截齿截割煤体变形破坏过程数值模拟研究

采用应变软化的模型,使用连续介质快速拉格朗日分析法(FLAC,FastLagrangianAnaly-sisofContinue)进行数值模拟计算;研究截齿截割作用下煤体变形破坏过程;分析各种工况下不同参数对煤体塑性区、最大位移、最大主应力、最大剪应力的影响。研究表明:截割力与塑性区大小成正比,位移、剪应力、主应力随截割力增大而增大;截深与塑性区大小成反比;截割角度与塑性区面积关系密切,试验用煤体最佳截割角度为5°左右;截割速度增加,塑性区面积减小;通过分析截割动态过程,得到位移矢量图及剪应变等值线图,发现截割过程中煤体的破坏是拉、剪联合作用的结果,以剪破坏为主。     

Mechanical and Barrier Properties of Biodegradable Films Made from Chitosan and Poly (Lactic Acid) Blends

Biodegradable film blends of chitosan with poly(lactic acid) (PLA) were prepared by solution mixing and film casting. The main goal of these blends is to improve the water vapor barrier of chitosan by blending it with a hydrophobic biodegradable polymer from renewable resources. Mechanical properties of obtained films were assessed by tensile test. Thermal properties, water barrier properties, and water sensitivity were studied by differential scanning calorimeter analysis, water vapor permeability measurements, and surface-angle contact tests, respectively. The incorporation of PLA to chitosan improved the water barrier properties and decreased the water sensitivity of chitosan film. However, the tensile strength and elastic modulus of chitosan decreased with the addition of PLA. Mechanical and thermal properties revealed that chitosan and PLA blends are incompatible, consistent with the results of Fourier transform infrared (FTIR) analysis that showed the absence of specific interaction between chitosan and PLA.     

除湿机的冷凝水化学成分与空气环境质量的关系

本文采用家用除湿机作为空气水溶性物质采样器方法，并验证了该方法作为空气水溶性物质采样嚣的可行性。本文通过空气冷凝水化学成分与空气总悬浮微粒(TSP)可溶性化学成分的对比，得到水汽中大部分阴阳离子的含量只比TSP低1个数量级，而水汽中的微量元素含量与各种碳的浓度不都比TSP低，TSP中一般检测不出亚硝酸根，而水汽中则检出大量亚硝酸根。     

MODELING SEDIMENT AND PHOSPHORUS LOSSES IN AN AGRICULTURAL WATERSHED TO MEET TMDLs1

ABSTRACT: This paper studies the effectiveness of alternative farm management strategies at improving water quality to meet Total Maximum Daily Loads (TMDLs) in agricultural watersheds. A spatial process model was calibrated using monthly flow, sediment, and phosphorus (P) losses (1994 to 1996) from Sand Creek watershed in south‐central Minnesota. Statistical evaluation of predicted and observed data gave r² coefficients of 0.75, 0.69, and 0.49 for flow (average 4.1 m³/s), sediment load (average 0.44 ton/ha), and phosphorus load (average 0.97 kg/ha), respectively. The calibrated model was used to evaluate the effects of conservation tillage, conversion of crop land to pasture, and changes in phosphorus fertilizer application rate on pollutant loads. TMDLs were developed for sediment and P losses based on existing water quality standards and guidelines. Observed annual sediment and P losses exceeded these TMDLs by 59 percent and 83 percent, respectively. A combination of increased conservation tillage, reduced application rates of phosphorus fertilizer, and conversion of crop land to pasture could reduce sediment and phosphorus loads by 23 percent and 20 percent of existing loads, respectively. These reductions are much less than needed to meet TMDLs, suggesting that control of sediment using buffer strips and control of point sources of phosphorus are needed for the remaining reductions.     

CHEMISTRY OF COALBED METHANE DISCHARGE WATER INTERACTING WITH SEMI‐ARID EPHEMERAL STREAM CHANNELS1

ABSTRACT: The objective of this study was to examine the chemistry of Coalbed Methane (CBM) discharge water reacting with semi‐arid ephemeral stream channels in the Powder River Basin, Wyoming. The study area consisted of two ephemeral streams: Burger Draw and Sue Draw. These streams are tributaries to the perennial Powder River. Samples were collected bimonthly from three CBM discharge points and seven channel locations in Burger Draw and Sue Draw. Samples were also collected bimonthly from the Powder River above and below the confluence of Burger Draw. Before sample collection, the pH and electrical conductivity (EC) were measured in the field. Samples were transported to the laboratory and analyzed for alkalinity, major cations, and anions. From the measurement of sodium (Na), calcium (Ca), and magnesium (Mg), practical sodium adsorption ratio (SARp) and true sodium adsorption ratio (SARt) were calculated. Results suggest pH and EC of CBM discharge water was 7.1 and 4.3 dS/m, respectively. The CBM discharge water consisted of higher concentrations of sodium and alkalinity compared to other components. The pH of CBM discharge water increased significantly (p = 0.000) in the downstream channel of Burger Draw from 7.1 to 8.84 before it joined with the Powder River. Dissolved calcium concentration of CBM discharge water decreased significantly (p = 0.000) in the downstream channel water. Subsequently, SARp increased approximately from 24 to 29. The SARt also increased significantly (p = 0.001) in the downstream channel water. For instance, SARt of CBM discharge water increased from 32.93 to 45.5 downstream channels after the confluence of Sue Draw with the Burger Draw. The only significant difference in water chemistry above and below the confluence of Burger Draw with the Powder River was pH, which increased from 8.36 to 8.52. The significant increase in SAR values of CBM discharge water in Burger Draw and Sue Draw tributaries suggest a careful monitoring of salinity and sodicity is needed if CBM discharge water is used for irrigation in semi‐arid environments. Results discussed in this study will be useful to downstream water users who depend on water for irrigation.     

基于CAN总线的分布式安全报警系统

CAN总线是一种多主站局部网络 ,支持分布式控制系统或实时控制系统的通信功能 ,具有检错功能强 ,抗干扰 ,传输速率高等优点 ,广泛应用于工业控制领域。笔者以CAN总线技术为基础 ,用单片机和个人计算机组成分布式安全报警系统 ,该系统具有开放性、全分散体系结构、安装维护简单等特点。笔者介绍了该系统的总体构成及其软件和硬件设计。试验结果表明 ,该系统实现了事故现场、住户与住宅小区三者联系的安全报警功能。系统稳定性好 ,实时性强 ,报警准确。     

基于ArcIMS的旅游安全管理系统

结合旅游业的特点,即综合性、敏感性、涉外性或国际性,提出旅游安全管理系统应该包括:灾前的防范系统、灾时的抗灾系统以及灾后的评估善后系统3大部分的设计思路。将相应的旅游重大危险源监控系统的功能定为:以行政监察、社会监督、行业自律和应急救援体系为主的宏观管理系统。阐述了Web GIS的优点并推荐了一种构建Web GIS的新技术———ArcIMS,利用ArcIMS的系统构建的旅游安全管理系统具有功能健全、管理方便、系统成熟和安全可靠的诸多优点;同时整个系统的构建相对于其他Web GIS系统的开发而言,技术难度比较低、开发速度比较快,而且系统运行相对稳定,减轻了系统维护的负担。最后,结合旅游安全信息流的特点,具体阐述了运用ArcIMS作为旅游安全管理系统的平台的合理性和可行性。     

A multi-objective optimisation approach to water management

The management of river basins is complex especially when decisions about environmental flows are considered in addition to those concerning urban and agricultural water demand. The solution to these complex decision problems requires the use of mathematical techniques that are formulated to take into account conflicting objectives. Many optimization models exist for water management systems but there is a knowledge gap in linking bio-economic objectives with the optimum use of all water resources under conflicting demands. The efficient operation and management of a network of nodes comprising storages, canals, river reaches and irrigation districts under environmental flow constraints is challenging. Minimization of risks associated with agricultural production requires accounting for uncertainty involved with climate, environmental policy and markets. Markets and economic criteria determine what crops farmers would like to grow with subsequent effect on water resources and the environment. Due to conflicts between multiple goal requirements and the competing water demands of different sectors, a multi-criteria decision-making (MCDM) framework was developed to analyze production targets under physical, biological, economic and environmental constraints. This approach is described by analyzing the conflicts that may arise between profitability, variable costs of production and pumping of groundwater for a hypothetical irrigation area.     

Influence of particle size on the aggregation behavior of nanoparticles: Role of structural hydration layer

More and more attention has been paid to the aggregation behavior of nanoparticles, but little research has been done on the effect of particle size. Therefore, this study systematically evaluated the aggregation behavior of nano-silica particles with diameter 130–480 nm at different initial particle concentration, pH, ionic strength, and ionic valence of electrolytes. The modified Smoluchowski theory failed to describe the aggregation kinetics for nano-silica particles with diameters less than 190 nm. Besides, ionic strength, cation species and pH all affected fast aggregation rate coefficients of 130 nm nanoparticles. Through incorporating structural hydration force into the modified Smoluchowski theory, it is found that the reason for all the anomalous aggregation behavior was the different structural hydration layer thickness of nanoparticles with various sizes. The thickness decreased with increasing of particle size, and remained basically unchanged for particles larger than 190 nm. Only when the distance at primary minimum was twice the thickness of structural hydration layer, the structural hydration force dominated, leading to the higher stability of nanoparticles. This study clearly clarified the unique aggregation mechanism of nanoparticles with smaller size, which provided reference for predicting transport and fate of nanoparticles and could help facilitate the evaluation of their environment risks.     

预腐蚀条件下不同孔数冷挤压强化7075-T6铝合金板件疲劳寿命退化规律

目的 研究腐蚀环境下单孔和多孔冷挤压强化铝合金板件的疲劳寿命退化规律和损伤机理。方法 针对2种不同孔距的三孔冷挤压强化7075-T6铝合金板件,采用模拟热带海洋大气环境的实验室加速腐蚀谱,开展不同腐蚀时间下的预腐蚀疲劳试验。结果 获得了3倍孔距的三孔挤压强化铝板以及单孔挤压强化铝板的C(t)曲线、疲劳S-N曲线和损伤形貌特征,分析了腐蚀后挤压强化试件的腐蚀机理及挤压强化作用。同时,将不同孔数试件的试验结果进行比较,探明了孔数对挤压强化铝板腐蚀和疲劳性能的影响。结论 腐蚀后挤压强化铝合金板件的疲劳性能发生显著退化,腐蚀损伤主要为剥蚀,疲劳裂纹萌生位置由孔边转移至表面。挤压孔数量对挤压强化铝合金板件的疲劳和腐蚀疲劳性能的影响较小。