废渣──Al(OH)_3凝胶再利用研究

研究了对处理铝材加工含Al3＋的酸性废液过程中产生的二次污染物Al（OH）3凝胶废渣的应用。含水分约90％、80％左右的Al（OH）3凝胶200g分别与14～16mL、22～24mL95％的工业浓硫酸酸反应，可制得浓度为20％～23％的Al（SO4）3溶液，经稀释可用作造纸原料。     

脉冲等离子法烟气脱硫的放大实验

锅炉烟气进行脉冲等离子法脱硫的扩大实验，得到与模拟烟气实验相近的结果。研究表明，脉冲等离子法对锅炉烟气中的ＳＯ２去除率可达９５％以上，烟气在反应器内的停留时间（ｔｓ）、脉冲电源的放电功率（Ｐ）和添加ＮＨ３等条件，对脱硫效率９η）有较大影响。ｔｓ、Ｐ越大、η越高。处理烟气量（Ｑ）、能耗（Ｐ）与η存在函数关系：η＝１１８．０（Ｐ／Ｑ）＾０．１１１１。烟气中加入适量ＮＨ３，对脱硫效率有显著提高，以ＮＨ３     

Al（Ⅲ）溶液的水解─沉淀特性研究─—磷酸根的作用

采用连续碱滴定方法和Ｘ射线衍射及红外光谱分析，研究了在Ａｌ（Ⅲ）－磷酸根溶液体系中Ａｌ（Ⅲ）的水解－沉淀特性，结果表明，当Ｐ／Ａｌ＞０．０５时，磷酸根对Ａｌ（Ⅲ）的水解－成核－沉淀过程有显的促进作用，描述了磷酸根作用的动力学机理。     

高镁铝合金在喷射成形过程中显微组织的变化

研究了高镁铝合金在喷射成形过程中显微组织的变化。沉积态高镁铝合金基体呈全部等轴晶组织并存在少量显微孔洞是沉积态组织的主要特征。分析了等轴晶组织和显微孔洞在喷射成形中生成的机制。     

聚合硫酸铁和聚合硫酸铝的配伍和性能研究

将聚合硫酸铁 (PFS)与聚合硫酸铝 (PAS)按一定比例混合 ,即可制得一类具有不同铝铁含量的新型净水剂——聚合硫酸铁铝 (PFAS)混合液 ,分析、检测了几种 PFAS的性质及其净水性能。结果表明 ,PFAS的综合性能优于 PFS和PAS,更能适应原水水质的变化 ,其中尤以铝铁分子摩尔比为 0 .64的 PFAS性能最优。     

利用粉煤灰制备高纯超细氧化铝粉体的研究

利用粉煤灰为原料制备高纯超细氧化铝粉体。给出了采用硅酸二钙晶相转变自粉化、高效分散剂———碳化法从粉煤灰中制备氧化铝方法的工艺路线 ,确定了从粉煤灰制备高纯超细氧化铝粉体的最佳工艺条件 ,为粉煤灰的高价值利用开辟了一条新途径     

COD/SO_4~(2-)值对硫酸盐还原率的影响

研究利用 UASB反应器考察了 COD和硫酸盐浓度的比值对硫酸盐还原的影响 ,同时分析了硫酸盐还原菌和产甲烷菌对COD的竞争情况 .发现在 HRT为 3.8h,SO2 -4 负荷为 6～ 7kg· ( m3· d) - 1 ,SO2 -4 浓度为 1 0 0 0 mg· L- 1 条件下 :1在 COD不足时 ,SRB与 MPB在竞争中占微弱优势 ;对于产甲烷活性比较好的厌氧污泥要经过较长的时间 ,SRB才能确立优势菌种的地位 .2 COD/ SO2 -4 比值决定了 SO2 -4 的去除率 .比值等于 2时 ,SO2 -4 的还原率在 95%以上 ;当比值为 1 .5时 ,SO2 -4 还原率为 75% ;当比值为 1时 ,SO2 -4 的还原率为 60 % .     

Catalytic oxidation effect of MnSO4 on As(III) by air in alkaline solution

The catalytic oxidation effect of MnSO₄ on As(III) by air in an alkaline solution was investigated. According to the X-ray diffraction (XRD), scanning electron microscope-energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS) analysis results of the product, it was shown that the introduction of MnSO₄ in the form of solution would generate Na_0.55Mn₂O₄·1.5H₂O with strong catalytic oxidation ability in the aerobic alkaline solution, whereas the catalytic effect of the other product MnOOH is not satisfactory. Under the optimal reaction conditions of temperature 90°C, As/Mn molar ratio 12.74:1, air flow rate 1.0 L/min, and stirring speed 300 r/min, As(III) can be completely oxidized after 2 hr reaction. The excellent catalytic oxidation ability of MnSO₄ on As(III) was mainly attributed to the indirect oxidation of As(III) by the product Na_0.55Mn₂O₄·1.5H₂O. This study shows a convenient and efficient process for the oxidation of As(III) in alkali solutions, which has potential application value for the pre-oxidation of arsenic-containing solution or the detoxification of As(III).     

PASS混凝去除给水腐植酸的研究

用所研制的聚硅硫酸铝对含腐植酸原水进行了混凝处理 ,研究了投加量、pH值等对腐植酸去除效果的影响 ,探讨了PASS对腐植酸的混凝去除机理 ,并作了经济分析     

Enzymatic degradation of poly([R,S] β-hydroxybutyrate)

The synthetic analogue of a bacterially produced polyester, poly(-hydroxybutyrate) (PHB) was synthesized from racemic -butyrolactone using anin situ trimethyl aluminum-water catalyst. The polymer was fractionated into samples differing in molecular weight and isotactic diad content. The latter was closely related to degree of crystallinity. The biodegradation of these fractions were examined by monitoring mass loss over time in the presence of anAlcaligenes faecalis T1 extracellular bacterial poly(-hydroxybutyrate) depolymerase. The fraction with high isotactic diad tacticity content showed little or no degradation over a 50 hour incubation period, whereas the fraction of intermediate isotactic diad content degraded in a continuous steady fashion at a rate that was less than that for bacterial PHB. The low isotactic diad fraction underwent a rapid initial degradation, followed by no further mass loss. The presence of stereoblocks in the polymer structure of the various fractions was an influence on the degree of susceptibility towards degradation and is related to sample crystallinity.