混凝一气浮控制三卤甲烷生成势的研究

研究了混凝一气浮工艺对不同分子量区间三卤甲烷生成势（trihalomethanes formation potential,THMFP）的去除效果及絮体形态对THMFP去除效果的影响。结果表明,混凝一气浮工艺以去除大分子量区间THMFP为主,对小分子量区间THMFP的去除效果较差。UV254值与THMFP值的线性相关系数为0．9449,UV254值可以较好地反映THMFP的含量。絮体的分形维数为1．17～1．2时,孔隙率较大,可增加絮体对THMFP的活性吸附空间,且絮体相对密度较小,可增强同向絮凝作用,增加絮体和THMFP的接触概率,有利于气浮对THMFP的去除。     

凹凸棒土的氨氮吸附性能研究

在以氨氮去除率为指标,在振荡时间60 min,振荡温度25℃,振荡速度140r/min的条件下发现凹凸棒土的最佳投加量2.5 g;添加凹凸棒土可以加强SBR生物系统去除氨氮的能力;拟合凹凸棒土吸附氨氮的等温线方程符合Freundlich吸附模型.     

大宝山矿区水体和沉积物中重金属的污染评价

分别于丰水期和枯水期对广东省大宝山矿区铁龙拦泥坝至凉桥河段水体中溶解态的重金属进行了调查,应用EPA推荐的健康风险评价模型发现,水体中非致癌物通过饮水途径所导致平均个人年风险排列顺序是Cu〉Pb〉Zn,最大值的平均个人年风险在丰水期和枯水期的平均值分别是2.14×10-7 a-1和4.13×10-7 a-1,小于国际防辐射委员会（ICRP）推荐的最大可接受平均个人年风险5.0×10-5a-1。致癌物Cd的平均个人年风险在丰水期和枯水期的平均值分别是3.52×10-4 a-1和4.53×10-4 a-1,大于ICRP推荐的最大可接受值,同时也大于非致癌物3～4个数量级。另外,通过对枯水期沉积物的重金属总量分析,发现凉桥槽对坑支流受水体pH的影响,导致其沉积物重金属的浓度最高。根据Long和Macdonald利用生物效应数据库法建立的沉积物质量基准,发现除冷水泾外,其他采样点的平均效应中值指数（mERMQ）值都大于1.5,可见沉积物中的重金属会对当地底栖生物产生毒害作用。     

宁波市大气可吸入颗粒物PM1o和PM2.5的源解析研究

在宁波市布设4个代表性点位,于2010年春季、夏季和冬季进行大气PM10和PM2.s的采样,同时采集了多种颗粒物源样品,建立了PM10、PM2.5和源样品的化学成分谱.采用化学质量平衡模型(CMB)对宁波市PM10、PM2.5进行源解析.结果表明,城市扬尘、煤烟尘、机动车尾气尘是宁波市PM10、PM2.5的3大污染源,...     

Experimental investigation of outdoor and indoor mean concentrations and concentration fluctuations of pollutants

Tracer gas was released upwind of a two-compartment complex shaped building under unstable atmospheric conditions. The mean wind direction was normal to or at 45° to the long face of the building. The general patterns of concentration distribution on the building external walls and inside the building were analysed and the influence of natural and mechanical ventilation on indoor concentration distributions was discussed. Mean concentration levels, as well as the concentration fluctuation intensity, were higher on the windward walls of the building, although concentration levels varied along each wall. Concentration fluctuations measured inside the building were lower than those measured outside. Inside the two compartments of the building, the time series of concentrations had a similar general behaviour; however, gas concentrations took approximately 1.5 times longer to reach the mean maximum concentration value at the downwind compartment 02 while they also decreased more rapidly in the upwind compartment 01 after the source was turned off. The highest indoor concentration and concentration fluctuation values were observed at the detectors located close to the windward walls, especially when the building windows were open. Experiments with and without natural ventilation suggested that infiltration and exfiltration of contaminants is much faster when the building windows are open, resulting to higher indoor concentration levels. Furthermore, mechanical ventilation tends to homogenize concentrations and suppress concentration fluctuations, leading to lower maximum concentration values.     

盐城市区环境空气污染原因分析及对策建议

通过对盐城市区建成空气自动监测站来的数据分析,简要说明了盐城市区环境空气质量下降的原因,并提出了改善城市大气污染的建议措施。     

江苏省污染减排与空气质量变化相关性分析

利用2000—2007年大气污染物排放量数据和同期环境空气质量监测数据,分析了江苏省主要大气污染物减排与环境空气质量变化的相关性。结果表明,近年来江苏省SO2排放量与环境空气中SO2浓度存在正相关,而烟尘和粉尘排放总量与空气中可吸入颗粒物的浓度呈现出弱的负相关关系。对江苏省经济发展和环境关系的进一步分析揭示,江苏省环境库兹涅茨曲线呈现出倒U型关系,表明江苏省已经进入经济环境双赢区间,但近年来政策对经济环境关系的影响突出。该研究对中国十二五环境管理政策的制定有着重要的参考意义。     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.     

催化湿式氧化预处理造纸黑液

采用连续式固定床反应器,利用自制稀土类复合金属氧化物催化剂对草浆造纸黑液进行了催化湿式氧化(CWAO)预处理研究.通过正交实验确定了最佳工艺条件为:进水COD 40 800 mg/L,空速0.8h-1,反应温度260℃,反应压力6.5 MPa.在此最佳条件下进行实验,COD去除率达90％.经CWAO工艺处理后,草浆造纸...     

Indicator framework for sustainable production planning and controlling

Production facilities serve to transform raw materials into products, usually with the goal of achieving a designated output, in terms of quantity and quality, with the minimum of cost and labour. With the aid of production planning and controlling (PPC) systems, raw material inputs, and labour can be planned to achieve a determined output of products. In general, the role of environmental and social aspects is neglected in production planning processes. Because of the growing pressure from politics and customers, sustainable production of products is becoming more important. One possibility for supporting sustainable manufacturing is, to integrate sustainable aspects in the production planning process. This paper presents input and output information for current PPC systems and discusses the need for additional information necessary for sustainable PPC. For this approach, a text review of cooperate social responsibility (CSR) reporting indicators provided by the GRI was performed. Based on the text review, an input-output model has been developed for conventional and another one for sustainable PPC systems. Through the comparison of the two input-output models, challenges and requirements for sustainable PPC systems have been defined as a basis for future work and analyses.