自然环境因素对铝合金大气腐蚀的影响性研究

目的 研究铝合金大气腐蚀受自然环境因素的影响性，探索环境因素对铝合金腐蚀的影响规律。方法 采用多层感知器神经网络分析环境因素对7种铝合金平均腐蚀速率的影响。结果 确定了影响铝合金腐蚀损伤的重要因素为SO2沉积率、Cl^–沉积率、NOx沉积率；辅要因素为年降雨量、年雾露时数、相对湿度、年日照时数、温度、铝合金成分；次要因素为年累积降水时数、雨水pH值。结论 基于多层感知器神经网络分析有效展现了环境因素对平均腐蚀速率的影响性。     

Are calcareous soils in uplands less prone to damage from road salting than acidic soils?

Previous studies of upland roadside soils in Cumbria, that would normally be naturally acidic, have highlighted that (a) runoff from roads subjected to long-term road salting can dramatically raise soil pH down slope in upland areas; (b) the soil pH increase dramatically changes N cycling in soils down slope, increasing mineralisation of organic matter, ammonification, ammonium leaching down slope and nitrification and nitrate leaching; (c) the increase in nitrification substantially increases nitrate leaching to down-slope rivers, and this is readily detectable in field studies; and (d) loss of soil organic matter over decades of salting is so great that organic matter is no longer substantially solubilised by high salt concentrations found in soil solution below road drains. This paper tests and supports the hypothesis that such effects are minimal for more calcareous soil ecosystems. It examines the soil and soil solution chemistry on another Cumbrian upland highway, the A686 near Leadgate, Alston. Sodium % of soil CEC values for soil transects affected by spray containing road salt are similar at both the A6 and A686 sites. However, spatial trends in calcium, magnesium, ammonium, and nitrate concentrations as well as pH differ, as a direct result of the higher weathering rate of parent material and possibly also the presence of limestone walls above both spray-affected and control transects at the A686 site.     

基于正交试验的谷物粉尘燃烧特性影响因素研究

为了研究谷物粉尘燃烧特性影响因素，以可食用玉米淀粉为研究对象，通过ZY6243锥形量热仪（CONE）进行了单因素和正交试验，研究了粉尘粒径、惰性介质CaCO3质量分数、热辐射通量对玉米淀粉燃烧特性的影响效应。应用直观分析法和方差分析法定性地研究了各因素对玉米淀粉热释放速率峰值的影响程度并进行了排序，2种方法得出的结论基本一致。研究结果表明:各因素对玉米淀粉热释放速率峰值的影响程度依次为:CaCO3质量分数＞粉尘粒径＞热辐射通量；其中惰性介质CaCO3对热释放速率峰值和引燃时间的影响最为显著。     

Numerical simulation of landfill aeration using computational fluid dynamics

The present study is an application of Computational Fluid Dynamics (CFD) to the numerical simulation of landfill aeration systems. Specifically, the CFD algorithms provided by the commercial solver ANSYS Fluent 14.0, combined with an in-house source code developed to modify the main solver, were used. The unsaturated multiphase flow of air and liquid phases and the biochemical processes for aerobic biodegradation of the organic fraction of municipal solid waste were simulated taking into consideration their temporal and spatial evolution, as well as complex effects, such as oxygen mass transfer across phases, unsaturated flow effects (capillary suction and unsaturated hydraulic conductivity), temperature variations due to biochemical processes and environmental correction factors for the applied kinetics (Monod and 1st order kinetics). The developed model results were compared with literature experimental data. Also, pilot scale simulations and sensitivity analysis were implemented. Moreover, simulation results of a hypothetical single aeration well were shown, while its zone of influence was estimated using both the pressure and oxygen distribution. Finally, a case study was simulated for a hypothetical landfill aeration system. Both a static (steadily positive or negative relative pressure with time) and a hybrid (following a square wave pattern of positive and negative values of relative pressure with time) scenarios for the aeration wells were examined. The results showed that the present model is capable of simulating landfill aeration and the obtained results were in good agreement with corresponding previous experimental and numerical investigations.     

Landfill aeration in the framework of a reclamation project in Northern Italy

In situ aeration by means of the Airflow technology was proposed for landfill conditioning before landfill mining in the framework of a reclamation project in Northern Italy. A 1-year aeration project was carried out on part of the landfill with the objective of evaluating the effectiveness of the Airflow technology for landfill aerobization, the evolution of waste biological stability during aeration and the effects on leachate and biogas quality and emissions.The main outcomes of the 1-year aeration project are presented in the paper.The beneficial effect of the aeration on waste biological stability was clear (63% reduction of the respiration index); however, the effectiveness of aeration on the lower part of the landfill is questionable, due to the limited potential for air migration into the leachate saturated layers.During the 1-year in situ aeration project approx. 275 MgC were discharged from the landfill body with the extracted gas, corresponding to 4.6 gC/kgDM. However, due to the presence of anaerobic niches in the aerated landfill, approx. 46% of this amount was extracted as CH₄, which is higher than reported in other aeration projects. The O₂ conversion quota was lower than reported in other similar projects, mainly due to the higher air flow rates applied.The results obtained enabled valuable recommendations to be made for the subsequent application of the Airflow technology to the whole landfill.     

Remediation of DDT-Contaminated Water and Soil by Using Pretreated Iron Byproducts from the Automotive Industry

The objective of this study was to quantify the effectiveness of different pretreated iron byproducts from the automotive industry to degrade DDT [(1,1,1-trichloro-2,2-bis(4-chlorophenyl) ethane] in aqueous solutions and soil slurry. Iron byproducts from automotive manufacturing were pretreated by three different methods (heating, solvent and 0.5N HCl acid washing) prior to experimentation. All pretreated irons were used at 5% (wt v^{? 1}) to treat 0.014 mM (5 mgL^{? 1}) of DDT in aqueous solution. Among the pretreated irons, acid pretreated iron results in the fastest destruction rates, with a pseudo first-order degradation rate of 0.364 d^{? 1}. By lowering the pH of the DDT aqueous solution from 9 to 3, destruction kinetic rates increase more than 20%. In addition, when DDT-contaminated soil slurry (3.54 mg kg^{? 1}) was incubated with 5% (wt v^{? 1}) acid-pretreated iron, more than 90% destruction of DDT was observed within 8 weeks. Moreover, DDT destruction kinetics were enhanced when Fe(II), Fe(III) or Al(III) sulfate salts were added to the soil slurry, with the following order of destruction kinetics: Al(III) sulfate > Fe(III) sulfate > Fe(II) sulfate. These results provide proof-of concept that inexpensive iron byproducts of the automotive industry can be used to remediate DDT-contaminated water and soil.     

Nitrogen and phosphorus removal for swine wastewater by ammonium crystallization and intermittent aeration process

Abstract

A process on crystallized precipitation of ammonium by adding magnesium salt and phosphate was carried out to improve C/N ratio in swine wastewater. After completion of crystallized precipitation of ammonium, an intermittent aeration process with aeration and non‐aeration periods alternated at interval of 1:1 hr day^‐1 is used for the improved swine wastewater (T‐N/BOD=0.14: BOD=8200 mg/liter and T‐N=1166 mg/liter). The results obtained from the experiment show that the removal ratios of T‐N and NH₄‐N are 91% and 99%, respectively. T‐P is not removed, while the removal ratio of PO₄‐P is 60% as 3% of CaCl₂ liquid is added. The results also indicate that dilution with water is effective to improve the removal of phosphorus even if raw swine wastewater contains high concentrations of T‐N, T‐P, BOD, and TOC.     

壬基酚聚氧乙烯醚在碱性印染废水中的降解

通过静态和动态连续降解实验,揭示了壬基酚聚氧乙烯醚(NPEO,Nonylphenol ethoxylates,浓度6.25~12.5 mg·L-1)在碱性牛仔布印染废水中的去除规律.批式活性污泥实验表明,厌氧环境下,随着p H值的增加,壬基酚(NP,Nonylphenol)产生受到抑制,短链NPEO(环氧乙烯加成数1~3,NP(1~3)EO)总浓度水平虽然只有500~900μg·L-1,却呈现增加趋势;好氧环境下,尽管NPEO总量降解率超过85%,但产生的各种短链NP(1~3)EO和短链壬基酚聚氧乙烯醚酸酯(NPEC,Nonylphenol polyethoxycarboxylate)浓度区间为10~110μg·L-1,碱性环境下两类物质总量最低,不足100μg·L-1.耦合厌氧水解和好氧曝气的连续实验表明,增设填料的厌氧折板水解池出水中短链NP(1~3)EO的总浓度增至4000~5000μg·L-1,这与厌氧环境下一部分NPEO附着在废水杂质和厌氧污泥上,在污泥龄较长的附着型污泥作用下,生成了大量的NP(1~3)EO有关;好氧段出水中NP(1~3)EO浓度降至230~610μg·L-1,短链NPEC(NP(1~3)EC)总量上升到800~1000μg·L-1,NP(1~3)EC由NP(1~3)EO转化来的可能最大.印染出水中NP及NP(1~3)EO受厌氧段出水中NP及NP(1~3)EO浓度影响明显.     

有机溶剂对过氧化环己酮热危险性的减敏效果评价

在纯过氧化环己酮(CYHPO)储运中常添加减敏剂,以降低其热危险性。为了对比评价减敏性能,采用绝热加速量热仪测试了纯CYHPO及加入等质量邻苯二甲酸二丁酯(DBP)、邻苯二甲酸二辛酯(DOP)、正己酸(HAA)和环己醇(CCH)后的热危险参数,并计算了上述5种样品的反应动力学常数和绝热校正数据,建立了包括初始放热温度T0和绝热反应加速度SARC的减敏效果判据,对4种减敏剂的热危险性减敏效果进行了评价。结果表明,DOP对CYHPO热危险性的减敏效果最好。     

一株高效絮凝剂产生菌的分离鉴定与絮凝特性研究

采用富集培养及平板分离方法从成都某污水处理厂活性污泥中筛选出一株具有絮凝活性的菌株SNUX-1,经形态特征及16S rRNA鉴定该菌株为约氏不动杆菌(Acinetobacter johnsonii).对该菌株絮凝活性分布及在不同生长条件下所产絮凝剂的絮凝率进行了研究,并对其絮凝剂成分进行了分析.结果表明,该菌株所产微生物絮凝剂为胞外产物,显色剂显色结果表明,该絮凝剂不含蛋白质成分,含有糖类成分;在以蔗糖为碳源、培养基初始pH值为8、以氯化铜为助凝剂的条件下培养12 h,该菌株所产微生物絮凝剂的絮凝率最高,达96.71％,可作为治理环境污染的菌种资源.