Thermodynamics of interaction of lindane on silty loam and silty clay loam Indian soils

Abstract

Interaction of lindane with silty loam and silty clay loam soils was studied in batch tests at 23, 30 and 37° C. Sorption experiments were carried out at four concentrations and for varying time of contact upto 72 hours. This was followed by desorption studies. No desorption was observed. The sorption data was analysed using sorption equations and evaluating the thermodynamic parameters. The sorption was found to be predominantly entropic in nature and a combined effect of adsorption and chemisorption. The effect of organic matter and other chemical and mineralogical constituents of soils has also been discussed. The sorption with single application of lindane with the two soil types indicates that the insecticide is less likely to reach groundwater.     

山西省耕地资源的开发与保护

文章从山西能源基地建设为出发点,分析了山西省耕地资源利用的现状特点,提出了耕地资源合理利用的途径以及保护性措施。     

A COMPARISON OF STREAMFLOW GENERATION MODELS FOR RESERVOIR CAPACITY-YIELD ANALYSIS1

ABSTRACT: An analysis of four streamflow generation schemes for the use in the estimation of the required conservation storage for a single reservoir is presented. The comparison of the generating schemes should aid in the selection of an appropriate model type for the reservoir sizing problem. The streamflow generation models are compared using two criteria. The first comparison is between the statistics of the generated streamflow sequences and the corresponding statistics from the historical record. The second evaluation compares the median reservoir size determined by each model with the required storage based on the historical flow sequence. The results of a comparative analysis for monthly streamflow data for the Rzav River in Yugoslavia are presented and discussed. The results indicate that both evaluation criteria are required to discriminate between the various options.     

Storage stability of injection-molded starch-zein plastics under dry and humid conditions

Corn starch and zein mixtures (4 : 1 dry weight) were extruded and injection-molded in the presence of plasticizers (glycerol and water). Tensile strength and percentage elongation of the molded plastics were measured before and after 1 week of storage under a dry or humid condition (11 or 93% RH). With 10–12% glycerol and 6–8% water, injection-molded plastics had relatively good tensile properties (20- to 25-MPa tensile strength and 3.5–4.7% elongation). But while exposed to dry conditions (11% RH), the molded plastics lost weight (0.5–1.5% in 7 days) and became very brittle, with significant decreases in tensile strength and elongation. Partial replacement (5–10%) of starch with a maltodextrin (average DE 5) reduced the glass transition and melting temperatures of the starch-zein mixture as well as the dry storage stability. Using potato starch instead of corn starch significantly improved the dry storage stability of the injection-molded starch-zein plastics (18- vs 11-MPa tensile strength). Anionic corn starches with a maleate or succinate group (DS<0.01) produced injection-molded plastics with improved tensile properties and storage stability. Plastics prepared from the starch maleate and zein mixture retained the strength during 1 week of dry storage without a significant change (26-MPa tensile strength and 3.7% elongation after 1 week of storage).Paper presented at the Bio/Environmentally Degradable Polymer Society—Second National Meeting, August 19–21, 1993, Chicago, Illinois.Journal paper No. J-15561 of the Iowa Agriculture and Home Economics Experiment Station, Ames, Iowa, Project No. 2863.     

SUSPENDED SEDIMENT AND METALS REMOVAL FROM URBAN RUNOFF BY A SMALL LAKE1

ABSTRACT: A small lake in the Chicago Metropolitan Area was from 91 to 95 percent efficient in removing suspended sediment and from 76 to 94 percent efficient in removing copper, iron, lead, and zinc from urban runoff. Sediments accumulated in the lake in the form of an organic-rich mud at an average rate of 20 millimeters per year; this reduced lake storage and covered potential habitat for aquatic organisms. Copper, lead, and zinc concentrations were closely associated with suspended-sediment concentrations and with silt- and clay-sized fractions of lake sediment. Although concentrations of mercury and cadmium were near detection limits in runoff, measurable concentrations of these metals accumulated in the lake sediments.     

几种碳氢燃料与空气混合物相对爆轰敏感度的测定

利用矩形激波管测定了几种碳氢燃料（丁烷，石脑油，ＪＣ５，戊烯，已烯）直接起爆时形成爆轰所需的临界起爆能，并以化学当量比的乙炔氧气混合物直接起爆形成爆轰的临界起爆能为基准，定义了一个无量纲常数Ｄｈ。再利用这个常数，比较了这几种燃料的相对爆轰敏感度。     

ESTIMATION OF ENERGY REQUIREMENTS OF MORNING DEW EVAPORATION FROM LEAF SURFACES1

ABSTRACT: Evapotranspiration from vegetation is generally computed without consideration for early morning energy loss involved in drying wet leaf surfaces. In humid areas where dew formation is frequent, estimation of energy requirements for evaporating dew should be of interest. In this study, sensible heat flux (H) was computed from wind and temperature profile measurements over the study site. A leaf wetness sensor was used to measure the duration of evaporation from an exposed leaf surface, and net radiation was measured with a radiometer. The energy flux during the period of wet leaf surface evaporation was integrated over time. A cattail lysimeter situated at the site indicated the time when evapotranspiration started after wet leaves were dry. The energy requirements to dry an exposed wet leaf surface was estimated using energy balance methods. The mean value based on 44 days of observations from mid February to early May of 1993 indicates that the energy required to evaporate dew from openly exposed wet leaves was 5 percent of the total daily evapotranspiration of cattails with a coefficient of variation of 0.72. The mean time required to evaporate dew from exposed leaf surfaces from the onset of positive net radiation was 78 minutes. The mean dew evaporation in a morning from an exposed leaf surface was 0.16 mm with a maximum value of 0.41 mm. The energy required to dry wet leaves is a factor that should be considered when modeling evapotranspiration at hourly or shorter time intervals. Also, physical evapotranspiration models need to account for energy requirements for drying dew and rainfall wetted leaves.     

Effects of increased wood energy consumption on carbon storage in forests of the United States

Large but feasible increases that have been projected for the production of wood energy in the United States can be expected to significantly alter the current carbon storage patterns in US forest vegetation. The 1976 net wood increment left after forest cutting equals about 136 × 10⁶ tons of carbon/year, with about 60% of the increment found in merchantable trees, and the remainder in nonmerchantable components.Achieving 5–10 quads of wood energy beyond 1976 levels by the year 2010 can significantly change current carbon storage patterns with the magnitude of change dependent on the extent of residue harvest to meet energy goals, and the rate of future forest growth. Complete loss of the apparent net wood increment is a possible outcome.Although the future growth and harvest situation cannot be known now, a range of possible scenarios suggests that US forests in the year 2010 will store much less carbon than today, thus significantly changing their role in the global carbon cycle.     

Developing of a pricing model for Turkish lignite used in thermal plants

The objective of this paper is to develop a general pricing model for Turkish Lignite, which is mainly sold to thermal plants. This model will contribute to the development of coal mining within the scope of privatization efforts of the Turkish energy market. The paper consists of two stages. First, data of 10 thermal plants have been evaluated by using hedonic pricing analysis to determine influential price parameters. The results of hedonic regression analysis indicate the effect and importance of calorific value and electricity price on lignite prices. Second, a general coal-pricing model has been developed by taking into account the results of hedonic analysis. Comparison of the coal prices estimated by the developed pricing model and the coal prices obtained from thermal plants indicates an acceptable relation.     

ASSESSING FLOOD MITIGATION ALTERNATIVES IN SHIJR AREA IN METROPOLITAN TAIPEI1

The Keelung River Basin in northern Taiwan lies immediately upstream of the Taipei metropolitan area. The Shijr area is in the lower basin and is subject to frequent flooding. This work applies micromanagement and source control, including widely distributed infiltration and detention/ retention runoff retarding measures, in the Wudu watershed above Shijr. A method is also developed that combines a genetic algorithm and a rainfall runoff model to optimize the spatial distribution of runoff retarding facilities. Downstream of Wudu in the Shijr area, five dredging schemes are considered. If 10‐year flood flows cannot be confined in the channel, then a levee embankment that corresponds to the respective runoff retarding scheme will be required. The minimum total cost is considered in the rule to select from the regional flood mitigation alternatives. The results of this study reveal that runoff retarding facilities installed in the upper and middle parts of the watershed are most effective in reducing the flood peak. Moreover, as the cost of acquiring land for the levee embankment increases, installing runoff retarding measures in the upper portion of the watershed becomes more economical.