电子束辐照降解水中氯霉素的研究

本研究对氯霉素(CAP)在不同条件下的电子束辐照降解进行了研究.结果表明,电子束辐照可有效去除水中CAP,低浓度CAP在酸性条件下的辐照降解更为显著,且降解过程符合准一级动力学模型.通过添加不同的自由基清除剂,发现HO·在CAP降解中起关键作用,此外,CAP分子也会吸收辐照而发生分解.水中共存的阴离子和腐殖酸(HA)对CAP辐照降解均有抑制作用,这跟其与HO·的反应速率常数大小有关,并且反应速率越大,其抑制能力越强.CAP在去离子水中的去除率高于其他实际水体,但辐照剂量为4 k Gy时,污水厂污水过滤水和胶体浓缩液中的CAP也可分别去除89.1%和81.7%.利用GC-MS检测到辐照后溶液中有6种中间产物,主要是通过脱水、不对称中心断键和脱酰胺作用形成.此外,IC检测有Cl-、NO-3和NO-2的产生,并且TOC在一定程度上降低,说明部分CAP被矿化.     

In field arsenic removal from natural water by zero-valent iron assisted by solar radiation

An in situ arsenic removal method applicable to highly contaminated water is presented. The method is based in the use of steel wool, lemon juice and solar radiation. The method was evaluated using water from the Camarones River, Atacama Desert in northern Chile, in which the arsenic concentration ranges between 1000 and 1300 μg L⁻¹. Response surface method analysis was used to optimize the amount of zero-valent iron (steel wool) and the citrate concentration (lemon juice) to be used. The optimal conditions when using solar radiation to remove arsenic from natural water from the Camarones river are: 1.3 g L⁻¹ of steel wool and one drop (ca. 0.04 mL) of lemon juice. Under these conditions, removal percentages are higher than 99.5% and the final arsenic concentration is below 10 μg L⁻¹. This highly effective arsenic removal method is easy to use and inexpensive to implement.     

γ-射线辐照降解水中阿莫西林

研究了60Coγ-射线辐照条件下水中阿莫西林(AMX)的辐照降解,考察了AMX初始浓度、辐照剂量、p H、H2O2、自由基消除剂(碳酸氢钠和正丁醇)以及溶解氧等因素对AMX辐照降解的影响。结果表明,γ辐照可有效降解水中AMX,当AMX初始浓度为10.0 mg/L,辐照剂量为15 k Gy时,降解率达100%,随着AMX浓度增大,其降解率降低。碱性条件有利于AMX的降解,当p H为11,且辐照剂量大于10 k Gy时,AMX的降解率在90%以上。同时,加入H2O2可以促进AMX的降解;·OH自由基消除剂的存在和缺氧条件会明显抑制γ-射线对AMX的辐照降解,分析表明,AMX的降解主要是基于·OH自由基的氧化。     

通风口高度对太阳能烟囱建筑自然通风和自然排烟性能的影响研究

安装太阳能烟囱后的建筑具有效果优良、节能环保的自然通风系统。室内通风口高度是太阳能烟囱建筑性能的关键参数之一。提出通过改变太阳能烟囱建筑室内通风口高度位置,使太阳能烟囱既可用于建筑的日常自然通风,也能实现室内火灾场景下的自然排烟。利用缩比例实验台研究了不同室内通风口高度对太阳能烟囱建筑自然通风与自然排烟效果的影响,发现自然通风和自然排烟效果随通风口高度增加呈现先增大后减小的趋势,且最佳室内通风口高度位于窗户上檐位置附近。研究结果对太阳能烟囱建筑的建筑结构关键参数设计具有指导意义。     

Photodegradation of azithromycin in various aqueous systems under simulated and natural solar radiation: kinetics and identification of photoproducts

This article describes the photolysis of azithromycin, a macrolide antibiotic with reported occurrence in environmental waters, under simulated solar radiation. The photodegradation followed first-order reaction kinetics in five matrices examined. In HPLC water, the degradation rate was the slowest (half-life: 20 h), whereas in artificial freshwater supplemented with nitrate (5 mg L⁻¹) or humic acids (0.5 mg L⁻¹) the degradation of azithromycin was enhanced by factors of 5 and 16, respectively, which indicated the role of indirect photolysis involving the formation of highly reactive species. Following chromatographic separation on a UPLC system, the characterization of the transformation products was accomplished using high-resolution QqToF-MS analysis. The presence of seven photoproducts was observed and their formation was postulated to originate from (bis)-N-demethylation in the desosamine sugar, O-demethylation in the cladinose sugar, combinations thereof, as well as from hydrolytic cleavages of the desosamine and/or cladinose residue. Two of these photoproducts could also be detected in natural photodegradation process in river water which was spiked with azithromycin.     

某退役后辐照装置的辐射水平监测与评价

依据国家相关标准对某退役后辐照装置周围的辐射水平进行监测与评价,通过数据评价得出该单位辐照装置退役场所未受到放射性污染,其退役后对环境的辐射影响可以忽略。     

Fast,cheap, and imperfect? US public opinion about solar geoengineering

ABSTRACT

Solar geoengineering, which seeks to cool the planet by reflecting a small fraction of sunlight back into space, has drawn the attention of scientists and policymakers as climate change remains unabated. Unlike mitigation, solar geoengineering could quickly and cheaply lower global temperatures. It is also imperfect. Its environmental impacts remain unpredictable, and its low cost and immediate effects may result in ‘moral hazard,’ potentially crowding out costly mitigation efforts. There is little understanding about how the public will respond to such tradeoffs. To address this, a 1000-subject nationally representative poll focused on solar geoengineering was conducted as part of the Cooperative Congressional Election Study (CCES) of the US electorate in October–November 2016. The importance that individuals place on solar geoengineering’s speed and cost predicts their support for it, but there is little to no relationship between their concerns about its shortcomings and support for its research and use. Acquiescence bias appears to be an important factor for attitudes around solar geoengineering and moral hazard.     

Sustainability of silicon feedstock for a low-carbon society

We need to ensure the sustainable management of advanced materials, such as purified silicon, that contribute to a low-carbon society. Because a drastic increase in the demand for photovoltaic (PV) systems is tightening the supply of silicon for PV cells, the sustainability of silicon feedstock needs to be explored. For this purpose, a material flow analysis of silicon in Japan from 1996 to 2006 is presented in this paper. Our analysis finds that rapid growth in demand for polycrystalline silicon (pc-silicon) and single crystalline silicon (sc-silicon) has changed the structure of the purified silicon supply. The strong demand for purified silicon for solar cells is responsible for this change. While off-grade silicon obtained as a by-product of electronic-grade silicon (EG-Si) covered the demand for solar sells before 2000, pc-silicon is currently produced independently for solar cells via an energy-intensive process. Analysis of the resource effective-use index (REI), which indicates how effectively purified silicon is used, shows progress in the effective use of pc- and sc-silicon. REI analysis indicates that the effective use of pc-silicon is reaching a maximum, while the effective use of sc-silicon is advancing, with a corresponding increase in price. To ensure a sustainable supply of silicon feedstock, this paper proposes four solutions: (1) production of solar-grade pc-silicon by a less costly and less energy-consuming method; (2) reduction in the amount of crystalline silicon per watt in solar cells; (3) acceleration of the development and deployment of other solar cell types; and (4) reuse and recycling of solar cells in the future.     

超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

紫外辐照-催化湿式过氧化氢氧化技术处理酸性大红GR染料废水

采用自制的负载型CuO-ZnO-CeO2/γ-Al2O3催化剂,常温常压下通过紫外辐照-催化湿式氧化技术处理酸性大红GR模拟染料废水。考察了催化剂加入量、H2O2加入量、废水pH、反应时间、初始酸性大红GR质量浓度等对废水脱色率的影响。实验得到最佳工艺条件为初始酸性大红GR质量浓度200mg/L,催化剂加入量10.0g/L,H2O2加入量2.0mL/L,废水pH4,反应时间2h。最佳工艺条件下废水脱色率达99.33%。