济增长关系

运用物质流分析方法以及最新发展的自回归分布滞后模型(ARDL),对福建省1990~2008年资源利用和实际GDP二者关系进行检验和分析.采用了物质流分析指标中直接物质投入来表征区域资源利用量.ARDL边界检验结果表明,资源利用和经济增长间存在稳定的长期均衡关系.进一步通过ARDL模型揭示了区域经济增长对资源利用长期弹性系数,其值约为0.73,通过误差修正模型揭示了短期弹性系数,表明了经济增长到资源利用的长期格兰杰因果关系.对福建省经济增长和资源保护战略提出了政策建议.这一研究思路和方法具有普适性,可以适用于其他地区关于资源利用和经济增长的问题的讨论和研究.