Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

Monitoring Air Quality in Mountains: Designing an Effective Network

A quantitatively robust yet parsimonious air-quality monitoring network in mountainous regions requires special attention to relevant spatial and temporal scales of measurement and inference. The design of monitoring networks should focus on the objectives required by public agencies, namely: 1) determine if some threshold has been exceeded (e.g., for regulatory purposes), and 2) identify spatial patterns and temporal trends (e.g., to protect natural resources). A short-term, multi-scale assessment to quantify spatial variability in air quality is a valuable asset in designing a network, in conjunction with an evaluation of existing data and simulation-model output. A recent assessment in Washington state (USA) quantified spatial variability in tropospheric ozone distribution ranging from a single watershed to the western third of the state. Spatial and temporal coherence in ozone exposure modified by predictable elevational relationships ( 1.3 ppbv ozone per 100 m elevation gain) extends from urban areas to the crest of the Cascade Range. This suggests that a sparse network of permanent analyzers is sufficient at all spatial scales, with the option of periodic intensive measurements to validate network design. It is imperative that agencies cooperate in the design of monitoring networks in mountainous regions to optimize data collection and financial efficiencies.     

阿图什市空气质量变化趋势分析

分析了阿图什市“八五”至“九五”期间空气质量监测数据不同年度、不同季节及不同污染因子的动态变化趋势．结合当地能源结构、气候特征、城市环境综合发展水平，指出影响阿图什市空气质量的主要因素，为防治和减轻阿图什市的空气污染提供了科学依据。     

Distribution of airborne particles from multi-emission source

The purpose of this work was to study the distribution of airborne particles in the surroundings of an iron and steel factory in southern Finland. Several sources of particulate emissions are lying side by side, causing heavy dust loading to the environment. This complicated multi-pollutant situation was studied mainly by SEM/EDX methodology.Particles accumulated on Scots pine bark were identified andquantitatively measured according to their element content,size and shape. As a result, distribution maps of particulateelements were drawn and the amount of different particle typesalong the study lines was plotted. Particulate emissions fromthe industrial or energy production processes were not themain dust source. Most emissions were produced from theclinker crusher. Numerous stockpiles of the industrial wastesand raw materials also gave rise to particulate emissions as aresult of wind erosion. It was concluded that SEM/EDXmethodology is a useful tool for studying the distribution ofparticulate pollutants.     

Trace Metal Concentration in Roadside Surface Soil and Tree Back: A Measurement of Local Atmospheric Pollution in Abuja, Nigeria

Cadmium, copper, lead, nickel and zinc concentrations were analysed by atomic absorption spectrophotometry in surface soil and tree bark from different districts of Abuja, Nigeria, in order to determine the atmospheric trace metal input in the area.Elevated concentrations of some of the studied metals were observed in the soil and tree bark samples from the commercial/high traffic areas of the city compared to backgroundvalues. In soil samples, the average concentration of the metals were 0.6±0.4, 18.0±4.0, 281±39, 16±4 and66±23 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively, whilst the average concentrations in tree bark were 0.3±0.2, 12±4, 133±32, 13±3 and 61±10 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively. The trend in trace metal levels suggested that automobile emissions are a major source of these metals as the highest concentrations of Pb and Zn were recorded in the commercial areas of the city known for their high traffic densities. The levels of metal in the study area were relativelylow compared to levels found in some larger and older cities in various countries worldwide.     

Formulation and Validation of an Empirical Moisture Damage Index

An empirical moisture damage index was developed in order to reduce the subjectivity of the estimation of moisture damage in domestic residences, in relation to occupant health. The database was generated using information gathered from a sample of 164 houses that were examined by civil engineers, and questionnaire data collected from the occupants. The index was formulated to associate with the occupant reported respiratory symptoms by calculating weighted estimates of selected moisture damage attributes using 80% of the sample. The remaining 20% of the sample was used to verify the final index. The index associated strongly with the health symptoms of interest. This index is a tool that may be used as an indicator of moisture damage induced exposure in domestic residences.     

Study on the effect of porous fence on air quality and traffic noise level around a double-decked road structure

Fence for traffic noise control sometimes causes adverse effect on air pollution. Thus in this study, performance of porous fence as a tool for control of both air pollution and noise pollution was evaluated. A two-dimensional numerical model for flow and pollutant concentration and an analytical model for traffic noise were utilized in the analysis of a double-decked road structure with fences only at ground (Case 1) and at both ground and upper deck (Case 2). Porous fences were assumed only at the ground level since the solid fences at the upper deck usually leads to desirable result on air pollution. Effects of the variable porosity on air quality and noise level near road were evaluated. Obtained results showed: (1) flow pattern in leeward of fence was drastically changed at 40–50% porosity in Case 1 and 50% in Case 2. The porosity larger than 40% excluded presence of a circulation behind the fence. (2) Effect of porous fence on air pollution was different in Cases 1 and 2. In Case 1, the porous fence generally resulted in the reduction of air pollution at the ground level; on the other hand, in Case 2, it rather led to increase of the concentration. (3) Traffic noise level was also largely changed by the porosity of the fence; an example of simultaneous evaluation of the effects of porous fence on both air and noise pollution in Case 1 showed that the fence of 60% porosity leads to reduction of air pollution by 20% compared with solid fence case, and reduction of noise pollution by 4–6% in dB compared with no fence case, at l m high and 10 m from the road.     

Risk-Based Prioritization of Air Pollution Monitoring Using Fuzzy Synthetic Evaluation Technique

Air pollution monitoring programs aim to monitor pollutants and their probable adverse effects at various locations over concerned area. Either sensitivity of receptors/location or concentration of pollutants is used for prioritizing the monitoring locations. The exposure-based approach prioritizes the monitoring locations based on population density and/or location sensitivity. The hazard-based approach prioritizes the monitoring locations using intensity (concentrations) of air pollutants at various locations. Exposure and hazard-based approaches focus on frequency (probability of occurrence) and potential hazard (consequence of damage), respectively. Adverse effects should be measured only if receptors are exposed to these air pollutants. The existing methods of monitoring location prioritization do not consider both factors (hazard and exposure) at a time. Towards this, a risk-based approach has been proposed which combines both factors: exposure frequency (probability of occurrence/exposure) and potential hazard (consequence).This paper discusses the use of fuzzy synthetic evaluation technique in risk computation and prioritization of air pollution monitoring locations. To demonstrate the application, common air pollutants like CO, NO_x, PM₁₀ and SO_x are used as hazard parameters. Fuzzy evaluation matrices for hazard parameters are established for different locations in the area. Similarly, fuzzy evaluation matrices for exposure parameters: population density, location and population sensitivity are also developed. Subsequently, fuzzy risk is determined at these locations using fuzzy compositional rules. Finally, these locations are prioritized based on defuzzified risk (crisp value of risk, defined as risk score) and the five most important monitoring locations are identified (out of 35 potential locations). These locations differ from the existing monitoring locations.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

焦作市区大气污染状况与防治措施

根据“九五”期间焦作市区的大气污染监测资料，对市区大气污染状况进行了分析和评价，并对其成因进行了分析，提出了一些具体的防治措施。