地面水中叶枯灵的高效液相色谱测定

本文采用反相高效液相色谱法，在质控条件下，对河水，塘水两种地面水中叶枯灵的检验方法进行了测试，用Shimapck ODS柱为分析柱，以甲醇：水＝50：50为流动相，并用冰醋酸调PH至4－5，紫外检测波长281nm，两种水样的平均回收率分别为91．7－96．3％，90－95．8％，相对标准偏差为4．3％，最低检出限为0．0261mg/l，为地面水中叶枯灵卫生标准的实施提供了简便，灵敏，正确的配套测试手段。     

Preferred surface microscopic geometric features on floors as potential interventions for slip and fall accidents on liquid contaminated surfaces

PROBLEM: Surface roughness affects friction, so selection of floor surfaces with certain roughness characteristics could potentially reduce slip and fall accidents. This article summarizes the preferred surface microscopic geometric features that could increase friction on surfaces covered with liquid contaminants. METHOD: Three types of surface features, represented by the average of the maximum height above the mean line in each cut-off length (R(pm)), the arithmetical average of surface slope (Delta(a)), and the kernel roughness depth (R(k)), are identified as preferred surface microscopic geometric features for a higher friction. The proper settings on the profilometers (instruments used to measure surface roughness) for optimizing these surface parameters are specified. The friction mechanisms involved reveal why these features are more desirable. RESULTS: Although surface roughness is important in determining slipperiness, there is still insufficient information to establish a safety criterion based on roughness; however, the method presented in this paper can readily provide a relative comparison. IMPACT ON INDUSTRY: The summary presented will help safety professionals properly select new floor surfaces or assess existing floors to reduce slip and fall accidents.     

Chemical Treatments of Natural Fiber for Use in Natural Fiber-Reinforced Composites: A Review

Studies on the use of natural fibers as replacement to man-made fiber in fiber-reinforced composites have increased and opened up further industrial possibilities. Natural fibers have the advantages of low density, low cost, and biodegradability. However, the main disadvantages of natural fibers in composites are the poor compatibility between fiber and matrix and the relative high moisture sorption. Therefore, chemical treatments are considered in modifying the fiber surface properties. In this paper, the different chemical modifications on natural fibers for use in natural fiber-reinforced composites are reviewed. Chemical treatments including alkali, silane, acetylation, benzoylation, acrylation, maleated coupling agents, isocyanates, permanganate and others are discussed. The chemical treatment of fiber aimed at improving the adhesion between the fiber surface and the polymer matrix may not only modify the fiber surface but also increase fiber strength. Water absorption of composites is reduced and their mechanical properties are improved.     

Retrieval of refractive index of ultrafine single particle using hygroscopic growth factor obtained by high sensitive surface plasmon resonance microscopy

When exposed to different relative humidities (RHs), the optical properties of atmospheric aerosols will change because of changes in the aerosol particle size and complex refractive index (RI), which will affect haze formation and global climate change. The potential contributions of ultrafine particles to the atmospheric optical characteristics and to haze spreading cannot be ignored because of their high particle number concentrations and strong diffusibility; measurement of the optical properties of wet ultrafine particles is thus highly important for environmental assessment. Therefore, a surface plasmon resonance microscopy with azimuthal rotation illumination (SPRM-ARI) system is designed to determine the RIs of single particle aerosols with diameters of less than 100 nm in the hygroscopic growth process. Measurements are taken using mixed single particles with different mass ratios. The RIs of mixed single aerosols at different RHs are retrieved by measuring the scattering light intensity using the SPRM-ARI system and almost all the RIs of the bicomponent particles with different mass ratios decrease with increasing water content under high RH conditions. Finally, for each of the bicomponent particles, the maximum standard deviations for the retrieved RI values are only $2.06\times {10}^{-3}$, $3.08\times {10}^{-3}$ and $3.83\times {10}^{-3}$, corresponding to the NaCl and NaNO₃ bicomponent particles with a 3:1 mass ratio at 76.0% RH, the NaCl and glucose particles with a 1:3 mass ratio at 89.0% RH, and the NaCl and OA particles with a 1:1 mass ratio at 78.0% RH, respectively; these results indicate that the high-sensitivity SPRM-ARI system can measure the RI effectively and accurately.     

Predicting the aquatic risk of realistic pesticide mixtures to species assemblages in Portuguese river basins

Although pesticide regulatory tools are mainly based on individual substances, aquatic ecosystems are usually exposed to multiple pesticides from their use on the variety of crops within the catchment of a river. This study estimated the impact of measured pesticide mixtures in surface waters from 2002 and 2008 within three important Portuguese river basins (‘Mondego’, ‘Sado’ and ‘Tejo’) on primary producers, arthropods and fish by toxic pressure calculation. Species sensitivity distributions (SSDs), in combination with mixture toxicity models, were applied. Considering the differences in the responses of the taxonomic groups as well as in the pesticide exposures that these organisms experience, variable acute multi-substance potentially affected fractions (msPAFs) were obtained. The median msPAF for primary producers and arthropods in surface waters of all river basins exceeded 5%, the cut-off value used in the prospective SSD approach for deriving individual environmental quality standards. A ranking procedure identified various photosystem II inhibiting herbicides, with oxadiazon having the relatively largest toxic effects on primary producers, while the organophosphorus insecticides, chlorfenvinphos and chlorpyrifos, and the organochloride endosulfan had the largest effects on arthropods and fish, respectively. These results ensure compliance with European legislation with regard to ecological risk assessment and management of pesticides in surface waters.     

Fabrication of ion doped WO3 photocatalysts through bulk and surface doping

Na⁺ doped WO₃ nanowire photocatalysts were prepared by using post-treatment (surface doping) and in situ (bulk doping) doping methods. Photocatalytic degradation of Methyl Blue was tested under visible light irradiation, the results showed that 1 wt.% Na⁺ bulk-doped WO₃ performed better, with higher photoactivity than surface-doped WO₃. Photoelectrochemical characterization revealed the differences in the photocatalytic process for surface doping and bulk doping. Uniform bulk doping could generate more electron–hole pairs, while minimizing the chance of electron–hole recombination. Some bulk properties such as the bandgap, Fermi level and band position could also be adjusted by bulk doping, but not by surface doping.     

Respective contributions of point and non-point sources of E. coli and enterococci in a large urbanized watershed (the Seine river, France)

Because the large rivers of the Seine watershed have a low microbiological water quality, the main sources of fecal contamination were investigated in the present study. The inputs of the point (wastewater treatment plants (WWTPs) effluents) and non-point sources (surface runoff and soil leaching) of fecal bacteria were quantified for Escherichia coli and intestinal enteroccoci used as bacterial indicators. In order to assess the contamination through non-point sources, fecal indicators abundance was estimated in samples collected in small streams located in rural areas upstream from all point sources; these small rivers were characterized by the land use of their watershed. Bacterial indicator numbers were also measured in effluents of WWTPs, some using classical treatment (settling followed by activated sludge process) and some using an additional disinfection stage (UV irradiation). These data were used to estimate the respective importance of each type of source at the scale of the whole Seine river watershed taking into account the land use and the population density. It shows the predominant importance of the point sources of fecal indicator bacteria at the scale of the whole watershed. In a scenario in which activated sludge treatment would be complemented with UV in all WWTPs located in this watershed, the non-point sources of fecal indicator bacteria would be dominant.     

The integrated project AquaTerra of the EU sixth framework lays foundations for better understanding of river-sediment-soil-groundwater systems

The integrated project "AquaTerra" with the full title "integrated modeling of the river-sediment-soil-groundwater system; advanced tools for the management of catchment areas and river basins in the context of global change" is among the first environmental projects within the sixth Framework Program of the European Union. Commencing in June 2004, it brought together a multidisciplinary team of 45 partner organizations from 12 EU countries, Romania, Switzerland, Serbia and Montenegro. AquaTerra is an ambitious project with the primary objective of laying the foundations for a better understanding of the behavior of environmental pollutants and their fluxes in the soil-sediment-water system with respect to climate and land use changes. The project performs research as well as modeling on river-sediment-soil-groundwater systems through quantification of deposition, sorption and turnover rates and the development of numerical models to reveal fluxes and trends in soil and sediment functioning. Scales ranging from the laboratory to river basins are addressed with the potential to provide improved river basin management, enhanced soil and groundwater monitoring as well as the early identification and forecasting of impacts on water quantity and quality. Study areas are the catchments of the Ebro, Meuse, Elbe and Danube Rivers and the Brévilles Spring. Here we outline the general structure of the project and the activities conducted within eleven existing sub-projects of AquaTerra.     

Distribution of uranium isotopes in surface water of the Llobregat river basin (Northeast Spain)

A study is presented on the distribution of ²³⁴U, ²³⁸U, ²³⁵U isotopes in surface water of the Llobregat river basin (Northeast Spain), from 2001 to 2006. Sixty-six superficial water samples were collected at 16 points distributed throughout the Llobregat river basin. Uranium isotopes were measured by alpha spectrometry (PIPS detectors). The test procedure was validated according to the quality requirements of the ISO17025 standard. The activity concentration for the total dissolved uranium ranges from 20 to 261 mBq L⁻¹. The highest concentrations of uranium were detected in an area with formations of sedimentary rock, limestone and lignite. A high degree of radioactive disequilibrium was noted among the uranium isotopes. The ²³⁴U/²³⁸U activity ratio varied between 1.1 and 1.9 and the waters with the lowest uranium activity registered the highest level of ²³⁴U/²³⁸U activity ratio. Correlations between uranium activity in the tested water and chemical and physical characteristics of the aquifer were found.     

Entry and toxicity of organic pesticides and copper in vineyard streams: Erosion rills jeopardise the efficiency of riparian buffer strips

The present study was performed to characterise in-stream pesticide exposure within the Palatinate vineyard region in south-west Germany, evaluate the influence of buffer strip widths and identify mitigation measures for the relevant entry pathways. In-stream water and sediment samples that were taken at nine sampling sites of different buffer widths following intense rainfall, and edge-of-field runoff that were sampled in erosion rills were analysed regarding 28 active ingredients of pesticides including copper. In-stream samples contained a mix of 8 ± 4 pesticide compounds, resulting in total pesticide concentrations of 1.4-8.9 μg l⁻¹ for water and 16-670 μg kg⁻¹ dw for sediment. Following an exceptional rainfall event with a previous 34-day drought period, pesticide concentrations reached 7.0-83.4 μg l⁻¹. Fungicides were the most important pesticides found and were significantly correlated with the pesticide application frequency and rate. The calculated toxicity values per sample (TU_max) indicated that both organic pesticides and copper concentrations likely cause ecotoxicological effects in the field. The buffer strip width was of little importance for pesticide in-stream concentrations because pesticide entry occurred mainly via the field path network and erosion rills. Pesticide in-stream concentrations were significantly and positively correlated with the concentrations detected in erosion rills (R² = 0.56). As possible risk mitigation measures, we suggest the implementation of grassed field paths and vegetated ditches or wetlands.