双波长紫外吸收法有机废水COD测量技术与仪器设计

紫外吸收法直接测定有机废水COD是一种无需化学试剂、无样品前处理、无二次污染的绿色无损检测技术,但在实际应用中发现,有机废水中的悬浮物对测量结果产生较大影响.以实际废水水样为例,详细阐述了双波长紫外吸收法测量有机废水COD的操作方法及其消除悬浮物干扰的原理,并介绍了运用该技术设计开发的COD在线测量仪器.该仪器采用嵌入式计算机系统实时采集和处理数据,根据实际废水在双波长测量条件下的有效紫外吸光度快速推算出其COD值,具有快速、准确、无污染的特点.     

鼓泡式反应器高径比对氨法烟气脱碳性能的影响

以N2和CO2混合气模拟燃烧烟气,研究了鼓泡反应器的高径比以及反应条件对氨法烟气脱碳性能的影响。实验结果表明:在相同高径比的条件下,CO2吸收率随氨水质量分数的增加、反应温度的升高而逐渐增大,随进气CO2体积分数和模拟烟气流量的增加而逐渐减小;CO2吸收率随高径比的增加而增大,在高径比为3.98、氨水质量分数为28%、进气CO2体积分数为10%、模拟烟气流量为1.0L/min、反应温度为40℃的条件下,CO2吸收率最高可达100%。     

燃烧后CO2气体捕集技术研究

从燃煤电厂排出的烟气分离技术,分为即燃烧前处理、富氧燃烧以及燃烧后处理三类,阐述燃烧后的处理方法.这种方法有五大技术发展方向,包括吸收、吸附、膜分离、霜冻分离和生物捕捉.对这五个方向的技术做一些阐述,并列举这几个方向下正在开展的研究实例,对二氧化碳捕集技术做一个较全面的介绍.     

Fe_3O_4@SiO_2/TiO_2核壳结构纳米颗粒降解TNT溶液

针对TNT炸药废水具有成分复杂、排放量大、有毒等特点,立足于炸药废水在排放前的降解处理,研究开发一种基于核壳结构Fe3O4@SiO2/TiO2纳米颗粒的高效、可控回收、无二次污染且成本低的光催化降解方法。利用高温碳还原法和溶胶凝胶法制备了具有核壳结构的Fe3O4@SiO2/TiO2纳米颗粒。XRD分析表明,内核Fe3O4呈现磁铁矿特征,表面覆盖的纳米TiO2为锐钛矿型。磁滞回线测试结果显示,复合颗粒的饱和磁化强度为46.5 emu/g,N2吸附-解吸分析结果表明,该颗粒具有典型的介孔结构。使用Fe3O4@SiO2/TiO2纳米颗粒在紫外光下对含TNT废水进行降解,降解率达到81.9%,且颗粒的回收率达到88.4%,为实现高效、可控回收、无二次污染光催化-吸附降解TNT奠定了基础。     

Removal of phenolic estrogen pollutants from different sources of water using molecularly imprinted polymeric microspheres

The efficiency and effects of using Bisphenol A-molecularly imprinted polymeric microspheres (MIPMs) to remove phenolic estrogens from different sources of water were evaluated. MIPMs prepared by precipitation polymerization removed a group of phenolic estrogens from different kinds of water selectively and effectively. The highest removal efficiency was observed at pH=5. Fifty millimoles per litre ions or 10mg/L humid acid improved removal efficiency. MIPMs were more suitable to remove trace estrogens in large volume than high concentration of estrogens in small volume. The removal efficiency of spiked tap water, lake water and river water were better than that of distilled water. Hundred milligrams of MIPMs had higher removal selectivity and efficiency than those of 100mg or 300mg activated carbons. Moreover, MIPMs can be re-used for at least 30 times without losing any removal efficiency. MIPMs provided a selective, simple, reliable and practicable solution to remove trace phenolic estrogens from different sources of water.     

Preconcentration technique for the determination of trace elements in natural water samples by ICP-AES

A procedure was developed for the determination of Cd, Cu, Zn, Co, Ni, Mn, Pb and Mo in water samples by inductively coupled plasma atomic emission spectrometry (ICP-AES) after preconcentration on a morpholine dithiocarbamate (mor-DTC) supported by bagasse (Saccharam aphisinaram). The sorbed elements were subsequently eluted with 4,M HNO₃ and the acid eluates were analysed by ICP–AES. The influence of various parameters such as pH, flow rate of sample, eluent concentration, volume of the sample and volume of eluent were investigated to enhance the sensitivity of the present method. A 20,mL disposable syringe served as preconcentration column. Under the optimal conditions Cd, Cu, Zn, Co, Ni, Mn, Pb and Mo in aqueous sample was concentrated about 100-fold. The sorption recoveries of elements were higher than 99.6%. The method is also applied for the analysis of natural and spiked water samples.     

流动注射在线离子交换微柱富集-火焰原子吸收法测定环境样品中的铜、铅和镉

本文用流动注射在线阳离子交换树脂预富集-火焰原子吸收法测定了标准参考物(头发GBW09 101和桃叶GBW08501)及水样中的微量铜、铅和镉.对铜、铅和镉测定灵敏度分别提高27.0 ,37.5和27.5倍;回收率分别为93.7-109.9%,88.9-101.4%,84.7-103.0% ;分析速度为30次·h-1.对0.05μg·ml-1Cu2+,0.2μg·ml-1 Pb2+,0.02μg·ml-1Cd2+溶液,其测定相对标准偏差(n ＝11)分别为2.74%,1.05%和2.97%.     

火电厂烟气脱硫装置吸收塔倒装工艺

吸收塔是火电厂烟气脱硫装置中的关键设备,以铜陵电厂2×1 000MW机组烟气脱硫装置吸收塔安装为例,介绍了吸收塔倒装工艺及其特点。由于倒装法在降低费用、缩短工期、减少高空作业量、不受场地限制等方面具有显著的优点,因而在吸收塔的施工技术中被广泛采用。     

膜吸收法净化低浓度甲醛和氨气

基于膜吸收技术自制双层平板式膜吸收器,搭建净化低浓度甲醛和氨气污染模拟系统,考察不同膜结构参数、进气流量、吸收剂流量等因素对其净化效果的影响。结果表明,聚偏氟乙烯PVDF对低浓度甲醛和氨气的净化效率高于聚四氟乙烯PTFE。对同一材质膜,随着膜孔隙率的增大,甲醛和氨气的净化率呈上升趋势。随着进气流量的增加。甲醛和氨气的净化效率降低;而吸收剂流量对其净化效率影响不大。对于所有实验条件,平均膜孔径为0．22μm的PVDF4#在进气流量ug=120L／h时,甲醛和氨气的净化效率最高,分别达94．7％和96．3％。     

震后某工号建渣及土壤样品中铀的分析测定

采用激光荧光法对"5.12"地震后某工号建筑垃圾和土壤样品进行了铀的测定。方法检出下限D.L≤3×10-11g/mL,相对标准偏差RSD为7.4%,回收率达到86%~109%。对实验数据进行了分析和初步评价,结果表明,该工号所测样品铀含量基本处于天然本底水平。